悬浮膜(CFM)分离技术在油田废水处理中的应用

应用微电解等技术对油田废水进行预处理,然后用悬浮膜进行分离,使其中的油、微生物和固体物与水相分离,使其达到回注用水要求。重点对CFM分离设备的结构及原理加以介绍,以期推进过滤技术的进步,提高油田废水的处理水平。     

Utilizing surfactants to control the sorption, desorption, and biodegradation of phenanthrene in soil-water system

An integrative technology including the surfactant enhanced sorption and subsequentdesorption and biodegradation of phenanthrene in the soil-water system was introduced and tested. For slightly contaminated agricultural soils, cationic-nonionic mixed surfactant- enhanced sorption of organic contaminants onto soils could reduce their transfer to plants, therefore safe-guarding agricultural production. After planting, residual surfactants combined with added nonionic surfactant could also promote thedesorption and biodegradation of residual phenanthrene, thus providing a cost-effective pollution remediation technology.0ur results showed that the cationic-nonionic mixed surfactantsdodecylpyridinium bromide (DDPB) and Triton X-100 (TX100) significantly enhanced soil retention of phenanthrene. The maximum sorption coefficient Kd* of phenanthrene for contaminated soils treated by mixed surfactants was about24.5 times that of soils without surfactant (Kd ) and higher than the combined effects of DDPB and TX100 individually, which was about 16.7 and 1.5 times Kd , respectively.0n the other hand, TX100 could effectively remove phenanthrene from contaminated soils treated by mixed surfactants, improving the bioavailability of organic pollutants. Thedesorption rates of phenanthrene from these treated soils were greater than 85% with TX100 concentration above2000 mg/L and approached 100% with increasing TX100 concentration. The biodegradation rates of phenanthrene in the presence of surfactants reached over 95% in30days. The mixed surfactants promoted the biodegradation of phenanthrene to some extent in 10-22days, and had no obvious impact on phenanthrene biodegradation at the end of the experiment. Results obtained from this study provide some insight for the production of safe agricultural products and a remediation scheme for soils slightly contaminated with organic pollutants.     

A pilot-scale study of cryolite precipitation from high fluoride-containing wastewater in a reaction-separation integrated reactor

Fluoride removal by traditional precipitation generates huge amounts of a water-rich sludge with low quality, which has no commercial or industrial value. The present study evaluated the feasibility of recovering fluoride as low water content cryolite from industrial fluoride-containing wastewater. A novel pilot-scale reaction-separation integrated reactor was designed. The results showed that the seed retention time in the reactor was prolonged to strengthen the induced crystallization process. The particle size of cryolite increased with increasing seed retention time, which decreased the water content. The recovery rate of cryolite was above 75% under an influent fluoride concentration of 3500 mg/L, a reaction temperature of 50℃, and an influent flow of 40 L/hr. The cryolite products that precipitated from the reactor were small in volume, large in particle size, low in water content, high in crystal purity, and recyclable.     

不同材质对催化裂化装置催化剂粉尘粘附性能的试验研究

在三座DN150 mmX1600 mm有机玻璃塔试验装置上,考察了DN15的塑料拉西环、陶瓷拉西环和不锈钢拉西环三种材质填料对催化剂的粘附能力。在催化剂浓度5‰,液相负荷40 L/h,气相负荷80 m3/h的条件下,经过408h的连续运转,结果表明不同材质填料对催化剂的粘附能力均存在饱和状态,粘附在填料上的催化剂不随时间的持续增加而增多。其中,塑料填料对催化剂的粘附能力最强,增重0.125kg;不锈钢填料次之,增重为0.115kg;陶瓷填料最弱,增重为0.055kg。可为相关领域的工业应用提供借鉴和数据支撑。     

我国工业固体废物的产生特征及控制对策

工业固体废物是固体废物的重要组成部分。根据我国最近10年发布的工业固体废物统计数据,全面分析了我国工业固体废物的产生特点,研究了工业固体废物产生量、利用量和处置量、工业固体废物区域和行业分布特点以及与工业产值的关系,并针对我国工业固体废物管理存在的问题,提出了相应的对策和建议。     

复合膜生物反应器处理环氧氯丙烷废水

实验利用复合膜生物反应器处理以甘油为原料制备环氧氯丙烷产生的废水,考察了不同进水COD、水力停留时间以及盐度对处理能力的影响,并进行盐度冲击实验。生物处理后出水进行了深度处理的研究。结果表明:进水COD对处理能力影响较小;适当延长水力停留时间能优化出水水质;废水盐度高于22g/L时会对微生物产生抑制作用;深度处理能进一步降低出水COD;微生物通过一定时间的驯化期能适应并处理高盐度废水。     

飞灰对废弃物焚烧过程中二恶英的抑制和捕获作用研究

通过工程试验和分析测试,分别对城市生活垃圾和医疗废弃物焚烧过程中高温烟气段和低温烟气段飞灰对二恶英的抑制和捕获作用进行了初步的研究。研究表明:适当增加锅炉灰循环量对于二恶英的再合成能起到抑制作用,飞灰中金属氧化物介质可能存在着催化和阻止的双重竞争机制;添加飞灰对于吸附医疗废物焚烧尾气中的二恶英所起作用不明显,但飞灰对燃烧残炭的吸附作用非常明显。     

地质雷达在监测地下水石油烃污染中的应用

随着我国工业迅速发展,石油烃污染威胁地下水安全问题逐渐暴露出来。地质雷达作为一种非破坏性的原位探测技术在国外已广泛应用于地下水监测,由于石油烃在地质雷达图谱上通常显示出高阻异常特征,这为探测地下水中的石油烃污染提供了可能。简述了地质雷达探测石油烃的原理,探测效果的影响因素,并列举了部分国外实例,证实了地质雷达探测地下水石油烃污染的可行性。     

明胶厂剩余高钙污泥作为燃煤固硫剂的应用研究

明胶生产产业在废水处理工艺中产生大量剩余高钙污泥,采用该剩余污泥作为燃煤固硫剂,在高温管式电阻炉内进行燃烧实验,通过测定燃烧前和燃烧后样品中的硫含量确定该剩余污泥的固硫效果。通过单因素研究煤粉粒径、剩余污泥粒径和剩余污泥/煤样%等影响因素对固硫率的影响。在单因素试验的基础上通过正交设计法优选达到较高固硫率的实验条件。实验结果表明:影响固硫率的因素从大到小依次为燃烧温度>剩余污泥/煤样%>煤粉粒径>剩余污泥粒径。以剩余污泥作为固硫剂,固硫率最高的实验条件为:燃烧温度800℃,剩余污泥/煤样为3%,煤粉粒径60⁹0目,剩余污泥粒径9090目,剩余污泥粒径90¹20目。并且,当温度达到1150℃,煤粉粒径90120目。并且,当温度达到1150℃,煤粉粒径90¹20目,剩余污泥粒径为60120目,剩余污泥粒径为60⁹0目,污泥/煤样(质量比)为3%时,固硫率可达62.78%,说明在高温下该剩余污泥保持较高的固硫率。将明胶厂剩余污泥作为固硫剂是较为合适的再利用方法,可有效缓解当前该污泥大量堆积污染环境的状况。     

Pb(II) removal from water using Fe-coated bamboo charcoal with the assistance of microwaves

Bamboo charcoal(BC) was used as starting material to prepare iron-modified bamboo charcoal(Fe-MBC) by its impregnation in FeCl 3 and HNO 3 solutions simultaneously,followed by microwave heating.The material can be used as an adsorbent for Pb(Ⅱ) contaminants removal in water.The composites were prepared with Fe molar concentration of 0.5,1.0 and 2.0 mol/L and characterized by means of N 2 adsorption-desorption isotherms,X-ray diffraction spectroscopy(XRD),scanning electron microscopy coupled with energy dispersive X-ray spectrometry(SEM-EDS),Fourier transform infrared(FT-IR) and point of zero charge(pH pzc) measurements.Nitrogen adsorption analyses showed that the BET specific surface area and total pore volume increased with iron impregnation.The adsorbent with Fe molar concentration of 2 mol/L(2Fe-MBC) exhibited the highest surface area and produced the best pore structure.The Pb(Ⅱ) adsorption process of 2Fe-MBC and BC were evaluated in batch experiments and 2Fe-MBC showed an excellent adsorption capability for removal Pb(Ⅱ).The adsorption of Pb(Ⅱ) strongly depended on solution pH,with maximum values at pH 5.0.The ionic strength had a significant effect on the adsorption at pH < 6.0.The adsorption isotherms followed the Langmuir isotherm model well,and the maximum adsorption capacity for Pb(Ⅱ) was 200.38 mg/g for 2Fe-MBC.The adsorption processes were well fitted by a pseudo second-order kinetic model.Thermodynamic parameters showed that the adsorption of Pb(Ⅱ) onto Fe-MBC was feasible,spontaneous,and exothermic under the studied conditions,and the ion exchange mechanism played an significant role.These results have important implications for the design of low-cost and effective adsorbents in the removal of Pb(Ⅱ) from wastewater.