Soil vapor extraction in sandy soils: influence of airflow rate

Airflow rate is one of the most important parameters for the soil vapor extraction of contaminated sites, due to its direct influence on the mass transfer occurring during the remediation process. This work reports the study of airflow rate influence on soil vapor extractions, performed in sandy soils contaminated with benzene, toluene, ethylbenzene, xylene, trichloroethylene and perchloroethylene. The objectives were: (i) to analyze the influence of airflow rate on the process; (ii) to develop a methodology to predict the remediation time and the remediation efficiency; and (iii) to select the most efficient airflow rate. For dry sandy soils with negligible contents of clay and natural organic matter, containing the contaminants previously cited, it was concluded that: (i) if equilibrium between the pollutants and the different phases present in the soil matrix was reached and if slow diffusion effects did not occur, higher airflow rates exhibited the fastest remediations, (ii) it was possible to predict the remediation time and the efficiency of remediation with errors below 14%; and (iii) the most efficient remediation were reached with airflow rates below 1.2 cm(3)s(-1) standard temperature and pressure conditions.     

Influence of humic substances on the photolysis of aqueous pesticide residues

The present work investigated the direct and indirect photolysis of pesticide residues (atrazine, imazaquin, iprodione), in aqueous solutions and under UV-visible radiation (280-480nm). Different kinds of humic substances (HS) were added to samples in order to evaluate their behaviour as possible photocatalysts and their effect on the photolysis of pesticides. The fulvic acids were purchased from the International Humic Substances Society, and they were added to samples in concentrations ranging from 1 to 150 mgl(-1). Titanium dioxide was used as the photocatalyst, in concentration ranging from 10 to 150 mgl(-1). Pesticides photolysis were measured by UV-visible absorption spectroscopy and differential pulse polarography with all used pesticides, reaching total degradation after 2h of irradiation, thus indicating a fast direct photolysis. Photocatalysis by TiO(2) could increase the pesticides photolysis rate up to 40%. This effect, however, was not observed for imazaquin photolysis. Again, except for imazaquin, HS presence showed a positive effect in increasing pesticide degradation, but only within specific concentration ranges (below 10mg l(-1) for iprodione and about 30mgl(-1) for atrazine). Above these ranges HS induce a decrease in the pesticides photolysis rate. Spin-trapping measurements by electronic paramagnetic resonance spectroscopy, using the spin-trap DMPO, showed that HS are able to photogenerate hydroxyl radicals, increasing the pesticides molecule degradation. However, the HS also react with the photogenerated hydroxyl radical, influencing the pesticide photolysis, leading to a decrease in the photolysis rate and causing it to be strongly dependent on the nature and concentration of residues in the water to be treated.     

PM sources in a highly industrialised area in the process of implementing PM abatement technology. Quantification and evolution

Principal component analysis (PCA) coupled with a multilinear regression analysis (MLRA) was applied to PM(10) speciation data series (2002-2005) from four sampling sites in a highly industrialised area (ceramic production) in the process of implementing emission abatement technology. Five common factors with similar chemical profiles were identified at all the sites: mineral, regional background (influenced by the industrial estate located on the coast: an oil refinery and a power plant), sea spray, industrial 1 (manufacture and use of glaze components, including frit fusion) and road traffic. The contribution of the regional background differs slightly from site to site. The mineral factor, attributed to the sum of several sources (mainly the ceramic industry, but also with minor contributions from soil resuspension and African dust outbreaks) contributes between 9 and 11 microg m(-3) at all the sites. Source industrial 1 entails an increase in PM(10) levels between 4 and 5 microg m(-3) at the urban sites and 2 microg m(-3) at the suburban background site. However, after 2004, this source contributed less than 2 microg m(-3) at most sites, whereas the remaining sources did not show an upward or downward trend along the study period. This gradual decrease in the contribution of source industrial 1 coincides with the implementation of PM abatement technology in the frit fusion kilns of the area. This relationship enables us to assess the efficiency of the implementation of environmental technologies in terms of their impact on air quality.     

Evaluation of genotoxicity and toxicity of water and sediment samples from a Brazilian stream influenced by tannery industries

This paper reports results of genotoxicity and toxicity studies of water and sediment samples collected from the Estancia Velha stream of southern Brazil, a stream transporting both domestic sewage and effluents from regional factories working in the leather industry. Three sites were selected: in the stream headwaters (Site 1), located downstream of an urban area (Site 2), and near the basin outfall (Site 3). Results obtained with Allium cepa showed no evidence of chromosomal mutation, either in water or in sediment, during winter or summer seasons, but samples collected below Site 1 showed high toxicity. Physical and chemical analyses showed high concentrations of pollutants at these sites. Ecotoxicity tests with Daphnia magna and Ceriodaphnia dubia measured toxicity in water from Sites 2 and 3 in summer 2004. A toxic effect on Hyalella azteca was only found in sediment from Site 3 during winter 2003 and summer 2004. The results suggest that the synergy among different compounds in domestic and industrial sewage discharges can make it difficult to maintain system stability.     

Cephalopods and cetaceans as indicators of offshore bioavailability of cadmium off Central South Brazil Bight

Regarding Brazilian coast, industrial and urban developments are concentrated along Central South Brazil Bight. Samples from inshore and offshore species from the concerned area were analyzed, comprising 24 cetaceans (9 species) and 32 squids (2 species). Cadmium was determined by GFAAS and our results were in agreement with certified values (DOLT-2, NRCC). Mean cadmium concentration (in microg/g, wet weight) observed in the digestive gland of sexually mature Argentine short-finned squids (Illex argentinus) was 1002.9. To our knowledge this is the highest cadmium level ever reported for a cephalopod. Concerning cetaceans, our results include one of the highest renal cadmium concentrations described for striped dolphins (71.29 microg/g, wet weight). Anthropogenic action, upwelling and cannibalism of Argentine short-finned squid on the studied area are possible reasons for such remarkable cadmium concentrations.     

Fuzzy input–output model for optimizing eco-industrial supply chains under water footprint constraints

Global water stress is expected to increase due to population growth, economic development and climate change. Because of this trend, there is an increased interest in the water intensity of industrial activities conducted via the product supply chain or within specified geographical boundaries or regions, both at the enterprise- or regulatory-level. The total water footprint of economic activities should be evaluated in consideration of local water resource consumption, virtual water trade and resource availability. As individual entities seek to protect their respective interests, the challenge is to optimize inter-regional trade of goods with the consideration of the interests of participants in the network. This work presents a fuzzy input–output model for optimizing supply chains under water footprint constraints. Two case studies, involving tile manufacturing and biofuel production, are considered to demonstrate the use of the model.     

A simulation model for projecting changes in salinity concentrations and species dominance in the coastal margin habitats of the Everglades

Sharp boundaries typically separate the salinity tolerant mangroves from the salinity intolerant hardwood hammock species, which occupy the similar geographical areas of southern Florida. Evidence of strong feedback between tree community-type and the salinity of the unsaturated (vadose) zone of the soil suggests that a severe disturbance that significantly tilts the salinity in the vadose zone might cause a shift from one vegetation type to the other. In this study, a model based upon the feedback dynamics between vegetation and salinity of the vadose zone of the soil was used to take account of storm surge events to investigate the mechanisms that by which this large-scale disturbance could affect the spatial pattern of hardwood hammocks and mangroves. Model simulation results indicated that a heavy storm surge that completely saturated the vadose zone at 30 ppt for 1 day could lead to a regime shift in which there is domination by mangroves of areas previously dominated by hardwood hammocks. Lighter storm surges that saturated the vadose zone at less than 7 ppt did not cause vegetation shifts. Investigations of model sensitivity analysis indicated that the thickness of the vadose zone, coupled with precipitation, influenced the residence time of high salinity in the vadose zone and therefore determined the rate of mangrove domination. The model was developed for a southern Florida coastal ecosystem, but its applicability may be much broader.     

The Power of Innovation and Strategic Sustainability Positioning: A Survey of the Mining Sector in Brazil

This study investigates the relationship between the power of innovation and the sustainability strategies of companies involved in the minerals extraction sector in Brazil. The study included companies associated with the Brazilian Mining Institute, and it used research surveys to gather data. Analysis of the survey data revealed that companies with highly intensive characteristics in regard to innovation and environmental activities (environmental management activities) also display offensive, or proactive, strategies for pursuing sustainability.