Assessing demineralization treatments for PVC effluent reuse in the resin polymerization step

To reduce fresh water consumption in a polyvinyl chloride (PVC) plant, the effluent from a biological treatment must be demineralized to be re-used in the resin polymerization process. Demineralization is a critical process, since the quality and the stability of the PVC resins are highly influenced by the water quality used in the process. The main target values for water parameters are the following: conductivity <10 μScm^?1, TOC < 10 mg L^?1, and Al < 0.1 mg L^?1. To achieve this quality, several reverse osmosis membranes from different materials and suppliers were tested and compared in the demineralization treatment. Polyamide membranes showed higher salt rejection compared to cellulose acetate membranes yielding both types similar flux and permeability. Two-pass reverse osmosis treatment was necessary to reach conductivities lower than 10 μS cm^?1. On the other hand, a good quality effluent for reuse was obtained by combining RO and ionic exchange resins. Results showed that good quality PVC resins in terms of color, granulometry, porosity, and bulk density were obtained when demineralized water from two-pass reverse osmosis was used as fresh water, proving the feasibility of the effluent reuse in the PVC industry.     

Adsorption of methabenzthiazuron on six allophanic and nonallophanic soils: effect of organic matter amendment

This article reports on methabenzthiazuron [1-(1,3-benzothiazol-2-yl)-1,3-dimethylurea] (MBT) adsorption process on six agricultural allophanic and nonallophanic soils. The effect of amendment with exogenous organic matter was also studied. Adsorption kinetic fits an hyperbolic model. MBT adsorption reached an apparent equilibrium within 2 h and followed a second-order reaction. The maximum adsorbed amounts for natural soils ranged from 32 to 145 microg g(-1). Rate constants were considered relatively low (0.27-1.5 x 10(-4) [microg g(-1)](1-n) s-1); the slow process was attributed to a combined effect of difussion and adsorption. MBT adsorption fits the Freundlich model with r values > or =0.998 at P < or = 0.001 significance levels. Kf and Freundlich exponents (l/n) ranged from 5.3 to 82.1 cm3 g(-1) and from 0.66 to 0.73, respectively. Kf values for soils with a low organic matter content were lower than that obtained from the only typical allophanic soil derived from volcanic ash under study. Lineal regression analysis between Kf and organic matter content of nonallophanic soils gave a correlation coefficient of 0.980 (P = 0.02). Dispersion of Kd values together with close values of K(OM) indicate that organic matter (OM) was the principal component responsible for MBT adsorption in unamended soils. Addition of peat decreased soil pH and increased adsorption capacity for allophanic and nonallophanic soils. Kinetic experiments showed enhancements of Xmax values and lower rate constants.     

Precipitation chemistry in the coast of the Metropolitan Region of Rio de Janeiro, Brazil

Precipitation chemistry was studied in the Metropolitan Region of Rio de Janeiro (MRRJ). This study reveals that rainwater in the MRRJ is affected by emissions of air pollutants and provides essential data for future estimates of regional biogeochemical cycles and the impacts of acid deposition on tropical ecosystems. The volume-weighted mean (VWM) pH was 4.77, varying from 3.50 to 6.85. Sea-salt aerosols were the dominant sources of the Na+, Cl- and Mg2+. Excess SO4(2-), Ca2+ and K+ comprised 82, 91, and 87% of their total VWM concentrations, respectively. There were very strong correlations (r > 0.75, P > 0.01) for NO3- and H+, NO3- and excess(exc-)SO4(2-), NH4+ and exc-K+, and exc-SO4(2-) and exc-Ca2+, suggesting causal relationships between these ion pairs. The VWM concentrations of all major ions, except H+, were higher in the dry season, with dry to wet VWM concentration ratios varying from 1.1 (NH4+) to 4.7 (for total K+).     

Genotoxicity in adult residents in mineral coal region—a cross-sectional study

The present study assessed the DNA damage in environmentally exposed volunteers living in seven municipalities in an industrial coal region, through the use of the comet assay with blood cells and the micronucleus test with buccal cells. Blood and buccal smears were collected from 320 male volunteers living in seven cities inserted in a coal region. They were ages of 18 and 50 years and also completed a questionnaire intended to identify factors associated with DNA damage through a Poisson regression analysis. The comet assay detected significant differences in DNA damage in volunteers from different municipalities, and neighboring cities (Pedras Altas, Aceguá, and Hulha Negra) had a higher level of DNA damage in relation to control city. Some of the risk factors associated with identified DNA lesions included residence time and life habits. On the other hand, the micronucleus test did not identify differences between the cities studied, but the regression analysis identified risk factors such as age and life habits (consumption of mate tea and low carbohydrates diet). We conclude that there are differences in the DNA damage of volunteers from different cities of the carboniferous region, but the presence of micronuclei in the oral mucosa does not differ between the same cities. Furthermore, we alert that some related factors may increase the risk of genotoxicity, such as residence location and time, and living and food habits. Finally, we suggest the need for continuous biomonitoring of the population, as well as for investing in health promotion in these vulnerable populations.

     

Sediments as a sink for UV filters and benzotriazoles: the case study of Upper Iguaçu watershed,Curitiba (Brazil)

Ingredients in home and personal care products, including UV filters and benzotriazoles, are high production volume chemicals extensively used in our daily life, despite several studies revealed their potential eco-toxicity and endocrine-disrupting capacity. Due to some features, such as high lipophilicity, low degradability, and persistence of many of these compounds, sediments can be considered a sink for them in the aquatic environment. In the present study, nine organic UV filters and three benzotriazoles were investigated for the first time in sediments from four urban rivers in Brazil. The contaminants were analyzed by liquid chromatography-tandem mass spectrometry (LC-MS/MS). The results revealed that octocrylene (OC), etylhexyl-methoxycinnamate (EHMC), benzophenone-3 (oxybenzone, BP3), and benzotriazole (BZT) were the predominant compounds adsorbed on the sediments, with concentrations ranging from 5.6 to 322.2 ng g⁻¹ dry weight. The results reported in this work constitute the first data on the accumulation of polar benzotriazoles and lipophilic organic UV filters in sediments from Brazil.

     

Baseline levels of PCDD/Fs in soil and herbage samples collected in the vicinity of a new hazardous waste incinerator in Catalonia,Spain

The construction in Constantí (Catalonia, Spain) of a new hazardous waste incinerator (HWI), which is the first one in Spain, finished in 1999. In order to determine the temporal variation (1996–1998) in the concentrations of polychlorinated dibenzo-p-dioxins (PCDDs) and dibenzofurans (PCDFs) in the vicinity of the new HWI, 40 soil and 40 herbage samples were collected (1998) at the same sampling points in which samples had been taken two years before (1996). Each sample was analyzed for PCDDs and PCDFs by high resolution gas chromatography/high resolution mass spectrometry. In the 1996 survey, PCDD/F concentrations in soils ranged from 0.13 to 24.20 ng I-TEQ/kg (d.m.), with median and mean values of 0.67 and 1.68 ng I-TEQ/kg (d.m.), respectively. In the present study, PCDD/F concentrations ranged from 0.12 to 17.20 ng I-TEQ/kg (d.m.), with a median value of 0.75 ng I-TEQ/kg (d.m.) and a mean value of 1.59 ng I-TEQ/kg (d.m.). In turn, in the present study PCDD/F concentrations in vegetation ranged from 0.14 to 2.01 ng I-TEQ/kg (d.m.) (median and mean values: 0.23 and 0.31 ng I-TEQ/kg, respectively), while in the 1996 survey PCDD/F concentrations ranged from 0.24 to 1.22 ng I-TEQ/kg (d.m.) (median and mean values: 0.53 and 0.61 ng I-TEQ/kg, respectively). According to the present (1998) and the previous (1996) levels of PCDD/Fs found in soils and vegetation, the area under potential influence of the new facility shows a rather low contamination by these compounds. The current results should be useful to establish the environmental impact of the HWI.     

Cobalt-based alumina pillared zirconium phosphate catalysts for the selective catalytic reduction of NO by propane

A series of cobalt containing alumina pillared zirconium phosphate materials have been prepared by ion exchange or by impregnation, and fully characterised. The catalytic behaviour of these materials in the selective catalytic reduction of NO by propane, in excess of oxygen, at temperatures ranging between 350 and 550 degrees C, has been also evaluated. A maximum NO conversion close to 14% is obtained on Co-impregnated catalysts heated at 600 degrees C. The NO reduction seems to be related to the presence of Co3+, thus the calcination temperature of samples influences the resulting activity much more than the cobalt content.     

Bioaccumulation and elimination of 14C-lindane by Enchytraeus albidus in artificial (OECD) and a natural soil

Bioaccumulation and elimination of 14C-lindane in Enchytraeus albidus was studied in artificial OECD soil and a silty loam from an agricultural field in Central West Portugal. Results showed that enchytraeids were able to bioaccumulate the chemical with a kinetic pattern similar to that of earthworms: fast uptake within a few days and a biphasic elimination pattern. A 10 day period to study uptake was sufficient, but a few more days were probably necessary for elimination. Bioaccumulation was influenced by soil type. The authors suggest that higher organic matter (OM) content and also the higher content on sand particles in the OECD soil may have led to a faster elimination: hydrophobic chemicals tend to adsorb to OM being in this way less bioavailable and therefore less bioaccumulated having bioaccumulation factor value around 6 while in natural soil is 10; the sand could act as abrasive particles (helpers) in the elimination process leading to an elimination of 90% of the chemical in two days while in natural soil 67% was eliminated in the same period of time.     

Methods for collecting time/activity pattern information related to exposure to combustion products

Focus groups, surveys and questionnaires, diaries and observations can be used to gather information about people's exposure to a wide range of combustion products. Information about locations and durations of exposure, and sources of exposure can be obtained with these instruments. The types of instruments used must be fine tuned to meet the design characteristics of the community in which the study will be conducted.     

Cancer risk from gaseous carbonyl compounds in indoor environment generated from household coal combustion in Xuanwei,China

Airborne carbonyls were characterized from emitted indoor coal combustion. Samples were collected in Xuanwei (Yunnan Province), a region in China with a high rate of lung cancer. Eleven of 19 types of samples (58%) demonstrated formaldehyde concentrations higher than the World Health Organization exposure limit (a 30-min average of 100 μg m^?3). Different positive significant correlations between glyoxal/methylglyoxal and formaldehyde/acetaldehyde concentrations were observed, suggesting possible different characteristics in emissions between two pairs of carbonyl compounds. A sample in the highest inhalation risk shows 29.2 times higher risk than the lowest sample, suggesting different coal sampling locations could contribute to the variation of inhalation risk. Inhabitants in Xuanwei also tend to spend more time cooking and more days per year indoors than the national average. The calculated cancer risk ranged from 2.2–63 × 10^?5, which shows 13 types of samples at high-risk level. Cumulative effect in combination with different carbonyls could have contributed to the additive actual inhalation cancer risk. There is a need to explicitly address the health effects of environmentally relevant doses, considering life-long exposure in indoor dwellings.