PCBs污染土壤的CaO诱导低温热处理脱氯研究

研究了低温热处理脱氯技术对废弃电容器封存点附近污染土壤中多氯联苯脱氯的效果,考察反应温度、反应时间及CaO添加比例对PCBs去除率、脱氯率的影响以及反应前后土壤中污染物的组分变化。实验土样中PCBs浓度为107.7 mg/g,属于罕见高浓度PCBs污染土壤。当反应温度为400℃、停留时间4h、CaO添加比例为10%,PCBs的去除率为87.7%,脱氯率为85.3%。土壤样品中五氯联苯和四氯联苯反应后含量降低或未检出,部分反应后样品检出一氯联苯和联苯,说明在CaO诱导PCBs低温热处理脱氯反应中存在逐步脱氯/加氢反应途径。     

前置反硝化曝气生物滤池的挂膜启动研究

为了解前置反硝化曝气生物滤池(BAF)的启动规律,构建了小试规模的前置反硝化BAF,采用快速排泥、逐步增大水力负荷的策略考察了其启动过程中的污染物去除情况及启动特性。结果表明,在好氧柱水力负荷为2.04 m3/(m2·h),厌氧柱水力负荷为4.08 m3/(m2·h),回流比为100%,气水比为5.6∶1的情况下,前置反硝化BAF的启动需要49 d。启动过程中好氧池中硝化细菌的成熟是启动的关键。厌氧池中的反硝化细菌的成熟标志着启动的完成。启动完成后,前置反硝化BAF的出水COD、NH3-N及NO-3-N分别稳定在50、15和5 mg/L以下,满足国家一级A排放标准。     

硅藻土固定化颗粒污泥对海水养殖废水除氨性能

针对实际海水养殖废水低碳高氮的特点,采用间歇式活性污泥法(SBR)和好氧活性污泥添加硅藻土载体的方式,考察硅藻土载体和活性污泥共同作用下的好氧曝气系统对海水养殖废水中氨态氮(NH+4-N)、亚硝酸态氮(NO-2-N)和化学耗氧量(COD)的去除效果,以及对污泥沉降性能和硝化细菌特征的影响。实验结果表明,常温条件下,溶解氧(DO)≥4.5mg/L,p H控制在7.0~8.0,HRT为11 h,沉降时间10 min,反应器可以处理NH+4-N浓度在50 mg/L左右的海水养殖废水,NH+4-N和COD去除率分别达到98.93%左右和76.62%以上,NO-2-N出水浓度低于0.028 mg/L。载体污泥颗粒照片和扫描电镜结果表明,添加硅藻土载体内核后,颗粒污泥的成熟期缩短,颗粒的稳固度和沉降性能提高。在系统启动成功稳定运行后,通过FISH分析表明,在氨氧化菌(AOB)与亚硝酸盐氧化菌(NOB)成为优势菌群后,AOB大约占总菌群的33.5%,并且AOB与NOB菌群数量约为1∶1.33,AOB和NOB两大类菌群之和约占总菌群的77.2%,成为系统中优势菌群。     

改性硅胶对水溶液中Pd2+的吸附

采用氨基硫脲对硅胶进行改性并表征,探讨了改性硅胶(SG-TSC)对水溶液中Pd2+的吸附性能。实验考察了p H值、吸附剂质量、吸附时间以及Pd2+初始浓度等因素对吸附的影响,并探讨了SG-TSC对Pd2+吸附动力学及等温吸附特性。结果表明:在p H为3~6范围内,吸附效果最好。吸附平衡时间为90 min,吸附动力学符合二级速率方程,颗粒内扩散与液膜扩散共同影响着吸附过程。Langmuir等温吸附方程能较好地描述Pd2+在SG-TSC上的吸附特性,298 K时静态饱和吸附容量为0.105 mmol/g。热力学参数计算结果表明,SG-TSC吸附水溶液中的Pd2+是自发、吸热和熵值增加的过程。     

响应面法优化甘蔗渣-污泥复合活性炭的制备工艺

为了提高污泥活性炭的吸附性能以提升其实际应用价值,提出在污泥中掺杂甘蔗渣制备复合活性炭,并采用Plackett-Burman联用响应面法对影响复合活性炭碘值的条件进行筛选优化。通过Plackett-Burman实验筛选出热解温度、热解时间和甘蔗渣与污泥干重比为主要影响因素,对这3个因素进行Box-Behnken实验,经响应面优化得到影响碘值的二次响应曲面模型,模型显示热解温度与热解时间、热解温度与干重比的交互作用显著,并确定了最佳制备条件:热解温度550℃、热解时间30 min和干重比50%,此时复合活性炭碘值为814 mg/g,优于未优化条件下制备的复合活性炭。通过比表面积、孔结构和碘值的测定以及元素和扫描电镜分析得出,甘蔗渣的掺杂提高了复合活性炭的比表面积、微孔体积、碘值及含碳量。研究结果表明,甘蔗渣掺杂和制备条件优化是提高污泥活性炭吸附性能的有效手段。     

Fe(Ⅱ)EDTA络合吸收-铁粉还原再生脱除NO性能

利用Fe(Ⅱ)EDTA络合吸收-铁粉间歇还原再生脱除NO并回收氨资源的方法,实验研究了铁粉还原再生Fe(Ⅱ)(NO)EDTA的过程及其影响因素。结果表明,以0.015 mol/L的Fe(Ⅱ)EDTA做吸收剂,在起始p H 5.5、温度323K条件下吸收400×10-6~500×10-6的NO,脱除率95%以上;铁粉还原再生Fe(Ⅱ)(NO)EDTA过程可用缩芯模型阐释;铁粉添加量与搅拌强度直接决定了铁粉质点数量,是影响反应的重要因素;实验中Fe(Ⅱ)(NO)EDTA络合液150 m L,氧气含量为5%时,搅拌速度900 r/min、粒径为0.12 mm的铁粉浓度5.3 g/L、温度353 K、p H=6为最适宜再生条件。     

Impact of demographic dynamics on CO_2 emissions in Sichuan,China

Global climate change is one of the major environmental issues faced by humans.Existing evidence indicates that the anthropogenic push for a rise in the atmospheric concentration of greenhouse gases(GHGs)(particularly CO_2)has been a primary cause for global warming.Aside from economic and teclinological factors,demographic dynamics(including human consumption in a broad demographic sense)has been a major driver for CO_2 emissions.In this paper,we performed both nonlinear regression analysis(based on the STIRPAT model)and gray correlation degree analysis(based on gray system theory)on the impact of demographic dynamics on CO_2 emissions.Our results reveal that CO_2 emissions are positively correlated with population size and GDP per capita and negatively correlated with energy intensity.We also show that gray correlation degree with CO_2 emissions for five variables(i.e.,household consumption,urbanization rate,household size,population aging rate,population size)varies substantially:household consumptionurbanization ratehousehold sizepopulation aging ratepopulation size,with household consumption being the highest,and population size the lowest.To mitigate the impact of demographic dynamics on CO_2 emissions,it is of vital significance to nurture people's awareness of sustainable consumption and to adhere to current population control policies.     

BiFeO3可见光催化降解甲基紫

采用柠檬酸-硝酸盐燃烧法制备了光催化剂BiFeO₃。采用SEM,XRD,FTIR等技术对光催化剂BiFeO₃进行表征。表征结果显示,光催化剂BiFeO₃晶相纯、粒径小、比表面积大,存在Fe#x02014;O的弯曲振动和伸缩振动。实验结果表明：通过鼓气及加入H₂O₂可有效提高BiFeO₃对甲基紫可见光催化降解的效率;在300mL质量分数为1.5#x000d7;10^-5的甲基紫溶液中加入0.9g光催化剂BiFeO₃和0.1mL质量分数为30%的H₂O₂溶液,当反应时间为240min时,甲基紫去除率可达99%。     

絮凝#x02014;微波辐射#x02014;Fenton试剂氧化法深度处理焦化废水

用絮凝#x02014;微波辐射#x02014;Fenton试剂氧化法深度处理焦化废水,研究了微波辐射时间、微波功率、FeSO₄加入量、H₂O₂加入量和废水pH对废水处理效果的影响。实验结果表明：在聚合氯化铝加入量为350mg/L、聚丙烯酰胺加入量为12mg/L、废水pH=5、FeSO₄加入量为250mg/L、H₂O₂总加入量为1400mg/L、H₂O₂分3次投加、微波功率为400W、微波辐射时间为60min的条件下,处理后出水的浊度、色度和COD去除率分别为98.59%,97.62%,86.21%。处理后出水澄清透明,COD为50.34mg/L,满足GB50050#x02014;2007《工业循环冷却水处理设计规范》的要求。     

Structure and Properties of Cocoons and Silk Fibers Produced by Attacus atlas

Silk fibers in the three layers of Attacus atlas (A. atlas) cocoons have morphological structure and tensile properties similar to that of Bombyx mori silk. Attempts are being made to produce silk for commercial applications from cocoons of relatively unknown wild insects due to the unique properties of the fibers and as a source of income and employment. In this research, A. atlas cocoons were used to study the chemical composition, morphology, physical structure and tensile properties of the silk fibers in the cocoons and ability of the fibers to support the attachment and proliferation of mouse fibroblast cells. It was found that A. atlas cocoons consists of outer, intermediate and inner layer with average breaking tenacity of 4.1, 4.3 and 3.6 g/den, respectively similar to that of B. mori silk (4.3–5.2 g/den). The heavier cocoons, less restrictive rearing conditions and good properties of the fibers compared to B. mori silk makes A. atlas a potential alternative to common silks for commercial scale silk production. A. atlas fibers had about 80 % higher optical densities of cells and extensive growth of F-actin compared to B. mori silk fibers.