Measurement of gas-phase total peroxides at the summit of Mount Tai in China

Measurement of ambient gas-phase total peroxides was performed at the summit of Mount Tai (Mt. Tai, 1534 m above sea level) in central-eastern China during March 22–April 24 and June 16–July 20, 2007. The hourly averaged concentration of peroxides was 0.17 ppbv (± 0.16 ppbv, maximum: 1.28 ppbv) and 0.55 ppbv (± 0.67 ppbv, maximum: 3.55 ppbv) in the spring and summer campaigns, respectively. The average concentration of peroxides at Mt. Tai, which is in a heavily polluted region, was much lower than hydrogen peroxide measurements made at some rural mountain sites, suggesting that significant removal processes took place in this region. An examination of diurnal variation and a correlation analysis suggest that these removal processes could include chemical suppression of peroxide production due to the scavenging of peroxy and hydroxy radicals by high NO_x, wet removal by clouds/fogs rich in dissolved sulfur dioxide which reacts quickly with peroxides, and photolysis. These sinks competed with photochemical sources of peroxides, resulting in different mean concentrations and diurnal pattern of peroxides in the spring and summer. A principal component analysis was conducted to quantify the major processes that influenced the variation of peroxide concentrations. This analysis shows that in the spring photochemical production was an important source of peroxides, and the major sink was scavenging during upslope transport of polluted and humid air from the lower part of the planetary boundary layer (PBL) and wet removal by synoptic scale clouds. During the summer, highly polluted PBL air (with high NO_x) was often associated with very low peroxides due to the chemical suppression of HO₂ by high NO_x and wet-removal by clouds/fogs in this sulfur-rich atmosphere, especially during the daytime. Higher concentrations of peroxides, which often appeared at mid-nighttime, were mainly associated with subsidence of air masses containing relatively lower concentrations of NO_y.     

Study on the hydrolysis/precipitation behavior of Keggin Al13 and Al30 polymers in polyaluminum solutions

The hydrolysis/precipitation behaviors of Al³⁺, Al₁₃ and Al₃₀ under conditions typical for flocculation in water treatment were investigated by studying the particulates' size development, charge characteristics, chemical species and speciation transformation of coagulant hydrolysis precipitates. The optimal pH conditions for hydrolysis precipitates formation for AlCl₃, PAC_Al13 and PAC_Al30 were 6.5–7.5, 8.5–9.5, and 7.5–9.5, respectively. The precipitates' formation rate increased with the increase in dosage, and the relative rates were AlCl₃ ? PAC_Al30 > PAC_Al13. The precipitates' size increased when the dosage increased from 50 μM to 200 μM, but it decreased when the dosage increased to 800 μM. The Zeta potential of coagulant hydrolysis precipitates decreased with the increase in pH for the three coagulants. The iso-electric points of the freshly formed precipitates for AlCl₃, PAC_Al13 and PAC_Al30 were 7.3, 9.6 and 9.2, respectively. The Zeta potentials of AlCl₃ hydrolysis precipitates were lower than those of PAC_Al13 and PAC_Al30 when pH > 5.0. The Zeta potential of PAC_Al30 hydrolysis precipitates was higher than that of PAC_Al13 at the acidic side, but lower at the alkaline side. The dosage had no obvious effect on the Zeta potential of hydrolysis precipitates under fixed pH conditions. The increase in Zeta potential with the increase in dosage under uncontrolled pH conditions was due to the pH depression caused by coagulant addition. Al–Ferron research indicated that the hydrolysis precipitates of AlCl₃ were composed of amorphous Al(OH)₃ precipitates, but those of PAC_Al13 and PAC_Al30 were composed of aggregates of Al₁₃ and Al₃₀, respectively. Al³⁺ was the most un-stable species in coagulants, and its hydrolysis was remarkably influenced by solution pH. Al₁₃ and Al₃₀ species were very stable, and solution pH and aging had little effect on the chemical species of their hydrolysis products. The research method involving coagulant hydrolysis precipitates based on Al–Ferron reaction kinetics was studied in detail. The Al species classification based on complex reaction kinetic of hydrolysis precipitates and Ferron reagent was different from that measured in a conventional coagulant assay using the Al–Ferron method. The chemical composition of Al_a, Al_b and Al_c depended on coagulant and solution pH. The Al_b measured in the current case was different from Keggin Al₁₃, and the high Al_b content in the AlCl₃ hydrolysis precipitates could not used as testimony that most of the Al³⁺ was converted to highly charged Al₁₃ species during AlCl₃ coagulation.     

“5·12”汶川地震灾区典型区域生态环境状况影响评价

“5·12”汶川特大地震发生后。带来的植被破坏、水土流失、次生地质灾害等,给灾区生态环境造成了极大的影响。本文重点以汶川县作为典型区域,运用“3S”技术,通过对汶川县震前、震后的生态环境状况及其变化情况进行定量评价。分析“5·12”大地震对龙门山区生态环境的影响,以期为区域灾后重建提供参考。     

一株高效脱硫脱氨氮菌的分离、鉴定及系统发育分析

从运行稳定的能同步脱臭的曝气生物滤池中采集样品,富集分离获得一株能高效脱硫脱氨氮的菌株TS-1。对分离菌株进行形态观察、生理生化试验及16S rRNA基因序列分析,结果表明,该菌株TS-1为革兰氏阳性菌,杆状;菌落在营养琼脂培养基上呈圆形,表面光滑,乳白色半透明;V-P试验阴性,能水解淀粉和明胶,利用柠檬酸盐生长;对菌株进行16S rRNA的PCR扩增,扩增产物测序结果表明分离菌株TS-1与巨大芽孢杆菌（Bacillus megaterium）同源性达到99%;以16S rRNA同源性为基础构建了包括24株相关种属细菌在内的系统发育树,在系统发育树中,分离菌株TS1与Bacillus megaterium在同一分支。结合形态观察、生理生化试验及16S rRNA基因序列分析结果,将其初步鉴定为巨大芽孢杆菌（Bacillus megaterium）。在常温（30±2）℃、转速为150 r/min的条件下,处理pH 7、S^2-和NH⁺₄-N分别为80 mg/L和88 mg/L的水样40 h,硫化物和氨氮的脱除率分别为91.8%和96.6%。     

低温试验能力验证中的不确定度分析评估

本文简述电气领域如何评定测量不确定度过程,并结合CNAS T0346低温试验能力验证计划,识别和具体分析低温试验中各测量不确定度的来源,对各种影响因素进行评价,论述人、机、料、法、环、测各环节对测量结果的影响,给出了低温试验测量结果不确定度的评估过程。     

Development of a multi-criteria index ranking system for urban runoff best management practices (BMPs) selection

Low impact development best management practices (LID-BMPs) are considered to be cost-effective measures for mitigating the water quantity and quality impact of urban runoff. Currently, there are many types of LID-BMPs, and each type has its own intrinsic technical and/or economical characteristics and limitations for implementation. The selection of the most appropriate BMP type(s) for a specific installation site is therefore a very important planning step. In the present study, a multi-criteria selection index system (MCIS) for LID-BMP planning was developed. The selection indexes include 12 first-level indices and 26 second-level indices which reflect the specific installation site characteristics pertaining to site suitability, runoff control performance, and economics of implementation. A mechanism for ranking the BMPs was devised. First, each individual second-level index was assigned a numeric value that was based on site characteristics and information on LID-BMPs. The quantified indices were normalized and then integrated to obtain the score for each of the first-level index. The final evaluation scores of each LID-BMP were then calculated based on the scores for the first-level indices. Finally, the appropriate BMP types for a specific installation site were determined according to the rank of the final evaluation scores. In order to facilitate the application of the MCIS BMP ranking system, the computational process has been coded into a software program, BMPSELEC. A case study demonstrating the MCIS methodology, using an LID-BMP implementation planning at a college campus in Foshan, Guangdong Province, is presented.     

Polychlorinated biphenyls (PCBs) and halogenated flame retardants (HFRs) in multi-matrices from an electronic waste (e-waste) recycling site in Northern China

The present study investigated the occurrence of polychlorinated biphenyls (PCBs) and halogenated flame retardants (HFRs) in soil, water, reed, air and dust samples collected from the e-waste recycling region in Ziya Town, Northern China. The results showed that the concentrations of PCBs reached relative high level in environmental matrices in the study area. HFRs including polybrominated diphenyl ethers (PBDEs), dechlorane plus (DP), allyl 2,4,6-tribromophenyl ether (ATE), tetrabromoethylcyclohexane (TBECH), pentabromotoluene (PBT), pentabromoethylbenzene (PBEB), 2,3-dibromopropyl 2,4,6-tribromophenyl ether (DPTE), 1,2-bis-(2,4,6-tribromophenoxy) ethane (BTBPE) and so on were also widely detected in multi-matrices. Long-range atmospheric transport (LRAT) potentials of non-BDE HFRs were assessed to address the LRAR abilities of these compounds. Analysis of soil–air exchange of PCBs and HFRs showed that soil acted as a secondary source to the atmosphere only for a few low molecular weight compounds, while the direction of the flux of most detected chemicals was from air to soil.     

Elemental mobility in sulfidic mine tailings reclaimed with paper mill by-products as sealing materials

Environmental Science and Pollution Research - Sealing layers made of two alkaline paper mill by-products, fly ash and green liquor dregs, were placed on top of 50-year-old sulfide-containing...     

Factors influencing adsorption and desorption of trimethoprim on marine sediments: mechanisms and kinetics

Environmental Science and Pollution Research - Adsorption-desorption behavior of ionic antibiotics in natural aquatic environment is complex, especially in coastal or estuary area where influencing...     

Future of global governance and climate change action in a changing political landscape

<正>1.Editor's note On 30 November 2016,the Brookings-Tsinghua Center for Public Policy(BTC),Caixin Video,and Columbia Global Centers(Beijing)jointly hosted a Seminar on the Future of Global Governance and Climate Change Action in a Changing Political Landscape.Leading experts on China's environmental policy and climate