Characterising the landscape of state environmental review policies and procedures in the United States: a national assessment

Following the intent of the National Environmental Policy Act of 1969, many states have adopted policies and procedures directing state agencies and local government units to evaluate the potential environmental impacts of development projects prior to their undertaking. In contrast to a rich literature on federal requirements, current understanding of state environmental review is narrowly focused and outdated. This paper seeks to provide information on the landscape of state environmental review policy frameworks. The paper identifies 37 states with formal environmental review requirements through a document review of state statutes, administrative rules and agency-prepared materials, and confirms this finding through a survey of state administrators. A two-tier classification is used to distinguish states based on the approach taken to address environmental review needs and the scope and depth of relevant policies and procedures implemented. This paper also provides a discussion of policy and programme attributes that may contribute to effective practice, and of the potential for adopting relevant legislation in states where environmental review is currently lacking.     

Characterization of aluminium-based water treatment residual for potential phosphorus removal in engineered wetlands

Aluminium-based water treatment residual (Al-WTR) is the most widely generated residual from water treatment facilities worldwide. It is regarded as a by-product of no reuse potential and landfilled. This study assessed Al-WTR as potential phosphate-removing substrate in engineered wetlands. Results indicate specific surface area ranged from 28.0 m² g⁻¹ to 41.4 m² g⁻¹. X-ray Diffraction, Fourier transform infrared and energy-dispersive X-ray spectroscopes all indicate Al-WTR is mainly composed of amorphous aluminium which influences its phosphorus (P) adsorption capacity. The pH and electrical conductivity ranged from 5.9 to 6.0 and 0.104 dS m⁻¹ to 0.140 dS m⁻¹ respectively, showing that it should support plant growth. Batch tests showed adsorption maxima of 31.9 mg P g⁻¹ and significant P removal was achieved in column tests. Overall, results showed that Al-WTR can be used for P removal in engineered wetlands and it carries the benefits of reuse of a by-product that promotes sustainability.     

光合细菌强化二级流化床工艺处理焦化废水的研究

采用厌氧酸化加二级流化床组合工艺处理焦化废水。一级反应器内光合细菌与兼性厌氧菌处于共生状态,二级反应器内光合细菌与亚硝酸细菌处于共生状态。一级反应器内光合细菌有充分的小分子有机酸可降解并形成二次酸化,在二级反应器内完成进一步降解。结合反应条件：温度,pH,DO和基质浓度等,将二级反应器内硝化反应控制在亚硝化阶段,有效地保证了废水中碳源的利用。稳定运行了60 d,结果显示,出水COD和NH₃-N浓度分别为105～135 mg/L和14～20 mg/L,去除率分别稳定在90.3%～92.5%和92%～95%。TN去除率稳定在83%～86%。酚、氰化物和BOD5的去除率均在95%以上。     

微生物絮凝剂改善城市污水厂浓缩污泥脱水性能的研究

采用酱油曲霉(Aspergillus sojae)产生的微生物絮凝剂(MBF)作为污泥絮凝脱水剂,对城市污水处理厂浓缩污泥进行调理,确定该絮凝剂对浓缩污泥脱水的处理工艺参数为：微生物絮凝液最佳投加体积为6%～8%（体积比）,发挥絮凝作用的最适污泥温度为28～32℃,最适pH为6～7。经微生物絮凝剂调理的污泥在3 000 r/min离心9 min,污泥脱水率高达82.7%,滤饼含水率降低至77.3%,污泥脱水后体积减至原来的1/5左右。     

微量金属元素及其配合物对厨余垃圾甲烷发酵的影响

生物可利用的微量金属元素不仅能够保证污染物以最大的速率转化,而且还可以使某些特殊的转化得以发生,并提高微生物对有毒污染物质的耐受能力。在研究厨余垃圾总固体浓度(total solid, TS)、接种量和C/N比对厨余垃圾厌氧发酵影响的基础上,重点探讨微量金属元素钴及其配合物丝氨酸对厨余垃圾厌氧发酵甲烷产量及关键酶含量的影响。结果表明,当TS为0.5%、接种污泥量为100 mL/L和C/N比为20∶1时,厨余垃圾厌氧发酵的甲烷产率较高,为367 mL/g COD;添加2 μmol/L的微量金属元素钴-配合物丝氨酸时,甲烷产率则提高到432 mL/g COD,相应地,辅酶M的含量由空白实验的41.21 μmol/g VSS提高到54.64 μmol/g VSS,辅酶F₄₂₀的含量由0.31 μmol/g VSS提高到0.48 μmol/g VSS。     

利用烧结脱硫灰制备胶凝材料的研究

研究了烧结烟气半干法脱硫灰复掺矿渣、钢渣,辅之外加剂,制备胶凝材料的可行性。结果表明,采用改性脱硫灰（GXTLH）、钢渣、矿渣及水泥熟料再混磨制备的复合胶凝材料,具有良好的安定性等水化性能和力学性能;当GXTLH 掺入量为20%、CFII 1.5%、减水剂0.5%及水泥熟料23%时,矿渣掺量在12%～44%、钢渣掺量11%～44%之间制备的胶凝材料初凝时间、终凝时间、力学性能满足GB13592-92《钢渣矿渣水泥标准》;矿渣与钢渣比、水泥熟料及外加剂等掺量一定,GXTLH掺量超过30%时,GXTLH胶凝材料的抗压抗折强度均有所下降。     

三氯生在碳纳米管上的吸附

药品和个人护理用品(PPCPs)已成为一个引起广泛关注的新的环境问题。采用碳纳米管（CNTs）对水溶液中的三氯生进行吸附处理,考察了碳纳米管粒径及用量、温度、pH、振荡时间等因素对三氯生去除率的影响。研究结果表明,碳纳米管能快速吸附水中的三氯生,粒径较小的碳纳米管可获得较高的三氯生去除率;低温有利于吸附反应的进行;pH在6.5～7.0时,三氯生的去除率可达97%。三氯生在碳纳米管上的吸附可以很好地用Langmuir和Freundlich吸附等温方程进行描述。     

DGGE、T-RFLP 、LH-PCR对两种活性污泥的微生物种群多样性分析的比较

采用基于PCR扩增的分子生态技术DGGE、T-RFLP和LH-PCR,对2种典型污水处理系统中的活性污泥（生活污泥、焦化污泥）进行微生物种群多样性分析;并以此比较3种技术的优劣,提出不同应用条件下研究方法的选择依据。根据实验结果：DGGE得到的条带较多,但误差来源也最多;T-RFLP技术较为灵敏,但需要选择适当的内切酶,严格控制酶切条件,并且文库比对误差较大;而LH-PCR操作简单,结果稳定性较高。虽然目前尚无法判断3种方法的准确性,但LH-PCR在活性污泥的微生物种群多样性分析中已显示出潜在优势。     

竹林土壤中甲基对硫磷降解菌的降解效果及其与土壤物理特性的关系

采用实验室控制试验研究了甲基对硫磷降解菌在竹林土壤生态系统中的降解效果及其与土壤物理特性的关系。试验结果表明,邻单胞菌（DLL-1）具有高效性,甲基对硫磷初始浓度为15 mg/kg干土,第5 d竹林土壤上、中和下层的降解率分别为88.6%、85.9%和79.2%,相应的半衰期为2.5、2.84与3.79 d。甲基对硫磷在土壤中的不同粒径范围吸附情况是不同的,从而影响DLL-1菌的降解效果,表现为土壤中粘粒含量与降解率呈显著正相关。孔隙度也是影响降解效果的一个因素,上中下3层的降解率随着孔隙度的减小而降低。     

污泥活性炭强化SBR法处理垃圾渗滤液的实验研究

为了进一步处理垃圾渗滤液,试验采用污泥活性炭强化序批式间歇反应器（SBR）法进行处理,通过对比普通SBR法试验,得出投加污泥活性炭强化SBR法处理垃圾渗滤液的效果要远远高于普通SBR法。当污泥活性炭的投加量为1.2 g/L,容积负荷为0.5～1.5 kg BOD₅/(m³·d)时,进水1 h,曝气10 h,沉淀1.5 h,闲置1.5 h,处理效果最好,COD的去除率达到了85%,NH³-N的去除率达到了90%。