光催化氧化技术对焦化废水的处理

通过自制的光催化剂对某厂焦化废水进行了处理.通过实验,论述了光催化剂的制取过程,并对其处理性能进行了评价,在低成本下,取得了比较好的效果.实验表明,通过混凝沉降预处理后,在紫外光照射下,加入适量H2O2,能够大大提升光催化剂的处理效率,通过40-60 min反应,可使COD去除率达到94%以上,基本达到相关的排放标准.     

Thermogravimetric analysis and kinetic study on pyrolysis of representative medical waste composition

To obtain detailed information on the pyrolysis characteristics, a thermogravimetric study on the pyrolysis of 14 typical medical waste compositions was carried out in thermogravimetric analysis (TGA) equipment using dynamic techniques in a stream of N(2). An index representing pyrolysis reactivity of waste was presented. Kinetic parameters were obtained by Coats-Redfern method and used to model the TG curve. The results showed that: (a) Plastic, protein, cellulosic material, synthetic fibre, and rubber entered pyrolysis process in succession. (b) There was one decomposition stage in the pyrolysis of one-off medical glove, operating glove, cellulosic waste, absorbable catgut suture and adhesive plaster, while other components had two obvious weight loss stages. (c) The obtained apparent activation energy for second stage pyrolysis was comparably higher than that for first stage. (d) Each stage was controlled by only one kinetic mechanism, in which kinetic parameters were constant. (e) The degradation kinetics of medical waste may be affected by special physical and chemical treatment in the product manufacturing process. (f) Among 13 waste samples, the pyrolysis index of cellulosic matter was the highest, which indicated cellulosic matter had strong pyrolysis reactivity. (g) With increasing heating rate, TG curve and DTG peak shifted to high temperatures and main reaction interval of the sample became longer.     

Geotechnical and leaching properties of flowable fill incorporating waste foundry sand

Waste foundry sand (WFS) can be converted into flowable fill for geotechnical applications. In this study, WFS samples were obtained from 17 independent metal casting facilities with different casting processes, thus representing a good range of WFS properties. The laboratory studies include physical, geotechnical and leaching properties of flowable fills consisting of WFS, cement, and fly ash mixed to different water contents. The main properties measured include WFS physical properties (density, particle gradation, grain shape, and fine content), WFS flowable fill geotechnical properties (unconfined compressive strength, hydraulic conductivity, setting time, and bleeding), and the fill's leaching properties (heavy metals and organics in the bleed water and the leachate extracted from hardened WFS flowable fills). The test results indicate that in terms of the physical properties, most of the data fall within narrow ranges, although data from the copper/aluminum-based WFS samples might fall beyond the ranges. Geotechnical properties of WFS flowable fills in both fresh and hardened phases were verified conforming to the features of specified flowable fills. Material leaching analyses indicate that the toxicity of WFS flowable fills is below regulated criteria. A mix formulation range originated from this study is proposed for the design of WFS made flowable fill.     

三种偶氮染料降解历程在紫外-可见光谱上的表现

本文对基本结构相似的三种偶氮染料橙黄Ⅱ、活性艳红Ｘ－３Ｂ和活性黑Ｋ－ＢＲ水溶液在铁粉还原－光氧化两步法处理中的紫外－可见光谱图作对比分析,依据其结构与特征吸收的关系,初步推测还原铁粉－光氧化法降解染料的历程。     

气相色谱法测定废水和废气中N′,N-二甲基甲酰胺

以气相色谱石英毛细管柱分离、ＦＩＤ检测,测定废水和废气中Ｎ′,Ｎ－二甲基甲酰胺（ＤＭＦ）。在１０ｍｇ／Ｌ～１８８１０ｍｇ／Ｌ范围内有良好的线性关系。检测限：废水为０５ｍｇ／Ｌ;废气为０８ｍｇ／ｍ３。样品测定的相对标准差为４％～８％,回收率在７６％～１１２％之间,精密度和准确度均较好     

基于云模型的富水岩溶隧道涌水风险评价

为适应风险因素不确定性、随机性及动态反馈性等特点,建立新型富水岩溶隧道涌水风险评价体系,提出1种基于云模型的模糊综合评价方法.选取5个1级指标、29个2级指标构建评价指标体系;综合层次分析、熵权与加权平均计算法合理分配各指标权重;利用云生成算法计算出云数字特征参数并生成足够数量的云滴;将方法应用于贵州省某隧道涌水风险评...     

苏南运河镇江段水环境污染特征及治理对策

利用2010~2012年例行监测数据和2011年实地补充监测数据对苏南运河镇江段水环境状况进行分析,并采用等标污染负荷法对该区域污染源数据进行评价。结果表明:苏南运河镇江段在2010~2012年期间污染情况较为严重,其主要超标项目为总氮、氨氮、总磷、COD Cr,总氮项目超标2.706~2.998倍,显示污染类型以氮磷类和有机类为主。研究区域内污染负荷以生活污水的排放所造成的污染的贡献率最大(占56.8%),农业面源排放所造成的污染居第2位(占32.3%),表明苏南运河镇江段的治理重点在于生活污水和农业面源的控制上。在此结论基础上,提出一整套有针对性的水环境污染防治措施的完整体系。     

城市固体废物生物处理方法及其可行性

生物反应堆是通过强化微生物转化和降解有机废物的能力进行处理固体废物的一种方法。本文分别对好氧生物处理、厌氧生物处理和兼性生物处理的机理、影响因素以及各污染物质的迁移转化规律进行综合分析。研究表明生物反应堆具有明显的社会、环境、经济效益，是实现可持续发展的一条重要途径，为以后的研究和应用提供可靠的理论依据。     

农村混合生活污水排放特征及其处理工艺研究

针对农村生活污水污染问题已成为影响我国农村水环境的主要因素以及目前黑灰分离收集处理与现状不相符合,本文对崇明县某村的污水排放特征以及水量水质进行调研,并对硝化预处理系统结合人工湿地反硝化以及脱氮预处理结合人工湿地深度处理两种运行模式进行了深入探讨并分析了其去除机理,结果显示,硝化预处理系统结合人工湿地反硝化由于后续反硝化需要投加大量碳源从经济管理方面而言变得不可行;脱氮预处理结合人工湿地深度处理在预处理系统以进水3h、曝气2h、沉淀0.5h、排水0.5h、气水比40∶1的模式运行、人工湿地水力停留时间为48h条件下出水可满足《城镇污水处理厂污染物排放标准》(GB18918-2002)的二级要求,且因氨氮指标的降低大幅缩短了人工湿地的水力停留时间而减小占地面积。     

我国标准气体应用于涉VOCs重点行业监测管理中的不足及建议

随着我国对VOCs监测控制的持续推进,VOCs标准气体的配套应用及其管理思路也面临着新要求和挑战。本文通过梳理我国VOCs类标准气体对涉VOCs企业污染物监测和管理支撑的现状,指出了VOCs监测管理中对标准气体的应用要求尚待细化、已有VOCs标准气体应用不够充分、VOCs标准气体对排放标准实施的精准支撑作用不足等问题。在探究现状与问题的基础上,提出进一步细化VOCs排放监测对标准气体应用要求、加强企业自行监测中VOCs标准气体的应用指导、加强短缺标准气体的研制与应用的建议。