膜电解法在线再生酸性蚀刻液及回收铜新技术

采用极化曲线法研究了酸性蚀刻液阴、阳极电化学行为,并构建了离子膜电解反应体系,考察了在线再生酸性蚀刻液及回收铜的效果。结果表明,阳极氧化过程发生浓差极化,存在极限电流密度,Cu＋含量越高,极限电流密度越大;阴极还原分4步反应进行,存在极限电流密度;强化溶液传质可有效提高阴、阳极极限电流密度,有利于避免电解过程中析出氯气和氢气;在线实验表明,通过监控阳极液ORP,可避免析出氯气;分步降低电流电解有利于避免析出氢气,形成致密的金属铜块;在电流为9～24A范围内分4步电解23．5h可再生酸性蚀刻液23．5L,同时电沉积回收510g铜,纯度高达99．98％。阴极电流效率达到95．2％,吨铜电耗3251kWh。电解过程中无氯气和氢气析出,无废液排放,表明膜电解法在线再生酸性蚀刻液具有良好的应用前景。     

微米Cu／Fe对污染土壤洗脱液中有机氯农药的降解

以表面活性剂TritonX-100（TX-100）为洗脱剂,某有机氯农药（organochlorinepesticides,OCPs）污染场地土壤为对象,七氯、氯丹和灭蚁灵为目标污染物,研究微米Cu／Fe双金属对污染土壤洗脱液中OCPs的降解效果。考察了洗脱液中OCPs初始浓度、洗脱液pH值、微米零价铁加入量和cu负载量对Cu／Fe去除OCPs效果的影响。结果表明,微米Cu／Fe可以有效的去除土壤洗脱液中目标污染物。当微米零价铁加入量为1．0g（25g／L）,cu负载量为1．0％,洗脱液pH值为6．89时,Cu／Fe对2号土壤洗脱液中七氯、γ-氯丹、α-氯丹和灭蚁灵的去除效果最好,去除率分别为100．0％、99．3％、80．8％和71．1％。洗脱液中OCPs初始浓度越低,微米零价铁加入量越大,Cu／Fe对OCPs去除率越高;偏酸性条件有利于Cu／Fe对γ-氯丹和灭蚁灵的去除,而α-氯丹在中性条件下去除效果最好;1号土壤和2号土壤洗脱液的最佳铜负载量分别为2．O％和1．0％。     

接种不同污泥源条件下厌氧氨氧化菌的特性

2组ASBR接种污泥源分别为好氧硝化污泥、好氧硝化污泥和厌氧氨氧化污泥按2：1比例}昆合的混合污泥。在相同条件下,经过驯化培养均实现了厌氧氨氧化的稳定运行。接种好氧硝化污泥的反应器的适应期为29d,经过105d的培养反应器成功启动;接种混合污泥的反应器的适应期为13d,经过49d反应器启动成功。从2组ASBR污泥中提取细菌总DNA,经过厌氧氨氧化菌特异引物Pla46rc／Amx820对污泥样品进行PCR扩增、克隆和测序等分析。实验结果表明,接种不同污泥源条件下的反应器中厌氧氨氧化菌的特性存在差异,接种污泥源为好氧硝化污泥的反应器中存在的厌氧氨氧化菌种为CandidatusKuenenia,而接种混合污泥的反应器中存在的厌氧氨氧化菌种为CandidatusAnammox—oglobus,与最初接种的混合污泥中的厌氧氨氧化菌相同。当接种污泥中存在厌氧氨氧化菌时,该菌株经过长时间的驯化可成为优势菌种,而当接种污泥中无厌氧氨氧化菌存在时,CandidatusKueneniasp．可以在反应器中占主导,具有更强的竞争优势。     

城市生活垃圾焚烧处理过程中重金属迁移规律研究

通过采集厦门2个垃圾焚烧发电厂进厂垃圾、渗滤液、飞灰、炉渣和烟气样品,分析垃圾组成成分及各组分的重金属含量,结果表明,垃圾中以厨余、橡塑类和纸类为主,共占到垃圾干基的78．08％,重金属含量大小次序为Zn〉Cu〉Pb〉Cr〉Ni〉Cd〉Hg;垃圾渗滤液中除Zn外,其他金属的含量都较低,一厂渗滤液中重金属Ni、Zn迁移量较大,分别达到24．46％和8．52％。二厂渗滤液中重金属的迁移有相同的趋势,但含量相对较高。垃圾焚烧后其重金属主要分布在飞灰和废渣中,烟气中的含量非常少,不同金属的含量均有差别,这与金属的性质有很大关系;通过浸出毒性分析,飞灰中重金属酸溶态含量多,容易浸出,属于危险废物。同时,不同烟气处理工艺产生的飞灰的重金属浸出量有很大差别。     

Transmissometer Measurement of Participate Emissions from a Jet Engine Test Facility

The body of information presented in this paper is directed toward those individuals involved with handling hazardous materials, whether in actual use of such chemicals, or in monitoring atmospheric emissions. Although specifically relating experience in the design and testing of phosgene emission control equipment, it attempts to establish general guidelines for effectively dealing with emissions of hazardous materials. An approach for handling chemical pollutants having no established air quality emission standards is developed. The paper presents a technique for establishing process emissions at acceptably low levels to insure the health and safety of the general population as well as that of the process workers themselves. Methods, suitable for measuring phosgene at these low levels, have been investigated, and problems associated with such an investigation are discussed. While complete theoretical scrubber design criteria are beyond the scope of this paper, many of the "real world" problems which affected scrubber performance are presented. Finally, the practical aspects of process emissions control are illustrated by actual results from the system test.     

The Use of Nahcolite Ore and Bag Filters For Sulfur Dioxide Emission Control

This paper describes some technical and economic aspects of the nahcolite ore injection process for the simultaneous removal of fly ash and sulfur oxides from stack gases. The process is capable of removing greater than 99% of the particulate matter and greater than 70% of the sulfur oxides present in such gases. In the process, nahcolite ore, a naturally occurring material containing 70 to 90% sodium bicarbonate, is ground to 90% passing through —200 mesh screens. Approximately 20% of the ground ore is used to precoat the filter bags in a baghouse filter while the remainder of the material is fed into the flue gas Just ahead of the baghouse. The flue gas is drawn through the baghouse by induced draft fans and sent up the stack. Most of the SO₂ and practically all of the fly ash in the flue gas can be removed as the gas passes through the filter bags. The spent nahcolite ore and fly ash are collected and conveyed to waste disposal as landfill, or alternatively processed for insolubilization by coprecipitation prior to landfilling. The technical feasibility of the process has been demonstrated in both bench scale and pilot scale engineering studies. Economic analyses performed for the cases of plants located in the midwest and southwest indicate lower capital costs for the nahcolite injection process when compared to wet scrubbing. On an annual cost basis, the nahcolite ore Injection process is comparable in cost to wet scrubbing for the case of the southwestern power plant, and somewhat more expensive for the case of the midwestern plant.     

Urban-Center CO Air Quality Projections

The distribution of mutagenic activity and nitroaromatic components of polycyclic organic matter (POM) in ambient air at industrial, urban, suburban, rural, and remote sites was studied using organic extracts from high volume aerosol samples. Direct-acting mutagens including 1-nitropyrene (1-NP), dinitropyrenes (DNP), and hydroxynitropyrenes (HNP) were measured by high performance liquid chromatography while the mutagenicity was determined in the Salmonella bioassay with strain TA-98. Benzo(a)pyrene (BaP), one of the possible precursors of nitroaromatic compounds in POM, was also measured. In comparing samples from a range of sites, TSP and the concentration of BaP per mass of particulate matter decreased, as expected, at greater distances from urban and industrial combustion sources. However, the concentrations of polar nitroaromatic POM compounds per mass of particles were higher at a remote site than in nonindustrial urban and suburban areas. The mutagenicity in particulate matter extracts from the remote area was predominantly (>90 percent) in the very polar fractions. There were also high atmospheric levels of nitroaromatic compounds and mutagenicity in heavily industrialized areas. These observations may reflect the influences of source emissions, atmospheric transformations of POM compounds, and ther atmospheric processes on the composition of ambient suspended particulate matter.     

Precipitation of Charged Dust Particles on Electrostatic Screen

The purpose of this paper is to present collection performance dependence upon the parameters of channeled electrodes in a twostage precipitator. The practical channeled electrostatic screens are classified into two types and the respective theoretical collection efficiency equations are obtained by employing idealized models. It is shown that In normal operating conditions the most effective particle collection mechanism in the device is electrostatic precipitation rather than the Inertlal separation. It is also pointed out that the channeled electrode, in comparison with the plate-type, should be a narrow width. An empirical efficiency equation is recommended and the agreement between experimental data and empirical equation is within 6%.     

Trends and Relationships of O3, NOx and HC in the South Coast Air Basin of California

A basin-wide air quality trend analysis for the South Coast Air Basin of California is conducted for hydrocarbons (HC), NO_x, O₃ and CO using multi-station composite daily maximum-hour average ambient concentrations for the third quarter (July, August and September) from 1968 to 1985. Emissions and air quality trends are compared for the period 1968-1984. Ambient HC and NOX trends are somewhat different from estimated emission trends of HC and NO_x, while a definite, downward trend of ambient CO is consistent with vehicular emission control measures. Basin-wide ambient HC, NO_x and O₃ appear to show downward trends for the period 1970-1985, but because of high fluctuations it is difficult to delineate trends for shorter periods. The meteorology (850 mb temperature)-adjusted O₃ shows a more consistent downward trend than does unadjusted O₃. Polynomial and multiplicative regression models for basin-wide empirical O₃-HC-NO_x relationships Indicate that the O₃ variation is explained largely by the meteorological variable (850 mb temperature) although model estimations are improved by adding HC and NO_x concentration terms.