垂直流人工湿地水力学特性研究

通过示踪剂实验从停留时间分布（RTD）曲线及其统计特征值等方面对垂直流人工湿地的水力学特性进行了定性和定量的分析。研究表明水流在垂直流人工湿地中的流动是一种非理想的不均匀流动,存在一定的死区和水流的扩散;垂直流人工湿地较大的死区率与其表面布水的不均匀性有关,这也可能是其死区率大于表流人工湿地的最主要的原因。实验还表明,进水流量对垂直流人工湿地停留时间分布影响较大,随着进水流量的增加,平均停留时间减小,但标准平均停留时间增大,死区率减小;当进水流量为15L／h（水力负荷为620mm／d）时,水流在湿地中的散度最大,水流更接近全混流,不利于污染物的降解。     

提高炼油废水处理场的氨氮去除率

对炼油废水处理场现有工艺进行流程优化,将MBR装置调整在接触氧化池之后运行.优化流程后氨氮平均去除率可从近于0提高至71.70％;COD平均去除率可从50.00％提高至72.00％.通过对工艺流程的对比,分析了现有工艺氨氮质量浓度难以降低的原因,指出废水中存在的某些污染物对硝化细菌起到抑制作用,减少了反应器中硝化细菌的...     

制药废水有机污染物特性分析与处理

分析了某制药企业废水生物处理站进出水中有机污染物的相对分子质量分布和气相色谱—质谱图谱,提出了根据废水水质特性有针对性地确定制药废水处理工艺的新思路.实验结果表明:进出水中的有机污染物主要是相对分子质量小于1 000的物质,且主要来源于车间5排放的COD比重大、水量小的工段废水;采用旋转蒸馏预处理法处理车间5废水,可使...     

Enhanced arsenate removal from aqueous solution by Mn-doped MgAl-layered double hydroxides

Environmental Science and Pollution Research - In this study, Mn-doped MgAl-layered double hydroxides (LDHs) were successfully synthesized for efficient removal arsenate from aqueous solution. The...     

Preparation and Properties of a Chitosan–Hyaluronic Acid-Polypyrrole Conductive Hydrogel Catalyzed by Laccase

Electro conductive hydrogels, consisting of chitosan (CS), hyaluronic acid (HA), and polypyrrole (PPy), were prepared via an in situ enzymic polymerization of pyrrole in the CS–HA hydrogel, using laccase as the catalyst. This CS–HA–PPy composite hydrogel showed good conductivity. The chemical structure and morphology of this conductive hydrogel were studied by Fourier transform infrared spectroscopy, scanning electron microscopy, and X-ray diffraction technique. For CS–HA–PPy and CH–HA hydrogel, the temperature at which fastest decomposition occurred was 260 and 244 °C, respectively. That means the thermal stability of CS–HA–PPy is better than CS–HA hydrogel. The conductive hydrogel also showed excellent swelling and deswelling behaviors.     

Continuous measurement of peroxyacetyl nitrate (PAN) in suburban and remote areas of western China

Knowledge on atmospheric abundance of peroxyacetyl nitrate (PAN) is important in assessing the severity of photochemical pollution, and for understanding chemical transformation of reactive odd nitrogen and its impact on the budget of tropospheric ozone (O₃). In summer 2006, continuous measurements of PAN were made using an automatic GC–ECD analyzer with an on-line calibrator at a suburban site of Lanzhou (LZ) and a remote site of Mt. Waliguan (WLG) in western China, with concurrent measurements of O₃, total reactive nitrogen (NO_y) and carbon monoxide (CO). At LZ, several photochemical episodes were observed during the study, and the average mixing ratio of PAN (plus or minus standard deviation) was 0.76 (±0.89) ppbv with the maximum value of 9.13 ppbv, compared to an average value of 0.44 (±0.16) ppbv at remote WLG. The PAN mixing ratios in LZ exhibited strong diurnal variations with a maximum at noon, while enhanced concentrations of PAN were observed in the evening and a minimum in the afternoon at WLG. The daily O₃ and PAN concentration maxima showed a strong correlation (r² = 0.91) in LZ, with a regression slope (PAN/O₃) of 0.091 ppbv ppbv^?1. At WLG, six well-identified pollution plumes (lasting 2–8 h) were observed with elevated concentrations of PAN (and other trace gases), and analysis of backward particle release simulation shows that the high-PAN events at WLG were mostly associated with the transport of air masses that had passed over LZ.     

Single particle mass spectrometry of oxalic acid in ambient aerosols in Shanghai: Mixing state and formation mechanism

Oxalic acid in individual aerosol particles was measured using single particle aerosol time-of-flight mass spectrometry (ATOFMS) in the summer of 2007 in Shanghai, China. Oxalate was found in 3.4% of total particles with diameters in the range of 0.2 – 2.0 μm. Size, chemical composition and hourly temporal counts of single particles that contained oxalic acid were measured. The predominant types of oxalate-containing particles were characterized to distinguish the primary and secondary sources of oxalic acid. Biomass burning was revealed as a major primary source of oxalic acid which contributed more than 20% of the oxalate-containing particles. Evidences for two different formation pathways of oxalic acid were observed in our experiment. The number fraction of oxalate-containing particles correlated with that of sulfate particles and the changes of air parcel backward trajectories, suggesting that in-cloud processing played important roles in oxalic acid formation. The diurnal patterns of dust and sea salt particle counts fitted well with the ambient relative humidity variation, suggesting that heterogeneous reactions occurring in hydrated/deliquesced aerosols also contributed to the production of oxalic acid.     

基于生态安全的DAT-IAT城市污水处理工艺改进研究

通过正交试验,得到了DAT-IAT工艺和A/DAT-IAT工艺处理城市污水的常规指标去除和生态毒理指标削减的最优运行条件。结果表明,在正交试验的同一工艺中,COD去除最优运行条件的出水COD值优于生态毒性削减最优运行条件的出水COD值,但前者出水的生态毒性较大。由于厌氧池的水解酸化作用,A/DAT-IAT工艺对COD和生态毒性的处理效果均优于DAT-IAT工艺,并且回流总能耗低于DAT-IAT工艺,但是出水COD仍不达标。为了降低进入工艺的COD的总量,以絮凝沉淀做为预处理工艺,并采用Al残留量最小的絮凝剂投药量以降低出水中残留Al带来的生态风险。结果表明,在COD去除最优运行条件下,具有絮凝预处理的工艺对COD的去除效果优于没有絮凝预处理的工艺。絮凝-A/DAT-IAT工艺在COD去除最优运行条件下出水COD为104.46 mg/L,满足排放标准。在毒性削减最优运行条件下,具有絮凝预处理的工艺的出水生态毒性有所上升,但是污染物的总量得到了大幅削减。絮凝-A/DAT-IAT工艺与DAT-IAT工艺相比,在污染物去除效率得到大幅增加的同时,生态毒性得到有效控制,生态安全得到了有效的保障。     

培养藻类制取生物能源的研究

能源紧张和环境污染是全世界所面临的共同问题,用藻类替代传统作物生产生物能源是生物质能的重要发展方向之一。文章介绍了国内外对藻类培养条件、光生物反应器型式、藻类基因工程、藻细胞收集方法以及能源藻类生产系统的研究成果。研究认为,以藻类为原料生产生物燃料具有良好的发展前景,并指出了今后能源藻类生长的重点研究方向。     

热化学洗涤－超声波分离技术处理油田含油污泥

为解决大量堆存的含油污泥所造成的环保隐患问题,长庆油田建设了含油污泥处理站。采用"热化学洗涤-超声波分离"工艺对含油污泥进行处理。含油污泥的含油率从处理前的48.9%降到处理后2.0%,除油率达到95.9%,除油效果较好。