Heterogeneous UV/Fenton degradation of bisphenol A catalyzed by synergistic effects of FeCo2O4/TiO2/GO

A new method for bisphenol A (BPA) degradation in aqueous solution was developed. The characteristics of BPA degradation in a heterogeneous ultraviolet (UV)/Fenton reaction catalyzed by FeCo₂O₄/TiO₂/graphite oxide (GO) were studied. The properties of the synthesized catalysts were characterized using scanning electron microscopy, X-ray diffraction, and vibrating sample magnetometry. FeCo₂O₄ and TiO₂ were grown as spherical shape, rough surface, and relatively uniform on the surface of GO (FeCo₂O₄/TiO₂/GO). Batch tests were conducted to evaluate the effects of the initial pH, FeCo₂O₄/TiO₂/GO dosage, and H₂O₂ concentration on BPA degradation. In a system with 0.5 g L⁻¹ of FeCo₂O₄/TiO₂/GO and 10 mmol L⁻¹ of H₂O₂, approximately 90 % of BPA (20 mg L⁻¹) was degraded within 240 min of UV irradiation at pH 6.0. The reused FeCo₂O₄/TiO₂/GO catalyst retained its activity after three cycles, which indicates that it is stable and reusable. The heterogeneous UV/Fenton reaction catalyzed by FeCo₂O₄/TiO₂/GO is a promising advanced oxidation technology for treating wastewater that contains BPA.

     

非饱和土壤渗透系数空间不确定性对溶质运移的影响

包气带渗透系数的不确定性是影响非饱和带溶质运移的主要因素。应用贝叶斯方法对非饱和土壤渗透系数进行前处理,使用Monte-Carlo方法模拟其空间不确定性,并通过HYDRUS-1D模型对溶质运移进行数值模拟,研究包气带渗透系数的空间不确定性对溶质运移的影响。结果表明,由于包气带渗透性的不确定性使得溶质浓度分布呈现明显的不确定性,包气带内不同点的浓度值相差很大。与忽略包气带土性参数空间不确定性的模拟结果相对比,考虑包气带渗透系数不确定性的模拟结果与实际情况更加接近,更具合理性和科学性。同时,根据模拟结果,对实际工作中进行地下水数值模拟时溶质初始浓度输入值的确定提出相应建议。     

我国腈纶废水物化预处理方法的研究进展

结合我国腈纶废水的特征,系统归纳了近年来我国腈纶废水常用物化预处理方法的研究进展。物化预处理方法包括内电解法、混凝法、Fenton氧化法、电解法、臭氧氧化法、光催化氧化法、微波法等。这些方法普遍存在高成本、高能耗、实际运行费用大等问题。对未来物化预处理方法的研究方向提出了建议。最后指出,腈纶废水的处理应朝着节能高效和资源化的方向发展,推动我国腈纶废水处理技术的不断进步和完善。     

低COD浓度废水启动EGSB反应器

以厌氧活性污泥和好氧活性污泥接种于2个膨胀颗粒污泥床(EGSB)反应器中,进水流量为10 mL/min,回流量为180 mL/min,进水COD浓度在180 mg/L左右,有机负荷率(OLR)为1.728 kg COD/m3·d左右,污泥负荷率(SLR)为0.19 kg COD/kg MLSS·d左右,出水COD浓度维持在40mg/L左右,COD去除率达80%以上.控制温度在32～35 ℃,pH在6.8～7.2,反应器内氧化还原电位在-340 mV以下,水力停留时间(HRT)4.2 h,上升流速4.86 m/h以及加入80 mg/L絮凝剂(硫酸铝钾),缩短了启动时间,促进了颗粒污泥的形成.分别经过60 d和120 d运行,反应器启动成功.结果表明,上升流速、絮凝剂和污泥类型对颗粒污泥的形成有影响;接种好氧活性污泥在低浓度COD下,合理控制负荷速率能成功启动EGSB反应器.     

电解-SBR联合技术处理硝基苯废水的试验

采用电解-SBR联合技术对硝基苯生产废水进行降解处理。考察了电流强度、反应时间对有机物去除率的影响,以及电解对废水可生化性的影响。通过试验确定了后续SBR反应器的操作方式和运行参数。结果表明,电解-SBR联合技术对硝基苯废水具有较好的处理效果。     

利用人工湿地系统深度处理城市污水尾水

利用垂直复合流模拟人工湿地系统对城市污水厂尾水进行深度处理实验研究,植物床选用美人蕉、菖蒲、茭草、芋头和象草混合栽种,采用石英砂为主体填料。实验研究表明:人工湿地系统在停留时间为24h,水力负荷为0.4m3(m2·d)的运行条件处理效果较佳,在此条件下连续稳定运行10个月,处理后的尾水主要指标达到(GBT189212002)标准。     

拉萨河夏季氢氧同位素空间分布特征及分析

稳定同位素示踪技术是河流水文过程研究的重要方式,可以用来判定河流补给的来源、研究河流与其它水体相互作用、示踪水文循环过程等.本文采用TC/EA-IRMS分析法对拉萨河水体的氢氧同位素进行测定,分析了 δD和δ18O的含量及空间分布特征,并分析了拉萨河的同位素效应,包括与大气降水氢氧同位素的关系、氢氧同位素的沿程变化特征...     

Metabolic uncoupler, 3,3′,4′,5-tetrachlorosalicylanilide addition for sludge reduction and fouling control in a gravity-driven membrane bioreactor

• Effects of metabolic uncoupler TCS on the performances of GDMBR were evaluated. • Sludge EPS reduced and transformed into dissolved SMP when TCS was added. • Appropriate TCS increased the permeability and reduced cake layer fouling. • High dosage aggravated fouling due to compact cake layer with low bio-activity. The gravity-driven membrane bioreactor (MBR)system is promising for decentralized sewage treatment because of its low energy consumption and maintenance requirements. However, the growing sludge not only increases membrane fouling, but also augments operational complexities (sludge discharge). We added the metabolic uncoupler 3,3′,4′,5-tetrachlorosalicylanilide (TCS) to the system to deal with the mentioned issues. Based on the results, TCS addition effectively decreased sludge ATP and sludge yield (reduced by 50%). Extracellular polymeric substances (EPS; proteins and polysaccharides) decreased with the addition of TCS and were transformed into dissolved soluble microbial products (SMPs) in the bulk solution, leading to the break of sludge flocs into small fragments. Permeability was increased by more than two times, reaching 60–70 L/m²/h bar when 10–30 mg/L TCS were added, because of the reduced suspended sludge and the formation of a thin cake layer with low EPS levels. Resistance analyses confirmed that appropriate dosages of TCS primarily decreased the cake layer and hydraulically reversible resistances. Permeability decreased at high dosage (50 mg/L) due to the release of excess sludge fragments and SMP into the supernatant, with a thin but more compact fouling layer with low bioactivity developing on the membrane surface, causing higher cake layer and pore blocking resistances. Our study provides a fundamental understanding of how a metabolic uncoupler affects the sludge and bio-fouling layers at different dosages, with practical relevance for in situ sludge reduction and membrane fouling alleviation in MBR systems.     

Monitoring land cover change detection with NOAA-AVHRR and MODIS remotely sensed data in the North and West of Africa from 1982 to 2015

Environmental Science and Pollution Research - Mapping land cover changes (LCC) cover three decades over North and West Africa regions provides critical insights for the climate research that...