Investigation into organic phosphorus species in sediments of Baiyangdian Lake in China measured by fractionation and 31P NMR

Organic phosphorus (OP) species in sediments of the Baiyangdian Lake in China was investigated via fractionation and phosphorus-31 nuclear magnetic resonance ((31)P NMR) spectroscopy. Results of chemical fractionation showed that different OP fractions ranked in the order: humic acid-P?>?HCl-OP?>?fulvic acid-P?≈?NaHCO(3)-OP?>?residual OP. Labile OP and moderately labile OP, which can be degraded for phytoplankton uptake, contributed to 58.7-68.5% of total extracted OP, indicative of the potential P release from sediments in the lake. (31)P NMR spectroscopy results suggested the rank order of P species present in the NaOH-EDTA extractant of the sediments: orthophosphate?>?monoester-P?>?DNA-P?>?pyrophosphate-P. Phytate, polyphosphates, and phosphonates, which appeared in sediments of some deeper lakes, were not detected in the shallow lake. Significant correlations were identified between total P (TP) in water column and sediment TP, monoester-P and DNA-P, positively indicating that sediment P species, especially OP components, should probably contribute to the contents of P in water column and further to the lake eutrophication.     

Comparative assessments of VOC emission rates and associated health risks from wastewater treatment processes

With the growing concern regarding emission of volatile organic compounds (VOCs) from wastewater treatment plants (WWTPs), the relationship between the VOC emission rates and the associated public health risks has been rarely discussed. The objective of this study was to examine and compare the VOC emission rates and cancer and non-cancer risks by inhalation intake, using a municipal WWTP in China as an example, with respect to the effects of treatment technologies, VOC species, and seasonal variation. Given the treatment technology considered, the emission rates of VOCs in this study were estimated by means of mass balance or calculated on the molecular level. From the viewpoints of both emission rates and cancer and non-cancer risks, sedimentation was the treatment technology with the highest health risks to the workers. Slightly lower VOC emission rates and health risks than those for sedimentation were observed in anaerobic treatment. Although the aeration significantly enhanced the VOC emission rates in the aerobic treatment process, the associated health risks were limited due to the low VOC concentrations in the gas phase, which were likely attributed to the strong mixing and dilution with fresh air by aeration. Amongst the VOCs investigated, benzene was the VOC with both a relatively high emission rate and health risk, while trichloroethylene possessed a high emission rate but the lowest health risk. Without strong interfacial aeration and turbulence between the water and atmosphere, the effects of treatment technology and seasonal variation on the health risks might be connected to the VOC emission rates, while the effect of VOC species depended considerably on the respective cancer slope factors and reference concentrations; the employment of aeration provided a different conclusion in which the emission rates were enhanced without a significant increase in the related cancer risks. These findings can provide insight into future health risk management and reduction strategies for workers in WWTPs.     

A novel approach to rapid detection of acute water toxicity and its policy implications for grassroots sustainable environmental monitoring

Unknown chemicals, emerging contaminants, and the resulting reactions among them make early detection and warning of acute water toxicity extremely challenging. The conventional approach using small fish for toxicity monitoring normally requires a designated species of fish and over a week's time to complete, including dilution of the wastewater, a pre-test, and a full test. It often increases chances for error and delays emergency management. This paper reports a novel approach, based on grassroots knowledge and field and lab experience in Jilin, China. This approach uses a combination of different species of aquarium fish to achieve fast and reliable monitoring. It tests the original source water directly without going through the dilution procedure, while paying attention to the time factor. The approach does not require a pre-test and may shorten the time needed for detecting acute toxicity to a few minutes, using a new classification of aquatic toxicity levels. It is inexpensive to use and may be easily adopted by grassroots organizations. The approach is "greener" and more financially and socially sustainable than traditional approaches. The wide use of the approach has the potential to encourage policy innovations for making toxicity monitoring grassroots based and more effective in reducing acute contamination emergencies.     

Baseline values for metals in soils on Fildes Peninsula, King George Island, Antarctica: the extent of anthropogenic pollution

Metal contents (Al, Ca, Cd, Cr, Cu, Fe, Hg, Mg, Mn, Ni, Pb, Ti, and Zn) have been measured in 30 surface soils on Fildes Peninsula, King George Island, Antarctica, yielding values (in milligrams kilogram(-1)) of 41.57-80.65 (Zn), 2.76-60.52 (Pb), 0.04-0.34 (Cd), 7.18-25.03 (Ni), 43,255-70,534 (Fe), 449-1,401 (Mn), 17.10-64.90 (Cr), 1,440-25,684 (Mg), 10,941-49,354 (Ca), 51.10-176.50 (Cu), 4,388-12,707 (Ti), 28,038-83,849 (Al), and for Hg (in nanograms gram(-1)) 0.01-0.06. Relative cumulative frequency analysis was used to determine the baseline values for the 13 metals. Compared with adjacent areas in Antarctica, Mg and Ni are significantly lower, but Cu is significantly higher than that of McMurdo Station. Enrichment factor analysis and the geo-accumulation index method were applied in order to determine the extent of anthropogenic contamination, and both show that Pb, Cd, and Hg have been significantly increased by human activities. Principal component analysis was used to identify the sources of metals in these soil samples.     

Real-time discharge measurement in tidal streams by an index velocity

Discharge measurement in a tidal stream is always a difficult task. Owing to the complex flow conditions, discharge measurement in tidal streams has to be finished quickly, and must be highly efficient in order to yield an accurate measurement of real-time discharge. Measuring the discharge of tidal streams is done in three steps: (1) establishing the stage and cross-sectional area relation, (2) estimating the index velocity by using a velocity distribution equation based on the probability concept, (3) establishing the relationship between the index and mean velocities. Then the cross-sectional area and mean velocity can be estimated by the gage height and index velocity, respectively. The discharge of tidal streams is computed as the product of the cross-sectional area and mean velocity. The velocity distribution of the Taipei Bridge and Guan-du Bridge in the Tanshui River were established and analyzed to demonstrate the use of discharge measurement by index velocity for estimating the discharge of this tidal stream. The results reveal no large difference between the discharges measured by the conventional methods and the index velocity. This pilot study proposed a cost-effectiveness and efficient method. It is an easy, quick, and accurate model for measuring the real-time discharge of a tidal stream. It makes automatic, real-time, and continuous monitoring of the discharge in a tidal stream become possible.     

中美环境监测体制之比较

对中美环境监测体制进行对比性评述,指出了中国环境监测行业存在的分析标准滞后、体制不完善、人员匮乏等问题,提出借鉴美国经验,完善法律体系,引入市场机制,逐步培育竞争有序、监管到位的环境监测行业的建议。     

Accuracy and uncertainty assessment on geostatistical simulation of soil salinity in a coastal farmland using auxiliary variable

Understanding the spatial soil salinity aids farmers and researchers in identifying areas in the field where special management practices are required. Apparent electrical conductivity measured by electromagnetic induction instrument in a fairly quick manner has been widely used to estimate spatial soil salinity. However, methods used for this purpose are mostly a series of interpolation algorithms. In this study, sequential Gaussian simulation (SGS) and sequential Gaussian co-simulation (SGCS) algorithms were applied for assessing the prediction accuracy and uncertainty of soil salinity with apparent electrical conductivity as auxiliary variable. Results showed that the spatial patterns of soil salinity generated by SGS and SGCS algorithms showed consistency with the measured values. The profile distribution of soil salinity was characterized by increasing with depth with medium salinization (EC_e 4–8 dS/m) as the predominant salinization class. SGCS algorithm privileged SGS algorithm with smaller root mean square error according to the generated realizations. In addition, SGCS algorithm had larger proportions of true values falling within probability intervals and narrower range of probability intervals than SGS algorithm. We concluded that SGCS algorithm had better performance in modeling local uncertainty and propagating spatial uncertainty. The inclusion of auxiliary variable contributed to prediction capability and uncertainty modeling when using densely auxiliary variable as the covariate to predict the sparse target variable.     

Dissipation and residue behavior of mepiquat on wheat and potato field application

A modified LC-MS method for the analysis of mepiquat residue in wheat, potato, and soil was developed and validated. A hydrophilic interaction liquid chromatographic column has been successfully used to retain and separate the mepiquat. Mepiquat residue dynamics and final residues in supervised field trials at Good Agricultural Practice (GAP) conditions in wheat, potato, and soil were studied. The limits of quantification for mepiquat in all samples were all 0.007 mg kg^?1, which were lower than their maximum residue limits. At fortification levels of 0.04, 0.2, and 2 mg kg^?1 in all samples, recoveries ranged from 77.5 to 116.4 % with relative standard deviations of 0.4–7.9 % (n?=?5). The dissipation half-lives (T _1/2) of mepiquat in soil (wheat), wheat plants, soil (potato), and potato plants were 4.5–6.3, 3.0–5.6, 2.2–4.6, and 2.4–3.2 days, respectively. The final residues of mepiquat were below 0.153 mg kg^?1 in soil (wheat), 0.052–1.900 mg kg^?1 in wheat, below 0.072 mg kg^?1 in soil (potato), and below 1.173 mg kg^?1 in potato at harvest time. Moreover, pesticide risk assessment for all the detected residues was conducted. A maximum 0.0012 % of acceptable daily intake (150 mg kg^?1) for national estimated daily intake indicated low dietary risk of these products.