Feasibility of incorporating waste grass clippings (Lolium perenne L.) in particleboard composites

This study investigated some of the important physical (thickness swelling) and mechanical (modulus of rupture, modulus of elasticity and internal bond) properties of single-layer particleboard panels made from eucalyptus (Eucalyptus camaldulensis Dehn.), waste of grass clippings (Lolium perenne L.) and combinations of the two. The chemical properties (pH, holocelluse and alpha cellulose contents, and water, alcohol-benzene and 1% sodium hydroxide solubilities) of the raw materials were also determined. Panels with a 6:94 ratio of grass-to-eucalyptus particles had the required mechanical properties for interior fitments including furniture and general uses. Boards manufactured with 100% grass clippings exhibited the lowest quality. The overall panel properties improved with a lower percentage of grass clippings added. Based on initial results, it also appears that grass should compose no more than 13% to achieve acceptable panel properties for interior fitments and general uses.     

Bench-scale composting of source-separated human faeces for sanitation

In urine-diverting toilets, urine and faeces are collected separately so that nutrient content can be recycled unmixed. Faeces should be sanitized before use in agriculture fields due to the presence of possible enteric pathogens. Composting of human faeces with food waste was evaluated as a possible method for this treatment. Temperatures were monitored in three 78-L wooden compost reactors fed with faeces-to-food waste substrates (F:FW) in wet weight ratios of 1:0, 3:1 and 1:1, which were observed for approximately 20 days. To achieve temperatures higher than 15 degrees C above ambient, insulation was required for the reactors. Use of 25-mm thick styrofoam insulation around the entire exterior of the compost reactors and turning of the compost twice a week resulted in sanitizing temperatures (>or=50 degrees C) to be maintained for 8 days in the F:FW=1:1 compost and for 4 days in the F:FW=3:1 compost. In these composts, a reduction of >3 log(10) for E. coli and >4 log(10) for Enterococcus spp. was achieved. The F:FW=1:0 compost, which did not maintain >or=50 degrees C for a sufficiently long period, was not sanitized, as the counts of E. coli and Enterococcus spp. increased between days 11 and 15. This research provides useful information on the design and operation of family-size compost units for the treatment of source-separated faeces and starchy food residues, most likely available amongst the less affluent rural/urban society in Uganda.     

The Effect of Masterbatch Addition on the Mechanical, Thermal, Optical and Surface Properties of Poly(lactic acid)

There has been considerable interest in the use of the biodegradable polymer poly(lactic acid) (PLA) as a replacement for petroleum derived polymers due to ease of processability and its high mechanical strength. Other material properties have however limited its wider application. These include its brittle properties, low impact strength and yellow tint. In an attempt to overcome these drawbacks, PLA was blended with four commercially available additives, commonly known as masterbatches. The effect of the addition of 1.5 wt% of the four masterbatches on the mechanical, thermal, optical and surface properties of the polymer was evaluated. All four masterbatches had a slight negative effect on the tensile strength of PLA (3–5% reduction). There was a four fold increase in impact resistance however with the addition of one of the masterbatches. Differential scanning calorimetry demonstrated that this increase corresponded to a decrease in the polymer crystallinity. However there was an associated increase in polymer haze with the addition of this masterbatch. The clarity of PLA was improved through the addition of an optical brightener masterbatch, but the impact resistance remained low. The glass transition and melting temperatures of PLA were not affected by the addition of the masterbatches, and no change was observed in surface energy. Some delay in PLA degradation, in a PBS degradation medium at 50 °C, was observed due to blending with these masterbatches.     

A method for ranking components importance in presence of epistemic uncertainties

Importance Measures (IMs) are used to rank the contributions of components or basic events to the system performance, e.g. its reliability or risk. Most times, IMs are calculated without due account of the uncertainties in the model of the behavior of the system. The objective of this work is to investigate how uncertainties can influence IMs and to develop a method for giving them due account in the corresponding ranking of the components or basic events. The uncertainties considered in this work affect the model parameters values and are assumed to be described by probability density functions. The method for ranking the contributors to the system performance measure is applied to the auxiliary feedwater system of a nuclear pressurized water reactor.     

Nanofiltration of concentrated and salted tuna cooking juices

Tuna cooking juice from a Tunisian tuna-processing unit has a high level of polluting load: chemical oxygen demand (COD) is comprised between 4 and 20 g L⁻¹, nitrogen kjedahl (NK) between 0.6 and 3 g L⁻¹ and dry matter between 120 and 160 g L⁻¹. The juice has thus to be treated before being rejected into the environment. This paper considers the nanofiltration (NF) of these concentrated organic/inorganic mixtures using an AFC 30 (NF) membrane. The work focusses on the effect of organic and inorganic matters on the permeate flux and rejections of these matters. For this purpose, mixtures of salt and organic pollution (COD), used as model solutions, were prepared by the dilution of a typical industrial tuna cooking juice. The permeate flux was found to decrease when salt and organic matter concentrations increase. The recovery rate in organic matter decreases with increasing salt or organic matter content and the recovery rate of salt decreases when the COD concentration increases.     

Physico-Chemical Quality of Drinking Water in Rohtas District of Bihar

Water Quality Survey of Rohtas district of Bihar was conducted. Samples were collected from differentsources and analysed. 209 samples were collectedfrom 196 villages. Results of water quality surveyidentified the problem areas in respect of high iron,manganese, fluoride, nitrate and brackishness of water in the district.     

Numerical Simulations of the Urban Roughness Sub-Layer : A First Attempt

Most of the mesoscale models use roughness parameters to characterise the ground and to compute the surface stress. As the experimental determinations of the urban roughness parameters are rare and not very reliable, a new methodology based on microscale numerical simulations is presented here and the first results from two-dimensional simulations with different roof shapes are analysed.Firstly, it appears that the roof shape has a large influence : large difference in the Reynolds stress profile and in the roughness sub-layer thickness, enhancement of the exchanges at the roof level by buildings with attic. It also appears that the fetch necessary to obtain a constant flux layer is unrealistic compared to the real spatial homogeneity of quarters in European cities. Consequently, a new parameterisation of the urban ground-induced friction is to be developed without reference to the constant flux layer theory.     

Models at the interface between science and society: impacts and options

Within the CLEAR project a new approach to integrated assessment modelling has been developed for the participatory integrated assessment of regional climate change involving citizens' focus groups. The climate change decision problem was structured by focusing separately on climate impacts and mitigation options. The attempt was made to link the different scales of the problem from the individual to the global level. The abstract topic of climate change was related to options on the level of a citizen's individual lifestyle. The option of a low energy society was emphasised in order to embed the climate change decision problem in a wider range of societal concerns. Special emphasis was given to the characterisation and communication of uncertainties. The chosen approach allows different kinds of uncertainties in one framework to be addressed. The paper concludes with a summary of the experience made, and recommendations for the use of models in participatory integrated assessments. This revised version was published online in July 2006 with corrections to the Cover Date.     

Long-Term Relationship between Phosphorus Inputs and Wetland Phosphorus Concentrations in a Northern Everglades Marsh

Assessments of long-term relationships between changes innutrient inputs and wetland nutrient concentrations can becomplicated by fluctuations in other environmental factors aswell as by problems typical of long-term monitoring data.Consequently, statistical analysisof these types of data sets requirescareful consideration of environmental covariates, potentialbiases in the monitoring design, and irregularities caused bychanges in field sampling protocols. We evaluated therelationship between anthropogenic phosphorus (P) inputs andwater-column total P (TP) concentrations in a northernEverglades marsh by statistically analyzing available datacollected from several sampling programs over the past 20 years(1978–1997). Canal inputs of agricultural runoff contributemost of the P to the marsh and have produced a zone ofenrichment within the marsh during the past few decades.Regression analyses showed that both canal and marsh TPconcentrations increased during the 1980s and then decreased inthe 1990s. However, the statistical relationship between canal Pinputs and marsh TP, while significant, generally was weakexcept for marsh locations adjacent to the canal. Strongerrelationships existed between marsh TP and hydrologic parameterssuch as marsh water depth, which is controlled by changes inweather patterns and marsh management. In particular, dryconditions during the 1980s may have contributed to observedincreases in marsh P concentrations and the movement of a P`front' further into the marsh. Higher rainfall and water depthsand agricultural best management programs initiated during the1990s have been associated with reduced P concentrations incanal waters entering the marsh. While it is anticipated thatthis reduction eventually will result in lower marsh TPconcentrations, this effect is not yet evident, possibly due tointernal loading of P from enriched marsh soils. Our findingsillustrate some of the environmental factors that can complicateattempts to develop empirical relationships between P inputs andwetland P concentrations and to use such relationships to forecast changesin marsh concentrations based on past monitoring data alone.