Forecasting model to assess the potential of secondary lead production from lead acid battery scrap

Environmental Science and Pollution Research - Lead acid battery (LAB) scrap management is an important issue both environmentally and economically. The recovery of lead from battery scrap leads to...     

Minimizing disruptions caused by damming and ensuring the health of downstream ecosystems

In view of the Brazilian Ten‐Year Energy Expansion Plan 2021, this article presents a discussion on environmental flow (e‐flow). The authors analyze the literature to show the evolution of publications concerning e‐flow releases from the perspective of ecosystems services preservation considering results from different case studies from throughout the world. Finally, two main recommendations are drawn regarding e‐flow are: (1) performing a holistic approach to e‐flow planning, including hydrological, hydraulic, water quality, habitat, and riparian zone considerations; and (2) installing in new structures adequate bottom outlets to allow a range of adjustable e‐flow from reservoir dams to reproduce natural flow variations.     

Wood burning impact on PM10 in three Austrian regions

Anhydrosugars (levoglucosan, mannosan and galactosan) were investigated during one year in three Austrian regions at three types of sites (city-heavy traffic-impacted, city-residential and background) in order to assess the magnitude of the contribution of wood smoke to the particulate matter load and its organic fraction. The annually averaged concentrations of levoglucosan ranged from 0.12 to 0.48 μg m^?3. The levoglucosan concentration exhibited a strong annual cycle with higher concentrations in the cold season. The minor anhydrosugars had a similar annual trend, but their concentrations were lower by a factor of about 5 and about 25 in the cold season for mannosan and galactosan, respectively. Levoglucosan concentrations were higher at the inner-urban as compared to rural sites. The contribution of wood smoke to organic carbon and PM₁₀ levels was calculated using a constant ratio of levoglucosan and OC, respectively PM₁₀ as derived for fire wood typical for Alpine European regions [Schmidl, C., Marr, I.L., Caseiro, A.e, Kotianová, P., Berner, A., Bauer, H., Kasper-Giebl, A., Puxbaum, H., 2008a. Chemical characterisation of fine particle emissions from wood stove combustion of common woods growing in mid-European Alpine regions. Atmospheric Environment 42, 126–141]. The estimated contribution of wood smoke-OC to the OC of PM₁₀ ranged from one third to more than half in the cold season with higher contributions up to 70% in winter (December, January and February) in the smaller cities and the rural background. This indicates, that wood smoke is the predominant source of organic material at rural and small urban sites in central Europe. Consistently, wood smoke was an important contributor to PM₁₀ during the cold season, with contributions of around 10% in the Vienna larger region and around 20% at rural sites in the densely forested regions of Salzburg and Styria during the winter months. In those regions residential sites exhibited highest relative wood smoke contents in PM₁₀ during autumn (September till November), indicating the use of wood stoves for auxiliary heating in the transition of warm to cold season. Using the relationships between the different anhydrosugars the combustion of softwood was found to be dominant for the wood smoke occurrence in ambient air at the investigated sites. Potassium, a commonly used tracer for biomass burning, correlated well to levoglucosan, with a mass ratio of around 0.80 in the cold season.     

Aerosol formation yields from the reaction of catechol with ozone

The formation of secondary organic aerosol from the gas-phase reaction of catechol (1,2-dihydroxybenzene) with ozone has been studied in two smog chambers. Aerosol production was monitored using a scanning mobility particle sizer and loss of the precursor was determined by gas chromatography and infrared spectroscopy, whilst ozone concentrations were measured using a UV photometric analyzer. The overall organic aerosol yield (Y) was determined as the ratio of the suspended aerosol mass corrected for wall losses (M_o) to the total reacted catechol concentrations, assuming a particle density of 1.4 g cm^?3. Analysis of the data clearly shows that Y is a strong function of M_o and that secondary organic aerosol formation can be expressed by a one-product gas–particle partitioning absorption model. The aerosol formation is affected by the initial catechol concentration, which leads to aerosol yields ranging from 17% to 86%. The results of this work are compared to similar studies reported in the literature.     

Mass conservative,positive definite integrator for atmospheric chemical dynamics

Air quality models compute the transformation of species in the atmosphere undergoing chemical and physical changes. The numerical algorithms used to predict these transformations should obey mass conservation and positive definiteness properties. Among all physical phenomena, the chemical kinetics solver provides the greatest challenge to attain these two properties. In general, most chemical kinetics solvers are mass conservative but not positive definite. In this article, a new numerical algorithm for the computation of chemical kinetics is presented. The integrator is called Split Single Reaction Integrator (SSRI). It is both mass conservative and positive definite. It solves each chemical reaction exactly and uses operator splitting techniques (symmetric split) to combine them into the entire system.The method can be used within a host integrator to fix the negative concentrations while preserving the mass, or it can be used as a standalone integrator that guarantees positive definiteness and mass conservation. Numerical results show that the new integrator, used as a standalone integrator, is second order accurate and stable under large fixed time steps when other conventional integrators are unstable.     

Evaluation of the aggressive potential of marine chloride and sulfate salts on mortars applied as renders in the Metropolitan Region of Salvador--Bahia, Brazil

In recent years, growing interest has focused on determining the performance of materials and evaluating the service life of structures exposed to various environmental forces. In this context, the determination of the aggressive potential of marine salts on mortars used as external renders is critical. The present study aimed to evaluate the spatial distribution of marine salts relative to distance from the sea. This was done by monitoring the deposition rate of chlorides and sulfates in wet candle sensors, located at nine stations scattered around the Metropolitan Region of Salvador, state of Bahia, Brazil. The study also determined the effectiveness of water-soluble salts at penetrating three different types of mortars of varying cement content via deposition and diffusion. The methodology employed enabled an evaluation of the efficiency of the monitoring sensors' measurement of the aggressiveness potential of local marine aerosol, and determination of the comparative performance of the three mortars tested, from the standpoint of resistance to salt penetration. The type and amount of salts captured both in solution and in powder samples extracted from the mortars were determined by ion chromatography. The analysis of the various types of mortars tested indicated which types are more resistant to the aggressive potential of the region's marine aerosol and the distance from the shore where local buildings are liable to be most strongly affected.     

The reliability of experts' opinions in constructing a composite environmental index: The case of ESI 2005

The complexity of the environment demands a well-constructed composite environmental index (CEI) to provide a useful tool to draw attention to environmental conditions and trends for policy purposes. Among the common difficulties in constructing a proper CEI are uncertainties due to the selection of the most representative underlying variables or indicators. A degree of uncertainty accompanies experts' judgments, and to deal with vague, subjective or inconsistent information, logic other than classic is required. This study analyzes a procedure that uses different experts' opinions in constructing a CEI, with the use of paraconsistent annotated logic. For this, a sensitivity analysis of the Environmental Sustainability Index (ESI 2005) was used as an example to assess the reliability of experts' opinions. The uncertainty due to the disagreement in experts' opinions clearly indicates that the forms we presently use to measure and monitor the actual environment are insufficient, that is, there is a lack of a “science of sustainability”.     

Use and knowledge of fuelwood in three rural caatinga (dryland) communities in NE Brazil

The woody species known, used, and preferred as fuelwood were examined in three rural communities within the county of Soledade, Paraíba State, NE Brazil. Ethnobotanical information was collected using semi-structured interviews with more than 90% of the local households (55 adult residents; 31 women, and 24 males). The interviewees cited 36 plant species as fuelwoods, distributed among 30 genera and 15 families, in addition to two unidentified plants. The plant families represented by the largest numbers of species were Euphorbiaceae, Anacardiaceae, Mimosaceae, Caesalpiniaceae, Sapotaceae, and Fabaceae. The species Caesalpinia pyramidalis Tul. (“catingueira”) was cited with the greatest frequency in all three communities. Within the communities we found significant differences on the number of plants cited and actually used (p < 0.05), indicating that the residents knew more fuelwood species than they effectively harvest. The different distances from the communities to the urban centers were not related to differences on the use or the size of the stocks of fuelwood. Additionally, the study revealed that the communities examined still maintain a significant knowledge of the use of energy-providing plants in spite of the widespread use of liquefied petroleum gas (LPG). Readers should send their comments on this paper to: BhaskarNath@aol.com within 3 months of publication of this issue.     

Differential blood counting in fish as a non-destructive biomarker of water contamination exposure

Differential white blood cell counting was performed on blood from the fish species Oreochromis niloticus and was used as an in situ indicator of the species’ exposure to contamination. Ten young fish were collected in an area influenced by the discharge of effluents and from a fish farm (control group). The fish were anesthetized and caudal puncture was used to collect the blood. Differential white blood cell counting was performed, as well as the counting of total leukocytes and thrombocytes (in 2000 cells). Physicochemical parameters of the water from both sites were analyzed. The water from the polluted area was found to have high conductivity and low levels of dissolved oxygen, factors that indicate poor environmental quality. Fish collected from the polluted site presented higher percentages of eosinophils and monocytes and fewer thrombocytes because of exposure to pollution and hypoxic conditions. The differential white blood cell count represents a suitable biomarker of environmental health and provides a tool for biomonitoring water quality.     

Renewable energy and greenhouse gas emissions from the waste sectors of European Union member states: a panel data analysis

In the last two decades, there has been a rich debate about the environmental degradation that results from exposure to solid urban waste. Growing public concern with environmental issues has led to the implementation of various strategic plans for waste management in several developed countries, especially in the European Union. In this paper, the relationships were assessed between economic growth, renewable energy extraction and greenhouse gas (GHG) emissions in the waste sector. The Environmental Kuznets Curve hypothesis was analysed for the member states of the European Union, in the presence of electricity generation, landfill and GHG emissions for the period 1995 to 2012. The results revealed that there is no inverted-U-shaped relationship between income and GHG emissions in European Union countries. The renewable fuel extracted from waste contributes to a reduction in GHG, and although the electricity produced also increases emissions somewhat, they would be far greater if the waste-based generation of renewable energy did not take place. The waste sector needs to strengthen its political, economic, institutional and social communication instruments to meet its aims for mitigating the levels of pollutants generated by European economies. To achieve the objectives of the Horizon 2020 programme, currently in force in the countries of the European Union, it will be necessary to increase the share of renewable energy in the energy mix.