Heavy metal pollution in vegetables grown in the vicinity of a multi-metal mining area in Gejiu,China: total concentrations,speciation analysis,and health risk

A field survey was conducted to investigate the present situation and health risk of arsenic (As), lead (Pb), cadmium (Cd), copper (Cu), and zinc (Zn) in soils and vegetables in a multi-metal mining area, Gejiu, China. Furthermore, three vegetables (water spinach, potato, and summer squash) containing high metal concentrations were selected to further analyze metal speciation. The results showed that the average concentrations of five metals in soil exceeded the limiting values, and their bioavailable concentrations were significantly positively correlated to the total ones. Heavy metals in the edible parts of vegetables also exceeded the corresponding standards. The leaves of pakchoi, peppermint, and coriander had a strong metal-accumulative ability and they were not suitable for planting. Except the residue forms, the main forms of metals in the edible parts of three selected vegetables were ethanol-, NaCl-, and HAc-extractable fractions for As, Pb, and Cd, respectively; however, Cu was mainly presented as NaCl-extractable and Zn as HAc-extractable fractions. A high proportion of ethanol-extractable As showed that As bioactivity and toxic effects were the highest. Although the total and bioavailable Cd were high in soil, its speciation in vegetables was mainly presented as HAc-extractable fraction, which has a relatively low bioactivity. Lead and arsenic were imposing a serious threat on the local residents via vegetable consumption.     

拉索预应力空间网格结构的索张力计算及张拉全过程分析

实际工程中,对于拉索预应力空间网格结构的索张拉是一个需要反复调整的繁琐过程。对此,提出了一种针对多阶段多批次张拉施工全过程分析的计算方法,用以提高索张拉施工的效率。该法通过不断减小拉索实际张力与目标张力的差值来求解各索在张拉过程中应该产生的初始应变,最后只要利用计算结果并按照预定的顺序张拉,便可使所有索只经过一次张拉就能最终达到各自的目标张力值。对一个150 m跨度的拉索预应力球面巨型网格结构进行了计算,并利用计算结果,对结构的杆件内力和最大节点位移进行了张拉全过程跟踪分析。结果表明,在实际工程中采用上述方法进行计算与张拉是切实可行的,另外,在张拉过程中进行跟踪分析十分必要。     

River channel network design for drought and flood control: A case study of Xiaoqinghe River basin, Jinan City, China

Vulnerability of river channels to urbanization has been lessened by the extensive construction of artificial water control improvements. The challenge, however, is that traditional engineering practices on isolated parts of a river may disturb the hydrologic continuity and interrupt the natural state of ecosystems. Taking the Xiaoqinghe River basin as a whole, we developed a river channel network design to mitigate river risks while sustaining the river in a state as natural as possible. The river channel risk from drought during low-flow periods and flood during high-flow periods as well as the potential for water diversion were articulated in detail. On the basis of the above investigation, a network with “nodes” and “edges” could be designed to relieve drought hazard and flood risk respectively. Subsequently, the shortest path algorithm in the graph theory was applied to optimize the low-flow network by searching for the shortest path. The effectiveness assessment was then performed for the low-flow and high-flow networks, respectively. For the former, the network connectedness was evaluated by calculating the “gamma index of connectivity” and “alpha index of circuitry”; for the latter, the ratio of flood-control capacity to projected flood level was devised and calculated. Results show that the design boosted network connectivity and circuitry during the low-flow periods, indicating a more fluent flow pathway, and reduced the flood risk during the high-flow periods.     

悬浮载体生物膜工艺挂膜试验研究

悬浮载体挂膜需经历微生物在载体表面可逆吸附-不可逆吸附-固着态生长的过程.试验研究发现,悬浮载体挂膜效果受载体性质、环境因素、接种污泥活性及悬浮微生物浓度等多种因素影响,而控制较低的悬浮态微生物浓度,保证固着态微生物的优势生长,是挂膜能否成功的关键.在适宜的温度和操作条件下,经历20 d左右时间可完成悬浮载体挂膜.     

Fenton氧化法深度处理抗生素废水二级出水

采用Fenton氧化法对青霉素和土霉素混合废水二级处理出水进行深度处理,通过正交和单因素实验研究了废水初始反应pH值、H2O2投加量、Fe2+/H2O2摩尔比及反应时间等因素对废水处理效果的影响。实验结果表明,Fenton氧化法处理的最佳反应条件为:初始pH值4、H2O2(30%)投加量50 mL/L、Fe2+/H2O2摩尔比1/20和反应时间60 min,处理后出水COD小于120 mg/L,COD去除率在75%以上,急性毒性(HgCl2毒性当量)小于0.07 mg/L,满足《发酵类制药工业水污染物排放标准》(GB21903-2008)表2标准要求。     

机械清洗法对MBR膜泥饼层的影响

膜污染是制约MBR发展的瓶颈。考察投加ABS颗粒对MBR膜组件上膜泥饼层的影响,并设对照实验。结果表明,对照MBR膜通量下降速度快,膜污染严重,膜表面上累积厚厚的泥饼层,而在ABS MBR中膜通量下降速度则缓慢的多,且膜上泥饼层积累量则明显少于对照MBR;曝气量越大,颗粒运行的速度也越快,泥饼层被撞落量也越多;颗粒以碰撞角度为45°冲刷膜的情况下,泥饼层掉落效果明显增加;泥饼层包裹的膜丝根数越多,泥饼层的静摩擦力和保持泥饼层不被破坏的力也越大,泥饼层就越难被冲刷掉。SEM照片显示,ABS MBR的膜孔堵塞要严重于对照MBR,表面的褶皱要较对照MBR多。     

新疆油田抽汲排液污染控制研究

抽汲排液存在抽汲设备和工具密封性差,对井场环境污染比较严重的问题,为解决抽汲排液对井场造成的污染,分别对抽汲钢丝绳的选择、试油井口防喷盒的密封以及试油抽汲作业规程及其它方面作了研究和应用,使抽汲排液对井场造成的污染得到了较好控制,符合新疆油田创建"绿色油气田"的要求。     

Phytoremediation of the polluted Waigang River and general survey on variation of phytoplankton population

The Waigang River, a major tributary of the Qinhuai River system, has suffered from long-standing pollution because of lack of management. Restoration was commenced in April 2006 to reduce pollutants and improve water quality. Four ecological areas and ten surface carriers were constructed for the culture of plants (mainly water hyacinth (Eichhornia crassipes) and ryegrass (Lolium perenne L.)) for phytoremediation. Chemical oxygen demand (COD), total suspended solids (TSS), total phosphorus, total nitrogen (TN), ammonia?Cnitrogen (NH₃?CN), water transparency, and variations in phytoplankton population were investigated to evaluate the effects of restoration. Over 36?months, TSS, COD, TN, and NH₃?CN levels decreased by 91.1, 55.3, 91.5, and 86.5?%, respectively. Transparency increased from 25?cm in 2006 to 165?cm in 2009. Improvements in water quality significantly enhanced the diversity of phytoplankton, which were harmed by pollution stress. Our results show that the water hyacinth and ryegrass cultured in the ecological areas and the surface carriers can be used to restore other heavily polluted rivers with conditions similar to those of the Waigang River, especially in the initial stages of restoration.     

高分子量高纯度阳离子聚丙烯酰胺的合成

以丙烯酰胺与丙烯酰氧乙基三甲基氯化铵为单体,在复合引发剂的作用下,选择水溶液共聚法合成高分子量与高纯度阳离子型聚丙烯酰胺(CPAM)。实验表明,有机偶氮引发剂A用量0.5‰、氧化还原引发剂用量0.45‰、还原剂与氧化剂摩尔比2∶1、反应体系pH为4与反应时间5 h条件下,CPAM分子量为1 042万,且溶解性好。通过对聚合物残单含量影响因素添加剂用量、反应时间的研究,结果表明,添加剂EDTA和增溶剂D对残留AM含量影响小,而苯甲酸钠对聚合物残留AM的含量影响显著;延长反应时间至7 h,残单含量可降低至0.27%,CPAM的纯度高。通过与国内外3种同类型产品进行对比,结果表明,自制产品的分子量明显高于其他产品,且残单含量比国内产品降低了50%～75%。     

非离子型聚丙烯酰胺絮凝剂的制备及其絮凝性能

以丙烯酰胺（AM）和烷基酚聚醚（APAP）为单体,采用反相乳液聚合法制备了流动性好的非离子型聚丙烯酰胺絮凝剂（PAM-APAP）。考察了乳化剂和引发剂的种类、单体总质量分数、单体配比和反应温度等因素对聚合反应的影响。实验结果表明,制备PAM-APAP的最佳工艺条件为：单体总质量分数35%、m（AM）∶m（APAP）=9.0∶1.0、Span80+Tween80复配乳化剂加入量为油水总质量的7%、m（Span80）∶m（Tween80）=7.0∶1.5、V50加入量为单体总质量的1.5‰、反应温度50℃。PAM-APAP具有较好的絮凝效果,与其他絮凝剂相比用量较少,在加入量为100mg/L时,对聚合物驱油中产生的含聚合物污水的浊度去除率为87.9%,去油率为89.5%,且絮体不黏壁。