废矿堆中黄铁矿氧化控制新技术--有机盐包膜法

于３０℃时研究了有机盐包膜对湿润和干燥条件下经接氧化亚铁矿杆菌的黄铁矿氧化的控制作用,湿润下经有机盐包膜的矿石样品的氧化程度与对照相比下降了９７．８％;直接添加有机盐的下降了９６．４％,两种淋洗收集液中有关元素的浓度经ＩＣＰ测定明显低于对照。干燥下微生物未能发挥对黄铁矿的氧化作用,但经包膜后的样品与对照相比,氧化程度又下降了７５．２％,这些结果表明,有机盐包膜既有明显的抑制黄铁矿的化学氧化作用,又     

热解含油污泥制备吸附材料浅析

介绍了含油污泥热解技术及热解实验方法,提出热解产生的残渣进行适当处理可成为具有吸附性的材料。进行了含油污泥热解正交实验,得出影响最大的因素分别是热解温度、热解时间、升温速率,并得出最佳的热解温度、热解时间、升温速率等。分析了含油污泥热解的机理,探讨了热解含油污泥制备吸附材料的活化改性,并在此基础上对所制备吸附材料的脱硫性和除油性进行了研究。     

The determination and matching analysis of pinch point temperature difference in evaporator and condenser of organic rankine cycle for mixed working fluid

Exergo-economic analysis of the pinch point temperature difference (PPTD) in both evaporator and condenser of sub-critical organic Rankine cycle system (ORCs) are performed based on the first and second laws of thermodynamics. Taking mixture R13I1/R601a as a working fluid and the annual total cost per net output power Z as exergo-economic performance evaluation criterion, the effects of PPTD in evaporator ΔT_e, and the PPTD ratio of condenser to evaporator y, on the exergo-economic performance of ORCs are analyzed. Moreover, how some other parameters influence the optimal PPTD in evaporator ΔT_e,opt and the optimal PPTD ratio of condenser to evaporator y_opt are also discussed. It has been found that the exergo-economic performance of ORCs is remarkably influenced by ΔT_e and y, and there exists ΔT_e,opt and y_opt. In addition, ΔT_e,opt and y_opt are affected by heat transfer coefficient ratio of condenser to evaporator ß, the temperature of working fluid at dew point in condenser T_1a, and composition of R13I1/R601a: larger ß and T_1a lead to lower ΔT_e,opt and y_opt; by contraries, larger mass fraction of R13I1 makes ΔT_e,opt and y_opt increase, and y_opt increases linearly. The effects of the temperature of working fluid at bubble point in evaporator T_3a, mass flow rate of exhaust flue gas m_g, and inlet temperature of exhaust flue gas T_gi on ΔT_e,opt and y_opt are very slight. For comparison, three additional working fluids, namely R601a, R245fa, and 0.32R245fa/0.68R601a, are also taken into account.     

Rebound effect and its decomposition – an analysis based on energy types in China

Rebound effect derived from energy efficiency improvement has been widely invested. However, most of studies focus on the rebound effect of the energy composite level and neither distinguish nor compare different energy types. We compare the differences in energy saving and energy rebound between primary and secondary energy sources, and further decompose the rebound effect into production rebound part and final demand component. To do so, we add a module for rebound into a comparative state China-CGE model. We design and test two simulation scenarios using the model. In Scenario 1, all production sectors’ energy efficiency of using primary energy increases by 5%. In Scenario 2, all production sectors’ energy efficiency of using secondary energy increases by 5%. The results show that Scenario 2 leads to more GDP growth and more energy saving. Our scenarios show rebound effects range between 9.6% and 27.9%, and in general are higher when energy efficiency of using primary energy sources is improved. Our decomposition analysis shows that improving energy efficiency in production sectors would stimulates energy use of final demand. Indeed, the consumption side has significant contribution to rebound in secondary energy use, especially in crude oil and gas. This study reveals that improving efficiency of using secondary energy is better than improving that of primary energy, both in terms of economic impact and energy rebound. And complementary policies that prevent energy services prices from falling too much can be adopted to reduce rebound. Controlling residential energy use could also be effective in reducing rebound, this has particular implication to economies in which residential energy consumption are far from saturation.     

Pseudomonas sp.fz胞外分离物降解四溴双酚A

四溴双酚A(TBBPA)是全球消耗量最大的溴系阻燃剂。通过活性物质的定位、分离和TBBPA产物的分析等步骤,对Pseudomonas sp.fz胞外分离物降解TBBPA进行了研究。结果表明,存在于胞外的活性物质通过异丙基断裂和脱溴两条途径降解TBBPA。通过超滤,Sephadex G-10分离纯化得到了具有降解活性的小分子物质,分子量约为376~456 Da,初步鉴定为短肽类物质。这种小分子物质具有很好的热稳定性(30~80℃),在弱酸性条件下(2.0~5.0)活性较高,其活性还受金属离子、氧气和抑制剂(Na N3)的影响。此外,部分纯化的小分子物质在一定条件下能够产生羟基自由基(·OH)。     

不同培养条件下锰过氧化物酶(MnP)的合成及其对甲基橙的降解

高效、大规模、低成本合成木质素降解酶是直接采用其降解难降解有机污染物所必须解决的问题.对锰过氧化物酶(MnP)降解甲基橙和在非灭菌的反应器中连续合成MnP的可行性进行考察.结果表明,在采用2 mmol H2O2和1.5 mmol MnSO4的降解体系中,获最大脱色效果,且100、200和300 U/L的MnP可在8h内将甲基橙分别脱色18％、23％和35％;在非灭菌的反应器水平上实现了固定化培养的P.chrysosporium连续23 d合成MnP,但MnP酶活仅为2～ 23 U/L,难以酶解甲基橙;然而,在摇瓶培养条件下固定化的P.chrysosporium合成的MnP却能达1 152 U/L.因此,直接采用MnP对污染物进行降解以及在非灭菌的反应器中持续合成MnP是可行的,但就在非灭菌条件下如何提高MnP的合成量还有待开展深入的研究.     

阳离子型聚合物对低温低浊水的絮凝效果与形态学特性

采用微絮凝-深床直接过滤工艺,以西安市曲江水厂低温低浊水质为原水(水温低于10 ℃,初始浊度低于10NTU),投加阳离子型聚合物(简称CP)作主混凝剂或助凝剂,借助分形数学理论与图像分析技术,对滤料粒径、原水浊度、原水温度、药剂种类、聚合物分子量及投加量、混合强度等因素对处理效果的影响进行了研究,分析探讨了不同药剂处理低温低浊水的作用机理、絮凝形态学特征以及絮体结构的分形特性.结果表明,①当温度低于4 ℃、初始浊度小于4NTU时,不宜单独采用Al2(SO4)3或PAC作为絮凝剂;当温度为4～10 ℃、初始浊度小于10NTU时,如果只投加Al2(SO4)3或PAC作为絮凝剂,宜用细砂滤料过滤;低温低浊条件下,无机混凝剂形成的絮体粒径小、结构松散脆弱、有效质量密度低、沉速慢,但表征絮体分形特性的分维值较高.②CP作絮凝剂能显著改善低温低浊水的絮凝效果与过滤性能,但混合强度需增大,宜用粗砂滤料过滤;③单独用CP作絮凝剂时,宜投加分子量较低的弱阳性聚合物或投加低剂量较高分子量的强阳性聚合物;CP用作助凝剂时,能显著减少主混凝剂用量,但宜投加强阳性聚合物或增加弱阳性聚合物的剂量.④CP兼备电性中和与吸附架桥絮凝作用,能形成粒径较大、吸附性能与过滤性能良好的网状絮体构型,其有效质量密度高,产生的污泥量少,污泥沉降速度快,脱水效果好,但分维值低.⑤各种水处理药剂的处理效果为:Al2(SO4)3(或PAC) CP＞CP＞PAC＞Al2(SO4)3,这种差别由絮体的形态学特性与构型特征各异引起.     

环境影响后评价的最新进展与建议

结合《中华人民共和国环境影响评价法》的有关条款,探讨了环境影响后评价的概念、分类、适用对象、意义和内容,提出了环境影响后评价的管理和实施程序.结合多年的实践,分析了目前环境影响后评价工作在理论、方法和管理上存在的问题,提出了改进和完善的建议.案例实践表明,开展环境影响后评价有助于提高环境影响评价制度的有效性.