热碱法破解污泥动态实验的条件优化

以城市污水处理厂二沉池污泥为研究对象,利用热碱处理工艺对其进行处理,研究污泥的最佳处理条件,分析静态实验对动态实验的指导作用。结果表明:静态实验处理条件下,污泥热碱处理的最佳初始pH、反应温度、反应时间分别为13、30℃、10 h;在最适条件下,COD溶出率、水相中的蛋白质和多糖浓度依次为61.53%、761.73 mg/L、649.85 mg/L;动态实验最佳反应时间为10 h,在此最佳条件下COD溶出率为75.77%、多糖浓度为842.34 mg/L,蛋白质浓度随着反应时间上下波动,总体破解效果高于静态实验。以上结果表明,污泥静态实验对动态实验具有现实指导作用,热碱联合具有较好的应用前景。     

不同挂膜方式成熟滤料去除地下水中As(Ⅲ)研究

通过动力学和动态柱实验对比研究了不同挂膜方式成熟滤料去除地下水中As（Ⅲ）效能.并采用SEM-EDS?XRD及FTIR等表征手段对滤料形态和结构进行了分析.结果表明,两种滤料的形貌具有较大差异.采用化学挂膜的滤料去除As（Ⅲ）性能更优.二级动力学模型能较好地模拟两种滤料除As（Ⅲ）动力学过程,自然挂膜滤料和化学挂膜滤料拟合速率常数分别为8.568×10^-6和14.248×10^-6mg/（g·min）.Yan模型对动态柱实验穿透曲线的拟合系数R²>0.999.通过脱附再生实验,发现0.5mol/L的NaHCO₃作为脱附剂可使滤料有效再生.对比过滤前后滤料的XRD分析结果,滤料结构变化不大,除砷能力稳定.滤料表面铁锰氧化物含量直接影响滤料除As（Ⅲ）性能.两种滤料在除砷过程中均消耗了羟基.本研究为不同方法去除地下水中As（Ⅲ）提供了理论支撑,具有一定工程指导意义.     

Efficient low-temperature soot combustion by bimetallic Ag–Cu/SBA-15 catalysts

In this study, the effects of copper(Cu) additive on the catalytic performance of Ag/SBA-15 in complete soot combustion were investigated. The soot combustion performance of bimetallic Ag–Cu/SBA-15 catalysts was higher than that of monometallic Ag and Cu catalysts. The optimum catalytic performance was acquired with the 5 Ag_1-Cu_(0.1)/SBA-15 catalyst, on which the soot combustion starts at T_(ig)= 225°C with a T_(50)= 285°C. The temperature for 50% of soot combustion was lower than that of conventional Ag-based catalysts to more than 50°C(Aneggi et al., 2009). Physicochemical characterizations of the catalysts indicated that addition of Cu into Ag could form smaller bimetallic Ag–Cu nanolloy particles, downsizing the mean particle size from 3.7 nm in monometallic catalyst to 2.6 nm in bimetallic Ag–Cu catalyst. Further experiments revealed that Ag and Cu species elicited synergistic effects, subsequently increasing the content of surface active oxygen species. As a result, the structure modifications of Ag by the addition of Cu strongly intensified the catalytic performance.     

Allowance and allocation of industrial volatile organic compounds emission in China for year 2020 and 2030

As an effective pollution control method, emission allowance and allocation just implemented in volatile organic compounds(VOCs) control strategy of China in 2016. This article presents a possible way to set the emission allowance targets and establishes an allowance allocation model for the object year, 2020 and 2030, using 2010 as the reference year. On the basis of regression and scenario analysis method, the emission allowance targets were designed,which were 17.902 Tg and 18.224 Tg for 2020 and 2030, with an increasing rate of 28.75% and31.06% compared to 2010. From the perspective of industries, processes using VOCscontaining products, like machinery and equipment manufacturing, would continue to be the most significant industrial VOCs emission sources in the future of China. Four allocation indicators were selected, which are per capita GDP of each province, per capita industrial VOCs emission of each province, the economic contribution of industrial sector to regional economy of each province, and the emission intensity per land area of each province, respectively.Based on information entropy, the weights of the indicators were calculated and an emission allocation model was established, and the results showed that provinces like Shandong,Jiangsu, Guangdong, Zhejiang and Fujian were calculated to obtain more emission allowance while burden more reduction responsibility. Meanwhile, provinces like Guizhou, Ningxia,Hainan, Qinghai and Xizang were on the contrary. This paper suggests governments to enhance or ease to industrial VOCs reduction burden of each province in order to stimulate its economy or change its way of economy development.     

Selection of cost-effective magnesium sources for fluidized struvite crystallization

Struvite crystallization has been considered a promising approach to recover phosphorus from wastewater. However, its practical application is limited, probably because of the high cost of magnesium(Mg). In this study, a comprehensive economic analysis was conducted using five Mg sources(MgCl_2, MgSO_4, MgO, Mg(OH)_2, and bittern) during the operation of a pilot-scale fluidized bed reactor(FBR), using swine wastewater as the case matrix. First, the economic operating conditions were investigated, and subsequently, the performance and the costs of the five Mg sources were compared. The results indicated that the FBR could be operated most economically at pH of 8.5 and Mg to phosphorus(Mg/P) molar ratio of 1.5. Under these conditions, no significant differences in phosphorus removal and product quality could be found between the five Mg sources. Selecting the most economical Mg source was thus highly dependent on the prices of the reagents and Mg sources. Low-solubility Mg sources were preferable when NaOH was priced higher, while high-solubility Mg sources proved more economical when HNO_3 was expensive. The bittern was the most economical choice only when the distances for total inorganic orthophosphate removal and struvite recovery were shorter than 40 and 270 km, respectively. The current study provides an overview of the economic selection of an Mg source, which can help reduce the cost of struvite crystallization.     

Characteristics of the pollutant emissions in a tunnel of Shanghai on a weekday

Tunnel displays a typical semi-closed environment, and multitudes of the pollutants tend to accumulate. The samples of gaseous pollutants and particulate matter(PM) were collected from the Xiangyin tunnel at Shanghai to investigate the characteristics of the pollutant emissions. The results indicated that both gaseous pollutants and PM exhibited much higher concentrations during the rush hours in the morning and at night due to vehicle emission. Two peaks of the PM concentration were observed in the scope of 0.7‐1.1 and 3.3–4.7 μm, accounting for 14.6% and 20.3% of the total concentrations, respectively.Organic matter(OM), EC, and many water-soluble ions were markedly higher at the rush hours in the morning than those at night, implicating comprehensive effects of vehicle types and traffic volume. The particle number concentrations exhibited two peaks at Aitken mode(25 nm and 100 nm) and accumulation mode(600 nm), while the particle volume concentration displayed high values at the accumulation mode(100–500 nm) and coarse mode(2.5–4.0 μm). The peak around 100 nm was detected in the morning rush hours, but it diminished with the decrease of the traffic volume. Individual-particle analysis revealed that main particles in the tunnel were Fe-rich particles, K-rich particles, mineral particles,Ca–S rich particles and Al–Si particles. The particles collected at the rush hours displayed marked different morphologies, element concentrations and particle sizes compared to the ones collected at the non-rush period. The data presented herein could shed a light on the feature of vehicle emissions.     

Enhanced photocatalytic activity of rGO/TiO2 for the decomposition of formaldehyde under visible light irradiation

Due to the low concentration of indoor air contaminants,photocatalytic technology shows low efficiency for indoor air purification.The application of TiO_2 for photocatalytic removal of formaldehyde is limited,because TiO_2 can only absorb ultraviolet(UV) light.Immobilization of TiO_2 nanoparticles on the surface of graphene can improve the visible light photocatalytic activity and the adsorption capacity.In this study,rGO(reduced graphene oxide)/TiO_2 was synthesized through a hydrothermal method using titanium tetrabutoxide and graphene oxide as precursors,and was used for the degradation of low concentration formaldehyde in indoor air under visible light illumination.Characterization of the crystalline structure and morphology of rGO/TiO_2 revealed that most GO was reduced to rGO during the hydrothermal treatment,and anatase TiO_2 nanoparticles(with particle size of 15–30 nm) were dispersed well on the surface of the rGO sheets.rGO/TiO_2 exhibited excellent photocatalytic activity for degradation of formaldehyde in indoor air and this can be attributed to the role of rGO,which can act as the electron sink and transporter for separating photo-generated electron–hole pairs through interfacial charge transfer.Furthermore,rGO could adsorb formaldehyde molecules from air to produce a high concentration of formaldehyde on the surface of rGO/TiO_2.Under visible light irradiation for 240 min,the concentration of formaldehyde could be reduced to 58.5 ppbV.rGO/TiO_2 showed excellent moisture-resistance behavior,and after five cycles,r GO/TiO_2 maintained high photocatalytic activity for the removal of formaldehyde(84.6%).This work suggests that the synthesized rGO/TiO_2 is a promising photocatalyst for indoor formaldehyde removal.     

2006—2015年中国电力碳足迹及其生态压力分析

电力行业是我国节能减排的主力军.本文根据电力来源多样性特征,采用IPCC计算方法,结合净初级生产力模型,定量分析了中国2006-2015年电力消费碳足迹及其生态压力的变化,并将电力碳足迹生态压力与人均GDP进行脱钩分析.结果表明,2006-2015年,电力消费碳排放量经历了先升后降两个阶段,其中,2006-2013年,碳排放量稳步上升,2013年后开始逐渐下降,电力碳足迹生态压力与人均GDP之间主要呈弱脱钩关系,但在2013-2015年,开始出现强脱钩状态.可见在国家″十二五″政策引导下,推动经济结构转型调整,促进电力产业节能减排,已获得显著成效,但仍需继续努力,缓解电力消费过程给生态环境带来的压力.     

杭州市郊菜区大气及蔬菜中氟化物的含量和分布

本文分析调查了杭州市郊菜区大气及一些主要蔬菜中氟化物的含量及分布，并对蔬菜中氟化物含量与大气氟污染的关系进行了相关分析。结果表明，杭州市郊菜区个别蔬菜中氟化物含量已超过有关标准，这主要与工业污染源的分布有关；蔬菜中氟化物含量与大气氟浓度之间存在着明显的相关关系。     

长链烷烃降解菌alkB片段的分离和鉴定

分离并鉴定了长链烷烃降解菌Pseudomonasaeruginosa1785和P.marginata766烃羟化酶基因alkB片段.根据烃羟化酶的保守氨基酸序列,设计兼并引物,扩增P.aeruginosa1785和P.marginata766的alkB片段,获得了目标产物.经DNA测序和氨基酸序列分析,证实目标片段编码的肽段含有烃羟化酶的特征基序.由此确认采用该方法分离到了长链烷烃降解基因的alkB同源体片段.DNA序列比对结果表明,P.aeruginosa1785和P.marginata766的alkB片段与P.aeruginosaPAO1的alkB1和alkB2的相似性分别达到95.7%和94.8%.这些alkB片段可用于分析烃降解微生物群落结构.图3表2参11