Location and migration of cations in Cu(2+)-adsorbed montmorillonite

Locations of Cu2+ ion in Cu(2+)-adsorbed montmorillonite have been studied by electron paramagnetic resonance (EPR), supplemented by X-ray diffraction (XRD) and differential thermal analysis (DTA). In the EPR spectra of Cu(2+)-adsorbed montmorillonite, three signals, corresponding to Cu2+ ion, have been simultaneously recorded. Some Cu2+ ions seemed to replace the original interlayer metal cations and some entered into the hexagonal cavities. A small fraction of Cu2+ ions penetrated into the octahedral vacancies. There were two ways for the adsorption of Cu2+ ion by montmorillonite--exchangeable and specific. On heating, the hydrated Cu2+ ion in the interlayer loses the coordinating water and then enters into the hexagonal cavities. When the heating temperature further increased, dehydroxylation occurs, which facilitates Cu2+ ion in the hexagonal cavities to penetrate into the octahedral vacancies.     

Greenhouse gas emissions from MSW incineration in China: Impacts of waste characteristics and energy recovery

Determination of the amount of greenhouse gas (GHG) emitted during municipal solid waste incineration (MSWI) is complex because both contributions and savings of GHGs exist in the process. To identify the critical factors influencing GHG emissions from MSWI in China, a GHG accounting model was established and applied to six Chinese cities located in different regions. The results showed that MSWI in most of the cities was the source of GHGs, with emissions of 25–207 kg CO₂-eq t^?1 rw. Within all process stages, the emission of fossil CO₂ from the combustion of MSW was the main contributor (111–254 kg CO₂-eq t^?1 rw), while the substitution of electricity reduced the GHG emissions by 150–247 kg CO₂-eq t^?1 rw. By affecting the fossil carbon content and the lower heating value of the waste, the contents of plastic and food waste in the MSW were the critical factors influencing GHG emissions of MSWI. Decreasing food waste content in MSW by half will significantly reduce the GHG emissions from MSWI, and such a reduction will convert MSWI in Urumqi and Tianjin from GHG sources to GHG sinks. Comparison of the GHG emissions in the six Chinese cities with those in European countries revealed that higher energy recovery efficiency in Europe induced much greater reductions in GHG emissions. Recovering the excess heat after generation of electricity would be a good measure to convert MSWI in all the six cities evaluated herein into sinks of GHGs.     

工程建设过程中人为失误的原因分析及预防探讨

分析了工程建设过程中常见的人为失误,以及人为失误产生的根源,从技术和管理两方面探讨了人为失误的预防和控制措施,以期达到有效管控事件发生,确保工程建设过程安全的目的.     

Global Trend of Low-carbon Economy and China's Responses

Based on the analysis on the global economic crisis,climate change crisis and their mutual underlying reasons,the authors believe that low-carbon economy has become an inevitable choice to break through the dual crises,coordinate the economic development,and protect the global climate.The global trend of low-carbon economy finds expression in Green Recovery currently,while,in a long run,it will give rise to a new pattern of world competition in politics,economy,technology,trade and finance.The impact of the...     

大型锅炉房的噪声监测与治理

对大型锅炉房(燃煤、燃气、燃油)的噪声源进行测试分析．给出了隔声、吸声、消声量的计算公式．同时针对燃煤、燃油、燃气锅炉房的噪声污染．采取了不同的治理措施．取得了较好的治理效果。     

Measurement of air exchange rates in different indoor environments using continuous CO2 sensors

A new air exchange rate (AER) monitoring method using continuous CO₂ sensors was developed and validated through both laboratory experiments and field studies. Controlled laboratory simulation tests were conducted in a 1-m³ environmental chamber at different AERs (0.1-10.0 hr^-1). AERs were determined using the decay method based on box model assumptions. Field tests were conducted in classrooms, dormitories, meeting rooms and apartments during 2-5 weekdays using CO₂ sensors coupled with data loggers. Indoor temperature, relative humidity (RH), and CO₂ concentrations were continuously monitored while outdoor parameters combined with on-site climate conditions were recorded. Statistical results indicated that good laboratory performance was achieved: duplicate precision was within 10%, and the measured AERs were 90%-120% of the real AERs. Average AERs were 1.22, 1.37, 1.10, 1.91 and 0.73 hr^-1 in dormitories, air-conditioned classrooms, classrooms with an air circulation cooling system, reading rooms, and meeting rooms, respectively. In an elderly particulate matter exposure study, all the homes had AER values ranging from 0.29 to 3.46 hr??1 in fall, and 0.12 to 1.39 hr^-1 in winter with a median AER of 1.15.     

Ammonium-dependent regulation of aerobic methane-consuming bacteria in landfill cover soil by leachate irrigation

The impacts of landfill leachate irrigation on methane oxidation activities and methane-consuming bacteria populations were studied by incubation of landfill cover soils with leachate and (NH₄)₂SO₄ solution at different ammonium concentrations. The community structures and abundances of methane-oxidizing bacteria (MOB) and ammonia-oxidizing bacteria (AOB) were examined by PCRDGGE and real-time PCR. Compared with the pure (NH₄)₂SO₄ solution, leachate addition was found to have a positive effect on methane oxidation activity. In terms of the irrigation amount, ammonium in leachate was responsible for the actual inhibition of leachate. The extent of inhibitory effect mainly depended on its ammonium concentration. The suppression of the predominant methaneconsuming bacteria, type I MOB, was responsible for the decreased methane oxidation activity by ammonium inhibition. Methaneconsuming bacteria responded diversely in abundance to ammonium. The abundance of type I MOB decreased by fivefold; type II MOB showed stimulation response of fivefold magnification upon the first addition but lessened to be lower than the original level after the second addition; the amount of AOB was stimulated to increase for 20-30 times gradually. Accumulated nitrate from nitrification strengthened the ammonium inhibition on type I and type II MOB, as a result, repetitive irrigation was unfavorable for methane oxidation.     

Effects of rare earth elements La and Yb on the morphological and functional development of zebrafish embryos

In recent years, with the wide applications and mineral exploitation of rare earth elements, their potential environmental and health effects have caused increasing public concern. Effect of rare earth elements La and Yb on the morphological and functional development of zebrafish embryos were studied. The embryos were exposed to La³⁺ or Yb³⁺ at 0, 0.01, 0.1, 0.3, 0.5 and 1.0 mmol/L, respectively. Early life stage parameters such as egg and embryo mortality, gastrula development, tail detachment, eyes, somite formation, circulatory system, pigmentation, malformations, hatching rate, length of larvae and mortality were investigated. The results showed La³⁺ and Yb³⁺ delayed zebrafish embryo and larval development, decreased survival and hatching rates, and caused tail malformation in a concentration-dependent way. Moreover, heavy rare-earth ytterbium led to more severe acute toxicity of zebrafish embryo than light rare-earth lanthanum.     

Operating condition influences on PCDD/Fs emissions from sinter pot tests with hot flue gas recycling

This study was designed to clarify the influence of operating conditions on the formation and emissions of polychlorinated-pdibenzodioxins and dibenzofurans (PCDD/Fs) from a sintering process with hot flue gas recycling. A pilot scale sinter pot with simulated flue gas recycling was developed, and four key operational parameters, including temperature, oxygen content of the simulated waste flue gas, the coke rate of the sintering mixture, and the quicklime quality, were selected for exploring PCDD/Fs formation. The results showed that the temperature of the recycled flue gas had a major affect on PCDD/Fs formation, and a high temperature could significantly increase their formation during sintering. A clear linear correlation between the temperature of recycling flue gas and PCDD/Fs emission (r = 0.93) was found. PCDD/Fs could be reduced to a certain extent by decreasing the level of oxygen in the recycled flue gas, while sintering quality was unchanged. The coke rate had no significant influence on the formation of PCDD/Fs, but the quality of quicklime used in the sintering mixture could affect not only the amount of PCDD/Fs emissions but also the sintering productivity. Compared with a benchmark sinter pot test, PCDD/Fs emissions markedly decreased with improvements to quicklime quality. However, the reduction in PCDD/Fs emissions realized by using high-quality quicklime was limited by the temperature of the inlet gas. The highest reduction achieved was 51% compared with conventional quicklime when the temperature of the inlet gas was 150°C.     

Three-dimensional hydrodynamic and water quality model for TMDL development of Lake Fuxian, China

Lake Fuxian is the largest deep freshwater lake in China. Although its average water quality meets Class I of the China National Water Quality Standard (CNWQS), i.e., GB3838-2002, monitoring data indicate that the water quality approaches the Class II threshold in some areas. Thus it is urgent to reduce the watershed load through the total maximum daily load (TMDL) program. A three-dimensional hydrodynamic and water quality model was developed for Lake Fuxian, simulating flow circulation and pollutant fate and transport. The model development process consists of several steps, including grid generation, initial and boundary condition configurations, and model calibration processes. The model accurately reproduced the observed water surface elevation, spatiotemporal variations in temperature, and total nitrogen (TN), total phosphorus (TP), and chemical oxygen demand (COD) concentrations, suggesting a reasonable numerical representation of the prototype system for further TMDL analyses. The TMDL was calculated using two interpretations of the water quality standards for Class I of the CNWQS based on the maximum instantaneous surface and annual average surface water concentrations. Analysis of the first scenario indicated that the TN, TP and COD loads should be reduced by 66%, 68% and 57%, respectively. Water quality was the highest priority; however, local economic development and cost feasibility for load reduction can pose significant issues. In the second interpretation, the model results showed that, under the existing conditions, the average water quality meets the Class I standard and therefore load reduction is unnecessary. Future studies are needed to conduct risk and cost assessments for realistic decision-making.