Ammonia emission from grassland and livestock production systems in the UK

Emissions of ammonia were measured from livestock excreta and fertilisers applied to grass swards, from grazed paddocks, from decomposing grass herbage and from an animal house containing dairy cows. Emissions from urine, dung, slurry and fertilisers were determined using a system of wind tunnels with each tunnel covering an area of 1 m(2). Emissions from grazed swards were determined using a micrometeorological mass balance method. From the results of these measurements, together with other published information, an inventory for ammonia emissions has been calculated for grassland and livestock production systems over the UK as a whole. It is estimated that emissions from grassland and cattle and sheep production amount to about 230 kt NH(3)-N annually, while emissions from pig and poultry production amount to about 40 kt and 80 kt NH(3)-N, respectively.     

Electrochemical oxidation of bisphenol A. Application to the removal of bisphenol A using a carbon fiber electrode

Leachate samples with a high strength of ammonium-nitrogen (NH4+-N) were collected from a local landfill site in Hong Kong. Two experiments were carried out to study (1) the inhibition of microbial activity of activated sludge by NH4+-N and (2) the chemical precipitation of NH4+-N from leachate as a preliminary treatment prior to the activated sludge process. The experimental results demonstrated that the efficiency of COD removal decreased from 97.7% to 78.1%, and the dehydrogenase activity of activated sludge decreased from 9.29 to 4.93 microg TF/mg MLSS, respectively, when the NH4+-N concentration increased from 53 to 800 mg/l. The experiment also demonstrated that the NH4+-N in the leachate can be quickly precipitated as MgNH4PO4 x 6H2O after addition of MgCl2 x 6H2O + Na2HPO4 x 12H2O. The NH4+-N concentration was reduced from 5618 to 112 mg/l within 15 min when a molar ratio of Mg2+:NH+:PO4(3-) = 1:1:1 was used. The optimum pH to reach the minimum solubility of MgNH4PO4 x 6H2O was found to be in the range of 8.5-9.0. Attention should be given to the high salinity formed in the treated leachate by using MgCl2 x 6H2O + Na2HPO4 x 12H2O, which may affect microbial activity in the following biological treatment processes. Using two other combinations of chemicals [MgO + 85%H3PO4 and Ca(H2PO4)2 x H2O + MgSO4 x 7H2O] could minimise salinity generation after precipitation, while they were less efficient for NH4+-N removal.     

The first commercial supercritical water oxidation sludge processing plant

Final disposal of sludge continues to be one of the more pressing problems for the wastewater treatment industry. Present regulations for municipal sludge have favored beneficial use, primarily in land application. However, several agencies and entities have warned of potential health risks associated with these methods. Hydrothermal oxidation provides an alternative method that addresses the health concerns associated with sludge disposal by completely converting all organic matter in the sludge to carbon dioxide, water, and other innocuous materials. A hydrothermal oxidation system using HydroProcessing, L.L.C.'s HydroSolids process has been installed at Harlingen, Texas to process up to 9.8 dry tons per day of sludge. Based on a literature review, this system is the largest hydrothermal oxidation system in the world, and the only one built specifically to process a sludge. Start up of Unit 1 of two units of the HTO system began in April 2001. Early results have indicated COD conversion rates in excess of 99.9%. Harlingen Waterworks System estimates that the HydroSolids system will cost less than other alternatives such as autothermal thermophilic aerobic digestion and more traditional forms of digestion that still require dewatering and final disposal. The Waterworks intends to generate income from the sale of energy in the form of hot water and the use of carbon dioxide from the HydroSolids process for neutralization of high pH industrial effluent. The Waterworks also expects to generate income from the treatment of septage and grease trap wastes.     

Spatiotemporal variability of wet atmospheric nitrogen deposition to the Neuse River Estuary, North Carolina

Excessive nitrogen (N) loading to N-sensitive waters such as the Neuse River estuary (North Carolina) has been shown to promote changes in microbial and algal community composition and function (harmful algal blooms), hypoxia and anoxia, and fish kills. Previous studies have estimated that wet atmospheric deposition of nitrogen (WAD-N), as deposition of dissolved inorganic nitrogen (DIN: NO3-, NH3/NH4+) and dissolved organic nitrogen, may contribute at least 15% of the total externally supplied or "new" N flux to the coastal waters of North Carolina. In a 3-yr study from June 1996 to June 1999, we calculated the weekly wet deposition of inorganic and organic N at eleven sites on a northwest-southeast transect in the watershed. The annual mean total (wet DIN + wet organics) WAD-N flux for the Neuse River watershed was calculated to be 956 mg N/m2/yr (15026 Mg N/yr). Seasonally, the spring (March-May) and summer (June-August) months contain the highest total weekly N deposition; this pattern appears to be driven by N concentration in precipitation. There is also spatial variability in WAD-N deposition; in general, the upper portion of the watershed receives the lowest annual deposition and the middle portion of the watershed receives the highest deposition. Based on a range of watershed N retention and in-stream riverine processing values, we estimate that this flux contributes approximately 24% of the total "new" N flux to the estuary.     

Respiration and lipid content of the Arctic copepod<Emphasis Type="Italic"> Calanus hyperboreus</Emphasis> overwintering 1 m above the seafloor at 2,300 m water depth in the Fram Strait

In August 2000 high concentrations of the dominant herbivorous copepod Calanus hyperboreus were detected in the Arctic Fram Strait, west of Spitsbergen, 1 m above the seafloor at 2,290 m water depth. Individuals from that layer were sampled by a hyper-benthic net attached to the frame of an epi-benthic sledge. For comparison, the vertical distribution of C. hyperboreus in the water column was studied simultaneously by a multiple opening/closing net haul from 2,250 m depth to the surface. Maximum abundance was found close to the surface with 6.6 and 10.0 ind. m^?3 at 0–50 m and 50–100 m depth, respectively. However, the major fraction of the population (>40%) occurred between 1,000 and 1,500 m depth. In the deepest layer (2,000–2,250 m) abundance measured 2.2 ind. m^?3 and was twice as high as between 100 and 1,000 m depth. In comparison to individuals from surface waters, copepods from the hyper-benthic layer were torpid and did not react to mechanical stimuli. Stage CV copepodids and females from the deep sample contained 4–10% less lipid and showed significantly reduced respiration rates of 0.24 and 0.26 ml O₂ h^?1 g^?1 dry mass (DM) as compared to surface samples (0.49 and 0.43 ml O₂ h^?1 g^?1 DM). All these observations indicate that the hyper-benthic part of the population had already started a dormant overwintering phase at great depth. Based on the lipid deposits and energy demands, the potential maximum duration of the non-feeding dormant phase was estimated at 76–110 days for females and at 98–137 days for CV copepodids, depending on what indispensable minimum lipid content was assumed. In any case, the estimated times could not meet the necessary requirements for a starvation period of >6 months until the next phytoplankton bloom in the following spring. The ecological implications of these results are discussed with respect to the life cycle and eco-physiological adaptations of C. hyperboreus to its high-Arctic habitat.     

Spatial sampling and the environment: some issues and directions

In this paper we summarize research issues for spatial environmental sampling stemming from a NISS/USEPA workshop held on 21-22 September 1994 at Chapel Hill, NC.     

New Metal Emission Patterns in Road Traffic Environments

The increased awareness of traffic as a major diffuse metal emission source emphasizes the need for more detailed information on the various traffic-related sources and how and where the metals are dispersed. In this study, metal emission patterns in the road traffic environment were examined from the perspective of different surrounding factors, e.g. the importance of intersections, deceleration, vehicle speed and traffic density. A total of 148 topsoil samples from 18 south Swedish roads were analysed (using GFAAS) for traffic-emitted metals, i.e. Cd, Cr, Cu, Ni, Pb, Sb and Zn. The roadside topsoil metal concentrations were used to examine correlations between metals and surrounding factors. The studied metals were divided into three groups corresponding to different emission sources: metals from decelerating activities (Cu, Sb and Zn), metals as historical residues from the combustion of petrol (Pb and Cd), and non-source-specific metals (Cr and Ni). It was found that Cu and Sb, despite their rather short history as traffic-emitted metals, have increased more than eightfold in roadside soils compared to background levels. The major source of road traffic related Cu and Sb is brake linings. The significant increase of Cu and Sb in roadside topsoil stresses the need for metal transport studies as well as effect studies of these metals. Metals emitted due to decelerating activities were not correlated to elevated concentrations near road junctions. Emission patterns of traffic-related metals alongside roads are crucial in order to be able to evaluate the optimal localization of storm water treatment ponds.     

Municipal solid waste characteristics and management in China

The purpose of this investigation is to evaluate the current status and identify the problems of municipal solid waste (MSW) management in China in order to determine appropriate remedial strategies. This is the first of two papers, discussing primarily the general characteristics of MSW and its management in China. The second paper focuses on specific remedial strategies. MSW generation in China has increased rapidly in the past 20 years from 31.3 million tons in 1980 to 113.0 million tons in 1998. The annual rate of increase is 3-10%. The average generation per capita is 1.0 kg/day (0.38 t/year). Nearly one-half of the waste generated is dumped in the suburbs, where the accumulated quantity has reached 6 billion tons, which has caused heavy environmental pollution. This paper provides information on MSW management in China, such as MSW generation and its physical, chemical, and biological properties. Low calorific value and high moisture content characterize China's municipal waste. Other issues related to MSW management in China are also discussed, including the factors that influence MSW generation quantity and