Two-phase jet releases,droplet dispersion and rainout,II. Rainout experiments

This paper describes the results of the first experimental stage of Phase IV of a Joint Industry Project (JIP) on liquid jets and two-phase droplet dispersion. The objective of this stage of the JIP was to generate experimental rainout data for non-flashing water and xylene experiments. See the overview companion paper I for a wider overview of the problem, model implementation and associated model validation.A range of orifice sizes (2.5 and 5 mm) and stagnation pressures (4–16 barg) were applied. Measurements included flow rate, initial droplet size, plume concentrations/temperatures for a range of downstream locations, and distributed rainout.Instead of the Phase Doppler Anemometry method used for droplet size measurements earlier in the JIP, a photographic technique was applied in an attempt to include measurement of the larger (non-spherical) droplets. This enabled a more accurate evaluation of the initial droplet size distribution and a much clearer understanding of the droplet morphology. The results showed that the droplet behaviour in the jet is more complex than had been anticipated with the mass distribution dominated by a very small number of large non-spherical droplets. Consequently a large number of spray images were required to evaluate an accurate size distribution.Distributed rainout was measured by weighing the amount of rainout in trays positioned along the jet direction. The rainout results showed a good degree of repeatability and internal consistency. They indicated that an increasing proportion of the released material did not rainout for increasing pressure. Rainout distance also increased with increasing pressure. Evaporation of the liquid was confirmed by temperature measurements, which showed the effect of evaporative cooling.Xylene concentration measurements (up to 1%) were carried out using a direct reading photoionization detector calibrated for xylene (measuring vapour only). For a limited dataset, the accuracy of these measurements was estimated by means of comparison against an alternative more time-consuming concentration method (xylene absorption onto a charcoal filter; measuring both vapour and liquid). The concentration measurements displayed several consistent qualitative features. For example, at a given downstream distance, the peak concentration increases with increasing pressure and nozzle diameter and the vertical height at which the peak is achieved increases. The cross-stream profiles displayed a consistent tendency to increased concentration at the edge of the jet, and the reason for this has not been established.Finally recommendations are provided for potential future work.     

Flammability of hydrocarbon and carbon dioxide mixtures

The effect of carbon dioxide (CO₂) concentration on the ignition behaviour of hydrocarbon and CO₂ gas mixtures is examined in both jets and confined explosions. Results from explosion tests are presented using a 20 l explosion sphere and an 8 m long section of 1.04 m diameter pipeline. Experiments to assess the flame stability and ignition probability in free-jets are reported for a range of different release velocities. An empirically-based flammability factor model for free-jets is also presented and results are compared to ignition probability measurements previously reported in the literature and those resulting from the present tests.The results help to understand how CO₂ changes the severity of fires and explosions resulting from hydrocarbon releases. They also demonstrate that it is possible to ignite gas mixtures when the mean concentration is outside the flammable range. This information may be useful for risk assessments of offshore platforms involved in carbon sequestration or enhanced oil recovery, or in assessing the hazards posed by poorly-inerted hydrocarbon processing plant.     

Synthesis of Soy-Polyol by Two Step Continuous Route and Development of Soy-Based Polyurethane Foam

Soy-polyol has been synthesized via a low energy two-step continuous route thus avoiding intermediate steps and chemicals. The functional groups of soy-polyol thus produced were identified by Fourier transform infrared (FTIR) spectroscopy which confirmed the cleavage of the double bonds, the formation of new epoxy linkages and the presence of hydroxyl groups. The change in chemical structure and physical properties of the soy polyol was further characterized and the results indicated a successful conversion with reduced unsaturation, increased hydroxyl number and increased viscosity. Polyurethane foam was prepared from soy-polyol using isocyanate and thermogravimetric analysis was used to study its thermal decomposition behaviour. Multiple transitions were identified in relation to depolymerization and bond dissociation. Density and compressive strength of the soy-foam were found to be satisfactory. An investigation of microstructure of soy foam by scanning electron microscope and X-ray computed tomography revealed the internal cell morphology and cell structure.     

Investigation of the ozonolysis of ethylenebisdithiocarbamate-fungicides in model solutions

A study of the effectiveness of ozonation for the removal of nabam (disodium ethylenebisdithiocarbamate) from aqueous solutions was carried out. Nabam is the parent compound of a commonly used group of fungicides. The process of nabam degradation was followed in terms of several parameters such as nabam concentration, chemical oxygen demand (COD), sulphate ion concentration as a measure of the relative degree of mineralization of nabam, and the pH value of the solution. Ozonation accelerates the decomposition of nabam with the formation of sulphates and nitrates as final products. The intermediate decomposition products of nabam are more resistant to degradation by ozone than the parent compound. The amounts of ozone which are used in wastewater treatment plants for disinfection may be sufficient to remove both nabam and its decomposition products, at a low level of contamination, but if the concentration of nabam is too high the intermediate decomposition products can still be present. Lowering the pH of the medium favours the oxidation of nabam.     

Compositional Limitations in Poly–3–Hydroxyalkanoates Produced by Pseudomonas oleovorans

It is well known that Pseudomonas oleovorans can utilize sodium octanoate for both cell growth and the synthesis of polyhydroxyalkanoates (PHAs), but it can utilize sodium butyrate only for limited cell growth and not for the polyester formation when this substrate is the sole carbon source. Therefore, these two substrates were evaluated as cofeeds for the possible incorporation of 3-hydroxybutyryl groups in the resulting PHA. When sodium butyrate and sodium octanoate were fed to P. oleovorans as cosubstrates in various proportions, the resultant cell density and polymer content were proportional to the amount of sodium octanoate in the feed. The PHA extracted from cells grown in all combinations of these cosubstrates had similar unit compositions of approximately 8 mole % 3-hydroxyhexanoate, 91 mole % 3-hydroxyoctanoate and 1 mole % 3-hydroxydecanoate. 3-Hydroxybutyrate units were not detected in any of the PHAs isolated, indicating that these units could not be incorporated in the copolymer synthesized by P. oleovorans either because the cell did not synthesize that monomer or, if it did, the PHA synthase could not copolymerize it with the longer chain monomers.     

Limb regeneration and subsequent asymmetry in a male secondary sexual character influences sexual selection in wolf spiders

Males of the brush-legged wolf spider Schizocosa ocreata (Hentz) have conspicuously decorated forelegs used in courtship and agonistic displays. Approximately one in five juvenile males has a missing or regenerating foreleg, and regeneration of a leg lost during development usually results in the absence of a decorative tuft on that leg. The subsequent asymmetry in this male secondary character significantly decreases success in both courtship of females and male-male agonistic interactions. Experimental removal of tufts from one leg of previously successful symmetric males produces similar results. As a test for concomitant behavioral effects, female spiders were shown video images of a courting male with symmetric tufts and the same video image altered to have asymmetric tufts. Female receptivity to the asymmetric video image was lower. In contrast to fluctuating asymmetry resulting from developmental instability, leg tuft asymmetry in S. ocreata most likely arises from a single event during ontogeny – possibly leg loss from an aggressive or predator encounter  – and may serve as a quality indicator in female mate choice. Received: 27 July 1995/ Accepted after revision: 19 November 1995