Plasma versus Thermal Effects in Flue Gas NOx Reduction Using Ammonia Radical Injection

Abstract

A plasma-assisted ammonia injection technique was previously demonstrated as having the potential to remove NO_x from combustion flue gases at SCR-comparable levels without the use of catalysts. However, these demonstrations did not prove the advantage of plasma assistance because they did not explicitly account for enhanced radical production by bulk thermal heating. An experiment using hot ammonia injection was performed to separate this thermal effect from the effect of radical production via interaction with a plasma. Under excess air conditions, results show that a thermal effect does provide improved NO_x reduction, but not to the level achieved with the use of a plasma source. However, heating the injection gases provides only a minor improvement in NO_x reduction at NH₃/NO_x ratios and temperatures typical of commercial cold SNCR applications. The plasma effect in ammonia radical injection was also found to be significant, accounting for an additional 15% to 35% of absolute NO_x reduction beyond any thermal benefit at typical excess air conditions. The ammonia radical injection technique continues to show promise as an effective NO_x reduction alternative.     

Properties of Pyrolytic Chars and Activated Carbons Derived from Pilot-Scale Pyrolysis of Used Tires

Abstract

Used tires were pyrolyzed in a pilot-scale quasi-inert rotary kiln. Influences of variables, such as time, temperature, and agent flow, on the activation of obtained char were subsequently investigated in a laboratory-scale fixed bed. Meso-porous pores are found to be dominant in the pore structures of raw char. Brunauer-Emmett-Teller (BET) surfaces of activated chars increased linearly with carbon burnoff. The carbon burnoff of tire char achieved by carbon dioxide (CO₂) under otherwise identical conditions was on average 75% of that achieved by steam, but their BET surfaces are almost the same. The proper activation greatly improved the aqueous adsorption of raw char, especially for small molecular adsorbates, for example, phenol from 6 to 51 mg/g. With increasing burnoff, phenol adsorption exhibited a first-stage linear increase followed by a rapid drop after 30% burnoff. Similarly, iodine adsorption first increased linearly, but it held as the burnoff exceeded 40%, which implied that the reduction of iodine adsorption due to decreasing micro-pores was partially made up by increasing mesopores. Both raw chars and activated chars showed appreciable adsorption capacity of methylene-blue comparable with that of commercial carbons. Thus, tire-derived activated carbons can be used as an excellent mesoporous adsorbent for larger molecular species.     

基于排队论的城市垃圾箱最佳间距研究

针对城市垃圾箱最佳间距的研究不够精细的现状,本文通过建立排队论模型得到了可供不同城市参考的城市垃圾箱最佳间距参数表。通过对部分城市街道的垃圾箱摆放间距情况进行实地调查,运用层次分析法将影响垃圾箱间距分布的多重因素转化为单因素;建立了基于指数分布的数学模型,利用排队论分析单因素状态下的垃圾箱间距分布,得到了求解城市垃圾箱最佳间距的一般方法。     

Enhanced degradation of azo dye alizarin yellow R in a combined process of iron–carbon microelectrolysis and aerobic bio-contact oxidation

Purpose

With the aim of enhanced degradation of azo dye alizarin yellow R (AY) and further removal of the low-strength recalcitrant matter (LsRM) of the secondary effluent as much as possible, our research focused on the combination of aerobic bio-contact oxidation (ABO) with iron/carbon microelectrolysis (ICME) process.

Materials and methods

The combined ABO (with effective volume of 2.4?l) and ICME (with effectively volume of 0.4?l) process were studied with relatively short hydraulic retention time (HRT) of 4 or 6?h.

Results

At the HRT of 6?h with the reflux ratio of 1 and 2, the AY degradation efficiency in the final effluent was >96.5%, and the total organic carbon (TOC) removal efficiency were 69.86% and 79.44%, respectively. At the HRT of 4?h and the reflux ratio of 2, TOC removal efficiency and AY degradation efficiency were 73.94% and 94.89%, respectively. The ICME process obviously enhanced the total AY removal and the generated micromolecule acids and aldehydes then that wastewater backflow to the ABO where they were further biodegraded.

Conclusion

The present research might provide the potential options for the advanced treatment azo dyes wastewater with short HRT and acceptable running costs.     

超声波促进城市生活污泥缺氧/好氧消化的研究

本研究将超声波预处理引入城市生活污泥缺氧/好氧消化工艺中,自主设计了容积为30 L的生活污泥超声波-缺氧/好氧消化中试系统并用以实验研究。超声波预处理的参数为超声频率28 kHz,声能密度0.15 W/mL,超声时间10 min,超声间隔12 h,污泥超声比例30%。结果表明,引入超声预处理后,缩短了污泥的稳定时间,提高了污泥的消化效率。污泥消化10 d就已经达到了稳定标准,比未引入超声预处理时缩短了12 d,而MLVSS最大去除率提高了11%,达到了55.10%。超声波的引入,对污泥缺氧/好氧消化系统中污泥上清液溶解性COD（SCOD）的变化趋势影响比较明显,而对上清液的pH、氨氮和TP的变化趋势没有明显影响。     

复合型絮凝剂处理景观水体

利用以生物絮凝剂(1 g/L MBF-28)与化学絮凝剂(5 g/L PAC)复配后的复合絮凝剂CBF28C处理景观水体,考虑了复配比、投加量、pH和投加顺序对处理景观水的影响。实验结果表明:对于反应体系为100 mL景观水体,当MBF-28与PAC溶液复配体积比为3∶1,反应体系pH为7.0,1 mL 1%CaCl2作助凝剂,1.5 mL CBF28C时,其絮凝效果最好,其COD,色度,TN,TP的去除率分别为90.7%,54.1%、46.6%和51.5%。最佳水力条件为:快速320 r/min,快搅时间45 s,慢速80 r/min,慢搅时间100 s。并且得出了前10 min内絮凝率的反应关系方程式。     

组合阳极联合气体扩散阴极电催化降解苯胺

采用气体扩散电极为阴极,钛基氧化物（Ti／SnO2-Sb2O5-IrO2）和金属铁构成组合阳极,构建了新型电化学氧化体系用于降解有机污染物。利用该氧化体系,在不同实验条件下考察了苯胺降解的效果与降解过程的相关规律。结果表明,阴极电位、铁阳极通电时间以及苯胺初始浓度均显著影响苯胺的降解效果。当阴极电位为-0．7V,pH3．0,铁阳极通电时间20min时,电化学处理200mg／L苯胺480min,TOC的去除效率达到80．4％,矿化电流效率（MCE）为8．6％,显示了该氧化体系具有良好的有机物降解能力。此外,苯胺降解过程中氨氮和硝态氮浓度的变化表明,苯胺分子中的氮主要转化为NH4和NO3^-。     

Agricultural Productivity Changes Induced by the Sloping Land Conversion Program: An Analysis of Wuqi County in the Loess Plateau Region

This paper examines the agricultural productivity change induced by the Sloping Land Conversion Program (SLCP) using the Malmquist index method and household data collected from Wuqi. We find that during the period of 1998–2004, the total factor productivity (TFP) grew by 15.8%. While numerous households suffered a TFP decline, the majority of them experienced a large gain. By decomposing the TFP, we further show that its increase is due exclusively to the improvement of technical efficiency rather than to technological change. To validate these findings and put them in perspective, we also estimated the TFP change with county-level aggregate data. It is revealed that driven by technological change and scale efficiency, the TFP grew slightly during the period of 1992–1998. Because of the tremendous cropland reduction and production mode shift caused by implementing the SLCP, the TFP declined substantially during the first three years of the program; due to continued improvement of technical efficiency; however, its growth accelerated later. Altogether, our evidence consistently suggests that implementing the SLCP has contributed to the agricultural TFP growth in the longer term and that the efficiency improvement has resulted mainly from the increased public expenditures for extension services and diffusion of technical knowledge. Wuqi’s experience proves that it is possible to achieve environmental conservation and increase productivity simultaneously, even when facing a cropland reduction and production mode alternation.     

Development Potentials and Policy Options of Biomass in China

Biomass, one of the most important renewable energies, is playing and will continue to play an important role in the future energy structure of the world. This article aims to analyze the position and role, assess the resource availability, discuss the geographic distribution, market scale and industry development, and present the policy options of biomass in China. The resource availability and geographical distribution of biomass byproducts are assessed in terms of crop residues, manure, forest and wood biomass byproducts, municipal waste and wastewater. The position of biomass use for power generation is just next to hydropower among types of renewable energy in China. The potential quantity of all biomass byproducts energy in 2004 is 3511 Mtce (Mtce is the abbreviation of million tons of coal equivalents and 1 Mtce is equal to10⁶ tce.), while the acquirable quantity is 460 Mtce. Biomass energy plays a critical role in rural regions of China. The geographical distribution and quantity of biomass byproducts resources depends mainly on the relationship between ecological zones and climate conditions. Our estimation shows that the total quantity of crop residues, manure, forest and wood biomass byproducts, municipal waste and wastewater resources are 728, 3926, 2175, 155 and 48240 Mt (million tons), respectively. Crop residues come mainly from the provinces of Henan, Shandong, Heilongjiang, Jilin and Sichuan. All manure is mainly located in the provinces of Henan, Shandong, Sichuan, Hebei and Hunan. Forest and wood biomass byproducts are mainly produced in the provinces or autonomous regions of Tibet, Sichuan, Yunnan, Heilongjiang and Inner Mongolia, while most of municipal waste mainly comes from Guangdong, Shandong, Heilongjiang, Hubei and Jiangsu. Most of wastewater is largely discharged from advanced provinces like Guangdong, Jiangsu, Zhejiang, Shandong and Henan. Biomass byproducts’ energy distribution also varies from province to province in China. Based on the analysis of the market scale and industry development, the article argues that China’s biomass energy industry is still at a very early stage of development and that Feed-in Tariffs (FIT) might be the best policy option for China to promote its development of biomass energy. A successful enforcement of FIT in China needs some policy combination of special capital subsidies, R&D funding, tax incentives and pricing.