Seasonal variation of monoterpene emission rate in a pine forest

A technique to observe terpene emission rate in a forest without disturbing the environment of plant, was developed, and the seasonal variation of monoterpene emission rate from a branch in a pine forest was measured.     

Strontium isotope constraints on the seasonal variation of the provenance of base cations in rain water at Kawakami, Central Japan

The ⁸⁷Sr/⁸⁶Sr ratios in monthly precipitation in the forested basin at Kawakami, central Japan, varied seasonally from 0.709 to 0.711 in spring to as low as 0.7062 ± 0.0004 in autumn over nine years from 1987 to 1995. The seasonal variation can be explained in terms of the mixing of three sources of Sr: sea salt (⁸⁷Sr/⁸⁶Sr 0.70917), soluble eolian minerals originating from deserts in continental Asia ( 0.711), and biogenic materials growing on soils derived from the volcanic rock substrates in the vicinity ( 0.706). It is estimated that the contribution of sea-salt Sr into the Kawakami rain Sr is relatively constant (10 ± 5%) and that more than half of the Sr is of biogenic origin throughout the year except during spring rains when 50% of the Sr is due to the dissolution of Ca-minerals from Asian dusts. The dominant contribution of eolian components to spring rains is consistent with the high concentration of ³H, which is typical of air masses from Asia.     

A hydrodynamic study of a modified model of the Clarke Jet Net

A hydrodynamic study of a modified model of the Clarke Jet Net, a high speed plankton sampler, was made using a wind tunnel and an IBM 7040. Modifications allowed a somewhat larger amount of water filtered than in the original model. By adjusting the size of the net chamber exhaust (water control aperture), an average net chamber velocity of about 100 cm/sec could be obtained at any cruising speed. The curvature of the towing cable of the deep tow of a high speed sampler seemed to be determined mainly by the cable characteristics. The stability, vertical and horizontal, of the modified model was satisfactory.Contribution No. 218 from the Seikai Regional Fisheries Research Laboratory, Nagasaki.     

Experimental study on flow analysis and energy loss around discontinued vertically layered vegetation

Environmental Fluid Mechanics - Vegetation acts as a natural protection measure as it reduces inundation depth downstream of it and dissipates the energy of flow like flood and tsunami. The present...     

Development of a Practical Method to Detect Noroviruses Contamination in Composite Meals

Various methods to detect foodborne viruses including norovirus (NoV) in contaminated food have been developed. However, a practical method suitable for routine examination that can be applied for the detection of NoVs in oily, fatty, or emulsive food has not been established. In this study, we developed a new extraction and concentration method for detecting NoVs in contaminated composite meals. We spiked NoV-GI.4 or -GII.4 stool suspension into potato salad and stir-fried noodles. The food samples were suspended in homogenizing buffer and centrifuged to obtain a food emulsion. Then, anti-NoV-GI.4 or anti-NoV-GII.4 rabbit serum raised against recombinant virus-like particles or commercially available human gamma globulin and Staphylococcus aureus fixed with formalin as a source of protein A were added to the food emulsion. NoV-IgG-protein A-containing bacterial complexes were collected by centrifugation, and viral RNA was extracted. The detection limits of NoV RNA were 10–35 copies/g food for spiked NoVs in potato salad and stir-fried noodles. Human gamma globulin could also concentrate other NoV genotypes as well as other foodborne viruses, including sapovirus, hepatitis A virus, and adenovirus. This newly developed method can be used as to identify NoV contamination in composite foods and is also possibly applicable to other foodborne viruses.     

Environmental impact evaluation of feeds prepared from food residues using life cycle assessment

There is increasing concern about feeds prepared from food residues (FFR) from an environmental viewpoint; however, various forms of energy are consumed in the production of FFR. Environmental impacts of three scenarios were therefore investigated and compared using life cycle assessment (LCA): production of liquid FFR by sterilization with heat (LQ), production of dehydrated FFR by dehydration (DH), and disposal of food residues by incineration (IC). The functional unit was defined as 1 kg dry matter of produced feed standardized to a fixed energy content. The system boundaries included collection of food residues and production of feed from food residues. In IC, food residues are incinerated as waste, and thus the impacts of production and transportation of commercial concentrate feeds equivalent to the FFR in the other scenarios are included in the analysis. Our results suggested that the average amounts of greenhouse gas (GHG) emissions from LQ, DH, and IC were 268, 1073, and 1066 g of CO(2) equivalent, respectively. The amount of GHG emissions from LQ was remarkably small, indicating that LQ was effective for reducing the environmental impact of animal production. Although the average amount of GHG emissions from DH was nearly equal to that from IC, a large variation of GHG emissions was observed among the DH units. The energy consumption of the three scenarios followed a pattern similar to that of GHG emissions. The water consumption of the FFR-producing units was remarkably smaller than that of IC due to the large volumes of water consumed in forage crop production.     

Trace elements accumulation and their variations with growth, sex and habitat: effects on Formosan squirrel (Callosciurus erythraeus)

Formosan squirrels are considered a useful bio-indicator because their habitat exists within that of humans. Therefore, concentrations of 19 trace elements were determined in tissues of this species for assessment of environmental pollution in urban Kamakura and rural Izuohshima. Results of analyses revealed high Cu concentrations in the livers of Formosan squirrels. Moreover, concentrations of some trace elements from automobile exhausts-V, Zn, Cu and As-in the specimens from Kamakura were higher than those from Izuohshima. These results reflect the presence of pollution caused by human activities in Kamakura.     

Microbial Poly(L-Lactide)-Degrading Enzyme Induced by Amino Acids, Peptides, and Poly(L-Amino Acids)

Poly(L-lactide)(PLA)-degrading activities of a fungus, Tritirachium album, and two strains of actinomycetes,Lentzea waywayandensis and Amycolatopsis orientalis, were inducible by some proteins (poly-L-amino acid), peptides and amino acids. Extracellular PLA-degrading activity of the culture filtrates was detected when these strains grew in liquid basal medium containing 0.1% (w/v) of (poly-L-amino acids), peptides or amino acids as the enzyme inducer. In addition to PLA-degrading activity, succinyl-(L-alanyl-L-alanyl-L-alanine)-p-nitroanilide (Suc-(Ala)₃-pNA)-degrading activity was observed, implying that the enzymes produced were protease-type. The enzyme activities produced varied between different strains and different inducers. Silk fibroin was the best inducer for A. orientalis and that elastin was the best inducer for L. waywayandensis and T. album.     

Distribution behavior of pyrene to adsorbed humic acids on kaolin

The distribution behavior of pyrene on humic acid (HA)-kaolin complexes, prepared by adsorbing HA on kaolin, was investigated by batch experiments. The distribution coefficient (Kd) of pyrene on the HA-kaolin complex increased with the fraction (f(oc)) of organic carbon adsorbed to the surface of the kaolin. This can be attributed to hydrophobic interactions between pyrene and the adsorbed HAs. The effects of adsorbed HAs were quantitatively evaluated by calculating the distribution coefficient (K(oc)) and affinity constant (K(oc)ads) for pyrene to the adsorbed HAs. A fluorescence quenching method was employed to determine the affinity constant (K(oc)aq) of pyrene to HAs dissolved in an aqueous solution. When the K(oc) values were compared with the K(oc)aq values, the K(oc) values were found to be 4 to 11 times larger than the K(oc)aq values. On the other hand, the K(oc)ads values were 4 to 9 times larger than the K(oc)aq values. These indicate that the affinity for pyrene is enhanced by the adsorption of HAs to kaolin. In addition, the K(oc) values increased with increasing average molecular weights of the HAs. These results demonstrate that HAs, when they are adsorbed to clay minerals, play an important role in the deposition of polycyclic aromatic hydrocarbons (PAHs) in a soil environment.     

Preparation and characteristics of high performance paper containing titanium dioxide photocatalyst supported on inorganic fiber matrix

A novel paper-based material containing titanium dioxide (TiO₂) photocatalyst was successfully prepared by a papermaking technique with the internal addition of inorganic fibers on which TiO₂ particles were supported. Photodegradation performance of acetaldehyde gas, an indoor pollutant, and the durability of the TiO₂-containing papers were investigated under UV irradiation. Ceramic fiber suspension and polydiallyldimethylammonium chloride as a cationic flocculant were mixed, followed by the addition of TiO₂ suspension and anionic polyacrylamide. Subsequently, the inorganic mixture was poured into a pulp suspension, and TiO₂ handsheets then prepared by a papermaking method. The tensile strength of TiO₂-containing paper without a ceramic carrier decreased by more than 30% after 240-h UV irradiation (2 mW/cm²), although the strength of the TiO₂ sheet with ceramic fibers remained reasonably stable. The efficiency of acetaldehyde decomposition by the TiO₂ paper containing an inorganic carrier was nearly equal to that of the carrier-free TiO₂ paper. Scanning electron microscopic observation suggested that most TiO₂ particles were predominantly supported on the inorganic fiber matrix, and were mostly out of contact with organic pulp fibers. The TiO₂ paper with an inorganic carrier demonstrated both excellent photocatalytic performance and durability, which before had been mutually incompatible for organic materials containing TiO₂ photocatalyst. The two-stage mixing procedure for TiO₂ sheet-making is promising for the simple manufacture of high performance paper with photocatalytic ability.