Eliminating Reheat from Existing FGD Systems

The Clean Air Act Amendments of the early 1970_s required coal burning utilities to reduce their emissions of sulfur dioxide. Lime or limestone based wet systems were employed for flue gas desulfurization (FGD). These systems reduced flue gas temperatures to below acid dew point conditions. Concerned about the prospect of ductwork exposed to a saturated, acid-rich environment, most utilities turned to stack gas reheat (SGR) to increase flue gas temperatures. By 1980, 82 percent of all FGD facilities employed SGR. Today there are about 130 FGD systems of which 101 employ some form of stack gas reheat.     

Technical Session Preliminary Schedule Announced for 1988 APCA Annual Meeting

ABSTRACT

Stable heterogeneous catalysts for the oxidative removal of CO from air at ambient temperatures have been developed. An alumina support impregnated with PdCl₂, CuCl₂, and CuSO₄ is described. Optimal activity was obtained with Pd 0.020 mol/kg, Cu 0.50 mol/kg, CuCl₂ 20-30% of total Cu, a 2- to 24-hr soak, filtration of surplus raffinate, and a 2- to 4-hr firing in air at 200-350 °C. The catalysts are effective at 20-26 °C and relative humidities in the 15-90% range. They are reversibly deactivated by completely dry or water-saturated air streams. These catalysts have been tested at space velocities up to 30,000 hr^-1. In contact with <100 ppm CO, they are highly efficient, removing ~99% of the CO with contact times of ~120 msec (pseudo-first order k' > 25 sec^-1). At much higher CO concentrations, the maximum CO loading rate—limited by the Cu(I) reoxidation rate—is approximately 17 m mol CO per Limol Pd per hour.     

The Effects of Infiltration and Insulation on the Source Strengths and Indoor Air Pollution from Combustion Space Heating Appliances

Many energy conservation strategies for residences involve reducing house air exchange rates. Reducing the air exchange rate of a house can cause an increase in pollutant levels if there is an indoor pollution source and if the indoor pollutant source strength remains constant. However, if the indoor pollutant source strength can also be reduced, then it is possible to maintain or even improve indoor air quality. Increasing the insulation level of a house is a means of achieving energy conservation goals and, in addition, can reduce the need for space heating and thereby reduce the pollutant source strengths of combustion space heaters such as unvented kerosene space heaters, unvented gas space heaters, and wood stoves. In this paper, the indoor air quality trade-off between reduced infiltration and increased insulation in residences is investigated for combustion space heaters. Two similar residences were used for the experiment. One residence was used as a control and the other residence had infiltration and insulation levels modified. An unvented propane space heater was used as the source in this study. A model was developed to describe the dependence of both indoor air pollution levels and the appliance source strengths on house air exchange rates and house insulation levels. Model parameters were estimated by applying regression techniques to the data. Results show that indoor air pollution levels in houses with indoor combustion space heating pollution sources can be held constant (or lowered) by reducing the thermal conductance by an amount proportional to (or greater than) the reduction of the air exchange rate.     

Characterizing the Occurrence,Sources, and Variability of Radon in Pacific Northwest Homes

A compilation of data from earlier studies of 172 homes in the Pacific Northwest indicated that approximately 65 percent of the 46 homes tested in the Spokane River Valley/Rathdrum Prairie region of eastern Washington/northern Idaho had heating season indoor radon (²²²Rn) concentrations above the U. S. EPA guideline of 148 Bq m^?3 (4 pCi L^?1). A subset of 35 homes was selected for additional study. The primary source of indoor radon in the Spokane River Valley/Rathdrum Prairie was pressure-driven flow of soil gas containing moderate radon concentrations (geometric mean concentration of 16,000 Bq m^?3) from the highly permeable soils (geometric mean permeability of 5 × 10^?11 m²) surrounding the house substructures. Estimated soil gas entry rates ranged from 0.4 to 39 m³h^?1 and 1 percent to 21 percent of total building air infiltration. Radon from other sources, including domestic water supplies and building materials was negligible. In high radon homes, winter indoor levels averaged 13 times higher than summer concentrations, while in low radon homes winter levels averaged only 2.5 times higher. Short-term variations in indoor radon were observed to be dependent upon indoor-outdoor temperature differences, wind speed, and operation of forced-air furnace fans. Forced-air furnace operation, along with leaky return ducts and plenums, and openings between the substructure and upper floors enhanced mixing of radon-laden substructure air throughout the rest of the building.     

A Field Intercomparison and Fundamental Characterization of Various Dust Samplers with a Reference Sampler

The European Economic Community Council Directive 80/779/EEC¹ describes air quality limit values and guide values for sulfur dioxide and suspended particulates. However, article 10, paragraph 1 does not define well enough the reference method required, amongst others, for the gravimetric measurement of suspended particulates. It is explicity stated in article 10, paragraph 5 of the directive, that “the commission shall, in selected locations in the member states and in cooperation with the latter, carry out studies on the sampling…of suspended particulates. These studies shall be designed in particular to promote the harmonization of methods of sampling and analysis of these pollutants.” Therefore, in a joint research program the Umweltbundesamt (grant #104 02263), the commission of European Communities (grant #84-B-6642-11-017-11-N) and the U.S. EPA (grant #2-43211-3580) funded the development of a reference dust sampler by the Fraunhofer-lnstitute of Toxicology and Aerosol Research (FhITA, in Hannover, Federal Republic of Germany) in order: ? to study the particle size distribution of ambient air aerosol at a number of selected sites;

? to compare the results obtained with the reference dust sampler with those of particle samplers operated in Europe and the United States;

? to verify the applicability of wind tunnel results to sampling behaviour in the free atmosphere.

     

Evaluation of Regenerative-air Vacuum Street Sweeping on Geological Contributions to PM10

Street sweeping is often proposed as a means of reducing the emissions from paved roads. The objective of this study was to evaluate the effectiveness of street sweeping on ambient particulate matter concentrations and to determine the difference In source contributions to PM10 concentrations between street sweeping and non-street sweeping periods.

Chemically-speciated measurements of PM10 and PM2.5 were taken in the commercial section of Reno, Nevada, for a one-month sampling period. The Chemical Mass Balance (CMB) model was applied to these data and an average of approximately 50 percent of the PM10 was apportioned to resuspended geological material. During half of the sampling period, streets In the vicinity of the sampling site were completely swept with a regenerative-air vacuum sweeper, while no sweeping was performed during the remainder of the experiment. Ratios of primary geological contributions divided by primary motor vehicle contributions to PM10 were compared between sweeping and non-sweeping periods using analysis of variance. This ratio of source contributions minimizes the effects of variations in traffic volume and meteorological dispersion. No significant differences in geological contributions to PM10 were detected as a result of regenerative-air vacuum street sweeping.     

Evidence of degradation of polybrominated biphenyls in soil samples from michigan

Abstract

Soil samples obtained from the former polybrominated biphenyls (PBB) manufacturing site in Michigan were analyzed by gas chromatography and gas chromatography with mass spectrometric detection. The results indicate significant degradation of the PBB residue in the soil sample. The soil sample with the highest concentration of PBB has the greatest degree of degradation. Principal degradation products include 2,3’,4,4’,5‐pentabromo‐biphenyl, 2,2’,4,4’,5‐pencabromobiphenyl and two unidentified tetrabromobiphenyls.

The degradation pattern observed supports a photochemical decomposition mechanism. These degraded residues may be more toxic than the original Firemaster residues. The implications of the results are discussed.     

Effect of some xenobiotics on kynurenine hydrolase and kynurenine aminotransferase of mouse liver

Abstract

The effects of some xenobiotics on the activity of the B₆‐dependent kynurenine hydrolase (KH) and kynurenine aminotransferase (KATE) in mouse liver, were investigated. Polychlorinated biphenyl (Aroclor 1254) (400mg/kg/day ×4) markedly decreased the activity of both enzymes. Benzo(a)pyrene (BP) and 3‐methylcholanthrene (3‐MC) (40mg/Kg/day ×1) as well as phénobarbital (PB) (75mg/kg/day ×3) did not alter the activity of KH, while that of KATE was mildy reduced. The response of the two enzymes to treatment with chlorpromazine (CPZ) (5mg/Kg/day ×5) were opposite with marked elevation of KH and inhibition of KATE activities. Treatment with B‐naphthoflavone (B‐NF) (80mg/Kg/day ×2), Pyrazole (200mg/Kg/day ×1) or indole (400mg/kg/day ×1) produce no change in the activity of either enzyme. It, seems therefore, that Aroclor(1254) and chlorpromazine may cause disordered kynurenine metabolism through alterations in the activities of its metabolizing enzymes. This, in turn, might affect nicotinamide adenine dinucleotide biosynthesis and/or the accumulation of some tryptophan metabolites suspected of being carcinogenic or co‐carcinogenic.     

An improved method to study the impact of pesticide sprays on small song birds

Abstract

Four test groups of small songbirds (Zebra Finch, Poephila guttata) were sprayed in a chamber with varying concentrations of fenitrothion. Exposure levels were assessed by monitoring air concentrations, deposits of the active ingredient (AI) on glass plates and droplets/cm² on Kromekote® cards. All indices of exposure were linearly correlated and the mean AI deposit on glass plates for the four groups tested were equivalent to 38, 51, 139 and 255 g/ha or 14%, 18%, 50% and 91% of the highest permissible emitted rate for broadscale forest spraying in Canada. Significant depression in body weights and brain acetylcholinesterase levels were noted only for the highest exposure group. Fenitrothion residues in blood were detectable only at the highest exposure level, and in liver at the two higher levels. Carcass and feather residues were much higher than those in blood and liver, and were detectable at all exposure levels but the residues did not increase linearly with exposure. For one of the spray groups, we were able to compute an equivalent acute oral dose based on matching acetylcholinesterase inhibition.