Inhalation exposure to volatile organic compounds in the printing industry

ABSTRACT

This study reports on the occupational inhalation exposure to VOCs of workers in the Kuwaiti printing industry. Using the evacuated canister methodology, we targeted 72 VOCs in three printeries and compared the concentrations to previous reports and relevant occupational exposure levels (OELs). We found that recent efforts in the printing industry to reduce VOC usage had been successful, as concentrations of key hazardous VOCs were substantially lower than anticipated. On the other hand, nearly all target VOCs were found. Non-production areas were sampled along with the offset printing areas, another strength of this study, and revealed exposures to hazardous VOCs among administers and digital printer and CTP operators. Exposure to ototoxic VOCs amounted to 1–3% of the OEL, consisting mostly of ethylbenzene, which was likely in use in two of the study printeries. Exposure to carcinogenic or probably carcinogenic VOCs was 15–20% of the OEL at four locations across the three printeries, consisting mostly of vinyl chloride and benzyl chloride. Vinyl chloride VOC was partially sourced from outdoors, but was also likely used inside the study printeries. Interestingly, concentrations of vinyl chloride were similar in most sampling locations to that of CFC-114, a CFC banned by the Montreal Protocol and not commonly used as a refrigerant. This unexpected finding suggests further study is warranted to identify the use of these VOCs in printeries. Exposure to hazardous VOCs up to nearly 50% of the OEL, consisting largely of bromoform and vinyl chloride. Bromoform was found in all the study printeries, sourced partially from outdoor air. The higher concentrations found inside the study printeries likely resulted from the use of the desalinated water for washing. This finding raises of emissions from sources other than blanket washes, and inks, etc. adding to the total VOC load in printery indoor air.

Implications: Results from this study indicate that efforts to reduce worker exposure to VOCs particularly dangerous to human health in recent years have been successful, but there is still much to be done to protect workers. Exposures to ototoxic and carcinogenic VOCs were identified, among both production and non-production workers. Unexpected findings included the apparent use in printing activities of the carcinogen vinyl chloride and CFC-114, banned under the Montreal Protocol. Observed lapses in safety procedures included failure to utilize ventilation systems and closing doors between work areas, indicating management and worker education should remain a priority.     

Identification of Sources of Phoenix Aerosol by Positive Matrix Factorization

ABSTRACT

Chemical composition data for fine and coarse particles collected in Phoenix, AZ, were analyzed using positive matrix factorization (PMF). The objective was to identify the possible aerosol sources at the sampling site. PMF uses estimates of the error in the data to provide optimum data point scaling and permits a better treatment of missing and below-detection-limit values. It also applies nonnegativity constraints to the factors. Two sets of fine particle samples were collected by different samplers. Each of the resulting fine particle data sets was analyzed separately. For each fine particle data set, eight factors were obtained, identified as (1) biomass burning characterized by high concentrations of organic carbon (OC), elemental carbon (EC), and K; (2) wood burning with high concentrations of Na, K, OC, and EC; (3) motor vehicles with high concentrations of OC and EC; (4) nonferrous smelting process characterized by Cu, Zn, As, and Pb; (5) heavy-duty diesel characterized by high EC, OC, and Mn; (6) sea-salt factor dominated by Na and Cl; (7) soil with high values for Al, Si, Ca, Ti, and Fe; and (8) secondary aerosol with SO₄ ^-2 and OC that may represent coal-fired power plant emissions.

For the coarse particle samples, a five-factor model gave source profiles that are attributed to be (1) sea salt, (2) soil, (3) Fe source/motor vehicle, (4) construction (high Ca), and (5) coal-fired power plant. Regression of the PM mass against the factor scores was performed to estimate the mass contributions of the resolved sources. The major sources for the fine particles were motor vehicles, vegetation burning factors (biomass and wood burning), and coal-fired power plants. These sources contributed most of the fine aerosol mass by emitting carbonaceous particles, and they have higher contributions in winter. For the coarse particles, the major source contributions were soil and construction (high Ca). These sources also peaked in winter.     

Water Footprint of the Palestinians in the West Bank1

Abstract: Water in the West Bank of Palestine is a key issue due to its limited availability. Water is used from own sources for domestic, industrial, and agricultural purposes. Moreover, water is consumed in its virtual form through consumption of imported goods, such as crops and livestock, the production of which used water in the country of production. In addition, wastewater in many parts of the West Bank is disposed off without treatment into the wadis, deteriorating the quality of the water resources in the area and, therefore, further reducing the quantity of good quality water available. This paper calculates the water footprint for the West Bank. The consumption component of the water footprint of the West Bank was found to be 2,791 million m³/year. Approximately 52% of this is virtual water consumed through imported goods. The West Bank per capita consumption component of the water footprint was found to be 1,116 m³/cap/year, while the global average is 1,243 m³/cap/year. Out of this number 50 m³/cap/year was withdrawn from water resources available in the area. Only 16 m³/cap/year (1.4%) was used for domestic purposes. This number is extremely low and only 28% of the global average and 21% of the Israeli domestic water use. The contamination component of the water footprint was not quantified but was believed to be many times larger than the consumption component. According to the official definition of water scarcity, the West Bank is suffering from a severe water scarcity. Therefore, there is a need for a completely new approach towards water management in the West Bank, whereby return flows are viewed as a resource and that is geared towards a conservation oriented approach of “use, treat, and reuse.”     

Monitoring of bisphenol A diglycidyl ether (BADGE) and some derivatives in fish products in the Turkey market

The exposure to bisphenols and their derivatives was assessed in 33 fish products sold in Turkey using high-performance liquid chromatography-tandem mass spectrometry (LC–MS/MS). BADGE was determined in only four samples at concentrations ranging between 0.06 and 0.22 mg/kg. As the most abundant bisphenol groups, BADGE-hydrolyzed products such as BADGE·H₂O and BADGE·2H₂O were present in nine and fourteen samples in the range between 0.06–0.16 and 0.06–0.72 mg/kg, respectively. The total concentration of BADGE and hydrolyzed products was below the specific migration limit (SML) value of 9 mg/kg food, which in the European Union stated as tolerable. Chlorinated derivatives of BADGE were detected in fewer samples compared with hydrolyzed ones. BADGE·H₂O·HCl was the predominant migrant among chlorinated derivatives and was present in seven samples in a range between 0.02 and 0.06 mg/kg. All other samples contained less than or equal to 0.03 mg/kg of BADGE·HCl and BADGE·2HCl. The sum of these derivatives was lower than the SML value (1 mg/kg) of BADGE chlorohydrins legislated by the European Union. Besides these migrants, the analyzed samples did not contain any BFDGE and 3R-NOGE, which are prohibited in manufacturing food contact materials.

     

Comparison of gas chromatography and immunoassay methods in quantifying fenitrothion residues in grape juice processed into alcoholic drinks

Abstract

Wine and Arak, the national alcoholic drink in Lebanon, were prepared from grape juice fortified with fenitrothion to a concentration of 20ppm. Samples of the 11 fractions produced by the fermentation and distillation steps were analyzed for fenitrothion residues using gas chromatography (GC) and enzyme‐linked immunosorbent assay (ELISA). Results of residue analyses showed that the two techniques were highly correlated (r = 0.978) and indicated that fenitrothion was stable during the fermentation steps but not during distillation. The clarified wine 35 days later contained about 85% (15.3 ppm) of the fenitrothion concentration found in the juice as determined by GC analysis. Arak was prepared by a two‐steps distillation of the clarified wine. The alcohol distillate and undistilled fraction from the first distillation contained 2.5 ppm and 5.8 ppm of fenitrothion, respectively. No fenitrothion residues were detected by both techniques in the four fractions collected from the second distillation step.     

Contribution to the food products' analysis: A research and evaluation on the hemolytic effect of some pesticides used in Lebanon

Pesticides are a real concern for the society as their use has become critical, leading sometimes to their accumulation as residues in fruits and vegetables. After examining the pesticides sold in Northern Lebanon, this study is focused on the analysis and identification of pesticides residues in fruits and vegetables that are harvested in this region and treated with the locally sold pesticides. Results show: first, (i) a use of Zineb by the name of another pesticide Micronized Sulfur to avoid prosecution; (ii) a significant presence of Metalaxyl in lemons and oranges; (iii) a significant presence of Trifluralin in strawberries; and (iv) a significant presence of Zineb in lemons and tomatoes. Second, with the use of hemolytic tests on human blood results show: (i) a critical concentration and a significant hemolytic effect of some pesticides used in Lebanon; and (ii) an absence of hemolytic effect in the collected fractions of the different analyzed fruit extracts containing pesticides. Finally, this work is the first step for pesticides' analysis in vegetables and fruits in Lebanon, initiating a wider analytical study in order to control and examine the use of pesticides which, according to our results, could have an adverse effect on human health over a long term.     

Monitoring of atrazine in milk using a rapid tube-based ELISA and validation with HPLC

Although atrazine has been banned in the European Union since 2007 it still persists in soil from where it can enter the food chain. Milk-producing animals accumulate atrazine from contaminated feed and water and since large quantities of milk and milk products are consumed its quality should be constantly monitored. The objective of this investigation was to develop a simple tube ELISA procedure suitable for use in non-specialised laboratories and in the field. A polyclonal antibody raised in sheep and the hapten-gelatine conjugate was immobilised onto polystyrene tubes. This enables the colour produced to be read on a basic spectrophotometer. Milk samples were collected from three farms in different regions of Poland and diluted before immunoassay was performed. Samples were extracted with hexane-acetone for HPLC analysis. The amount of fat in the milk samples interferes with the dose response so it essential that the standards are prepared in the same samples matrix. A good correlation between 1% and 2% was found between the two methods in the analysis of real samples. However the ELISA procedure was more sensitive that the HPLC method since atrazine was detected in some samples by the ELISA but was not confirmed by the HPLC method. The study demonstrated that the simple antigen-coated tube assay provides a cost effective and valuable screening test that can be easily modified for direct use as a screening tool in the field.     

Environmental management of the stone cutting industry

Environmental Management of the stone cutting industry in Hebron is required to reduce the industry's adverse impact on the downstream agricultural land and the adverse impact on the drinking water aquifers. This situation requires the implementation of an industrial wastewater management strategic approach and technology, within the available technical and financial resources. Ten pilot projects at different locations were built at Hebron to reduce or eliminate the incompatible discharge of the liquid and solid waste to the environment and improve the stone cutting industry's effluent quality. A review of existing practices and jar test experiments were used to optimize the water recycling and treatment facilities. The factors reviewed included influent pumping rates and cycles, selection of the optimal coagulant type and addition methods, control of the sludge recycling process, control over flow rates, control locations of influent and effluent, and sludge depth. Based on the optimized doses and Turbidity results, it was determined that the use of Fokland polymer with an optimal dose of 1.5mg/L could achieve the target turbidity levels. The completion of the pilot projects resulted in the elimination of stone cutting waste discharges and an improvement in the recycled effluent quality of 44-99%. This in turn reduced the long term operating costs for each participating firm. A full-scale project that includes all the stone cutting firms in Hebron industrial area is required.