稠油污水回用锅炉处理工艺的应用

新疆油田公司稠油污水处理普遍采用成熟的离子调整旋流反应水处理技术,污水处理后达到回用锅炉水质标准SY/T 0097-2000《稠油油田采出水用于蒸汽发生器给水处理设计规范》,供给油田专用高压注汽锅炉用水。采用相同技术建成的采油一厂稠油处理站污水回用锅炉处理工艺投用后,处理后污水回用锅炉,减少了含油污水的外排,充分利用了稠油污水的热能,取得了良好的经济和社会效益。     

充分利用环保倒逼机制促进产业结构调整升级

淄博市污染聚集,环境质量易受外来因素影响,产业结构不合理,污染物排放量大,排放强度高。但其充分发挥环保的倒逼作用,通过建立健全环保政策法规体系,严格执行高于省及国家标准的地方环保标准,大力发展高新技术和现代服务业,加快改造传统产业,极大地促进了产业结构升级和经济发展方式的转变。     

Catalytic destruction of pentachlorobenzene in simulated flue gas by a V2O5-WO3/TiO2 catalyst

Pentachlorobenzene (PeCB) in simulated flue gas was destructed by a commercial V₂O₅-WO₃/TiO₂ catalyst in this study. The effects of reaction temperature, oxygen concentration, space velocity and some co-existing pollutants on PeCB conversion were investigated. Furthermore, a possible mechanism for the oxidation of PeCB over the vanadium oxide on the catalysts was proposed. Results show that the increase of gas hourly space velocity (GHSV) and the decrease of operating temperature both resulted in the decrease of PeCB removal over the catalyst, while the effect of the oxygen content in the range of 5-20% (v/v) on PeCB conversion was negligible. PeCB decomposition could be obviously affected by the denitration reactions under the conditions because of the positive effect of NO but negative effect of NH₃. The introduction of SO₂ caused the catalyst poisoning, probably due to the sulfur-containing species formed and deposited on the catalyst surface. The PeCB molecules were first adsorbed on the catalyst surface, and then oxidized into the non-aromatic acyclic intermediates, low chlorinated aromatics and maleic anhydride.     

Historical change of mercury pollution in remote Yongle archipelago, South China Sea

We collected three ornithogenic coral sand sedimentary profiles from Jinyin Island, Jinqing Island and Guangjin Island of Yongle archipelago, South China Sea and reconstructed the deposition flux of anthropogenic Hg over the past 700 years in the study area. On the whole, the anthropogenic Hg flux is relatively low; it remained at a low level before the Industrial Revolution with a small peak at about 1450-1550 AD, which may record the enhanced metallurgy activity in Ming Dynasty of China. During the 20th century, the deposition flux of anthropogenic Hg increased rapidly, but two troughs occurred during the periods around 1940s and 1970s, corresponding to the economic depression caused by World War II, Civil War in China (1945-1949), and the Culture Revolution (1966-1976) in China. Since the 1970s the deposition flux of anthropogenic Hg has been persistently increasing, apparently the result of fast economic development in East and Southeast Asia countries around South China Sea.     

Effect of humic acids on physicochemical property and Cd(II) sorption of multiwalled carbon nanotubes

Zinc pyrithione is used as an antifouling agent. However, the environmental impacts of zinc pyrithione have recently been of concern. Zinc induces diverse actions during oxidative stress; therefore, we examined the effect of zinc pyrithione on rat thymocytes suffering from oxidative stress using appropriate fluorescent probes. The cytotoxicity of zinc pyrithione was not observed when the cells were incubated with 3 μM zinc pyrithione for 3 h. However, zinc pyrithione at nanomolar concentrations (10 nM or more) significantly increased the lethality of cells suffering from oxidative stress induced by 3 mM H₂O₂. The application of zinc pyrithione alone at nanomolar concentrations increased intracellular Zn²⁺ level and the cellular content of superoxide anions, and decreased the cellular content of nonprotein thiols. The simultaneous application of nanomolar zinc pyrithione and micromolar H₂O₂ synergistically increased the intracellular Zn²⁺ level. Therefore, zinc pyrithione at nanomolar concentrations may exert severe cytotoxic action on cells simultaneously exposed to chemicals that induce oxidative stress. If so, zinc pyrithione leaked from antifouling materials into surrounding environments would be a risk factor for aquatic ecosystems. Alternatively, zinc pyrithione under conditions of oxidative stress may become more potent antifouling ingredient.     

Subcellular distribution and toxicity of cadmium in Potamogeton crispus L

The submerged macrophyte Potamogeton crispus L. was subjected to varying doses of cadmium (0, 20, 40, 60 and 80 μM) for 7 d, and the plants were analyzed for subcellular distribution of Cd, accumulation of mineral nutrients, photosynthesis, oxidative stress, protein content, and ultrastructural distribution of calcium (Ca). Leaf fractionation by differential centrifugation indicated that 48-69% of Cd was accumulated in the cell wall. At all doses of Cd, the levels of Ca and B rose and the level of Mn fell; the levels of Fe, Mg, Zn, Cu, Mo, and P rose initially only to decline later. Exposure to Cd caused oxidative stress as evident by increased content of malondialdehyde and decreased contents of chlorophyll and protein. Photosynthetic efficiency, as indicated by the quenching of chlorophyll a fluorescence (Fv/Fm, Fo and Fm), decreased significantly, the extent of decrease being directly proportional to the concentration of Cd. Increased amounts of precipitates of calcium were noticed in the treated plants, located either outside the cell membrane or in chloroplasts, mitochondria, the nucleus, and the cytoplasm whereas control plants showed small deposits of the precipitates around surface of the vacuole membrane and in the intercellular space but rarely in the cytoplasm. Photosynthetic efficiency and oxidative stress could be used as indicators of physiological end-points in determining the extent of Cd phytotoxicity.     

Ozonation as an advanced oxidant in treatment of bamboo industry wastewater

The present study employed ozonation process to treat the bamboo industry wastewater (BIWW). The impact of ozone dosage and initial organic concentration on color, COD and TOC removal rates were studied along with characterization of the major organics in raw and treated wastewater. The results suggested the ozone dosage of 3.15 g h⁻¹ (concentration 52.5 mg L⁻¹) was suitable for the treatment. After 25 min ozonation of 1 L raw wastewater, the color, COD and TOC removal efficiencies were 95%, 56% and 40%, respectively, with an influent COD concentration of 835 mg L⁻¹. The ratio of kg O₃ kg⁻¹ COD at 3.15 g h⁻¹ was 2.8 (<3), revealing that ozonation was a cost effective process for tertiary treatment of BIWW. Longer oxidization time was required to achieve similar results for raw wastewater with higher COD concentration. The chromatogram from gel permeation chromatography revealed that ozonation resulted in the breakdown of high molecular weight compounds into lower molecular weight components but could not completely mineralize the organic matter. The majority of these compounds were identified in both raw and ozonated samples via GC-MS analysis. In addition to ester derivatives as the main intermediates of ozonation, 1-chloroctadecane, methyl stearate, benzophenone and α-cyperone were identified as the by-products of ozonation.     

Extraction of raw sewage sludge containing iron phosphate for phosphorus recovery

The objective of the present study was to establish an alkali extraction technology for FePO₄-containing sewage sludge obtained from a wastewater treatment system that includes phosphorous removal by iron electrolysis. By clarifying the extraction properties of phosphorous, organic matter, and inorganic matter, conditions for alkali extraction were optimized. As a result, it was suggested that unheated phosphorous extraction would be superior for FePO₄-containing sewage sludge. And, extraction methods and sewage sludge properties were also compared, and the noteworthy result that extraction of metals can be suppressed to extremely low amounts with alkali extraction as compared with acid extraction was obtained. A new insight was also gained that, as compared with the use of incinerated ash reported in previous studies, alkali extraction was more efficient when raw sewage sludge was used.     

Can body-size patterns of ciliated zooplankton be used for assessing marine water quality? A case study on bioassessment in Jiaozhou Bay, northern Yellow Sea

Introduction

In order to reveal the potential relationships between body-size patterns of microzooplankton and environmental status, the spatial patterns in body-size spectra of ciliated zooplanktons were studied based on an annual dataset in a bay of the Yellow Sea, northern China.

Materials and methods

A total of 120 samples were collected at a depth of 1?m from each of five sampling sites with a spatial gradient of environmental stress from June 2007 to May 2008. A range of physico-chemical variables were measured synchronously for comparison with biotic parameters.

Results

The spatial body-size patterns of ciliated zooplankton represented significant differences among the five sites, and were significantly correlated with the changes of physico-chemical parameters, especially salinity, dissolved oxygen and nutrients. Two paired indices, the average body-size distinctness (AvBSD) and the variation in body-size distinctness (VarBSD), were proposed based on the trait resemblances among ciliate species in body-size pattern. The paired measures showed a clear decreasing trend of departure from the expected body-size spectra in response to water quality status.

Conclusion

These results suggest that the body-size pattern of ciliated zooplankton might be used as a potential indicator of marine water quality.     

Biofilm formation and microbial community analysis of the simulated river bioreactor for contaminated source water remediation

Background, aim, and scope

The start-up pattern of biofilm remediation system affects the biofilm characteristics and operating performances. The objective of this study was to evaluate the performances of the contaminated source water remediation systems with different start-up patterns in view of the pollutants removal performances and microbial community succession.

Methods

The operating performances of four lab-scale simulated river biofilm reactors were examined which employed different start-up methods (natural enrichment and artificial enhancement viadischarging sediment with influent velocity gradient increase) and different bio-fillers (Elastic filler and AquaMats? ecobase). At the same time, the microbial communities of the bioreactors in different phases were analyzed by polymerase chain reaction, denaturing gradient gel electrophoresis, and sequencing.

Results and discussion

The pollutants removal performances became stable in the four reactors after 2 months?? operation, with ammonia nitrogen and permanganate index (COD_Mn) removal efficiencies of 84.41?C94.21% and 69.66?C76.60%, respectively. The biomass of mature biofilm was higher in the bioreactors by artificial enhancement than that by natural enrichment. Microbial community analysis indicated that elastic filler could enrich mature biofilm faster than AquaMats?. The heterotrophic bacteria diversity of biofilm decreased by artificial enhancement, which favored the ammonia-oxidizing bacteria (AOB) developing on the bio-fillers. Furthermore, Nitrosomonas- and Nitrosospira-like AOB coexisted in the biofilm, and Pseudomonas sp., Sphaerotilus sp., Janthinobacterium sp., Corynebacterium aurimucosum were dominant in the oligotrophic niche.

Conclusion

Artificial enhancement via the combination of sediment discharging and influent velocity gradient increasing could enhance the biofilm formation and autotrophic AOB enrichment in oligotrophic niche.