等浓度配比法研究苯酚、硝基苯和问硝基苯胺对发光菌的联合毒性作用

分别测定了苯酚、硝基苯和间硝基苯胺对发光菌的单一毒性，以及等浓度配比和等毒性配比的二元及三元混合体系的联合毒性，采用相加指数法对其联合效应进行了评价。结果表明，等浓度比和等毒性比混合体系的联合作用结果一致：苯酚＋间硝基苯胺二元体系为协同作用，其他各体系为相加作用。为简化联合毒性实验方法，建议在研究相关系列化合物的联合毒性作用机制中，可采用等浓度配比方法。     

脉冲放电烟气脱硫脱硝技术研究进展

综述了脉冲放电等离子体烟气脱硫脱硝技术的发展历史、研究现状、进展及其存在的问题.     

SBR法降解有机物规律的研究

本研究是以处理啤酒废水的试验为基础展开的。试验结果进一步验证了SBR法具有简易,快速、低耗等优点。除此之外,还得出以下结论:增加间歇反应时起始污泥浓度可以提高处理效率或减少反应时间;非限制曝气方式耐冲击负荷,需氧均匀,能缩短反应周期;间歇反应中微生物细胞的合成代谢占主导地位,对氮与磷的需要量大于传统的理论值。本文还指出SBR法是很适合我国国情的一种废水处理工艺,应当加强对它的研究和推广应用。     

水污染·水资源·对策

本文详细论述了中国和世界的水资源状况，并论述了中国的水资源短缺状况、中国用水的优劣势，以及如何解决中国水资源短缺的措施和基本战略。     

臭氧-曝气生物滤池处理酸性玫瑰红染料废水

在实验室配制含酸性玫瑰红染料的印染废水，采用臭氧氧化-曝气生物滤池工艺开展处理试验。试验运行结果表明，臭氧氧化处理能提高模拟废水的可生化性，BOD／COD值由原水的0．18上升到0．36。经组合工艺处理后出水COD〈40mg／L，色度40倍以下，SS约50mg／L，处理效果良好。     

接种厌氧消化污泥EGSB反应器的快速启动

对接种市政消化污泥的EGSB反应器的启动进行实验研究以寻求快速启动EGSB反应器的有效方法。接种厌氧消化污泥EGSB反应器的成功启动仅需要46d。在整个启动期保持适当的液体上升流速是非常重要的。启动初期，高液体上升流速能够将悬浮污泥冲出反应器，使适合聚集的微生物留在反应器内。接下来需要降低进水流量和液体上升流速以利于构建稳定的微生态系统，使高活性颗粒污泥尽快形成。然后适当提高液体上升流速能保持污水与微生物的良好接触，促进颗粒污泥内外高效传质，形成更加稳定高效的微生物群落结构。为尽快形成高活性颗粒污泥，保证产甲烷菌的最佳营养需求是关键，可通过考虑进水基质、微量营养元素和硫化物来提高其活性。     

Effect of surfactants at low concentrations on the sorption of atrazine by natural sediment.

A series of experiments were carried out to determine the effect of surfactants at low concentrations on the sorption of atrazine by natural sediments. With surfactant concentrations ranging from 0 to 20 mg/ L, anionic and cationic surfactants appreciably reduce the adsorption of atrazine, while nonionic surfactant decreases the adsorption of atrazine at concentrations equal to or less than 1 mg/L and increases adsorption at higher concentrations. Desorption of atrazine in the presence of different sodium dodecylbenzene sulfonate (SDBS) concentrations shows that a portion of the bound pesticide resists desorption in the SDBS free system. However, the addition of SDBS accelerates the desorption of atrazine. Furthermore, the nature of sediment and the contacting sequence of SDBS, at 10 mg/L, with the sediment, also influence the adsorption of atrazine. The conclusions in this study could be explained partially by the effect of the type and concentration of surfactants and the characteristics of sediments.     

研究星载IPDA激光雷达探测CO2光谱纯度

光谱纯度是积分路径差分吸收激光雷达最重要的系统参数之一,光谱纯度直接影响CO₂数据的探测精度.在模式研究中要求输入观测的CO₂数据误差小于1×10^-6,对激光器光谱纯度参数设计提出很高要求.本文采用有效吸收截面分析探测反演误差的方法,研究了由光谱纯度带来的CO₂柱浓度探测误差,并基于窄带滤波器对光谱不纯能量的抑制作用,对不同带宽的窄带滤波器进行选择和分析,从而达到降低对光谱纯度的要求,提升探测精度的目的,最后讨论了由于窄带滤波器造成的能量衰减所对随机误差的影响.结果表明：当光谱纯度为99.9%,窄带滤波器带宽1GHz,透射率为0.86,脉冲能量为100mJ时CO₂探测的系统误差小于0.084×10^-6,随机误差小于0.02×10^-6,满足探测精度要求.     

Observation and analysis of atmospheric volatile organic compounds in a typical petrochemical area in Yangtze River Delta, China

Volatile organic compounds (VOCs) are a kind of important precursors for ozone photochemical formation. In this study, VOCs were measured from November 5th, 2013 to January 6th, 2014 at the Second Jinshan Industrial Area, Shanghai, China. The results showed that the measured VOCs were dominated by alkanes (41.8%), followed by aromatics (20.1%), alkenes (17.9%), and halo-hydrocarbons (12.5%). The daily trend of the VOC concentration showed a bimodal feature due to the rush-hour traffic in the morning and at nightfall. Based on the VOC concentration, a receptor model of Positive Matrix Factorization (PMF) coupled with the information related to VOC sources was applied to identify the major VOC emissions. The result showed five major VOC sources: solvent use and industrial processes were responsible for about 30% of the ambient VOCs, followed by rubber chemical industrial emissions (23%), refinery and petrochemical industrial emissions (21%), fuel evaporations (13%) and vehicular emissions (13%). The contribution of generalized industrial emissions was about 74% and significantly higher than that made by vehicle exhaust. Using a propylene-equivalent method, alkenes displayed the highest concentration, followed by aromatics and alkanes. Based on a maximum incremental reactivity (MIR) method, the average hourly ozone formation potential (OFP) of VOCs is 220.49?ppbv. The most significant source for ozone chemical formation was identified to be rubber chemical industrial emissions, following one by vehicular emission. The data shown herein may provide useful information to develop effective VOC pollution control strategies in industrialized area.     

Soot reduction by addition of dimethyl carbonate in normal and inverse ethylene diffusion flames: Nanostructural evidence

Oxygenated fuel represents an attractive alternative as an additive for reducing soot emissions.Dimethyl carbonate(DMC) is an oxygenated compound which is a good option to reduce soot,but the detailed characteristics of soot produced from combustion of hydrocarbon fuels blended with DMC are still lacking. The present research studied the nanostructure and reactivity of soot particles in ethylene/DMC normal and inverse diffusion flames. High resolution transmission electron microscopy(HRTEM), X-ray diffraction(XRD), and thermogravimetric analysis(TGA)were used to analyze the nanostructure and reactivity of soot. It was found that DMC addition was effective in decreasing the average weights of soot formed in flames. The results of HRTEM images showed that soot particles obtained with DMC addition showed liquid-like material and tight bonding, and exhibited more highly disorganized layers, which give it higher reactivity than soot obtained without DMC addition. Furthermore, HRTEM was used to analyze soot fringe characteristics consisting of fringe tortuosity, fringe length, and fringe separation. XRD was used to crosscheck the results for fringe separation, and was consistent with HRTEM results. In addition, the mass loss curve of TGA experiments showed that DMC addition could enhance the reactivity of soot particles.