3种典型微生物农药对家蚕的毒性研究

苏云金芽孢杆菌、球孢白僵菌以及棉铃虫核型多角体病毒是细菌类、真菌类和病毒类微生物农药的典型代表。为了明确微生物农药对家蚕的毒性影响,选取以上3种典型微生物农药,分别探究其对家蚕的毒性。结果显示:苏云金杆菌原药对家蚕LC50值为1.33×105CFU·m L-1;球孢白僵菌原药对家蚕LC50值为1.14×106CFU·m L-1;棉铃虫核型多角体病毒母药对家蚕LC50值大于1.00×108PIB·m L-1。与此同时,通过进一步试验,明确了以上3种微生物农药对家蚕结茧率、死笼率、全茧量、茧层量等关键指标的影响。结果显示:除了棉铃虫核型多角体病毒母药,高浓度苏云金杆菌原药、球孢白僵菌原药对家蚕的结茧率和死笼率均具有显著影响;3种微生物农药对家蚕产茧能力指标全茧量、茧层量以及蛹重均无显著性影响。     

3种镉超富集植物毛状根体系对镉胁迫响应的比较

近年来,转基因毛状根组织被越来越多地应用于重金属和有机污染物的植物修复技术研究中,已成为进行污染物毒性响应机制研究的便捷的实验室工具。为了探究龙葵、油菜、芥菜3种镉(cadmium,Cd)超富集植物对Cd毒性胁迫响应的差异,以诱导出的3种植物毛状根为研究材料,从毛状根的生长状态、富集Cd的能力、根组织细胞的凋亡程度和抗氧化酶活性等方面进行了探讨。结果表明:Cd浓度为0~50μmol·L-1时,龙葵、油菜、芥菜毛状根受Cd毒害的影响都不明显;Cd浓度为75~100μmol·L-1时,龙葵、油菜、芥菜毛状根均表现出对Cd胁迫的防御响应。在较高的Cd浓度(100μmol·L-1)下,龙葵毛状根的生物量受Cd毒害的影响最小,芥菜次之,油菜受影响最大;同时龙葵毛状根富集的Cd含量最高(745.0μg·g-1),芥菜次之(681.4μg·g-1),油菜最差(505.2μg·g-1)。龙葵、油菜、芥菜毛状根在Cd胁迫下的细胞凋亡水平均随Cd浓度的升高而升高,当Cd浓度为100μmol·L-1时,龙葵毛状根比油菜和芥菜毛状根的细胞凋亡程度均低。同时3种植物毛状根在不同浓度Cd处理下抗氧化酶活性的变化有一定差异。从上述结果综合来看,龙葵毛状根受Cd毒害的影响最小、富集Cd的能力最好,是进一步开展Cd超富集植物转基因改造研究的较好的实验室载体。     

二元联合作用藻红外测试方法——以重金属为例

为检验二元联合作用藻红外测试方法的可行性,用Cu~(2+)、Fe3+、Mn~(2+)、Al3+、Cr3+、Hg~(2+)、Cd~(2+)、Pb~(2+)、Zn~(2+)进行了二元联合作用测试实验。结果显示:联合药液的参照浓度与单药液的参照浓度比为0.5:0.25的有15组二元组合,为2.0:1.0的有10组二元组合,为1.0:0.5的有11组二元组合;在9种重金属的36组二元联合作用测试结果中出现拮抗作用、相加作用、协同作用,表明联合作用类型表现出多样性;14组拮抗作用中单组的再现性为50%~100%、多组的再现性的出现率为93%、单组的重现性为67%~100%、多组的重现性的出现率为100%,21组相加作用中单组的再现性为50%~100%、多组的再现性的出现率为86%、单组的重现性为67%~100%、多组的重现性的出现率为100%,1组协同作用重现性67%;36组联合作用测试结果的再现性为50%~100%、再现性的出现率为86%,重现性为67%~100%、重现性的出现率为100%。上述分析可知,9种重金属的36种二元联合作用测试结果具有较好的多样性、再现性、重现性,表明测试条件、藻温测试方法、三指标评价法能够保证藻响应温差和藻响应药品评价结果的质量,参照浓度分析方法、联合作用评价方法能够控制联合作用分析结果的质量;藻响应的有毒有害物都存在敏感浓度,用参照浓度分析方法可分析出藻响应有毒有害物的参照浓度。因此,藻红外测试技术可以用于测试重金属、农药、有机药品、抗生素等的二元联合作用。     

菲和镉单一及复合污染条件下在毛蚶体内的富集动力学研究

采用室内半静态双箱动力学模型实验,研究了菲和镉单一及复合污染条件下在毛蚶(Anadara subcrenata)体内的生物富集,通过对富集与释放过程中毛蚶体内菲和Cd的富集量进行非线性曲线拟合,获得了菲和Cd单一及复合污染条件下在毛蚶体内的吸收速率常数k1、释放速率常数k2、生物富集因子BCF、生物半衰期B1/2和平衡状态下最大富集量CA max等动力学参数。实验结果表明,菲和Cd在实验前期富集速率较高,8 d以后富集速率减缓,释放阶段与富集阶段相似。毛蚶对菲的BCF值为37.80,远大于Cd的BCF值13.12,且生物半衰期时间更长,菲更容易在生物体内富集。菲和Cd联合暴露条件下,在毛蚶体内的CA max和BCF值均大于单一作用,说明二者同时暴露时,毛蚶对菲和镉的吸收富集均有所增强。实验模型拟合度较好,输出值和实测值之间无显著性差异,拟合方程和拟合参数可信。     

利用重组大肠杆菌SOS法评价污水厂出水的遗传毒性以及工艺去除效果

SOS/umu测试法被广泛应用于化合物和复杂混合物遗传毒性的评价,由于该技术所用菌种为致病菌且操作步骤繁琐等原因,制约了技术的推广应用。研究建立了基于重组大肠杆菌SOS效应的水质遗传毒性检测方法(专利号:ZL201110022476.1),应用该方法评价了某市4座污水厂出水的直接遗传毒性效应,同时以污水处理一厂为例考察了直接遗传毒性效应的季节变化规律以及不同的工艺对水中直接遗传毒性物质的去除情况。结果显示:各污水厂出水均表现出一定的直接遗传毒性,对应的4-NQO毒性当量浓度范围为0.018~0.514 mg·L-1;一年四季中夏季进出水直接遗传毒性效应最高,现有工艺中生化处理工艺段对直接遗传毒性去除效果最佳,去除率为33.33%。该方法操作便利、检测敏感性较高、操作危险性较低,可用于水中直接遗传毒性效应的测试。     

Are we planning for sustainable disaster recovery? Evaluating recovery plans after the Wenchuan earthquake

This article examines local recovery plans that were created in response to the Wenchuan earthquake and then suggests ways that planners can better apply the concept of sustainability to the recovery process. We utilize a plan evaluation protocol to analyze 16 recovery plans in counties and towns that were severely affected by the earthquake. We also conducted semi-structured interviews with public officials and planners, with the qualitative data gleaned from these interviews being used to supplement the plan quality assessment. The results reveal that local recovery plans do not appear to have incorporated sufficiently the concepts of sustainability. We conclude the paper with the following recommendations: emphasizing sustainability as a policy priority during vision and goal development; developing solid databases and planning techniques; designing a diversified set of regulatory- and incentive-based policy tools suitable for local governments; enhancing social and institutional learning; and further integrating multi-level and interagency governmental units.     

太阳翼驱动机构的扰振力矩测试与分析

为了研究太阳翼驱动机构(solar array drive assembly,SADA)驱动太阳翼运行期间所产生的扰振力矩特性,设计了一套地面测试系统,包括应变式微振动测试平台、柔性负载以及模拟SADA在轨无重力工作环境的重力卸载装置。阐述了所设计测试系统的工作原理,并利用该测试系统进行了试验测试。测试结果表明:SADA驱动柔性负载运行期间所产生扰振力矩的扰振频率成分主要包含两部分,即:1)SADA驱动柔性负载耦合系统的低阶扭转固有频率;2)SADA电脉冲信号的输入频率及其高阶谐波。     

Performance evaluation of circulating fluidized bed incineration of municipal solid waste by multivariate outlier detection in China

This first nationwide survey was conducted to evaluate the overall performance of the circulating fluidized bed (CFB) incineration of municipal solid waste (MSW) in 2014-2015 in China. Total 23 CFB incineration power plants were evaluated. The data for monthly average flue gas emission of particles, CO, NO _x , SO₂ and HCl were collected over 12 consecutive months. The data were analyzed to assess the overall performance of CFB incineration by applying the Mahalanobis distance as a multivariate outlier detection method. Although the flue gas emission parameters had met the Chinese national emission standards, there were 11 total outliers (abnormal behavior) detected in 6 out of 23 CFB incineration power plants from the perspective of the MSWincineration performance. The results demonstrate that it is more important for a better performance of CFBs to reduce the frequencies of the MSW load changes, rather than the magnitudes of the MSW load changes, particularly reducing the frequencies in the range of 10% and more of the load changes, under the same and stable conditions. Furthermore, the overloading occurs more often than the underloading during the operation of the CFB incineration power plants in China. The frequent overloading is 0% to 30% of the designed capacity. To achieve the stable performance of CFBs in practice, an appropriately designed MSW storage capacity is suggested to build in a plant to buffer and reduce the frequency of the load changes.

Open image in new window

     

Investigation of the accumulation of ash,heavy metals,and polycyclic aromatic hydrocarbons to assess the stability of lysis–cryptic growth sludge reduction in sequencing batch reactor

The accumulation of ash, heavy metals, and polycyclic aromatic hydrocarbons (collectively called potential accumulating substances, PAS) was evaluated to ascertain the stability of lysis–cryptic growth sludge reduction process (LSRP) for municipal sludge treatment. One sequencing batch reactor (SBR) incorporated with homogenization was run to test the LSRP and another SBR as a control. The continuous monitoring results for 2 months showed that the ash and heavy metals slightly increased, and the polycyclic aromatic hydrocarbons decreased by 18.0%, indicating that there may be negligible accumulations during the LSRP. Their accumulations met pattern I, as demonstrated by statistical analysis, proving no PAS accumulation for LSRP. This was further confirmed by sludge activity and system performance. Moreover, the mechanism for no PAS accumulation was discussed. It was concluded that the LSRP was stable with no worries about PAS accumulation under the operational conditions.     

Heavy metal (Cu,Cd, Pb,Cr) washing from river sediment using biosurfactant rhamnolipid

Heavy metal-contaminated sediments posed a serious threat to both human beings and environment. A biosurfactant, rhamnolipid, was employed as the washing agent to remove heavy metals in river sediment. Batch experiments were conducted to test the removal capability. The effects of rhamnolipid concentration, washing time, solution pH, and liquid/solid ratio were investigated. The speciation of heavy metals before and after washing in sediment was also analyzed. Heavy metal washing was favored at high concentration, long washing time, and high pH. In addition, the efficiency of washing was closely related to the original speciation of heavy metals in sediment. Rhamnolipid mainly targeted metals in exchangeable, carbonate-bound or Fe-Mn oxide-bound fractions. Overall, rhamnolipid biosurfactant as a washing agent could effectively remove heavy metals from sediment.