Treatment of benzene and n-hexane mixtures in trickle-bed air biofilters

Trickle-bed air biofilters (TBABs) are suitable for treatment of hydrophilic volatile organic compounds, but they pose a challenge for hydrophobic compounds. Three laboratory-scale TBABs were used for the treatment of an airstream contaminated with different ratios of n-hexane and benzene mixtures. The ratios studied were 1:1, 2:1, and 1:3 n-hexane:benzene by volume. Each TBAB was operated at a pH of 4 and a temperature of 20 degrees C. The use of acidic-buffered nutrient solution was targeted for changing the microorganism consortium to fungi as the main biodegradation element. The experimental plan was designed to investigate the long-term performance of the TBABs with an emphasis on different mixture loading rates, removal efficiency with TBAB depth, volatile suspended solids, and carbon mass balance closure. n-Hexane loading rate was kept constant in the TBABs for comparison reasons and ranged from 4 to 22 g/(m3 x hr). Corresponding benzene loadings ranged from 4 to 43 g/(m3 x hr). Generally, benzene behavior in the TBAB was superior to that of n-hexane because of its higher solubility. n-Hexane showed improved performance in the 2:1 mixing ratio as compared with the other two ratios.     

New Methods for the Preparation Nanosized Metal Coordination Polymers

Transition-metal coordination polymers [M(ndc)(bpy)·(H₂O)m]·xH₂O (where M = Co(II), Ni(II), Cu(II) and Zn(II), ndc = 1,4-naphthalenedicarboxylate, bpy = 4,4′-bipyridine; m = 0 or 1; x = 1 or 2) were prepared by reacting the ligands and metal ions at room temperature with the aid of microwave irradiation and sonication methods. The structure of the coordination polymers was assigned based on elemental analysis, FT-IR and electronic spectral studies, thermal analysis, scanning electron microscope and X-ray powder diffraction. Thermogravimetric analysis was also used to follow up the possible thermal decomposition steps and to calculate the thermodynamic parameters of the nano-sized metal complexes. The kinetic parameters were calculated making use of the Coats–Redfern and Horowitz–Metzger equations. All obtained results of the different technics used in our study stated the ability to synthesis the metal coordination polymers of our interest using both microwave irradiation and sonication methods.     

Biomonitoring study of heavy metals in biota and sediments in the South Eastern coast of Mediterranean sea, Egypt

Concentrations of Cd, Cu, Co, Zn, Mn and Fe were determined in biota and sediment samples collected from the Eastern Harbour and El-Mex Bay in the Mediterranean Sea, Egypt. The levels of Cu, Co, Zn, Mn and Fe in the macroalgae, Ulva lactuca, Enteromorpha compressa (green algae) and Jania rubens (red algae), recorded high concentrations except for Cd. Moreover, Fe was the most predominant metal in the seaweed. The two species of bivalves, Donax trunculus and Paphia textile, showed different amounts of metals in their tissue. The abundance of heavy metal concentrations in the mussel samples was found in the order Fe> Zn> Mn> Cu> Co> Cd and Fe> Zn> Mn> Cu> Cd> Co, respectively for the two species. The metals concentrations were generally higher compared with the previous studies in mussels from the same area. The levels of metals accumulated in the investigated fish samples, Saurida undosquamis, Siganus rivulatus, Lithognathus mormyrus and Sphyraena sphyraena, were higher than those of Marmara Sea (Turkey), for Co and Cd and lower for Cu, Zn, Mn and Fe. El-Mex Bay having the highest metals concentration in sediments as their order of abundance were Fe> Zn> Mn> Cu> Cd> Co. Nevertheless, a high variability in the metal levels occurs among the studied algae and biota and also between the investigated Harbour. A significant correlations (p < 0.05) were found for each of Zn and Fe in P. textile and of Co in D. trunculus relative to their concentrations in surficial sediments.     

Eco-Synthesis of PVA/Chitosan Hydrogels for Biomedical Application

A drug delivery system based on physically cross-linked poly vinyl alcohol (PVA)/chitosan blend hydrogels for the release of sparfloxacin antibiotic as a model for drugs was described. Eco-synthesis in current work is based on synthesizing a hydrogel without using chemical crosslinking agents like in the conventional method. In addition all materials are used are non- toxic, safe, non-carcinogenic and can be accepted by the human body without danger. The swelling behavior was tested to be dependent on pH as temperature as well as time and number of freezing thawing cycles. The physical properties of the hydrogels, such as swelling percent, dissolution percent, gel fraction and mechanical properties was assessed. The antimicrobial activity of hydrogels having different compositions was evaluated for both gram positive and gram negative bacteria. Furthermore, the release of antibiotic from hydrogels prepared using the freeze—thawed process was studied. Results obtained disclose that the swelling percent of the hydrogels is pH- dependent and increases by increasing the chitosan percent and decreases with increasing the time and number of freezing cycle. With respect to the antimicrobial activity of the prepared hydrogels, display a positive effect for both gram positive and gram negative bacteria. Freeze-thawed hydrogels could serve as drug delivery system to release sparfloxacin in acidic medium. Indeed, the release percent of sparfloxacin relies on both pH and temperature.     

Preparation of antibodies and development of an enzyme immunoassay for determination of atrazine in environmental samples

An indirect competitive enzyme-linked immunosorbent assay (ELISA) has been developed and optimized for atrazine determination in soil at different depths (0–10, 10–20, and 20–30 cm) before and after 48 h of application, corn shoot and cow milk samples collected from Dina farm, Egypt. This assay was based on a specific polyclonal antibodies (PAb) raised by immunizing New Zealand rabbits with an immunogen prepared by coupling 3-{4-(ethylamino)-6-(isopropylamino)-1,3,5-triazine-2-yl} thiopropanoic acid to bovine serum albumin (BSA) via N-hydroxysuccinimide (NHS) active ester method. The sensitivity (estimated as IC₅₀value) was 17.5 μg mL^?1 with a detection limit of 0.1 ng mL^?1. The maximum atrazine concentration was found in soil especially in the deepest layer (325 and 890 μg kg^?1 before and after application, respectively). Atrazine concentration in corn shoot was 333.28, μg kg^?1 dry plant, while there was no detectable amount in milk. All samples screened by ELISA were validated by gas chromatography mass spectrometer procedure (GC/MS). Good correlation was achieved between the two methods (r = 0.997 for soil and 0.9814 for plant). This study demonstrates the utility and convenience of the simple, practical and cost–effective ELISA method in the laboratory for analysis of environmental samples. The method is ideal for the rapid screening of large numbers of samples in laboratories where access to GC/MS facilities, is limited or lacking.     

Hydrolysis of organophosphate insecticides in aqueous media

Hydrolysis of crucron [0-(4-bromo-2-chorophenyl)-ethyl-s-n-propyl phosphorothioate], bromophos [0-(4-bromo-2,5-dichlorophenyl)0,0-dimethyl phosphorothioate] and fenitrothion [0,0-dimethyl-0-(4-nitro-m-tolyl phosphorothioate] was investigated in buffered aqueous media at various pH values. Rate constants and half-life studies revealed that these insecticides were relatively stable in acidic medium, and their stability decreased as the pH increased. The mode of decomposition of these compounds in acidic; the neutral medium is dealkylation which results in deakylated compounds and alcohols. In an alkaline medium they undergo hydrolysis resulting in the formation of phenol derivatives and dialkylphosphoric acid.     

Monitoring Ambient Sulfur Dioxide Levels at some Residential Environments in the Greater Cairo Urban Region – Egypt

The impact of the increased sulfur dioxide emissions within the Greater Cairo Urban Region over the part 50 yr has been overwhelming. While previous air-pollution surveys measuring SO2 levels in the region converged upon the study of emissions from specific industrial activities, no correlation between the measured concentrations and the induced health-related impacts in living environments was provided. As well, no inventory of emissions from other sources within some residential areas were accounted for or evaluated. During the study period of January to April 2000, the ambient sulfur dioxide levels in four residential locations within the capital region were investigated. The results indicated that the measured cumulative ambient SO2 concentrations were in excess of the national and the international monthly mean exposure limits, irrespective of the type of local activity. As well, measurements within three of the selected environments surpassed the 0.5 ppm SO2 odor-threshold. The data also showed a significant dependency of the measured content upon the physical layout and topography of the studied environment as well as with respect to the prevailing seasonal weather conditions.     

Biomedical Textiles Through Multifunctioalization of Cotton Fabrics Using Innovative Methoxypolyethylene Glycol-N-Chitosan Graft Copolymer

Multifunctioalization of cotton fabrics was developed by a novel finishing formulation. The method is based on chitosan-N-polyethylene glycol graft copolymer along with citric acid and sodium hypophosphite (SHP) as catalysts. Treatment of the cotton fabric resulted in the chemical attachment of the copolymer to the cotton fabric via bridging-based esterification where the latter involves reaction of one molecule of the polycarboxylic acid (citric acid) with both the amino group of the copolymer and the hydroxyl groups of cotton. Inclusion of the copolymer in the crosslinked structure of cotton as well as by hydrogen bonding and van der Waals forces are additionally possible. Synthesis of the copolymer was raised out by the reaction of chitosan with methoxy polyethylene glycol (MPEG) aldehyde followed by the reduction with sodium borohydride. MPEG was prepared by oxidation of PEG with acetic anhydride in dimethyl sulphoxide at room temperature. Methoxypolyethylene glycol-N-chitosan graft copolymer (MPEG-N-CTS) structure was confirmed by IR, NMR, X-RD and TGA techniques. The copolymer is soluble in water. The pad dry-cure method was used for the cotton fabrics treatment with aqueous solution of prepared copolymer along with citric acid and SHP. The so treated fabrics were monitored for copolymer content (expressed as N%), crease recovery, tensile strength, elongation at break, air permeability, water permeability, roughness, bursting strength and antibacterial activity. Fabric performances based on the outputs of these measurements advocate these multifunctionalized fabrics for use as medical textile.     

Resilience from the ground up: how are local resilience perceptions and global frameworks aligned?

Numerous resilience measurement frameworks for climate programmes have emerged over the past decade to operationalise the concept and aggregate results within and between programmes. Proxies of resilience, including subjective measures using perception data, have been proposed to measure resilience, but there is limited evidence on their validity and use for policy and practice. This article draws on research on the Decentralising Climate Funds project of the Building Resilience and Adaptation to Climate Extremes and Disasters programme, which supports communities in Mali and Senegal to improve climate resilience through locally controlled adaptation funds. It explores attributes of resilience from this bottom‐up perspective to assess its predictors and alignment with food security, as a proxy of well‐being. We find different patterns when comparing resilience and the well‐being proxy, illustrating that the interplay between the two is still unclear. Results also point to the importance of contextualising resilience, raising implications for aggregating results.