Sources and patterns of polycyclic aromatic hydrocarbons pollution in kitchen air,China

Twelve polycyclic aromatic hydrocarbons, multi-ringed compounds known to be carcinogenic in air of six domestic kitchens and four commercial kitchens of China were measured in 1999-2000. The mean concentration of total PAHs in commercial kitchens was 17 microg/m3, consisting mainly of 3- and 4-ring PAHs, and 7.6 microg/m3 in domestic kitchens, where 2- and 3-ring PAHs were predominant, especially naphthalene. The BaP levels in domestic kitchens were 0.0061-0.024 microg/m3 and 0.15- 0.44 microg/m3 in commercial kitchens. Conventional Chinese cooking methods were responsible for such heavy PAHs pollution. The comparative study for PAH levels in air during three different cooking practices: boiling, broiling and frying were conducted. It was found that boiling produced the least levels of PAHs. For fish, a low-fat food, frying it produced a larger amount of PAHs compared to broiling practice, except pyrene and anthracene. In commercial kitchens, PAHs came from two sources, cooking practice and oil-fumes, however the cooking practice had a more predominant contribution to PAHs in commercial kitchen air. In domestic kitchens, except for cooking practice and oil-fumes, there were other PAHs sources, such as smoking and other human activities in the domestic houses, where 3-4 ring PAHs mainly came from cooking practice. Naphthalene (NA, 2-ring PAHs) was the most predominant kind, mostly resulting from the evaporation of mothball containing a large quantity of NA, used to prevent clothes against moth. A fingerprint of oil-fumes was the abundance of 3-ring PAHs. Heating at the same temperature, the PAHs concentrations in different oil-fumes were lard > soybean oil > rape-seed oil. An increase in cooking temperature increased the levels of PAHs, especially acenaphthene.     

The ageing effect on the bioaccessibility and fractionation of arsenic in soils from China

Ingestion of contaminated soil has been recognized as an important exposure pathway of arsenic for humans, especially for children through outdoor hand-to-mouth activities. An improved sequential extraction procedure was employed in an attempt to reveal the relationship between bioaccessibility and fractionation of As in five soils from China. Arsenic bioaccessibility in acidic ( approximately pH 4.5) soils reached approximately stable levels after a sharp decline within one week of ageing. In contrast, As bioaccessibility in higher pH (>6.0) soils was found to be significantly higher and took two weeks of ageing to reach stable levels. The artificially added As was more labile than indigenous As. The main proportions of added As were found in the specifically sorbed and amorphous and poorly-crystalline hydrous Fe/Al oxide-bound fractions. Correlation analysis shows that the non-specifically and specifically sorbed As are likely to constitute the main proportion of bioaccessible soil As. The soil content of amorphous and crystalline Fe/Al oxides and soil pH appear to be the key factors controlling, not only the time needed to reach a steady state, but also the magnitude of the bioaccessibility of As added to the soils.     

炭纤维载体固定床厌氧发酵启动运行效果实验

以开发高效率、抗冲击性能强的高浓度有机废水沼气发酵技术为目的,用传统的 UASB反应器作为对照,研究了以炭纤维为生物膜载体的固定床厌氧反应器的启动运行效果。反应器进口废水 COD 为 5 000 mg/L, 水力停留时间 (HRT) 由213 h 逐步缩短为35 h,进水有机容积负荷(OLR)由0.56 kg COD/ (m³·d)提到3.45 kg COD/(m³·d)。结果表明,固定床反应器厌氧发酵的效率比对照高,出水 pH 值也比对照稳定;运行到第 50 d 时,固定床厌氧反应器和对照的 COD去除率分别由第 7 d 的36.56%和33.58%上升到87.9%和62.6%;固定床厌氧反应器的容积比产气率最高为1.16 m³/(m³·d),累计产气量为415.59 L,而对照的容积比产气率最高值仅为0.31 m³ /(m³·d),累计产气量为 71.66 L,前者最高容积比产气率和累计产气量分别是后者的3.74倍和5.78倍。固定床厌氧反应器的启动速度、COD 去除率和产甲烷效率显著地高于对照反应器。     

高气泡表面积通量浮选柱气浮除藻的研究

湖泊、水库等水源的富营养化,使藻类去除成为饮用水生产的重要任务.本研究采用高气泡表面积通量浮选柱气浮除藻,考察了混凝剂、气泡表面积通量和浮选柱高度等因素的影响.试验表明,高气泡表面积通量浮选柱气浮可高效地去除绿藻、硅藻和蓝藻,叶绿素a和藻类去除率达95%以上,比传统浮选柱气浮和沉降作业有较大幅度提高.与普通气浮柱比较,高气泡表面积通量浮选柱增加了气泡与藻的碰撞几率,防止因大表观充气速率造成的紊流和扰动,使气泡/藻结合体有相对静态的浮升环境,避免了气泡/藻结合体在浮升过程中的脱落,实现对藻类的迅速捕集和转移.     

稀土Ce掺杂SnSb复合涂层电极的实验研究

采用涂刷热分解氧化法,把无机盐SnCl4·5H2O、SbCl3和Ce(NO3)3·6H2O以一定的配比溶解在有机溶剂异丙醇中制备涂层液,以钛板为基体,制备多组分的涂层电极.考察了不同掺杂量下制备的电极对生活污水的处理效果,并对稀土Ce掺杂SnSb涂层进行了SEM表征,结果表明,在热处理温度为500℃、稀土掺杂量(原子质量比)为Sn∶Sb∶Ce=100∶10∶1的电极降解效果最好;稀土Ce的掺杂有利于锡锑金属氧化物涂层电极的电化学性能的提高.     

类Fenton氧化技术去除榨菜生产废水COD的研究

研究了紫外光照射下类Fenton试剂对榨菜生产废水COD的去除,考察了光照时间、初始pH值、过氧化氢用量、FeCl₃·6H₂O用量等因素对榨菜废水中COD去除率的影响。结果表明,光照时间60 min,初始pH值3,H₂O₂（30%）的用量为理论值的120%,c₀(H₂O₂)∶c₀［Fe(Ⅲ)］=11.6∶1.0时,COD去除率效果为最佳,达到79%。当H₂O₂投加总量不变时,去除率随着投加次数的增多而增大。     

气质联用分析加硫酸化污泥中的有机酸

分别采用两种前处理方法分离富集加硫酸化污泥中的有机酸.方法一,利用阴离子交换树脂分离富集有机酸,在不洗脱的情况下直接和乙醇进行酯化反应,然后进行气质联用分析;方法二,利用活性炭纤维吸附型固相微萃取(ACF-SPME)的方法,顶空萃取分离后进行气质联用分析.两种方法的分析结果都未检测到酸化污泥中存在短链的有机酸,只检测到个别长链的和带苯环结构的有机酸.     

Bioaccumulation kinetics of sediment-associated DE-83 in benthic invertebrates (Nereis succinea, polychaete)

Polychaetes (Nereis succinea) were exposed to DE-83 contaminated sediments to investigate the bioaccumulation and bioavailability of nona- and deca-BDEs in sediment. All the major congeners in DE-83 were bioavailable to the lugworms. The uptake coefficients (K_s) of nona- and deca-BDE congeners in lugworms were in the range of 0.18-0.65 (d⁻¹), with the values of BDE-207 and -208 slightly higher than those of BDE-206 and -209. Elimination of nona- and deca-BDE congeners from lugworms was very fast. The estimated half-lives of nona- and deca-BDE congeners in the lugworms were at 0.7 d. The bioavailability of nona- and deca-BDE congeners was very low, with BSAF of 0.017 for BDE-206 and -209 and 0.054 for BDE-207 and -208. These may be due to the large molecular size and high affinity of PBDEs to sediment particles. The contribution of BDE-206 in the profile of nona-BDEs in lugworm tissue decreased with exposure time while those of BDE-207 and -208 increased, which could be the result of the biotransformation of BDE-209 to BDE-207 and -208.     

结构面长期强度确定方法对比研究∗

结构面长期强度的确定对工程岩体长期安全稳定性评价具有重要意义。在对水泥砂浆结构面试件分别进行了不同法向应力条件的剪切应力分级剪切蠕变试验和循环剪切应力松弛试验的基础上,分别利用过渡蠕变法、应力-应变等时曲线法和应力松弛法对结构面的长期强度进行了求解。结果表明:过渡蠕变法确定的长期强度精度依赖于蠕变试验中加载应力级的划分;等时曲线法将长期强度值视为考虑时效作用的屈服强度值,结果偏保守;应力松弛法考虑了循环加载条件应力松弛的终止条件和长期强度之间的关系求得,结果合理明确。该研究对考虑时效作用的工程岩体安全稳定性支护提供设计依据。     

企业安全管理信息系统的总体构建

通过对安全管理现状的调查研究,根据现行企业安全管理系统的实际情况和问题进行安全管理信息系统的总体构建.此系统可以解决目前企业安全管理中普遍存在的问题如安全信息缺乏,信息渠道不畅通,反馈不及时等.因此,对企业向着安全管理方面发展具有十分重要的现实意义.