Quantifying trace gas emissions from composite landscapes: A mass-budget approach with aircraft measurements

Quantifying trace gas emissions and the influence of surface exchange processes on the atmosphere is a necessary step towards the control of global greenhouse gas emissions and reliability of air quality models. This paper proposes a procedure based on the mass balance method and implemented on highly resolved aircraft data. It allows one to estimate surface exchanges on areas of several km² and heterogeneous features exploiting the characteristics of convective boundary layer during steady state conditions that permit the estimation of emission/absorption terms as functions of advective fluxes only. A nonparametric approach is adopted and the fluxes on the surface of a virtual box surrounding the area of interest are reconstructed on the basis of scalar densities and wind vectors using Shepard functions. Two different techniques are also proposed to face lack of data on the top surface of the box. The method has been applied to experimental data coming from measurement campaigns on two different sites. It provides realistic estimates of the CO₂ emission/absorption in the considered areas that are in good agreement with CO₂ fluxes evaluated by Airborne Eddy Covariance and confirm the suitability of the proposed approach for the assessment of turbulent exchange of trace gases by composite landscapes. Uncertainties on the estimated emissions due to both propagation of the experimental error and interpolation have been quantified by bootstrap analysis as 6%.     

Sea salt concentrations across the European continent

The oceans are a major source for particles that play an important role in many atmospheric processes. In Europe sea salt may contribute significantly to particulate matter concentrations. We have compiled sodium concentration data as a tracer for sea salt for 89 sites in Europe to provide more insight in the distribution of sea salt across Europe. The annual average sea salt concentrations above land were estimated to range between 0.3 and almost 13 μg m^?3. Maximum concentrations are found at the Irish coast. At coastal sites along the Atlantic and North Sea coast concentrations tend to be around 5 μg m^?3. More inland locations up to about 300 km away from the coast tend to show concentrations between 2 and 5 μg m^?3, whereas sites further away from the coast are characterized by lower concentrations. An analysis of the representativity of the data with respect to a long term average showed that the long average is associated with a standard deviation of around 15%. The compilation of observations provides an improved overview of sea salt concentrations in Europe as well as an improved basis for model validation. Verification of the results of the LOTOS-EUROS model learned that the model represents well the spatial variability of the observed sea salt concentrations very well. However, the absolute concentrations are significantly overestimated due to large uncertainties in the emission and dry deposition parameterizations. Using the high explained variability in the gradients across Europe, the bias-corrected modelled distribution serves as a best estimate of the sea salt distribution across Europe for 2005.     

Urban tracer dispersion experiments during the second DAPPLE field campaign in London 2004

As part of the DAPPLE programme two large scale urban tracer experiments using multiple simultaneous releases of cyclic perfluoroalkanes from fixed location point sources was performed. The receptor concentrations along with relevant meteorological parameters measured are compared with a three screening dispersion models in order to best predict the decay of pollution sources with respect to distance. It is shown here that the simple dispersion models tested here can provide a reasonable upper bound estimate of the maximum concentrations measured with an empirical model derived from field observations and wind tunnel studies providing the best estimate. An indoor receptor was also used to assess indoor concentrations and their pertinence to commonly used evacuation procedures.     

Characterisation of PM10 emissions from woodstove combustion of common woods grown in Portugal

A series of source tests was performed to evaluate the chemical composition of particle emissions from the woodstove combustion of four prevalent Portuguese species of woods: Pinus pinaster (maritime pine), Eucalyptus globulus (eucalyptus), Quercus suber (cork oak) and Acacia longifolia (golden wattle). Analyses included water-soluble ions, metals, radionuclides, organic and elemental carbon (OC and EC), humic-like substances (HULIS), cellulose and approximately l80 organic compounds. Particle (PM₁₀) emission factors from eucalyptus and oak were higher than those from pine and acacia. The carbonaceous matter represented 44–63% of the particulate mass emitted during the combustion process, regardless of species burned. The major organic components of smoke particles, for all the wood species studied, with the exception of the golden wattle (0.07–1.9% w/w), were anhydrosugars (0.2–17% w/w). Conflicting with what was expected, only small amounts of cellulose were found in wood smoke. As for HULIS, average particle mass concentrations ranged from 1.5% to 3.0%. The golden wattle wood smoke presented much higher concentrations of ions and metal species than the emissions from the other wood types. The results of the analysis of radionuclides revealed that the ²²⁶Ra was the naturally occurring radionuclide more enriched in PM₁₀. The chromatographically resolved organics included n-alkanes, n-alkenes, PAH, oxygenated PAH, n-alkanals, ketones, n-alkanols, terpenoids, triterpenoids, phenolic compounds, phytosterols, alcohols, n-alkanoic acids, n-di-acids, unsaturated acids and alkyl ester acids.     

Sustainable nations: what do aggregate indexes tell us?

What is a ‘sustainable nation’ and how can we identify and rank ‘sustainable nations?’ Are nations producing and consuming in a sustainable way? Although several aggregate indexes have been proposed to answer such questions, comprehensive and internationally comparable data are not available for most of these. This paper quantitatively compares three aggregate indexes of sustainability: the World Bank’s ‘Genuine Savings’ measure, the ‘Ecological Footprint,’ and the ‘Environmental Sustainability Index.’ These three indexes are available for a large number of countries and also seem to be the most influential among the aggregate indexes. This paper first discusses the main limitations and weaknesses of each of these indexes. Subsequently, it shows that rankings of sustainable nations and aggregate assessments of unsustainable world population and world GDP shares vary considerably among these indexes. This disagreement leads to suggestions for analysis and policy. One important insight is that climate change, arguable the most serious threat currently faced by humanity, is not or arbitrarily captured by the indexes.     

Plant availability of bound anilazine residues in a degraded loess soil

Abstract

The relative biological availability of [benzene ring‐U‐¹⁴C] and Ctriazine‐U‐¹⁴C] anilazine for maize plants was studied in a degraded loess soil in a standardized microecosystem. The total uptake of radiocarbon in the course of the 4‐week experiment was 3.1 and 4 % respectively of the radioactivity applied if anilazine was uniformly mixed into the soil immediately before beginning the experiment. However, if anilazine was subjected to a degradation at 65 % of the maximum water holding capacity of the soil and temperatures varying daily between 16 and 27°C for 100 days before the plant experiment then the uptake was reduced to 0.4 or 0.7 % respectively. The uptake from soil with non‐extractable (bound) anilazine residues was similarly low. The mineralization rate of aged and bound anilazine residues was below 0.1 % of the radioactivity applied. Up to 2/3 of the radioactivity present in the soil after the plant experiment remained in the humic fraction.     

Diflubenzuron residue and persistence on an oak forest after aerial application

Abstract

A twenty hectare forest block in central Pennsylvania was aerially sprayed with diflubenzuron (Dimilin 25W®) at the dose of 33.23g A.I./ha in 9.4 litres/ha. Leaf samples were collected from the upper and lower canopies of 27 oaks and understory within this block on the day of spray, May 29, 1991. Canopy leaves were also collected on May 31, June 10, July 29 and September 26, 1991.

Recovery of diflubenzuron residues on fortified canopy‐leaf and litter‐leaf samples using analytical techniques employed in this study averaged 87.4% (SE = 7.5%) and 66.2% (SE = 8.2%), respectively.

On the day of spray, diflubenzuron residues on the upper canopy, lower canopy and understory averaged 81.18, 39.65 and 8.35 ng/cm², respectively. Diflubenzuron residues on canopy‐leaf samples collected 2, 12, 61 and 120 days post‐spray averaged 14.83 (SE = 10.19), 16.75 (SE = 9.95), 12.84 (SE = 8.25) and 11.20 (SE = 7.52) ng/cm², respectively. Diflubenzuron residues on litter‐leaf samples collected after leaf senescence ‐ 169 and 323 days post spray contained measurable amounts of diflubenzuron in 51 and 59% of the samples, respectively. Of the samples with measurable amounts of diflubenzuron, residues averaged 1.36 (SE = 2.44) and 0.65 ng/cm² (SE = 0.73) respectively.     

Minimizing drift and exposure from knapsack sprayers

Abstract

An improved drift shield for attaching to the lance of conventional knapsack sprayer to reduce wind induced drift and operator exposure was designed and tested. The drift shield consists of a conical wire frame covered with polythene and has an annular opening at the point of attachment to the lance which allows air to be drawn into the shield while spraying. Tests conducted with winds in the range of 1.25–5.75 m/s show that wind can increase the width of spray swath from an unshielded lance, up to 4.3 times the normal swath in no‐wind condition. Use of a conventional shield contained the swath width within 3.5 times and the improved shield restricted the swath width to 3.1 times the normal swath. Spray deposit from an unshielded lance, within the normal swath decreased to as low as 45%, due to wind effects. However, use of the conventional, and the improved shields enhanced the spray deposit to 54.2% and 68%, respectively. The improved drift shield improved the spray pattern displacement (SPD) significantly (P<0.05) compared with the conventional shield and the unshielded lance when the wind speed exceeded 1.25 m/s. The improved shield decreased the off target drift by as much as 63% compared with the unshielded spray. It also decreased the quantity of pesticide deposit on the operator's body by 41–84% and thereby reduced exposure and improved safety.     

Numerical modeling on air quality in an urban environment with changes of the aspect ratio and wind direction

Due to heavy traffic emissions within an urban environment, air quality during the last decade becomes worse year by year and hazard to public health. In the present work, numerical modeling of flow and dispersion of gaseous emissions from vehicle exhaust in a street canyon were investigated under changes of the aspect ratio and wind direction. The three-dimensional flow and dispersion of gaseous pollutants were modeled using a computational fluid dynamics (CFD) model which was numerically solved using Reynolds-averaged Navier–Stokes (RANS) equations. The diffusion flow field in the atmospheric boundary layer within the street canyon was studied for different aspect ratios (W/H?=?1/2, 3/4, and 1) and wind directions (θ?=?90°, 112.5°, 135°, and 157.5°). The numerical models were validated against wind tunnel results to optimize the turbulence model. The numerical results agreed well with the wind tunnel results. The simulation demonstrated that the minimum concentration at the human respiration height within the street canyon was on the windward side for aspect ratios W/H?=?1/2 and 1 and wind directions θ?=?112.5°, 135°, and 157.5°. The pollutant concentration level decreases as the wind direction and aspect ratio increase. The wind velocity and turbulence intensity increase as the aspect ratio and wind direction increase.     

Emission characteristics of air pollutants from incense and candle burning in indoor atmospheres

Volatile organic compounds (VOCs) and particles emitted by incense sticks and candles combustion in an experimental room have been monitored on-line and continuously with a high time resolution using a state-of-the-art high sensitivity-proton transfer reaction-mass spectrometer (HS-PTR-MS) and a condensation particle counter (CPC), respectively. The VOC concentration–time profiles, i.e., an increase up to a maximum concentration immediately after the burning period followed by a decrease which returns to the initial concentration levels, were strongly influenced by the ventilation and surface interactions. The obtained kinetic data set allows establishing a qualitative correlation between the elimination rate constants of VOCs and their physicochemical properties such as vapor pressure and molecular weight. The emission of particles increased dramatically during the combustion, up to 9.1(±0.2)?×?10⁴ and 22.0(±0.2)?×?10⁴ part cm^?3 for incenses and candles, respectively. The performed kinetic measurements highlight the temporal evolution of the exposure level and reveal the importance of ventilation and deposition to remove the particles in a few hours in indoor environments.