关于水域面源污染的控制

分析了水域面源污染的现状,指出其治理上的难点,认为从解决点源污染着手,把握客观规律,才能有效解决面源污染.最后就面源污染的控制治理,提出了具体设想.     

新型环境材料提铯离子筛的研制

合成六种有离子交换性能的焦磷杂多酸盐 ,其中焦磷钼酸锆在 3M硝酸介质中有较高的化学稳定性和铯离子交换容量。经正交实验确定了合成焦磷钼酸锆的最佳工艺条件。以焦磷钼酸锆为基体 ,通过特殊的化学制筛手段 ,制成了对铯离子有高效选择性、抗强酸的提铯离子筛 ,可适用于直接从高放废液中提取铯。     

厌氧-好氧法治理中药废水研究

厌氧—好氧法处理中药废水 ,污泥中生物相丰富 ,原生、后生动物数量多 ,污泥沉降性能优良 ,出水水质好 ,CODCr、BOD5 等指标都达到了一级排放标准。     

Au/ZnO催化剂的表征及常温常湿 条件下CO氧化性能研究

常温下考察了焙烧温度、金含量及水分对Au/ZnO催化剂上CO氧化性能的影响 ,并在常湿条件下考察了ZnO上CO氧化活性同温度的关系。结果表明 ,金的存在极大地提高了催化剂CO的氧化活性。另外焙烧温度和金含量对Au/ZnO催化剂的活性和稳定性均有较大影响 ,在常温常湿条件下 ,2 4 0℃焙烧的 2 %Au/ZnO催化剂 ,可连续反应 1 750h保持CO完全转化。XRD结果表明 ,锌的化学状态对催化剂的稳定性有较大的影响 ,氧化锌较碳酸锌表现出较高的稳定性。     

桂西北明山金矿床表生带矿石中氨基酸的分布特征研究

在总结目前关于氨基酸溶金作用研究成果的基础上,对桂西北明山卡林型金矿床表生带的矿石样品进行了氨基酸的分离、定性和定量研究,结果表明,各种氨基酸的稳定性与所处的成岩成矿环境有关,因此不同环境中对成岩成矿发挥作用的氨基酸种类是不同的,所起的作用也有所差异;进行氨基酸溶金作用模拟实验时应该首先考虑氨基酸在不同成岩成矿环境中的稳定性。结合已有的氨基酸溶金作用模拟实验所得到的认识,对桂西北卡林型金矿成矿过程中氨基酸的作用进行了探讨。     

从高原环境特征论西藏环境保护重点

西藏８６．１％的土地位于海拔４０００ｍ以上的地区，受“高”、“寒”等恶劣自然条件的作用，生态环境自然退争执库上粗放型的经济发展模式，也在局部加剧了生态环境的退化。本文对上述环境特征分析后，提出生物多样性保护，草地生态环境建设、４大江源头和上游生态环境保护、藏中     

沙尘暴灾害及其防治

本文分析了中外重大沙尘暴的成因、造成的灾害并提出相应对策建议。     

A comparison of statistical methods for deriving freshwater quality criteria for the protection of aquatic organisms

Species sensitivity distributions (SSDs) are increasingly used in both ecological risk assessment and derivation of water quality criteria. However, there has been debate about the choice of an appropriate approach for derivation of water quality criteria based on SSDs because the various methods can generate different values. The objective of this study was to compare the differences among various methods. Data sets of acute toxicities of 12 substances to aquatic organisms, representing a range of classes with different modes of action, were studied. Nine typical statistical approaches, including parametric and nonparametric methods, were used to construct SSDs for 12 chemicals. Water quality criteria, expressed as hazardous concentration for 5 % of species (HC₅), were derived by use of several approaches. All approaches produced comparable results, and the data generated by the different approaches were significantly correlated. Variability among estimates of HC₅ of all inclusive species decreased with increasing sample size, and variability was similar among the statistical methods applied. Of the statistical methods selected, the bootstrap method represented the best-fitting model for all chemicals, while log-triangle and Weibull were the best models among the parametric methods evaluated. The bootstrap method was the primary choice to derive water quality criteria when data points are sufficient (more than 20). If the available data are few, all other methods should be constructed, and that which best describes the distribution of the data was selected.     

Adsorption of multi-heavy metals Zn and Cu onto surficial sediments: modeling and adsorption capacity analysis

Improved multiple regression adsorption models (IMRAMs) was developed to estimate the adsorption capacity of the components [Fe oxides (Fe), Mn oxides (Mn), organic materials (OMs), residuals] in surficial sediments for multi-heavy metal Zn and Cu. IMRAM is an improved version over MRAM, which introduces a computer program in the model developing process. As MRAM, Zn(Cu) IMRAM, and Cu(Zn) IMRAM again confirmed that there is significant interaction effects that control the adsorption of compounded Zn and Cu, which was neglected by additional adsorption model. The verification experiment shows that the relative deviation of the IMRAMs is less than 13 %. It is revealed by the IMRAMs that Mn, which has the greatest adsorption capability for compounded Zn and Cu (54.889 and 161.180 mg/l, respectively), follows by interference adsorption capacity of Fe/Mn (?1.072 and ?24.591 mg/l respectively). Zn and Cu influence each other through different mechanisms. When Zn is the adsorbate, compounded Cu mainly affects the adsorption capacities of Fe/Mn and Fe/Mn/OMs; while when Cu is the adsorbate, compounded Zn mainly exerts its effect on Mn, Fe/Mn, and Mn/OMs. It also shows that the compounded Zn or Cu weakened the interference adsorption of Fe/Mn, and meanwhile, strengthened the interference adsorption of Mn/OMs.     

Physicochemical and biological quality of soil in hexavalent chromium-contaminated soils as affected by chemical and microbial remediation

Chemical and microbial methods are the main remediation technologies for chromium-contaminated soil. These technologies have progressed rapidly in recent years; however, there is still a lack of methods for evaluating the chemical and biological quality of soil after different remediation technologies have been applied. In this paper, microbial remediation with indigenous bacteria and chemical remediation with ferrous sulphate were used for the remediation of soils contaminated with Cr(VI) at two levels (80 and 1,276 mg kg^?1) through a column leaching experiment. After microbial remediation with indigenous bacteria, the average concentration of water-soluble Cr(VI) in the soils was reduced to less than 5.0 mg kg^?1. Soil quality was evaluated based on 11 soil properties and the fuzzy comprehensive assessment method, including fuzzy mathematics and correlative analysis. The chemical fertility quality index was improved by one grade using microbial remediation with indigenous bacteria, and the biological fertility quality index increased by at least a factor of 6. Chemical remediation with ferrous sulphate, however, resulted in lower levels of available phosphorus, dehydrogenase, catalase and polyphenol oxidase. The result showed that microbial remediation with indigenous bacteria was more effective for remedying Cr(VI)-contaminated soils with high pH value than chemical remediation with ferrous sulphate. In addition, the fuzzy comprehensive evaluation method was proven to be a useful tool for monitoring the quality change in chromium-contaminated soils.