Solution by dilution?—A review on the pollution status of the Yangtze River

The Yangtze River has been a source of life and prosperity for the Chinese people for centuries and is a habitat for a remarkable variety of aquatic species. But the river suffers from huge amounts of urban sewage, agricultural effluents, and industrial wastewater as well as ship navigation wastes along its course. With respect to the vast amounts of water and sediments discharged by the Yangtze River, it is reasonable to ask whether the pollution problem may be solved by simple dilution. This article reviews the past two decades of published research on organic pollutants in the Yangtze River and several adjacent water bodies connected to the main stream, according to a holistic approach. Organic pollutant levels and potential effects of water and sediments on wildlife and humans, measured in vitro, in vivo, and in situ, were critically reviewed. The contamination with organic pollutants, including polycyclic aromatic hydrocarbons, polychlorinated biphenyls (PCBs), organochlorine pesticides (OCPs), polychlorinated dibenzo-p-dioxins/polychlorinated dibenzofurans, polybrominated diphenyl ethers (PBDEs), perfluorinated compounds (PFCs), and others, of water and sediment along the river was described. Especially Wuhan section and the Yangtze Estuary exhibited stronger pollution than other sections. Bioassays, displaying predominantly the endpoints mutagenicity and endocrine disruption, applied at sediments, drinking water, and surface water indicated a potential health risk in several areas. Aquatic organisms exhibited detectable concentrations of toxic compounds like PCBs, OCPs, PBDEs, and PFCs. Genotoxic effects could also be assessed in situ in fish. To summarize, it can be stated that dilution reduces the ecotoxicological risk in the Yangtze River, but does not eliminate it. Keeping in mind an approximately 14 times greater water discharge compared to the major European river Rhine, the absolute pollution mass transfer of the Yangtze River is of severe concern for the environmental quality of its estuary and the East China Sea. Based on the review, further research needs have been identified.     

H(+)/phenanthrene symporter and aquaglyceroporin are implicated in phenanthrene uptake by wheat (Triticum aestivum L.) roots

Polycyclic aromatic hydrocarbons (PAHs) are ubiquitous organic pollutants that are toxic to human and nonhuman organisms. Dietary intake of PAHs is a dominant route of exposure for the general population because food crops are a major source of dietary PAHs. The mechanism for crop root uptake of PAHs remains unclear. Here we reveal that wheat root uptake of PAHs involves active and passive processes. The passive uptake is mercury and glycerol dependent. Mercury and glycerol inhibit uptake, indicating that aquaglyceroporins sensitive to mercury contribute to passive uptake. Active uptake is mediated by a phenanthrene/H symporter. The electrical response of wheat roots triggered by phenanthrene consists of two sequential phases: depolarization followed by repolarization. The depolarization is phenanthrene concentration dependent, with saturation kinetics that have an apparent of K(m) 10.8 μmol L(-1). As uptake proceeds, external solution pH increase is noticed. Lower pH favors the uptake. Vanadate and 2,4-dinitrophenol suppress the electrical response to phenanthrene and phenanthrene uptake, suggesting that plasma membrane H(+)-ATPase is involved in the establishment of an electrochemical proton gradient acting as a driving force for active uptake. Therefore, it is suggested that aquaglyceroporin and phenanthrene/H symporter are implicated in phenanthrene uptake. Our results provide insight into PAH uptake mechanism in wheat roots that is relevant to strategies for reducing PAH accumulation in wheat for food safety, improving phytoremediation of PAH-contaminated soils or water by agronomic practices and genetic modification to target remedial plants for higher PAH uptake capacity.     

基于排队论的城市垃圾箱最佳间距研究

针对城市垃圾箱最佳间距的研究不够精细的现状,本文通过建立排队论模型得到了可供不同城市参考的城市垃圾箱最佳间距参数表。通过对部分城市街道的垃圾箱摆放间距情况进行实地调查,运用层次分析法将影响垃圾箱间距分布的多重因素转化为单因素;建立了基于指数分布的数学模型,利用排队论分析单因素状态下的垃圾箱间距分布,得到了求解城市垃圾箱最佳间距的一般方法。     

矿化垃圾床＋三维电极／电Fenton法处理老龄垃圾渗滤液

提出以二级矿化垃圾床为预处理单元,串联三维电极／电Fenton处理老龄垃圾渗滤液的组合工艺。矿化垃圾床处理后渗滤液中COD、氨氮、总磷、色度的去除率分别为80．55％、88．47％、98．32％和87．53％。通过单因素实验和正交实验,确定了三维电极／电Fenton法最佳工艺条件。经该组合工艺后,渗滤液中COD、氨氮、总磷和色度的最高去除率分别可达97．08％、95．24％、99．55％和96．92％,其中COD、总磷、色度这3个指标低于《生活垃圾填埋场污染控制标准》（GB16889．2008）表2规定的排放标准,为该组合工艺在实际中的应用提供重要理论依据。     

有害物质环境测试组合舱的研制及性能评价

研制了一种新型有害物质环境测试组合舱,该测试舱由舱体系（内舱和外舱）、恒温恒湿空气处理系统、空气循环装置和信号控制与处理软件组成。该测试舱具有可分别使用内舱和外舱对样品进行测试的特点,并采用美国FLUNT公司开发的air pack软件包对内舱和外舱的气流进行模拟与计算,并划分出内舱的层流区域,同时也对舱体系的性能进行了测试与评价。结果表明,有害物质环境测试组合舱的温湿度的相对标准偏差分别为0.04℃和0.7%,混合性达到90.7%。因此,该有害物质环境测试组合舱对温湿度控制精准,气流稳定,混合性能良好,能为室内空气污染研究提供条件稳定的室内仿真环境。     

昆明市污水排水系统产甲烷规律的模拟实验研究

通过对昆明市餐饮和居民生活污水厌氧模拟实验研究,初步探讨生活污水中CH4的产生规律,实验结果表明,在自然条件下,餐饮和居民生活污水中产生的甲烷浓度最大值分别为1.63 mg/L和3.82 mg/L。并且将COD、硫酸盐、硫化物、TN的浓度变化与甲烷浓度变化进行Pearson简单相关性分析,结果表明,1/COD、COD/硫酸盐和1/TN与甲烷在置信度为0.01时极显著相关,硫化物与甲烷在置信度为0.05时不相关;COD、硫酸盐和TN浓度的变化对生活污水中甲烷的产生起关键性作用。对居民生活污水中甲烷产生规律进行温度和pH控制分析研究,实验结果表明,生活污水在25~30℃时,24 h内甲烷产生量最大值为8.6494 mg/L,明显大于其他温度段的甲烷产生量;在pH为7~8之间时,甲烷的产生量在24 h内达到的最大值为3.0477 mg/L,明显高于其他pH控制段的甲烷产生量。     

曝气沉砂池除砂机理分析

针对曝气沉砂池小试装置模型,通过配砂实验对沉砂池除砂率进行统计分析,研究曝气强度与HRT对沉砂池除砂率的影响。实验结果表明,不同曝气强度下,随着HRT变化,除砂率逐渐上升,并最终趋于平衡状态;不同HRT下,曝气强度与除砂率近似呈现一定的线性关系,且随着曝气强度的增大,除砂率降低;在HRT小于1min时,砂粒的运行路径和沉降时间缩短,不利于砂粒的去除;在HRT大于1min时,其中1、3和4min,随着气水比的增加除砂率降低幅度相对较小,曝气所引起的横向环流在一定程度上有利于砂粒的沉降,而HRT为2min时,除砂率降幅却很大,这与砂粒在曝气沉砂池池体断面分布有关,即断面处旋转流速和水平流速的大小变化将影响砂粒的运动;相比曝气强度,HRT对除砂率的影响较大。     

利用污泥进行水体中重金属生物吸附研究现状及展望

对国内外利用废水处理等工业过程中所产生的污泥作为生物吸附剂吸附水体中重金属的研究现状进行了综述和分析,包括其预处理技术、反应机理、主要影响因素、处理效果以及反应器工艺等。同时,对该技术未来的发展趋势进行了展望,指出依托现有废水处理设施进行集约化开发将是该工艺的发展方向。     

A process integration approach to industrial water conservation: a case study for a Chinese steel plant

A systematic approach to optimizing water network has traditionally been utilized to exam and plan water conservation in industrial processes. In the present case study, water-pinch technology was used to analyze and optimize the water network of a steel plant near China's Zhangjiakou city. A system design was developed and a limiting constraint (Cl(-) concentration) was identified based on investigations of water quality then the minimum freshwater and wastewater targets were determined without considering water losses. The analysis was then extended by calculating the additional input of freshwater required to balance the actual water losses. A nearest-neighbor algorithm (NNA) was used to distribute the freshwater and recycled water among each of the plant's operations. The results showed that with some reconstruction of the water network, the flow rates of freshwater and wastewater could be decreased by 57.5% and 81.9%, respectively.