酸解破乳作用处理高含固率洗毛废水的研究

洗毛废水是一种高浓度有机废水,含固率高,主要成分是羊毛脂、羧酸盐和土杂,由于强极性物质的存在和胶体强的负电性,导致洗毛废水形成稳定的乳化体系.本试验通过加入硫酸改变洗毛废水的有机组成,降低体系的Zeta电位,破坏体系的稳定性,从而使得有机物发生凝聚沉降,达到去除COD的目的.硫酸加入量达到0.2%或以上时对洗毛废水中SS的自然沉降性、絮凝性和极性有很大影响,比阻从远大于9.81×1013m/kg,下降为5.54×1010m/kg,COD去除率达到86.8%,SS去除率达到98%.因此,洗毛废水加酸处理后通过机械脱水,实现固液分离,以降低原废水的色度和大幅降低COD的方式,是可供考虑的处理工艺.     

UV/Fenton法处理间-甲酚废水

利用UV/Fenton工艺对模拟间-甲苯酚废水进行了处理,研究了H2O2加入量、FeSO4加入量、pH、原水初始COD值、环境温度、反应时间等因素对COD去除率的影响.实验表明:间-甲苯酚浓度为100mg/L、初始COD值251 mg/L的废水,在30℃下,pH为4.Q,[H2O2]/[Fe2 ]=15(质量浓度比),紫外灯照射3 h后,COD去除率达86.3%,若再经Ca(OH)2絮凝沉降,则COD去除率提高到92.6%.同时,对Fenton及UV/Fenton的处理效果进行了比较,实验表明:UV/Fenton的处理效果明显优于Fenton法.     

活性炭纤维吸附废水中对硝基苯酚及其脱附研究

采用新型高效吸附剂——活性炭纤维吸附废水中对硝基苯酚，对其吸附和脱附影响因素进行了较详细的研究，确定了最佳工艺参数，并对动态吸附一脱附进行了稳定性实验。在最佳的吸附条件下，装填4g活性炭纤维可处理含对硝基苯酚1000mg/L的废水1400mL，出水对硝基苯酚浓度〈2mg／L，达到国家综合污水一级排放标准，活性炭纤维有效吸附量可达349．87mg／g。在最佳脱附条件下，脱附率〉99％，并可从高浓度脱附液中回收对硝基苯酚。稳定性实验表明，吸附-脱附性能稳定，采用活性炭纤维吸附处理对硝基苯酚废水是一种行之有效的处理方法。     

Fenton-混凝法处理焦化废水的试验研究

对Fenton预氧化-混凝法联用技术处理焦化废水进行了研究，探讨了Fenton氧化阶段H2O2投加量、混凝阶段pH值以及混凝剂投加量等因素对焦化废水COD去除率的影响，确定了最佳处理条件。结果表明，Fenton预氧化一混凝法处理焦化废水取得了良好效果，COD去除率达97．5％，为该工艺实际处理焦化废水提供了实验依据。     

Study of using microfiltration and reverse osmosis membrane technologies for reclaiming cooling water in the power industry.

A study of using dual membrane technologies, microfiltration (MF) and reverse osmosis (RO), for reclaiming blowdown of the cooling tower was conducted at ZJK power plant, Hebei province, China. The study shows that the combined MF-RO system can effectively reduce water consumption in the power industry. The results indicate that MF process is capable of producing a filtrate suitable for RO treatment and achieving a silt density index (SDI) less than 2, turbidity of 0.2 NTU. The water quality of RO effluent is very good with an average conductivity of about 40 micros/cm and rejection of 98%. The product water is suitable for injection into the cooling tower to counteract with cooling water intrusion. After adopting this system, water-saving effectiveness as expressed in terms of cycles of concentration could be increased from 2.5-2.8 times to 5 times.     

Use of chemical coagulants to control fouling potential for wastewater membrane bioreactor processes.

Chemical coagulation with ferric chloride, alum, and an organic polymer were used to control the fouling potential of mixed liquors for submerged membrane bioreactor (MBR) processes in treating municipal wastewater. Their filterability was evaluated using a submerged hollow fiber ultrafiltration apparatus operated in constant permeate flux mode. The collected transmembrane pressures over filtration time were used to calculate the membrane fouling rates. The results showed that coagulation pretreatment can reduce fouling rates when MBRs were operated above the critical flux. Even though coagulation with the organic polymer formed larger mixed liquor suspended solids particles and had shorter time-to-filtration than those with ferric chloride and alum, the filterability for membrane filtration were similar, indicating that the membrane fouling in MBR systems was mainly controlled by the concentration of smaller colloidal particles.     

啤酒生产废水处理设计及运行研究

分析了年产15万t啤酒的生产废水情况,介绍了采用IC厌氧反应器-一体化氧化沟处理该生产废水(7 200 m3/d)的工艺路线和主要设计参数,讨论了废水处理系统的运行情况.其中IC厌氧反应器的HRT为8 h,运行温度为35～37 ℃;一体化氧化沟包括氧化沟段和沉淀池段,总尺寸为40 m×24 m×6 m.IC厌氧反应器COD容积负荷在7.78 kg/(m3·d)时,COD去除率为84%左右.整套废水处理系统的COD总去除率为98%左右,出水COD小于80 mg/L.厌氧所产生的沼气可用于废水的升温.     

Trace metal behaviour in the Conwy estuary,North Wales

The distribution of trace metals Zn, Ni, Mn, Fe, Cu, Pb, Cd and Cr between suspended particulate matter (SPM) and water in the Conwy estuary, North Wales, has been studied in three surveys in 1998. Dissolved Cu and Mn showed some monthly variations. Most of the dissolved trace metals displayed a negative association with salinity, indicating rivers as a major source of inputs for them. Particulate Zn, Mn and Fe showed a decreasing concentration seaward, whilst the levels of Ni, Cu, Cr and Pb increased with salinity. SPM concentration was the most important variable significantly related to trace metal concentrations in SPM, with an inverse relationship between the two parameters. This was explained by the relative enrichment of trace metals in fine particles at low SPM concentrations and relative depletion of trace metals in coarse particles at high SPM concentrations. Particulate Zn, Mn and Pb were dominated by the fraction available to acetic acid (non-detrital), whilst particulate Ni, Fe and Cr were dominated by the fraction available to nitric acid (detrital). The partition coefficient of trace metals between SPM and water declined with increasing SPM concentration, consistent with the so-called "particle concentration effect". Such a phenomenon may be explained by the presence of fine particles (including colloids) enriched with trace metals at low SPM concentrations, and the salinity-induced desorption.     

Pesticides in precipitation in the Gdańsk region (Poland)

Selected organonitrogen, organophosphorus and organochlorine pesticides have been determined in precipitation samples collected at 10 sites in the Gdańsk region (northern Poland) over a period of one year (1998). Compounds which were detected most often included simazine (0.11-5.80 ng/l), fenitrothion (0.1-2.10 ng/l), chlorfenvinfos (0.1-1.30 ng/l), gamma-HCH (0.012-5.06 ng/l), heptachlor epoxide (0.05-3.28 ng/l) and aldrin (0.02-3.28 ng/l). The pesticide concentrations in precipitation samples revealed seasonal fluctuations, with higher concentrations observed during the application periods (June and July). The concentrations observed were also affected by the inflow of polluted air masses from the southwest. The total pesticide concentration in the precipitation samples was strongly related to the abundance of green areas in the vicinity of the sampling sites. A weak correlation was also found between the total concentration of organonitrogen and organophosphorus pesticides, and the total concentration of organochlorine pesticides in the samples collected.