脉冲电晕反应器结构对乙硫醇消除效果的影响

研究了脉冲电晕等离子体反应器结构的变化对乙硫醇消除效果的影响规律。结果表明,在反应器内设置折流板,可以增加气流的湍动程度,有利于活性粒子与污染物的充分接触,从而提高消除率。高压电极间距对电晕区范围及消毒效果有较大影响,间距较小将导致各电极产生的电场相互干扰明显,消除率减小;而电极间距过大,虽然电极间电场分布相互干扰小,但是反应器内可排布的电极数减少,总电晕区减少,消除率也减小。根据实验结果,电极间距设置为50 mm比较合理。另外,在相同的电场强度和脉冲频率下,毛刺形高压电极比线电极结构能耗低,能量利用率高。     

含中间层的DSA电极电催化氧化硝基苯废水的研究

为了提高难降解有机废水的可生化性,以及更高效地去除废水中的特征污染物,同时避免二次污染,利用自制的含锡锑中间层的钌钯氧化物涂层电极对有机废水中的硝基苯进行处理,并利用SEM、XRD等方法对电极中间层、表层进行微观表征。微观测试表明,基体、中间层、表层之间结合力较强,有利于增强电极寿命;水处理实验表明,电催化氧化反应体系适合高浓度有机废水的处理,由于该反应体系需要外加电解质加强传质,这在实际运用中为废水中盐度的处理提供了一种新的途径,当电流密度为20 mA/cm²、电解质浓度为10 g/L、pH=5、极板间距=2 cm时,电催化氧化体系对硝基苯具有较高的去除效率。     

摆管淋水试验装置的校准方法探讨

文中简述了摆管淋水试验装置的基本结构及其常见的校准方式,对其中的“摆角校准”这一技术难点提出了可行的解决方案并作了较详尽的说明分析。     

含油污泥调剖技术在陇东油田悦29区的应用

针对长庆陇东油田悦29区注水平面矛盾突出的特点,优选了含油污泥调剖技术。详细介绍了调剖体系的配制,调剖体系性能测试表明其相关性能指标满足要求。进行了驱替模拟试验,结果表明:其封堵作用可以维持较长时间,通过对不同注水井组进行现场应用,显示该技术能改善水驱开发效果,可以满足油藏深部封堵大孔道的技术要求,有增油降水效果。     

含磁粉生物反应器处理苯酚废水

采用含磁粉生物反应器对质量浓度为120～350 mg/L的苯酚模拟废水进行强化生物处理.实验结果表明:添加适量磁粉可使废水中DO提高约10%;与不含磁粉生物反应器比较,含磁粉生物反应器工艺使填料挂膜时间缩短1～2 d,填料上附着微生物量增多;质量浓度为350 mg/L的苯酚模拟废水在20 h内的苯酚去除率可达80%,降解时间缩短了10 h.初步分析了添加磁粉提高生物反应器处理废水效率的机理.实验证实了含磁粉生物反应器工艺的合理运用是强化处理含酚废水的有效途径.     

Biofiltration treatment of odors from municipal solid waste treatment plants

An in situ compost biofilter was established for the treatment of odors from biostabilization processing of municipal solid waste. The concentrations of total volatile organic compounds (VOCs) in odors and their components were measured. Biofilter media was characterized in terms of total carbon (TC), total nitrogen (TN), total phosphorus (TP), organic matter (OM), pH value and determination of bacterial colony structure. Gas chromatography–mass spectrometry (GC–MS) analysis showed that the main components of the produced gas were benzene, toluene, ethylbenzene and xylene (BTEX) along with other alkanes, alkenes, terpenes, and sulphur compounds. The compost biofilter had remarkable removal ability for alkylated benzenes (>80%), but poor removal for terpenes (～30%). Total VOC concentrations in odors during the biostabilization process period ranged from 0.7 to 87 ppmv, and the VOC removal efficiency of the biofilter varied from 20% to 95%. After about 140 days operation, TN, TC, TP and OM in compost were kept almost stable, but the dissolved N, NH₄–N and NO₃–N experienced an increase of 44.5%, 56.2% and 76.3%, respectively. Dissolved P decreased by 27.3%. The pH value experienced an increase in the early period and finally varied from 7.38 to 8.08. Results of bacterial colony in packing material indicated that bacteria and mold colony counts increased, but yeasts and actinomyces decreased along with biofilter operation, which were respectively, 3.7, 3.4, 0.04 and 0.07 times of their initial values.     

Development and Testing of 2D Finite Difference Model in Open Channels

This study develops a depth-averaged two-dimensional (2D) numerical model using a finite difference method (FDM) on a staggered grid. The governing equations were solved using the Marker and Cell method that was developed at the Los Alamos laboratories by Harlow and Welch in 1965. In the paper, an explicit FDM was used to solve the governing equations. A first-order approximation was used for the temporal derivative. Second-order central difference approximations were used for space discretization. The time step is limited by the Courant–Friedrichs–Lewy (CFL) condition. The time step used in this study depends on the grid spacing and velocity components in the x- and y-directions. The study is divided into two steps: the first step is to develop a depth-averaged 2D numerical model to simulate the flow process. The second constructs a module to calculate the bed load transport and simulate the river morphology in the areas that have steep slopes, torrents, and mountain rivers. Developed model was applied to the artificial channel and a flood event in the Asungjun River section of the mountainous Yangyang Namdae River (South Korea). General simulation results showed that the developed model was in good agreement with the observed data.     

Racemic,R-, and S-tebuconazole altered chitinase and chitobiase activity of Daphnia magna

Tebuconazole is a chiral trizole fungicide and widely used in many crops for controlling disease. Tebuconazole is potential toxic to some aquatic organisms but relative information of its isomers is scarce. To detect the endocrine disrupting effects and difference of rac-, R-, and S-tebuconazole, the chitinase activity in Daphnia magna and chitobiase activity in each test medium were used as biomonitors after a 14-day exposure. Results showed that chitinase activity was significantly reduced by rac-, R-, and S-tebuconazole. The chitobiase activity in the test medium was reduced by rac- and R-tebuconazole before day 10, and only one peak was observed at day 10 or day 12 compared with two obvious peaks in the control group (days 6 and 12). S-tebuconazole delayed and reduced the reproduction of D. magna, but did not delay the first chitobiase activity peak, whereas the second peak could not be characterized as the exposure concentration and time increased. Compared with chitinase activity, chitobiase activity can still be used as a rudimentary model for identifying molt-interfering xenobiotics, and further studies should focus on the analysis of correlations between these parameters.     

Changes in motorcycle-related injuries and deaths after mandatory motorcycle helmet law in a district of Vietnam

Objective: Our study measured the change in head injuries and deaths among motorcycle users in Cu Chi district, a suburban district of Ho Chi Minh City.

Methods: Hospital records for road traffic injuries (RTIs) were collected from the Cu Chi Trauma Centre and motorcycle-related death records were obtained from mortality registries in commune health offices. Head injury severity was categorized using the Abbreviated Injury Score (AIS). Rate ratios (RRs) were used to compare rates pre- and post-law (2005/2006–2009/2010). Cu Chi's population, stratified by year, age, and sex, was used as the denominator.

Results: Of records identifying the transportation mode at the time of injury, motorcyclists accounted for most injuries (3,035, 87%) and deaths (238, 90%). Head injuries accounted for 70% of motorcycle-related hospitalizations. Helmet use was not recorded in any death records and not in 97% of medical records. Males accounted for most injuries (73%) and deaths (88%). The median age was 28 years and 32 years for injuries and deaths, respectively. Compared to the pre-law period, rates of motorcycle injuries (RR = 0.53; 95% confidence interval [CI], 0.49–0.58), head injuries (RR = 0.35; 95% CI, 0.31–0.39), severe head injuries (RR = 0.47; 95% CI, 0.34–0.63), and deaths (RR = 0.69; 95% CI, 0.53–0.89) significantly decreased in the post-law period.

Conclusions: Rates of head injuries and deaths among motorcycle riders decreased significantly after implementation of the mandatory helmet law in Vietnam. To further examine the impact of the motorcycle helmet law, including compliance and helmet quality, further emphasis should be placed on gathering helmet use data from injured motorcyclists.     

Present status of recycling waste mobile phones in China: a review

A large number of waste mobile phones have already been generated and are being generated. Various countries around the world have all been positively exploring the way of recycling and reuse when facing such a large amount of waste mobile phones. In some countries, processing waste mobile phones has been forming a complete industrial chain, which can not only recycle waste mobile phones to reduce their negative influence on the environment but also turn waste into treasure to acquire economic benefits dramatically. However, the situation of recycling waste mobile phones in China is not going well. Waste mobile phones are not formally covered by existing regulations and policies for the waste electric and electronic equipment in China. In order to explore an appropriate system to recover waste mobile phones, the mobile phone production and the amount of waste mobile phones are introduced in this paper, and status of waste mobile phones recycling is described; then, the disposal technology of electronic waste that would be most likely to be used for processing of electronic waste in industrial applications in the near future is reviewed. Finally, rationalization proposals are put forward based on the current recovery status of waste mobile phones for the purpose of promoting the development of recycling waste mobile phones in developing countries with a special emphasis on China.