基于CA-MAS的水域总有机碳扩散模拟研究

当前水环境污染扩散研究一般基于普通数值模型模拟,忽略了水污染扩散微观驱动力的影响。为能更真实地反映其动态扩散过程,针对水域总有机碳(TOC)扩散机理,基于CA和MAS技术,将影响TOC扩散的自然和社会经济因素抽象为微观的水流Agent、风速Agent、径流量Agent、污水排放口Agent、人工管理Agent以及农业生产地Agent,将研究水域抽象为CA元胞空间,建立了CA-MAS水域总有机碳扩散模型,对水域总有机碳的动态演化过程进行模拟,并以武汉理工大学鉴湖水域作为实验区域,借助NetLogo仿真平台完成了模型的实现与验证。模拟结果表明,该模型基本能够反映水体总有机碳的扩散规律,可以为水环境污染控制提供参考。     

柴油机微粒中可溶性有机成分的真空干燥条件

柴油机碳烟颗粒(PM)中可溶性有机组分(SOF)含量是其重要的特性参数,而真空干燥法可方便、高效、可靠地分析颗粒SOF含量,对其干燥条件的探索具有重要的研究意义和应用价值。首先采用模拟的柴油机颗粒,分析不同的干燥条件对模拟SOF(柴油、润滑油)挥发率的影响规律,得出模拟的SOF分析的最佳干燥条件;在此基础上,探索了真实柴油机颗粒SOF分析的最佳干燥条件为:干燥温度220℃、干燥时间3 h、真空度98 kPa,得知SOF组分干燥的难易程度介于柴油和润滑油之间;同时,根据此干燥条件,分析了排气管末端采集的真实碳烟颗粒的SOF含量特性。     

电镀污泥的热处理特性以及对金属回收的影响

焙烧-酸浸法可有效回收电镀污泥中的有价金属,而污泥的热处理特性是决定能否采用焙烧预处理的重要因素。研究了氧化焙烧和还原焙烧对污泥成分和金属浸出性的影响,并对焙烧前后的污泥进行了金属形态分析和X射线衍射(XRD)分析。结果表明,焙烧预处理实现了污泥减量和金属富集;ES1经氧化焙烧后金属浸出率接近原泥,Cu的浸出率达99%;ES2的还原焙烧效果优于氧化焙烧,特别是Cu的浸出率超过97%,XRD分析发现,还原焙烧过程中金属Cu被还原为铁铜合金;2种焙烧均造成了ES3中目标金属Ni的浸出率的降低;金属浸出性的下降与残渣态的形成有关。     

水泥窑共处置过程中水泥生料对砷的吸附/冷凝特性

针对水泥生料开展了氮吸附与SEM测试分析,研究了水泥生料的比表面积,孔径结构和微观表面积。同时,利用管式回转炉和控温立式炉联用装置研究了砷元素在水泥生料上的吸附冷凝特性。结果表明,水泥生料的比表面积很小,微观表面结构致密无孔,砷元素主要是冷凝在生料表面上。进入吸附冷凝炉的重金属可以分为3部分,第1部分冷凝在管壁上,占80%左右;第2部分吸附/冷凝在生料上,占10%左右;第3部分随烟气释放到空气中,不到10%。水泥生料对砷的吸附冷凝量随时间的增加而增加,随温度的升高而降低。水泥生料对砷的吸附冷凝特性可用双常数速率方程拟合,拟合效果较好,计算得表观活化能在6~7 kJ/mol之间。此外,砷的初始浓度对水泥生料的吸附冷凝特性影响很小。     

The characteristics of nitrate removal by the psychrotolerant denitrifying bacterium Acinetobacter johnonii DBP-3, isolated from a low-temperature eutrophic body of water

A psychrotolerant denitrifying bacterial strain, DBP-3, was isolated from a eutrophic body of water by low-temperature-oriented acclimation culture. Based on its morphologicalandbiochemicalcharacteristics and 16S rDNA gene sequence, the bacterium was identified as belonging to the genus Acinetobacter and closely related to A. johnonii. The satisfactory growth of DBP-3 was observed at 10–30°C and pH 7–9. Strain DBP-3 was able to utilize three types of carbon sources (sodium acetate > sodium citrate > glucose) to support growth and denitrification. DBP-3 grew faster, but with lower nitrate removal efficiency and higher nitrite accumulation, under aerobic conditions than under anoxic conditions. DBP-3 was extremely susceptible to tetracycline and rifampicine and less sensitive to ampicillin and penicillin. The growth of DBP-3 was significantly affected by Hg (II), Cr (VI), Pb (II), Cd (II), and As (III) at 0.32, 0.63, 1.25, 2.5, and 25.0 mg L^?1, respectively. Interestingly, chromium (VI) significantly promoted DBP-3 growth at concentrations lower than 0.32 mg L^?1. These data may be helpful to support the use of strain DBP-3 in the purification of eutrophic water bodies at low temperatures.     

Inorganic Acid Emission Factors of Semiconductor Manufacturing Processes

Abstract

A huge amount of inorganic acids can be produced and emitted with waste gases from integrated circuit manufacturing processes such as cleaning and etching. Emission of inorganic acids from selected semiconductor factories was measured in this study. The sampling of the inorganic acids was based on the porous metal denuders, and samples were then analyzed by ion chromatography. The amount of chemical usage was adopted from the data that were reported to the Environmental Protection Bureau in Hsin-chu County according to the Taiwan Environmental Protection Agency regulation. The emission factor is defined as the emission rate (kg/month) divided by the amount of chemical usage (L/month). Emission factors of three inorganic acids (i.e., hydrofluoric acid [HF], hydrochloric acid [HQ], and sulfuric acid [H₂SO₄]) were estimated by the same method. The emission factors of HF and HCl were determined to be 0.0075 kg/L (coefficient of variation [CV] = 60.7%, n = 80) and 0.0096 kg/L (CV = 68.2%, n = 91), respectively. Linear regression equations are proposed to fit the data with correlation coefficient square (R²) = 0.82 and 0.9, respectively. The emission factor of H₂SO₄, which is in the droplet form, was determined to be 0.0016 kg/L (CV = 99.2%, n = 107), and its R² was 0.84. The emission profiles of gaseous inorganic acids show that HF is the dominant chemical in most of the fabricators.     

Absorption and Reaction Kinetics of Amines and Ammonia Solutions with Carbon Dioxide in Flue Gas

Abstract

The removal system for the absorption of CO₂ with amines and NH₃ is an advanced air pollution control device to reduce greenhouse gas emissions. Absorption of CO₂ by amines and NH₃ solutions was performed in this study to derive the reaction kinetics. The absorption of CO₂ as encountered in flue gases into aqueous solutions of monoethanolamine (MEA), diethanolamine (DEA), and NH₃ was carried out using a stirred vessel with a plane gas-liquid interface at 50 °C. Various operating parameters were tested to determine the effect of these variables on the absorption kinetics of the reactants in both gas and liquid phases and the effect of competitions between various reactants on the mass-transfer rate.

The observed absorption rate increases with increasing gas-liquid concentration, solvent concentration, temperature, and gas flow rate, but changes with the O₂ concentration and pH value. The absorption efficiency of MEA is better than that of NH₃ and DEA, but the absorption capacity of NH₃ is the best. The active energies of the MEA and NH₃ with CO₂ are 33.19 and 40.09 kJ/mol, respectively.     

Properties of Pyrolytic Chars and Activated Carbons Derived from Pilot-Scale Pyrolysis of Used Tires

Abstract

Used tires were pyrolyzed in a pilot-scale quasi-inert rotary kiln. Influences of variables, such as time, temperature, and agent flow, on the activation of obtained char were subsequently investigated in a laboratory-scale fixed bed. Meso-porous pores are found to be dominant in the pore structures of raw char. Brunauer-Emmett-Teller (BET) surfaces of activated chars increased linearly with carbon burnoff. The carbon burnoff of tire char achieved by carbon dioxide (CO₂) under otherwise identical conditions was on average 75% of that achieved by steam, but their BET surfaces are almost the same. The proper activation greatly improved the aqueous adsorption of raw char, especially for small molecular adsorbates, for example, phenol from 6 to 51 mg/g. With increasing burnoff, phenol adsorption exhibited a first-stage linear increase followed by a rapid drop after 30% burnoff. Similarly, iodine adsorption first increased linearly, but it held as the burnoff exceeded 40%, which implied that the reduction of iodine adsorption due to decreasing micro-pores was partially made up by increasing mesopores. Both raw chars and activated chars showed appreciable adsorption capacity of methylene-blue comparable with that of commercial carbons. Thus, tire-derived activated carbons can be used as an excellent mesoporous adsorbent for larger molecular species.     

安徽省旅游业转型升级对策研究

随着我国经济增长结构和产业增长方式调整转变,旅游业转型升级成为提高旅游业经济效益,实现旅游业可持续发展的必然要求。在全面分析安徽省旅游业转型升级背景的基础上,结合安徽省旅游业转型升级的优势条件与制约因素,提出安徽省旅游业在旅游产业结构、旅游产品、旅游企业、旅游市场、旅游人才等方面转型升级的路径与对策。     

香根草人工湿地处理生活污水的试验研究

通过建立香根草人工湿地系统,研究该系统对生活污水的COD、TP、TN的处理效果以及系统的耐污性。在水力停留时间(HRT)为6h的条件下,COD、TP、TN的去除率分别为63.5%、88.3%、72.4%。研究表明,香根草人工湿地系统对城镇生活污水具有较好的净化效果,且系统在该试验条件下耐污性良好。