Improving the activity of Mn/TiO2 catalysts through control of the pH and valence state of Mn during their preparation

In this study, the authors investigated the influence of the valence state of Mn on the efficacy of selective catalytic reduction using a Mn-based catalyst. The nitrogen oxides (NOx) conversion rate of the catalyst was found to be dependent on the type of TiO2 support employed and on the temperature, as the catalyst showed an excellent conversion of > 80% at a space velocity of 60,000 hr(-1) when the temperature was above 200 degrees C. Brunauer-Emmett-Teller, X-ray diffraction, and X-ray photoelectron spectroscopy analyses confirmed that catalyst displaying the highest activity contained the Mn4+ species and that its valence state was highly dependent on the pH during the catalyst preparation.     

Physicochemical properties of chars at different treatment temperatures

In this study, the physicochemical properties of the char of Indonesian SM coal following heat treatment at various temperatures were evaluated using X-ray photoelectron spectroscopy (XPS), Fourier-transform infrared spectroscopy (FT-IR), scanning electron microscopy (SEM), and morphological and specific surface area analysis. Based on these analyses, heat treatment of coal was determined to be the most effective in increasing the coal rank. In the XPS analysis, the C-O and C-O-C groups and quaternary-N species were found to be of a lower grade coal when the pretreatment temperature decreased, meanwhile the C-C group and pyridinic species increased. In the FT-IR analysis, the collapse of the C-O and C-O-C group was observed due to the collapse of the ether group. In SEM and Brunauer-Emmett-Teller (BET) analysis, a decrease in the ether group was shown to be accompanied with the formation of micropores.     

阴极液及底物浓度对AFB-MFC同步废水处理及产电性能影响

为了提高厌氧流化床微生物燃料电池（AFB-MFC）的性能,并为双室MFC寻找价廉、易得、无污染的阴极液,在曝气量16～24 L/h、温度（35±2）℃、回流量10.2 L/h、阴极底边距阴极室内底部17.3 cm、外电阻250 Ω、水力停留时间（HRT）14.0～14.9 h以及进水pH 7.81～8.37下,研究了阴极液及底物浓度对系统产电及废水处理性能的影响。结果表明,使用缓冲溶液、阳极室出水和自来水作阴极液时,自来水的产电性能最佳,阴极液种类不影响系统有机基质的去除。以自来水为阴极液时,阴极液pH及电导率随运行时间增加而增加,COD去除率为80.11%～89.29%,输出电压及功率密度开始随运行时间增加而增加,之后稳定在440～452 mV和48.40～51.08 mW/m²之间。增加底物浓度对COD去除率影响不大,而输出电压及功率密度随底物浓度增加而下降;底物COD浓度由3 307.09 mg/L增至9 520 mg/L时,COD去除率在85.77%～94.44%之间,输出电压及功率密度则分别由449 mV和50.40 mW/m²下降至406 mV和41.21 mW/m²。自来水作阴极液可避免二次污染及阴极液对阳极室微生物的影响,并得到高的产电能力。     

基于人工蜂群算法与BP神经网络的水质评价模型

针对BP网络水质评价模型的不足,引入人工蜂群(ABC)算法,将求解BP神经网络各层权值、阀值的过程转化为蜜蜂寻找最佳蜜源的过程,提出了一种新的结合人工蜂群算法的BP网络水质评价方法(ABC-BP)。并以2000—2006年渭河监测断面的10组实测数据作为测试样本对其水质进行了评价,实验结果表明该方法得到的水质评价结果准确,并具有很强的稳定性和鲁棒性。     

应用表面活性剂-生物柴油微乳液去除污染土壤中多环芳烃

针对修复焦化厂高浓度多环芳烃污染土壤高成本的现实,采用以非食用性植物油、生物柴油、表面活性剂及其乳化合成的微乳液为淋洗剂,比较不同淋洗剂的淋洗效果。结果表明乳化合成的微乳液对焦化厂土壤中多环芳烃的总去除率高于单独使用表面活性剂为淋洗剂对土壤中多环芳烃的总去除率,说明生物柴油及植物油与表面活性剂乳化形成的微乳液对原污染土壤中的多环芳烃具有显著的增溶作用。1%TW-80和2.5%TW-80对土壤中多环芳烃总去除率分别为11%和14%;以2.5%TW-80为原料乳化合成的微乳液的淋洗去除率较以1%TW-80为原料乳化合成的微乳液高,总去除率分别为15%～30%和11%～18%;以生物柴油为原料乳化合成的微乳液的淋洗去除率较以植物油为原料乳化合成的微乳液高,分别为17%～30%和15%～23%,且对多环芳烃的去除率与其辛醇水分配系数(logKow)呈线性相关关系。     

电催化氧化技术处理制革综合废水

选择DSA电极中的钛基掺硼金钢石膜电极(Ti/BDD),用于制革综合废水的电催化氧化处理研究,考察了在不同的电流密度、电压、电解质、pH值和电解时间等因素对COD去除率和电流效率的影响。结果表明,控制电流密度为30mA/cm2,电压为8.0 V,电解质(NaCl)浓度为2.0 g/L,pH为4.0,电催化氧化处理2 h后,废水的COD和NH4+-N的去除率分别达到了83.6%和90.3%,BOD/COD为0.45,比能耗为35.34 kWh/kg COD,电流效率为37%。     

Adsorption behavior of light green anionic dye using cationic surfactant-modified wheat straw in batch and column mode

An agricultural by-product, natural wheat straw (NWS), was soaked in 1 % cationic surfactant (hexadecylpyridinium bromide, CPB) solution for 24 h (at 293 K), and modified wheat straw (MWS) was obtained. Analysis of FTIR, XFR, and nitrogen element showed that CPB was adsorbed onto surface of NWS. Then, MWS was used as adsorbent for the removal of light green dye (LG, anionic dye) from aqueous solution. The experiment was performed in batch and column mode at room temperature (293 K). Sodium chloride (up to 0.1 mol/L) existed in solution was not favor of LG dye adsorption. The equilibrium data were better described by Langmuir isotherm, and adsorption capacity of q _m from Langmuir model was 70.01?±?3.39 mg/g. In fixed-bed column adsorption mode, the effects of initial LG concentration (30, 50, 70 mg/L) and flow rate (6.5, 9.0, 14.5 mL/min) on adsorption were presented. Thomas and modified dose–response models were used to predict the breakthrough curves using nonlinear analysis method, and both models can fit the breakthrough curves. Theoretical and experimental breakthrough curves were drawn and compared. The results implied that MWS can be used as adsorbent material to remove LG from aqueous solution.     

Ti（Ⅳ）催化臭氧／过氧化氢预处理酸性难降解废水

在Ti（Ⅳ）和过氧化氢存在条件下,考察了臭氧化酸性苯乙酮溶液、硝基苯溶液和垃圾渗滤液（浙江衢州某垃圾填埋场）的预处理效能。结果表明,在pH2．86条件下,单独臭氧化处理对苯乙酮、硝基苯和垃圾渗滤液的COD去除率分别为10．1％、44％和28．6％。BOD,／COD值分别从原来的0．039、0．060和0．085提高到了0．130、0．158和0．174,仍属生化难降解废水。当体系加入Ti（Ⅳ）后,臭氧化苯乙酮和硝基苯的COD去除率分别达到了75．5％和65％,BOD;／COD则提高到了0．679和0．314,可生化性提升明显。对于垃圾渗滤液,只有当体系加入Ti（Ⅳ）和H22后,臭氧化COD的去除率达到66．6％,BOD、／COD提高至0．425。上述结果对酸性难降解废水的处理实际意义非常突出。     

Correlation of climatic factors and dengue incidence in Metro Manila, Philippines

Dengue is a serious public health problem in Metro Manila, Philippines. Increasing dengue incidence has been attributed to climate change; however, contradicting reports show inconclusive relationships between dengue and climatic factors. This study investigates temperature and rainfall as climatic factors affecting dengue incidence in Metro Manila from 1996 to 2005. Monthly dengue incidence and climatic data for Metro Manila were collected over a 10-y period (1996-2005). Climatic factors temperature and rainfall were linked with dengue incidence through regression analysis. A predictive model equation plots dengue incidence (Y) versus rainfall (X), which suggests that rainfall is significantly correlated to dengue incidence (r2 = 0.377, p < 0.05). No significant correlation between dengue incidence and temperature was established (p > 0.05). Evidence shows dengue incidence in Metro Manila varies with changing rainfall patterns. Intensified surveillance and control of mosquitoes during periods with high rainfall are recommended.     

NMR study of the humification process during sewage sludge treatment

Humic acids, extracted from sludge at the biologic-mechanical sewage treatment plant in Jastrzebie Zdroj, have been investigated by means of (1)H, (13)C and (31)P NMR spectroscopy. Sludge samples for studies were taken from the primary settling tank, the nitrification chamber, the digestion chamber and the sludge drying beds. The (1)H NMR analysis of humic acid extracted from sludge at various stages of sewage treatment confirmed the presence of the functional groups that are characteristic for humic substances, and the analysis showed changes in their relative intensities. The (13)C NMR indicated that the aromatisation of the humic acid increased during sewage treatment. Moreover, the analysis of the (31)P NMR spectra allowed us to observe the changes in the phosphorus groups of the studied humic acids.