化学解耦联剂对活性污泥产率的控制作用

采用3,3',4',5-四氯水杨酰苯胺(TCS)作为代谢解耦联剂添加到活性污泥工艺中,进行连续曝气分批培养实验.结果表明:在TCS总投加量相同的情况下,采用一次性大剂量投加的污泥减量化效果好于分次小剂量投加.每d投加 12 mg TCS,污泥产量比对照下降了33%,而每2 d一次性投加24 mg TCS,污泥产量比对照下降了55%.污泥的CODCr去除能力有所下降,当一次性投加12 mg时,CODCr去除率比对照下降了12%,但出水氨氮及总氮质量浓度均未受影响.污泥的SVI有所上升,但沉降性能未见有明显变化.      

SBR法处理豆制品废水工艺条件的研究

用SBR法处理豆制品废水的试验表明,该系统具有较好的抗负荷冲击能力,进水COD在300～2000 mg/L之间变化,对系统不造成任何影响;考察了曝气时间、曝气量和污泥浓度等对去除效果的影响,试验结果表明,曝气时间和曝气量对处理效果影响很大,确定该反应系统最佳曝气时间是8 h,适宜的曝气量是800 L/h,而污泥浓度控制在4000 mg/L左右时,处理效率最高,采用进水顶出水的排水方式是可行的,确定系统的最佳排水比是3/5.厌氧段的插入可以减少剩余污泥的产量.     

山东崂山生物多样性及保护对策

根据多年来对青岛崂山生物资源的调查和文献资料,研究了崂山生物多样性的特点,分析了其在山东生物多样性保护中的地位,提出了崂山生物多样性保护对策和建议.研究表明:崂山生物多样性具有物种丰富度高、密度大,特有种、重点保护物种多,植物成分复杂,生态系统类型多样,古树名木众多,遗传多样性丰富的特点,崂山是山东乃至全国生物多样性保护的“关键区“之一.     

Persistence of fermentative process to phenolic toxicity in groundwater

The fermentation process is an important component in the biodegradation of organic compounds in natural and contaminated systems. Comparing with terminal electron-accepting processes (TEAPs), however, research on fermentation processes has to some extent been ignored in the past decades, particularly on the persistence of fermentation process in the presence of toxic organic pollutants. Both field and laboratory studies, presented here, showed that microbial processes in a groundwater-based system exhibited a differential inhibitory response to toxicity of phenolic compounds from coal tar distillation, thus resulting in the accumulation of volatile fatty acids (VFAs) and hydrogen. This indicated that fermentation processes could be more resistant to phenol toxicity than the subsequent TEAPs such as methanogenesis and sulfate reduction, thus providing us with more options for enhancing bioremediation processes.     

Nitrogen- vs. phosphorus-based dairy manure applications to field crops: nitrate and phosphorus leaching and soil phosphorus accumulation

Management of animal manures to provide nutrients for crop growth has generally been based on crop N needs. However, because manures have a lower N/P ratio than most harvested crops, N-based manure management often oversupplies the crop-soil system with P, which can be lost into the environment and contribute to eutrophication of water bodies. We examined the effects of N- vs. P-based manure applications on N and P uptake by alfalfa (Medicago sativa L.), corn (Zea mays L.) for silage, and orchardgrass (Dactylis glomerata L.), leaching below the root zone, and accumulation of P in soil. Treatments included N- and P-based manure rates, with no nutrient input controls and inorganically fertilized plots for comparison. Nitrate concentrations in leachate from inorganic fertilizer or manure treatments averaged 14 mg NO(3)-N L(-1), and did not differ by nutrient treatment. Average annual total P losses in leachate did not exceed 1 kg ha(-1). In the top 5 cm of soil in plots receiving the N-based manure treatment, soil test P increased by 47%, from 85 to 125 mg kg(-1). Nitrogen- and P-based manure applications did not differ in ability to supply nutrients for crop growth, or in losses of nitrate and total P in leachate. However, the N-based manure led to significantly greater accumulation of soil test P in the surface 5 cm of soil. Surface soil P accumulation has implications for increased risk of off-field P movement.     

Evaluation of the ADAPT model for simulating nitrogen dynamics in a tile-drained agricultural watershed in central Illinois

Assessing the accuracy of agronomic and water quality simulation models in different soils, land-use systems, and environments provides a basis for using and improving these models. We evaluated the performance of the ADAPT model for simulating riverine nitrate-nitrogen (NO3-N) export from a 1500-km2 watershed in central Illinois, where approximately 85% of the land is used for maize-soybean production and tile drainage is common. Soil chemical properties, crop nitrogen (N) uptake coefficient, dry matter ratio, and a denitrification reduction coefficient were used as calibration parameters to optimize the fit between measured and simulated NO3-N load from the watershed for the 1989 to 1993 period. The applicability of the calibrated parameter values was tested by using these values for simulating the 1994 to 1997 period on the same watershed. Willmott's index of agreement ranged from 0.91 to 0.97 for daily, weekly, monthly, and annual comparisons of riverine nitrate N loads. Simulation accuracy generally decreased as the time interval decreased. Willmott's index for simulated crop yields ranged from 0.91 to 0.99; however, observed crop yields were used as input to the model. The partial N budget results suggested that 52 to 72 kg N ha(-1) yr(-1) accumulated in the soil, but simulated biological N fixation associated with soybeans was considerably greater than literature values for the region. Improvement of the N fixation algorithms and incorporation of mechanisms that describe soybean yield in response to environmental conditions appear to be needed to improve the performance of the model.     

Modeling methyl isothiocyanate soil flux and emission ratio from a field following a chemigation of metam-sodium

Metam-sodium had become the most heavily used soil fumigant in recent years as the deadline approached for methyl bromide to phase out in January 2005. After application, metam-sodium decomposes rapidly to methyl isothiocyanate (MITC), a highly toxic compound capable of killing a wide spectrum of soil-borne pests. Inhalation risk of MITC ranked high among airborne agricultural pesticides in California. Information about off-gassing intensity and percentage of emission is essential for exposure risk assessment and mitigation measures, but is limited, especially for new application methods such as drip chemigation. Air concentrations of MITC were monitored around a field treated with metam-sodium through surface drip irrigation system. The field was tarped with plastic films before the chemigation. The air concentrations at receptor locations were simulated for the period of air monitoring with the Industrial Source Complex (ISC3) Dispersion Model, and soil flux density of MITC at various periods after chemigation was estimated through a back-calculation procedure. The estimated soil flux density of MITC showed a diurnal pattern, with the daytime flux stronger than nighttime. However, the average air concentration at nighttime was higher than that at daytime. Soil flux density peaked at 4.30 microg m-2 s-1 in the first 12-h period after chemigation, then declined with time. The MITC emission percentage in the first 60-h was 2.65% of applied mass, of which 57% occurred in the first 24-h after chemigation. The study indicated that the tarped bed drip application method of metam-sodium had a relatively good control of MITC emission from soil.     

Recycling of an industrial sludge and marine clay as light-weight aggregates

The geographical limitations of Singapore, its restricted natural resources and voluminous municipal and industrial waste streams, make environmental management a major challenge for the island state. In an attempt to find ways to reduce importation of raw materials and the waste sent to landfill, light weight aggregates were produced from marine clay and a CaF(2)-rich semiconductor industry sludge. Aggregates were produced in a bench-scale rotary kiln with three clay/sludge loadings (90/10, 70/30 and 50/50%). All three mixtures showed good bloating behavior during firing and the ceramic pellets (1-1.5cm diameter) had densities well below that required for light-weight aggregates. In the initial tests, the pore sizes of the aggregates were in general too large resulting in high water absorption. Comparisons between the composition of the two waste products and the aggregates showed a significant loss of fluorine (40-60%) during processing; a problem which may require flue gas treatment. Leach testing showed that the formed aggregates would not pose a human or environmental hazard in terms of fluorine mobilization.