Arsenic release from arsenic-bearing Fe-Mn binary oxide: effects of E(h) condition

Ferric and manganese binary oxide (FMBO) has been successfully used to remediate arsenic-polluted river, but there still lacks sufficient data to evaluate its effects on environments. The release behaviors of iron (Fe), manganese (Mn), and arsenic (As) in different E_h ranges were investigated for As-bearing FMBO sediment after remediating As-polluted DaSha River by FMBO. Under high E_h range (+550 to +400 mV), slight dissolution of Fe and Mn, which corresponded to 12.2% and 25.6%, and less than 5% of As release were observed in 336 h. Under lower E_h range (+50 to −100 mV), elevated extent of the dissolution of Mn and Fe were observed, which corresponded to as high as 61.3% and 70.1%. Under such conditions, the dissolution rate of Mn was higher than that of Fe. Furthermore, from the established relationship of As release and the dissolution of Fe and Mn, the release of As seemed dominated by the dissolution of Fe. X-ray photoelectron spectroscopy (XPS) analysis demonstrated the release of Fe, Mn, As(III), and As(V) after sodium ascorbate-treatment, and the re-adsorption of As(V), as indicated from the increased binding energy of As 3d from 44.78 to 45.83 eV. Surface element composition analysis indicated significant decrease of Mn from 3.22% to 0.54%, slight increase of Fe from 12.45% to 13.67%, and elevated ratio of As from 0.11% to 0.32% accordingly. The main reactions of Fe and Mn dissolution and the pathways of As release under different E_h ranges were also proposed.     

The Water Fluxes of the Yellow River to the Sea in the Past 50 Years, in Response to Climate Change and Human Activities

Since the 1970s, the water fluxes to the sea of the Yellow River have declined significantly. Based on data of precipitation, air temperature, the measured and “natural” river flow, the water diversion and consumption, and the areas of erosion and sediment control measures over the drainage basin, water fluxes to the sea of the Yellow River are studied in relation with the influences of changing climate and human activities. The Yellow River basin can be divided into different water source areas; multiple regression indicates that the variation in precipitation over different water source areas has different effect on water fluxes to the sea. In the period between 1970 and 1997, averaged air temperature over the whole Yellow River increased by about 1.0°C, from 16.5°C to 17.5°C, a factor that is negatively correlated with the water yield of the Yellow River. Water diversion and consumption has sharply increased and resulted in a significant decline in the water fluxes to the sea. Since the 1960s, erosion and sediment control measures have been practiced over the drainage basin. This factor, to a lesser degree, is also responsible for the decrease in water fluxes to the sea. A multiple regression equation has been established to estimate the change in water fluxes to the sea caused by the changes in precipitation, air temperature, water diversion and consumption, erosion, and sediment control measures, indicating that the contribution of water diversion and consumption to the variation in annual water flux to the sea is 41.3%, that of precipitation is 40.8%, that of temperature is 11.4%, and that of erosion and sediment control measures is 6.5%.     

生活垃圾填埋场渗滤液处理技术研究

根据处理工艺原理的不同 ,分别介绍生化和物化处理技术、膜处理技术、土地处理技术和蒸发处理技术等处理工艺研究与应用的进展情况 ,同时根据我国填埋场渗滤液的产生特点和处理处置现状 ,展望了我国渗滤液处理工艺的发展趋势。     

Treatment of refectory oily wastewater by electro-coagulation process

Electro-coagulation was used to treat refectory wastewater with high oil and grease contents. Different operational conditions were examined, including pH, current density, reaction time, conductivity, electrode distance and inlet concentration. The optimum current density was 10-14 A m(-2) within 30 min depending on the wastewater properties tested. Conductivity had little effect on the treatment efficiency. Although the addition of extra salts (e.g., sodium chloride) to the wastewater did not help increase the pollutant removal efficiency, it could save the power consumption significantly. The COD(Cr) and oil removal efficiency descended with increasing electrode distance. The optimal electrode distance was determined to be 10 mm for this equipment in consideration of the treatment cost and efficiency together. The pH effect on the performance of the electro-coagulation process was not very significant in the range of 3-10. The removal efficiency of oil and COD(Cr) under normal condition exceeded 95% and 75%, respectively.     

Role of illumination intensity in microcystin development using Microcystis aeruginosa as the model algae

Environmental Science and Pollution Research - Microcystis aeruginosa (M. aeruginosa) is one of the most common genera of cyanobacteria in algal blooms. In the present work, the impact of the...     

模拟黑水的生物处理

针对以糖蜜配制的半人工黑水生物处理时除磷效率下降和污泥膨胀的现象,利用序批式反应器(SBR)进行了实验分析,比较了以蔗糖和糖蜜为主要碳源时除磷效果的差异,并探讨了污泥膨胀发生的原因。研究表明,以糖蜜为主要碳源配制模拟黑水时的除磷效果比蔗糖为碳源时差,主要是由于GAOs的竞争性代谢所致。以糖蜜为碳源的条件下,污泥的胞外聚合物含量是正常活性污泥的一倍以上,导致污泥沉降性能变差;糖蜜碳源时的夏季高温条件下丝状菌大量生长也是导致污泥膨胀的重要原因。     

改性氧化铝微波诱导催化氧化处理高浓度苯酚废水的研究

采用微波诱导催化氧化技术,以改性氧化铝为催化剂,对高浓度模拟苯酚废水进行氧化处理。考察了微波功率、催化剂投加量、H202投加量、废水pH值和微波反应时间等因素对苯酚去除效果的影响。实验结果表明,处理30mL质量浓度为1 100mg/L的苯酚模拟废水,在微波功率500W,催化剂加入量1 g(液固比30∶1),30％双氧水...     

基于神经网络评估的密封点泄漏检测

介绍了运用神经网络评估方法对石化生产装置泄漏风险进行量化评估的主要程序：输入变量的选择、风险指标的确定及总风险评估指标的确定等。以某炼油厂柴油加氢精制装置的应用为例,说明该方法可以指导企业根据最终确定的风险等级制定泄漏检测计划,对高风险部位增加检测的频次,既能有效监控密封点的密封效果,又减少不必要的资源投入。     

橡胶制品工业环境影响评价重点问题研究

建设项目环境影响报告编制过程中常因未注意到某些关键问题的论述,而使环境影响报告缺乏科学性和可靠性,导致环境影响评价结论依据不足.为使建设项目从环境保护角度分析更具有可行性,以某橡胶制品项目为例,总结了橡胶制品工业项目环境影响评价文件中需注意的几个要点问题,为环境保护主管部门审批环境影响评价文件提供必要的依据,为此类项目更好地开展环境保护工作提供指导.     

Occurrence, distribution, and potential influencing factors of sewage sludge components derived from nine full-scale wastewater treatment plants of Beijing, China

Millions of tons of waste activated sludge (WAS) produced from biological wastewater treatment processes cause severe adverse environmental consequences. A better understanding of WAS composition is thus very critical for sustainable sludge management. In this work, the occurrence and distribution of several fundamental sludge constituents were explored in WAS samples from nine full-scale wastewater treatment plants (WWTPs) of Beijing, China. Among all the components investigated, active heterotrophic biomass was dominant in the samples (up to 9478 mg/L), followed by endogenous residues (6736 mg/L), extracellular polymeric substances (2088 mg/L), and intracellular storage products (464 mg/L) among others. Moreover, significant differences (p < 0.05) were observed in composition profiles of sludge samples among the studied WWTPs. To identify the potential parameters affecting the variable fractions of sludge components, wastewater source as well as design and operational parameters of WWTPs were studied using statistical methods. The findings indicated that the component fraction of sewage sludge depends more on wastewater treatment alternatives than on wastewater characteristics among other parameters. A principal component analysis was conducted, which further indicated that there was a greater proportion of residual inert biomass in the sludge produced by the combined system of the conventional anaerobic/anoxic/oxic process and a membrane bioreactor. Additionally, a much longer solids retention time was also found to influence the sludge composition and induce an increase in both endogenous inert residues and extracellular polymeric substances in the sludge.