附载型复合光催化剂TiO2·SiO2/beads降解有机磷农药

研究以四异丙醇钛 [Ti( iso- O C3 H7) 4]、硅酸乙酯为原料 ,以空心玻璃微球为载体 ,用溶胶—凝胶法制备可漂浮附载型复合光催化剂 Ti O2 · Si O2 / beads的过程 ,利用附载型复合光催化剂降解有机磷农药。结果表明 ,复合型光催化剂 Ti O2 · Si O2 摩尔比存在最佳值 ,n ( Ti O2 ) / m ( Si O2 ) =30 / 70时 ,光催化剂活性最高 ,其活性是同样降解条件下、同样含量 Degussa P- 2 5Ti O2 的 2倍左右。该光催化剂比表面大 ,吸附性强。并用 XRD和 SEM对附载型复合光催化剂进行表征     

自然生态系统中含硫气体的产生机理与环境归趋

基于当前可获得的与该课题相关的资料 ,本文综述了陆地生态系统产生挥发性含硫气体的微观和宏观机理过程。讨论了控制生物硫气体产生的环境因素。阐述了含硫气体释放进入大气后的环境归趋     

小型圆环状尖端脉冲电晕等离子体除尘器的研制

本文介绍一种小型的脉冲电晕等离子体除尘器 ,它采用圆环状尖端电晕极 ,电晕放电稳定 ,放电电流较集中 ,不容易产生火花放电     

重金属污染土壤中提高植物提取修复功效的探讨

随着对重金属超积累植物研究的加深 ,用植物提取修复技术来改良重金属污染的土壤已逐步进入实用阶段。本文所探讨的提高此技术功效的方法基于两个方面 :提高土壤溶液中重金属的浓度 ,促进植物对重金属的吸收 ;根据已了解的超积累的生理机制可能采取的一些措施     

高温与超高温UASB反应器的研究进展

本文介绍了国内外对上流式厌氧污泥床 (UASB)反应器应用于高温和超高温废水处理的研究进展现状 ,探讨了在高温和超高温下UASB反应器接种、启动及其处理效果的特点     

锆负载型树脂用于含氟废水深度处理的研究

本文研制了一种以火力发电厂废树脂为载体的锆负载型氟离子吸附剂 ,并在评价了该树脂对氟离子的吸附性能之后探讨了该树脂用于火力发电厂含氟废水深度处理的可能性。研究结果表明 ,锆的最佳负载的最佳浓度为0 .5mol/L ,该负载树脂的最佳吸附pH为 3.0— 4 .0 ,用填充柱进行的动态实验结果表明 ,pH =3时的吸附容量显著高于 pH=4时的值。利用该树脂对火力发电厂模拟含氟废水进行了双柱串联吸附工艺处理 ,当柱流量为 35mL/min(SV10 )、第二柱穿透时 ,第一柱的吸附容量为 10 2 2 8mg/L湿树脂 ;用 0 .1mol/L的NaOH溶液进行再生 ,柱流量选择为 35mL/min(SV10 )时 ,脱附率在 95 %以上。     

厌氧折流板反应器处理玉米秆纤维浆粕废水的研究

采用厌氧折流板反应器 (ABR)处理玉米秆纤维浆粕废水 ,研究了工艺条件和工艺特征。试验结果表明 ,在HRT为 2 4h ,OLR为 6 .5 6kgCOD/m3 ·d条件下 ,ABR能有效处理浓度为 6 5 6 0mgCOD/L的玉米秆纤维浆粕废水 ,COD去除率为 75 .1% ;ABR对负荷冲击有良好的适应性 ,且具有推流式和两相式反应器的双重特点。     

Performance evaluation of laser-induced breakdown spectrometry as a multimetal continuous emission monitor

Laser-induced breakdown spectroscopy (LIBS) has been evaluated as a multimetal continuous emissions monitor (CEM) at the U.S. Environmental Protection Agency (EPA) rotary kiln incinerator simulator (RKIS) facility in Raleigh, NC. Two detection systems with a bifurcated optical fiber bundle were used for simultaneously monitoring the concentrations of Be, Cd, Cr, and Hg in the test. Two calibration techniques were evaluated in the laboratory for the field measurements. On-line calibration of relative metal concentration was also performed in the simulated incinerator gas stream. Toxic metal concentrations measured with LIBS have been compared with the EPA reference method (RM) results.     

The velocity of DNAPL fingering in water-saturated porous media: laboratory experiments and a mobile-immobile-zone model.

Dense nonaqueous phase liquids (DNAPLs) are immiscible with water and can give rise to highly fingered fluid distributions when infiltrating through water-saturated porous media. In this paper, a conceptual mobile-immobile-zone (MIZ) model is presented to describe the structure of a DNAPL finger in water-saturated porous media and the velocity of finger propagation. A finger is composed of a finger body and a tip. The finger body has a mobile core and an immobile sheath. All the DNAPL within the tip of a finger is mobile. Lab experiments utilizing image analyses of a DNAPL (PCE) penetrating into water-saturated homogeneous glass beads were carried out in a two-dimensional transparent chamber. The results show that the fingers elongated almost linearly with time. The fingers did not grow laterally after the tip of the finger had passed. The average finger diameters were between 3.9 and 5.4 mm for PCE propagation in water-saturated glass bead porous media with mean particle diameters from 0.32 to 1.36 mm. The estimated mobile core diameters were 51-60% of the average finger diameters.     

基于室内PM2.5控制和节能的通风策略探讨

细颗粒物（PM2.5）随空调新风进入室内,和室内产生的PM2.5粒子一起作用,导致人体暴露在室内细颗粒物环境中。为保证室内空气品质,最大限度节约空调系统运行能耗,建立了室内PM2.5浓度与CO2体积分数双组分模型,提出了适用于某会议室不同室内外PM2.5源、不同人数以及不同天气状况下的最佳通风策略,利用Simulink对炎热天气室内有无PM2.5散发源、温和天气室内有无PM2.5散发源4种工况下的不同通风方式进行仿真对比。模拟结果表明：炎热天气存在最小新风量,该值由室内人数决定,过滤送风对控制室内PM2.5浓度效果最好;温和天气存在最大新风量,且该值与过滤器效率成正比;在所研究的情况下,温和天气节能潜力比炎热天气大。