Leaching and persistence of ametryn and atrazine in red–yellow latosol

This study evaluated the mobility and persistence of atrazine and ametryn in red–yellow latosols using polyvinyl chloride columns with a diameter of 100 mm and a height of 15 cm. The assays simulated 60-mm rainfall events at 10-day intervals for 70 days. The persistence and leaching were evaluated for these two herbicides. The analytes obtained from the samples were quantified by gas chromatography using flame ionization detection. Compared with ametryn, atrazine showed a greater potential to reach depths below 15 cm over 30 days of simulated rain. Ametryn, however, showed greater persistence in soil at 70 days after application. The persistence of atrazine and ametryn in soil under sunlight was 10 and 144 days respectively. Atrazine was more susceptible to sunlight than ametryn because sunlight favored atrazine degradation in hydroxyatrazine. The results indicate that in red–yellow latosol, atrazine has a high leaching potential in short term, but that ametryn is more persistent and has a high leaching potential in long term.     

Diquat associated with copper sources for algae control: Efficacy and ecotoxicology

The aims of this research were to evaluate the efficacy of copper oxychloride (CuCl₂.3Cu(OH)₂), copper hydroxide (Cu(OH)₂) and diquat (1.1′-ethylene-2.2′-bipyridyldiylium dibromide), isolated and in association with 0.1% of both copper sources, in the control of the unicellular algae Ankistrodesmus gracilis and the filamentous algae Pithophora kewesis, and to determine the acute toxicity of the tested chemicals in Hyphressobrycon eques, Pomacea canaliculata, Lemna minor and Azolla caroliniana. The efficacy was estimated by the methods of chlorophyll a and pheophytin a readings, changed into growth inhibition percentage. Both algae were exposed to the following concentrations: 0.2; 0.4; 0.8; 1.2 mg L^?1 of diquat and its association with the copper sources; and 0.1; 0.3; 0.5; 0.7; 1.0 and 1.5 mg L^?1 in the isolated applications of copper hydroxide and copper oxychloride. An untreated control was kept. The acute toxicity was estimatedby 50% lethal concentration (LC50). The copper sources were effective for A. gracilis control, at rates as high as 0.1 mg L^?1 (>95% efficacy). Isolated diquat and its association with copper hydroxide were both effective at rates as high as 0.4 mg L^?1, with 95 and 88% control efficacy, respectively. The copper oxychloride was effective at 0.2 mg L^?1, with 93% efficacy. None of the tested chemicals and associations was effective on P. kewesis control. The most sensitive non target organism to the tested chemicals was L. minor; the less sensitive was H. eques.     

Analytic Modeling of Rainwater Harvesting in the Brazilian Semiarid Northeast

During the past two decades, government efforts to provide water access to rural communities in Brazil's semiarid Northeast region have focused on building systems to capture and store rainwater, most importantly through the One Million Cisterns Program (P1MC). This article presents an analytic model based on daily precipitation data to evaluate the sustainability of rainwater capture. Application of this model to analysis of the P1MC reveals the heterogeneous climate in this region causes large spatial variability in the effectiveness of this program. In addition, the size of the area of capture, the run‐off coefficient of the roofs, and the amount of first‐flush diversion also have important effects. This analysis demonstrates while rainwater capture can offer sufficient water for drinking, as a stand‐alone solution it cannot meet P1MC objectives of guaranteeing sustainable and universal access to water for drinking, cooking, and basic hygiene in all regions and years.     

Electrochemical removal of synthetic textile dyes from aqueous solutions using Ti/Pt anode: role of dye structure

In this work, the efficiency of electrochemical oxidation (EO) was investigated for removing a dye mixture containing Novacron Yellow (NY) and Remazol Red (RR) in aqueous solutions using platinum supported on titanium (Ti/Pt) as anode. Different current densities (20, 40 and 60 mA cm^?2) and temperatures (25, 40 and 60 °C) were studied during electrochemical treatment. After that, the EO of each of these dyes was separately investigated. The EO of each of these dyes was performed, varying only the current density and keeping the same temperature (25 °C). The elimination of colour was monitored by UV-visible spectroscopy, and the degradation of organic compounds was analysed by means of chemical oxygen demand (COD). Data obtained from the analysis of the dye mixture showed that the EO process was effective in colour removal, in which more than 90 % was removed. In the case of COD removal, the application of a current density greater than 40 mA cm^?2 favoured the oxygen evolution reaction, and no complete oxidation was achieved. Regarding the analysis of individual anodic oxidation dyes, it was appreciated that the data for the NY were very close to the results obtained for the oxidation of the dye mixture while the RR dye achieved higher colour removal but lower COD elimination. These results suggest that the oxidation efficiency is dependent on the nature of the organic molecule, and it was confirmed by the intermediates identified. Figure

Chemical structures of a NY and b RR     

Comparison of Emission of Dioxins and Furans from Gasohol- and Ethanol-Powered Vehicles

ABSTRACT

The exhaust emissions of 17 polychlorinated dibenzo-p-dioxins and polychlorinated dibenzofurans (PCDD/Fs) were investigated in two spark-ignition light-duty vehicles, one gasohol-fueled and a flexible-fuel one fueled with hydrated ethanol. Gasohol is a mixture of gasoline and 22% ethanol. The influence of fuel type and quality, lubricant oil type, and use of fuel additives on the formation of these compounds was tested using standardized U.S. Federal Test Procedure (FTP)-75 cycle tests. The sampling of the PCDD/Fs followed the recommendations of a modified U.S. Environmental Protection Agency (EPA) Method 23 (http://www.epa.gov/ttn/emc/promgate/m-23.pdf) and the analysis basically followed the U.S. EPA Method 8290 (http://www.epa.gov/osw/hazard/testmethods/sw846/pdfs/8290a.pdf). Results showed that emission factors of PCDD/Fs for the gasohol vehicle varied from undetected to 0.068 pg international toxic equivalency (I-TEQ) km^?1 (average of 0.0294 pg I-TEQ km^?1), whereas in the ethanol vehicle they varied from 0.004 to 0.157 pg (I-TEQ) km^?1 (average of 0.031 pg I-TEQ km^?1). In the gasohol-powered vehicle, the use of fuel additive diminished the emission of Octachlorodibenzo-p-dioxin (OCDD) significantly, whereas in the ethanol vehicle no significant associations were observed between the investigated variables and the emissions.

IMPLICATIONS The objective of this work was to analyze differences in emissions from a traditional fossil fuel (gasoline) and an alternative renewable fuel (ethanol from sugarcane), and the influence of fuel additives and lubricant oils on the formation of chlorinated dioxins and furans in spark-ignition light-duty gasohol and ethanol vehicles. Renewable fuels are very important in terms of climate change but the risk to the population's health must not increase. Thus the results of this work could help in the development of environmental impact studies as well as orienting policy-makers in formulating strategies for air pollution control.     

浙江北部低洼田湿地农业种养结合模式的环境效应

浙江北部地区地势低洼,种粮易涝,严重制约当地农业的发展。2010年以来,作为湿地农业农作制度的创新,“水生作物 鱼类”种养结合模式在当地得到迅速发展。为了完善种养高效综合配套技术,在嘉兴市秀洲区3个农场开展了不同种养模式（藕 鱼和菱 鱼模式）的对比试验,对池塘水质、底质特征以及大气负氧离子浓度进行了分析。结果表明种养结合模式对池塘水质有一定改善作用。虽然养殖鱼类后水体有机污染有一定程度加重,但由于水生作物的吸收作用,使得水体氮磷含量明显降低。与菱 鱼模式相比,鱼塘种植莲藕后,对水质的改善效果更为明显。对底质的分析表明,鱼塘种植水生作物后,底泥中速效钾含量增加明显,尤其是在种植莲藕后。另外,由于施用化肥以及当年不收割引起的藕叶、茎杆等腐烂分解,使得藕 鱼模式池塘底泥中速效磷和总氮含量大幅增加,分别增加329.1% 和361.9%。对种养结合区域大气负氧离子浓度测定结果表明,种养结合开发利用有利于改善周边区域空气质量     

Cow excrements enhance the occurrence of tetracycline resistance genes in soil regardless of their oxytetracycline content

Fertilizing soils with animal excrements from farms with common antibiotic use represents a risk of disseminating antibiotic resistance genes into the environment. In the case of tetracycline antibiotics, it is not clear, however, whether the presence of antibiotic residues further enhances the gene occurrence in manured soils. We established a microcosm experiment in which 3 farm soils that had no recent history of fertilization with animal excrements were amended on a weekly basis (9 times) with excrements from either an oxytetracycline-treated or an untreated cow. Throughout the study, the concentration of oxytetracycline in excrements from the treated cow was above 500 μg g⁻¹ dw, whereas no oxytetracycline was detected in excrements from the healthy cow. Both excrements contained tetracycline resistance (TC-r) genes tet(L), tet(M), tet(V), tet(Z), tet(Q) and tet(W). The excrements from the treated cow also contained the tet(B) gene, and a higher abundance of tet(Z), tet(Q) and tet(W). Three weeks after the last excrement addition, the individual TC-r genes differed in their persistence in soil: tet(Q) and tet(B) were not detectable while tet(L), tet(M), tet(Z) and tet(W) were found in all 3 soils. There were, however, no significant differences in the total number, nor in the abundance, of TC-r genes between soil samples amended with each excrement type. The oxytetracycline-rich and the oxytetracycline-free excrement therefore contributed equally to the increase of tetracycline resistome in soil. Our results indicate that other mechanisms than OTC-selection pressure may be involved in the maintenance of TC-r genes in manured soils.