enforcement of diesel smoke emissions for the state of new jersey

This paper reports on the research program undertaken by the State of New Jersey to determine those tests and instruments which can be used by authorized state agencies for the enforcement of diesel smoke emissions. The state agencies under consideration for the enforcement of diesel smoke emissions are the following: (1) The Division of Motor Vehicles, in its system of state owned inspection stations, will be able to inspect all diesel-powered trucks, and tractors which are registered in New Jersey. (2) The Public Utilities Commission will be able to inspect at their home garages all buses registered in the State. (3) The New Jersey State Police will be able to inspect diesel-powered vehicles on the road. It was decided that the maximum inspection time for each vehicle was not to exceed one minute. On the basis of the one minute per vehicle requirement, eight different tests were evaluated to determine which ones correlated well with normal vehicle operation. These tests included acceleration of a fixed external inertia, free acceleration of only the moving parts of the engine, three ramp tests, a test in which a heavy vehicle was towed, and a driving test in which the vehicle being tested was actually accelerated. The results of tests demonstrated that the modified free acceleration method correlates reasonably well with a loaded steady state cycle, distinguishes the high emitters and is simple to perform. Consequently, the free acceleration test method is recommended for use in inspection stations and on the road. Finally, nearly two hundred vehicles have been tested by this procedure to determine present and potential levels of diesel smoke emissions. Another phase of the program consisted of the determination of smoke measuring techniques and instrumentation. The use and design of smokemeters were extensively investigated, as well as the use of the visual and photographic techniques. Of the various smokemeters tested for this application, several measured smoke satisfactorily in the laboratory, but none were found adequate for field use; they either lacked portability or were unstable due to the deposition of soot on the optics. At the time of writing, specifications for the necessary smokemeter have been drafted and published for bid to interested manufacturers.     

Ozone Injury to Pinus Strobus

In a study of the ozone-induced needle blight of eastern white pine in central New York, acute injuries naturally induced on field trees during a year of relatively low ozone concentrations (1 966) were compared with injuries induced during a year of higher concentrations (1967). Injuries were more frequent and severe and were associated with higher mean ozone concentrations in 1967 than in 1966. Characteristic symptoms were induced on foliage of pine branches exposed to controlled doses of ozone as low as 7 ± 1 pphm for four hours or 3 ± 1 pphm for 48 hours. Such doses were equalled or exceeded two and four times, respectively, in the field during the 1 967 season. Ozone sensitivity of pine needle tissue was increased by fumigation in atmospheres containing water mist. High concentrations of ozone (40-60 pphm) caused general injury of foliage of both ozone-susceptible and resistant trees; the symptoms were unlike those found in the field or caused by fumigation with low concentrations of ozone.     

New PbO2, Support for the Measurement of Sulfation

Since 1966, the Division of Laboratories of the Department of Health of the City of Montreal is carrying on measurements of gaseous pollutants. In order to efficiently use the technical staff that our administrators wanted to devote to the fight against air pollution, a new lead dioxide support for the determination of sulfur dioxide has been devised. The preparation of candies according to the standard method requires much time and skill from the operator, whereas the technique that is proposed is rapid, easy, and provides plates of a high degree of uniformity. A technician with little experience can coat a great number of plates per day with no difficulty. N. A. Huey working at the National Center for Air Pollution Control in Cincinnati published in the September 1968 issue of this Journal a new technique which consists of coating the inside of a plastic Petri dish with a PbO² paste. His method also has the above mentioned advantages. The plates that are suggested allow a simplification of the preliminary work for several types of analyses such as gra-vimetry,¹ colorimetry,³ turbidimetry,^4,5 titrimetry,⁶ and nephelemetry.⁸     

The Removal of Particulate Matter from Fluid Bed Catalytic Cracking Unit Stack Gases

The application of a high-efficiency centrifugal type of separator to fluid bed catalytic cracking units is described in which most of the catalyst particles often lost to the atmosphere are concentrated into a small part of the stack gas (2%). A further separation can then be made on this small stream by an auxiliary separator which further concentrates the catalyst particle into 0.1% of the initia stream. Performance of the main and auxiliary separators are such as to reduce the loss of catalyst particles in the stack gas from 800 ppm to less than 60 ppm in a typical unit. Large amounts of power can be recovered by application of expander turbines to catalytic cracking plants employing this system of separation.     

Determination of Oxides of Nitrogen in Combustion Effluents with a Nitrate Ion Selective Electrode

The nitrate ion selective electrode was investigated as an alternative approach to the present colorimetric determination of nitrate resulting from oxidative absorption of nitrogen oxides from combustion effluents. The electrode offers advantages of speed and relatively simple experimental procedure. Replicate measurements of 10^?4–10^?2M nitric acid solutions using bracketing standards show that the electrode approach is capable of good precision (coefficient of variation = ±4%). Comparison of a method utilizing the nitrate electrode with the more laborious phenol disulfonic acid method for the measurement of nitrogen oxides in both oil and gas fired combustion effluents showed agreement within 4% of the mean even in the presence of high levels of SO₂. The correlation coefficient found for PDS vs nitrate electrode is 0.987.     

Air Pollution Control of an Electric Furnace Steelmaking Shop

The body of information presented in this paper is directed to design engineers, operating management and others who may be concerned with the prevention of atmospheric emissions from electric arc steelmaking furnaces. Inland Steel Co. has recently begun operating its first electric furnace shop. Air pollution control equipment for the shop was installed to meet or exceed the legal requirements of applicable air pollution ordinances and regulations. General shop production requirements were established at 100 tons of steel per hour (maximum) to meet sales forecasts and intermediate production facility requirements. Conventional swing roof furnace design was selected for the pair of furnaces in the shop.     

A Portable,Battery-Operated,Immediate-Readout Dust-Particle Analyzer

A portable, battery-operated, electro-optical dust analyzer operating on the principle of light scattering from individual dust particles in air drawn through a high-intensity light field has been developed for monitoring dust levels where external power may be unavailable. The instrument counts and size-discriminates airborne particles over two size ranges upwards of 0.3 microns with immediate readout. A dilution mechanism permits analysis of particulate concentrations as high as 2400 particles/cm³ on each channel. The self-contained Ni-Cd batteries are rechargeable. Total weight, including batteries and all components, is approximately 14 Ib. Total power used, mainly for pumping a filtered air sheath at 300 cm/sec and for the light source, is less than 34 watts. Another unique feature is the flow system designed for turbulence suppression.

Electronic calibration in terms of number of particles/cm³ for each size range is accomplished in the laboratory by means of a pulse generator with respect to which the readout indicator is calibrated for count. The input voltages to the pulse-height discriminators are appropriately attenuated for various pulse amplitudes simulating the output of the light-sensitive pickup, a photomultiplier tube.Pulse height as a function of particle size was measured for polystyrene latex beads ranging from 0.3 to 2 microns in diameter. Good correlation is obtained with results from commercial analyzers.

Field surveys have been undertaken with the CAES prototype analyzer at various sites in central Pennsylvania and at numerous sampling points within the cities of Pittsburgh and Philadelphia. Particulate concentrations as high as 1400 particles/ cm³ have been measured at a coal cleaning plant.     

Modifications to an H2S Tape Sampler for Increasing Sensitivity and Accuracy in H2S Sampling

The tape samplers using lead acetate impregnated paper tapes for continuous hydrogen sulfide sampling are subject to a number of errors which can throw considerable doubt on the accuracy of H₂S concentrations being measured. Some of the errors have been minimized with a change in the humidification system and a reduction of the lamp intensity in the optical system.