Feasibility of incorporating waste grass clippings (Lolium perenne L.) in particleboard composites

This study investigated some of the important physical (thickness swelling) and mechanical (modulus of rupture, modulus of elasticity and internal bond) properties of single-layer particleboard panels made from eucalyptus (Eucalyptus camaldulensis Dehn.), waste of grass clippings (Lolium perenne L.) and combinations of the two. The chemical properties (pH, holocelluse and alpha cellulose contents, and water, alcohol-benzene and 1% sodium hydroxide solubilities) of the raw materials were also determined. Panels with a 6:94 ratio of grass-to-eucalyptus particles had the required mechanical properties for interior fitments including furniture and general uses. Boards manufactured with 100% grass clippings exhibited the lowest quality. The overall panel properties improved with a lower percentage of grass clippings added. Based on initial results, it also appears that grass should compose no more than 13% to achieve acceptable panel properties for interior fitments and general uses.     

The modelling of a hybrid combined cycle with pressurised fluidised bed combustion and CO2 capture

This study investigates the possibility of capturing CO₂ from flue gas under pressurised conditions, which could prove to be beneficial in comparison to working under atmospheric conditions. Simulations of two hybrid combined cycles with pressurised fluidised bed combustion and CO₂ capture are presented. CO₂ is captured from pressurised flue gas by means of chemical absorption after the boiler but before expansion. The results show a CO₂ capture penalty of approximately 8 percentage points (including 90% CO₂ capture rate and compression to 110 bar), which makes the efficiency for the best performing cycle 43.9%. It is 5.2 percentage points higher than the most probable alternative, i.e. using a natural gas fired combined cycle and a pulverised coal fired condensing plant separately with the same fuel split ratio. The largest part of the penalty is associated with the lower mass flow of flue gas after CO₂ capture, which leads to a decrease in work output in the expander and potential for feed water heating. The penalty caused by the regeneration of absorbent is quite low, since the high pressure permits the use of potassium carbonate, which requires less regeneration heat than for example the more commonly proposed monoethanolamine. Although the efficiencies of the cycles look promising it will be important to perform a cost estimate to be able to make a fair comparison with other systems. Such a cost estimate has not been done in this study. A significant drawback of these hybrid cycles in that respect is the complex nature of the systems that will have a negative effect on the economy.     

Application of fuzzy sets and cognitive maps to incorporate social science scenarios in integrated assessment modelsA case study of urbanization in Ujung Pandang, Indonesia

Decision–support systems in the field of integrated water management could benefit considerably from social science knowledge, as many environmental changes are human-induced. Unfortunately the adequate incorporation of qualitative social science concepts in a quantitative modeling framework is not straightforward. The applicability of fuzzy set theory and fuzzy cognitive maps for the integration of qualitative scenarios in a decision–support system was examined for the urbanization of the coastal city of Ujung Pandang, Indonesia. The results indicate that both techniques are useful tools for the design of integrated models based on a combination of concepts from the natural and social sciences. This revised version was published online in July 2006 with corrections to the Cover Date.     

Extraction of labile metals from solid media by dilute hydrochloric acid

Extraction of labile metals from solid media is environmentally more meaningful than a total digestion. A variety of reagents have been introduced in the literature, but dilute HCl has received the greatest attention. We compare metal concentrations liberated by a dilute HCl leach with the sum of the 3-step optimized (standardized) BCR sequential extraction procedure. This is the first study to compare these procedures over a range of grain sizes. Road-deposited sediments from 10 sites in Honolulu were fractionated into six grain size classes. Aliquots of individual fractions were digested with dilute HCl, the 3-step BCR procedure (‘labile’), and a 4-acid (total) procedure. Results indicated that the weighted labile concentrations of Al, Cu, Fe, Mn, Ni, Pb and Zn were statistically greater than those from the dilute HCl leach. However, regression analysis indicated strong statistically significant relationships between the two partial extraction procedures for all metals. On a whole-sample basis, the toxicity classifications for anthropogenic-enhanced metals (Cu, Pb and Zn) were similar between extractions. Taken together, results suggest that the application of dilute HCl to solid media provides a rapid, cost-effective, and environmentally meaningful approach for contaminant monitoring.     

Migratory crustaceans as biomonitors of metal pollution in their nursery areas. The Lesina lagoon (SE Italy) as a case study

Lichens collected in an unpolluted forest (background) in November 2004, transplanted at 41 sampling sites along the Madina-Tetteh Quarshie road, retrieved in February 2005 and analysed were found to contain higher concentrations of Manganese (Mn), Vanadium (V), lead, Cadmium (Cd), Chromium (Cr) and Nickel (Ni) than in the background area. Observations showed that of all the heavy metals studied, Manganese concentrations were highest at all sampling points with maximum values around a traffic light, an intersection and car fitting/mechanic workshops. Significant correlations were found between Ni and Mn, Mn and Cr and Mn and V. Statistical analysis also revealed a relatively even dispersion of the studied elements on the eastern side of the road than on the western side.     

Magnesium hydroxide bulk and colloid-associated 152Eu in an alkaline environment: colloid characterisation and sorption properties in the presence and absence of carbonate

The distribution of 152Eu between magnesium hydroxide bulk, colloids and solution has been assessed under alkaline conditions, such as those in nuclear fuel storage ponds. The colloidal phase has been characterised by two complementary methods: coupled ultrafiltration-ICP-AES and scanning electron microscopy. The quantity and the size distribution of the colloidal phase is strongly ionic strength-dependent. A decrease of the quantity of colloids, in particular the larger size ranges, has been observed with increasing ionic strength. Small colloids (1 kDa-10 kDa fraction) are predominant at all ionic strengths. The morphology of colloids, observed by field-emission gun scanning electron microscopy, appears to change from hexagonal prismatic (characteristic to the mineral) to spherical (energetically more favourable) as size decreases. The distribution of 152Eu between the solid and liquid/colloidal phases has been investigated at carbonate concentrations ranging from 0 to 10(-2) M by coupled ultrafiltration and gamma-spectrometry. Mg(OH)2 bulk appears to be a very strong sorbent for 152Eu, since complete sorption onto the bulk happens for carbonate concentrations as high as 10(-3) M. Scavenging of 152Eu by Mg(OH)2 colloids is negligible in the presence of Mg(OH)2 bulk. The distribution of 152Eu between liquid and colloidal phases has been investigated in the absence of bulk at various carbonate concentrations. A significant uptake of 152Eu by the colloids in solution has been observed, which decreases with increasing carbonate concentration. 152Eu appears to be mainly associated to the smallest colloids (1 kDa-10 kDa fraction). There is a strong correlation between the sorption properties and the surface area of the colloids.     

Cross-border response of mosses to heavy metal atmospheric deposition in Southeastern Bulgaria and European Turkey

First cross-border atmospheric pollution of 11 heavy metals and toxic elements assessed by Hypnum cupressiforme was reported for a part of Southeastern Europe (Southeastern Bulgaria and European Turkey). Moss monitoring technique followed the main requirements of European Moss Survey. Moss samples were collected in April 2006 both in Bulgaria and Turkey. Concentration of Al, As, Cd, Cr, Cu, Fe, Ni, Pb, Sb, V, and Zn were determined by ICP-AES. Interlaboratory parallel calibration (exchanged four moss samples from each country), standard reference moss materials (M2 and M3) results ensured the study. ANOVA showed no differences between measured results in both laboratories at the 99% confidence level. Principle Component Analyze proved two factors: F1 group of Al, As, Cd, Cr, Fe, Ni, and V and F2 of Cu, Pb, and Zn as main atmospheric pollutants. Results obtained showed approximately Cu and Pb high concentrations around Istanbul and Burgas and Zn pollution in Istanbul district. Arsenic cross-border atmospheric pollution in the study area of Southeastern Europe was found.     

An assessment of fluoride in the coastal aquifer of the Bara tract in Bharuch district, Gujarat (India)

The fluoride (F) concentration in the coastal aquifers of Bara tract in Bharuch district, Gujarat was determined by potentiometric method using an ion-selective electrode. The fluoride concentration in these aquifers varies between 0.060 to 3.51 mg/L. It was also found that F has a positive correlation with pH and HCO(3)(-) whereas negatively correlated with Ca(2+), indicating that high fluoride in ground water is associated with low calcium content. This suggests that the higher pH of water promotes the leaching of fluoride and thus affects the concentration of fluoride in the ground water. It was also found that there exists no relationship between F, EC, and ground water table from surface in the ground water.     

What do qualitative rapid assessment collections of macroinvertebrates represent? A comparison with extensive quantitative sampling

It is a fundamental tenet of Rapid Biological Assessments (RBA) that the samples collected reflect the community from which they are drawn. As with any biological sampling, RBA collections are subject to sampling error resulting in the omission of some taxa. The aim of this study is to compare the composition of RBA samples with an estimate of community structure based on extensive quantitative sampling. We used logistic regression to explore the relationships between the frequency of a taxon being collected in an RBA sample and its biological and ecological traits, namely its abundance, distribution, body size and habit. RBA samples and quantitative estimates of community structure were made in riffles in the Kangaroo and Nepean Rivers, New South Wales, Australia. Single RBA samples may collect up to 63% of the taxa that are collected by extensive quantitative sampling at a site. The frequency of a taxon being recorded in an RBA sample was significantly and positively related to all traits tested indicating a bias in the collection methods towards large, abundant and widely distributed taxa. Accordingly, taxa missed by RBA sampling were generally small, narrowly distributed or rare. These findings enhance our understanding of what RBA samples represent, and the bias and source of errors associated with RBA sampling. This study also quantifies the utility of RBA methods for biodiversity assessment.     

Evaluation of a fast wastewater odour characterisation procedure using a chemical sensor array

Sewage treatment works are one of the major sources that cause atmospheric odour pollution. The increase in the number of complaints about odour nuisance is due to the increase in environmental concerns. Unfortunately, the legislation on odour nuisance from sewage treatment works is very limited. In order to determine suitable thresholds on which to base legal standards, reliable and efficient odour measurement methods need to be defined. A chemical sensor array was developed for the purpose of measuring wastewater odour. This paper describes the development of the chemical sensor system which is specifically tuned to odours of wastewater origin and which can give an electronic measure of the wastewater odours. Odour emissions from a wastewater treatment facility were detected by using a quartz crystal microbalance (QCM) sensor array. The array consists of nine sensor elements, which were coated with different materials. In this paper, the usage of these novel instruments in the water industry was shown.