几种水合金属氧化物的磷酸根吸附性能

利用简单的碱沉淀法制备不同的水合金属氧化物,并对所得七种水合金属氧化物的磷酸根吸附等温线进行了系统的探讨比较.研究表明,25℃条件下,Al、Fe、Ni、Cu和Ce的水合金属氧化物对磷酸根的吸附最符合Langmuir线性吸附方程,而水合氧化锌和水合氧化钴吸附剂最符合线性等温线模型.所有这七种水合金属氧化物对磷酸根的吸附都...     

酸沉降物对土壤化学性质的影响

本文综述了酸沉降物对土壤酸化、营养物质的淋溶、重金属的活化、矿物分解等化学性质的影响，以及阻止酸雨危害土壤的化学方法。     

日本城市废弃物处理和综合利用技术简介

应日本新技术促进机构邀请,对日本城市废弃物处理和综合利用技术进行考察.简要介绍日本新技术促进机构以及日本企业对于城市垃圾、废塑料和电子废弃物的处置和再利用技术,为中日再生资源行业深入合作,推动我国再生资源行业技术发展提供借鉴.     

纳米Al_2O_3固定化红平红球菌菌球的制备及其对苯酚的降解

以海藻酸铝为主要包埋材料、纳米Al_2O_3为添加剂,包埋固定红平红球菌,制得纳米Al_2O_3固定化红平红球菌菌球,并将其用于苯酚的降解。表征结果显示:菌球内部包含丰富的菌丝体;内部孔径以中孔居多。实验结果表明:菌球的最优制备方案为0.05 g纳米Al_2O_3加入3 m L海藻酸钠溶液中、海藻酸钠质量分数6%、微生物包埋量0.5 m L/m L(以海藻酸钠溶液计)、Al_2(SO_4)_3质量分数3%;在初始苯酚质量浓度为400 mg/L、反应时间为24h、菌球加入量为8 g/L、反应p H为8.0、反应温度为30℃的条件下,菌球首次使用时可使苯酚完全降解,使用5次后的苯酚降解率仍达93%以上,具有良好的循环使用性。     

Delayed association of acute particulate matter 2.5 air pollution exposure with loss of complexity in cardiac rhythm dynamics: insight from detrended fluctuation analysis

Environmental Science and Pollution Research - There is a delayed (lag 1 to 2 days) correlation between acute PM 2.5 (particulate matter <?2.5 μm in aerodynamic...     

几种印染助剂对壳聚糖稳定纳米铁去除酸性品红的影响

以氯化铁为铁源,硼氢化钠为还原剂,壳聚糖为稳定剂,采用液相还原法制备壳聚糖稳定纳米铁（CS-nZⅥ）;研究了印染废水中常见助剂NaNO₃、Na₂SO₄、NaH₂PO₄、K₂Cr₂O₇、EDTA二钠盐存在下,超声波辅助CS-nZⅥ对酸性品红（AF）降解的影响。结果表明,反应15 min,0.01 g CS-nZⅥ对25 mL、100 mg/L AF的去除率高达99.9%;各种助剂的存在使得纳米铁表面不同程度失活,阻碍反应的进行,使得AF的去除率下降。NaNO₃、K₂Cr₂O₇、EDTA二钠盐与纳米铁发生反应,与AF存在明显的竞争作用。重复利用实验表明,CS-nZⅥ重复利用7次仍具有一定的反应活性。此外,CS-nZⅥ对加标（50 mg/L）实际废水中AF的去除率达到99%以上,表明CS-nZⅥ是一种潜在的环境修复材料。     

好氧颗粒污泥自生动态膜生物反应器处理碱减量印染废水

自生动态膜生物反应器(SFDMBR)接种颗粒污泥启动,研究溶解氧浓度和水力停留时间对该反应器处理碱减量印染废水的影响。自生动态膜生物反应器形成稳定的动态膜后,出水浊度小于10 NTU,系统对浊度的去除率在90%以上,溶解氧和水力停留时间对反应器出水浊度基本无影响。系统对废水色度的去除率随着溶解氧浓度的提高和水力停留时间的延长而增加,但是系统对色度的去除效率一般不超过40%。溶解氧浓度由0.3 mg/L逐渐增大至2.4 mg/L,COD的去除率由40%提升至80%,而当溶解氧浓度大于1.0 mg/L后,UV254的去除率达到95%。水力停留时间在8~48 h时,COD去除效率由65%逐渐上升至85%左右;水力停留时间在8~32 h,UV254去除效率为68%~93%,超过32 h后水力停留时间对UV254去除效率的影响已不明显。     

Occurrence of 222Rn, 226Ra, 228Ra and U in groundwater in Fujian Province, China

222Rn, 226Ra, 228Ra and U were determined in a total of 552 groundwater samples collected throughout Fujian Province of China. The geometric mean concentrations of 222Rn, 226Ra, 228Ra and total U in the groundwater were 147.8 kBq m-3, 12.7 Bq m-3, 30.2 Bq m-3 and 0.54 microgram kg-1, respectively. High groundwater 222Rn was explained by the predominantly granitic rock aquifers in Fujian. A lifetime risk of 1.7 x 10(-3) was estimated for the ingestion of groundwater 222Rn. High ratios of 228Ra to 226Ra contents (geometric mean of 2.4) and their disproportion suggest that 228Ra should also be measured in the assessment of population doses from drinking water in the regions of high rock or soil 232Th. No significant correlation between the 222Rn concentrations in groundwater and air was found.     

Investigation on the relationship between the fine particle emission and crystallization characteristics of gypsum during wet flue gas desulfurization process

The relationship between the fine particles emitted after desulfurization and gypsum crystals in the desulfurization slurry was investigated, and the crystallization characteristics varying with the operation parameters and compositions of the desulfurization slurry were discussed. The results showed that the fine particles generated during the desulfurization process were closely related to the crystal characteristics in the desulfurization slurry by comparison of their morphology and elements. With the higher proportion of fine crystals in the desulfurization slurry, the number concentration of fine particles after desulfurization was increased and their particle sizes were smaller, indicating that the optimization of gypsum crystallization was beneficial for the reduction of the fine particle emission. The lower pH value and an optimal temperature of the desulfurization slurry were beneficial to restrain the generation of fine crystals in the desulfurization slurry. In addition, the higher concentrations of the Fe^3 + ions and the F⁻ ions in the desulfurization slurry both promoted the generation of fine crystals with corresponding change of the morphology and the effect of the Fe^3 + ions was more obvious. With the application of the desulfurization synergist additive, it was beneficial for the inhibition of fine crystals while the thinner crystals were generated.     

喷漆房循环水处理系统维护与管理

介绍了汽车涂装过程喷漆房典型的循环水处理系统,比较各种不同的油漆凝聚产品特性,总结了油漆凝聚产品的使用特点,也对循环水系统的维护,循环水的监测与管理过程中的细节等进行了阐述。在维护和管理过程中,首先需要选择合适的油漆凝聚产品,其次需要根据具体的情况正确地使用油漆凝聚产品,特别是要注意根据漆渣和循环水状态进行相应调整,及时完成喷漆房和循环系统的维护和清理工作。这样才能保证水的循环使用,实现喷房系统的正常运行。