Evaluation of uncertainties originating from the different modeling approaches applied to analyze regional groundwater flow in the Tono area of Japan

Qualitative evaluation of the effects of uncertainties originating from scenario development, modeling approaches, and parameter values is an important subject in the area of safety assessment for high-level nuclear waste disposal sites. In this study, regional-scale groundwater flow analyses for the Tono area, Japan were conducted using three continuous models designed to handle heterogeneous porous media. We evaluated the simulation results to quantitatively analyze uncertainties originating from modeling approaches. We found that porous media heterogeneity is the main factor which causes uncertainties. We also found that uncertainties originating from modeling approaches greatly depend on the types of hydrological structures and heterogeneity of hydraulic conductivity values in the domain assigned by modelers. Uncertainties originating from modeling approaches decrease as the amount of labor and time spent increase, and iterations between investigation and analyses increases.     

Seasonal characteristics of water-soluble organic carbon in atmospheric particles in the inland Kanto plain,Japan

An investigation of water-soluble organic carbon (WSOC) in atmospheric particles was conducted as an index of the formation of secondary organic aerosol (SOA) from April 2005 to March 2006 at Maebashi and Akagi located in the inland Kanto plain in Japan. Fine (<2.1 μm) and coarse (2.1–11 μm) particles were collected by using an Andersen low-volume air sampler, and WSOC, organic carbon (OC), elemental carbon (EC), and ionic components were measured. The mean mass concentrations of the fine particles were 22.2 and 10.5 μg m^?3 at Maebashi and Akagi, respectively. The WSOC in fine particles accounted for a large proportion (83%) of total WSOC. The concentration of fine WSOC ranged from 1.2 to 3.5 μg-C m^?3 at Maebashi, rising from summer to fall. At Akagi, it rose from spring to summer, associated with the southerly wind from urban areas. The WSOC/OC ratio increased in summer at both sites, but the ratio at Akagi was higher, which we attributed to differences in primary emissions and secondary formation between the sites. The fine WSOC concentration was significantly positively correlated with concentrations of SO₄^2?, EC, and K⁺, and we inferred that WSOC was produced by photochemical reaction and caused by the combustion of both fuel and biomass. We estimated that SOA accounted for 11–30% of the fine particle mass concentration in this study, suggesting that SOA is a significant year-round component in fine particles.     

Characteristics of cesium accumulation in the filamentous soil bacterium Streptomyces sp. K202

A filamentous soil bacterium, strain K202, was isolated from soil where an edible mushroom (Boletopsis leucomelas) was growing and identified as belonging to the genus Streptomyces on the basis of its morphological characteristics and the presence of LL-2, 6-diaminopimelic acid. We studied the existence states of Cs and its migration from extracellular to intracellular fluid in the mycelia of Streptomyces sp. K202. The results indicated that Cs accumulated in the cells through at least 2 steps: in the first step, Cs⁺ was immediately and non-specifically adsorbed on the negatively charged cell surface, and in the second step, this adsorbed Cs⁺ was taken up into the cytoplasm, and a part of the Cs entering the cytoplasm was taken up by an energy-dependent transport system(s). Further, we confirmed that a part of the Cs⁺ was taken up into the mycelia competitively with K⁺, because K⁺ uptake into the intact mycelia of the strain was significantly inhibited by the presence of Cs⁺ in the culture media. This suggested that part of the Cs is transported by the potassium transport system. Moreover, ¹³³Cs-NMR spectra and SEM-EDX spectra of the mycelia that accumulated Cs showed the presence of at least 2 intracellular Cs states: Cs⁺ trapped by intercellular materials such as polyphosphate and Cs⁺ present in a cytoplasmic pool.     

Recovery of Nd and Dy from rare earth magnetic waste sludge by hydrometallurgical process

This paper describes a hydrometallurgical process for recovering neodymium (Nd) and dysprosium (Dy) from a magnetic waste sludge generated from the Nd–Fe–B(–Dy) manufacturing process. Phase analysis by XRD study revealed Nd(OH)₃ and Fe₂O₃ as main mineral phases, and chemical analysis by ICP showed the contents of 35.1 wt% Nd, 29.5 wt% Fe, 1.1 wt% Dy and 0.5 wt% B. A solution of 1 M HNO₃ + 0.3 M H₂O₂ was used to dissolve up to 98 % Nd and 81 % Dy, while keeping Fe dissolution below 15 % within 10 min. Fe dissolved in solution was completely removed as Fe(OH)₃ at pH 3 followed by precipitation of Nd and Dy with oxalic acid (H₂C₂O₄) and recovered 91.5 % of Nd and 81.8 % of Dy from solution. The precipitate containing Nd and Dy was calcined at 800 °C to obtain Nd₂O₃ as final product with 68 % purity, and final recovery of 69.7 % Nd and 51 % of Dy was reported in this process.     

Mineral carbonation using alkaline waste and byproducts to reduce CO2 emissions in Taiwan

Environmental Chemistry Letters - Climate change induced partly by emissions of carbon dioxide (CO2) is an urgent issue worldwide, calling for advanced methods of carbon sequestration. Since...     

Assessment of river water quality during snowmelt and base flow periods in two catchment areas with different land use

River water quality was evaluated with respect to eutrophication and land use during spring snowmelt and summer base flow periods in Abashiri (mixed cropland-livestock farming) and Okoppe (grassland-based dairy cattle farming), eastern Hokkaido, Japan. Water from rivers and tributaries was sampled during snowmelt and summer base flow periods in 2005, and river flow was measured. Total N (TN), NO₃–N, and Si concentrations were determined using standard methods. Total catchment and upland areas for each sampling site were determined with ArcGIS hydrology modeling software and 1:25,000-scale digital topographic maps. Specific discharge was significantly higher during snowmelt than during base flow. In both areas, TN concentrations increased, whereas Si concentrations decreased, with increased specific discharge, and were significantly higher during snowmelt. The Si:TN mole ratio decreased to below or close to the threshold value for eutrophication (2.7) in one-third of sites during snowmelt. River NO₃–N concentrations during base flow were significantly and positively correlated with the proportion of upland fields in the catchment in both the Abashiri (r = 0.88, P < 0.001) and Okoppe (r = 0.43, P < 0.01) areas. However, the regression slope, defined as the impact factor (IF) of water quality, was much higher in Abashiri (0.025) than in Okoppe (0.0094). The correlations were also significantly positive during snowmelt in both areas, but IF was four to eight times higher during snowmelt than during base flow. Higher discharge of N from upland fields and grasslands during snowmelt and the resulting eutrophication in estuaries suggest that nutrient discharge during snowmelt should be taken into account when assessing and monitoring the annual loss of nutrients from agricultural fields.     

Evaluating stream water quality through land use analysis in two grassland catchments: impact of wetlands on stream nitrogen concentration

We evaluated the impacts of natural wetlands and various land uses on stream nitrogen concentration in two grassland-dominated catchments in eastern Hokkaido, Japan. Analyzing land use types in drainage basins, measuring denitrification potential of its soil, and water sampling in all seasons of 2003 were performed. Results showed a highly significant positive correlation between the concentration of stream NO3-N and the proportion of upland area in drainage basins in both catchments. The regression slope, which we assumed to reflect the impact on water quality, was 24% lower for the Akkeshi catchment (0.012 +/- 0.001) than for the Shibetsu catchment (0.016 +/- 0.001). In the Akkeshi catchment, there was a significant negative correlation between the proportion of wetlands in the drainage basins and stream NO3-N concentration. Stream dissolved organic nitrogen (DON) and carbon (DOC) concentrations were significantly higher in the Akkeshi catchment. Upland and urban land uses were strongly linked to increases in in-stream N concentrations in both catchments, whereas wetlands and forests tended to mitigate water quality degradation. The denitrification potential of the soils was highest in wetlands, medium in riparian forests, and lowest in grasslands; and was significant in wetlands and riparian forests in the Akkeshi catchment. The solubility of soil organic carbon (SOC) and soil moisture tended to determine the denitrification potential. These results indicate that the water environment within the catchments, which influences denitrification potential and soil organic matter content, could have caused the difference in stream water quality between the two catchments.     

Development of a testing method for asbestos fibers in treated materials of asbestos containing wastes by transmission electron microscopy

Appropriate treatment of asbestos-containing wastes is a significant problem. In Japan, the inertization of asbestos-containing wastes based on new treatment processes approved by the Minister of the Environment is promoted. A highly sensitive method for testing asbestos fibers in inertized materials is required so that these processes can be approved. We developed a method in which fibers from milled treated materials are extracted in water by shaking, and are counted and identified by transmission electron microscopy. Evaluation of this method by using asbestos standards and simulated slag samples confirmed that the quantitation limits are a few million fibers per gram and a few μg/g in a sample of 50 mg per filter. We used this method to assay asbestos fibers in slag samples produced by high-temperature melting of asbestos-containing wastes. Fiber concentrations were below the quantitation limit in all samples, and total fiber concentrations were determined as 47–170 × 10^?6 f/g. Because the evaluation of treated materials by TEM is difficult owing to the limited amount of sample observable, this testing method should be used in conjunction with bulk analytical methods for sure evaluation of treated materials.     

Development of novel absorbents for CO2 capture from blast furnace gas

In order to establish energy-saving technology for CO₂ capture from blast furnace gas, novel absorbents were developed in the laboratory and evaluated at a 1 t_CO2/d test plant. At first, CO₂ absorption and desorption behaviors of single-component amine solvents for simulated blast furnace gas (CO₂/N₂ = 20%/80%) were investigated through a screening test using a small scrubbing bottle. These amine solvents were additionally analyzed using nuclear magnetic resonance (¹³C NMR) spectroscopy and reaction calorimetry. The results of the laboratory experiments showed that there was a trade-off between absorption rate and enthalpy of absorption but some absorbents had unique features. For example, 2-isopropylaminoethanol (IPAE) had high absorption rate and small enthalpy of absorption. Then, new IPAE-based amine solvents (RITE solvents: RITE-A and RITE-B) were formulated and evaluated at the 1 t_CO2/d test plant. CO₂ regeneration energies of the RITE solvents were 3.3 and 3.1 GJ/t_CO2, respectively. With certain process conditions and plant specifications optimized, RITE-B was estimated to have the potential to achieve 2.5 GJ/t_CO2.