Nitrogen mass balance in a constructed wetland treating piggery wastewater effluent

The nitrogen changes and the nitrogen mass balance in a free water surface flow constructed wetland （CW） using the four-year monitoring data from 2008 to 2012 were estimated. The CW was composed of six cells in series that include the first settling basin （Cell 1）, aeration pond （Cell 2）, deep marsh （Cell 3）, shallow marsh （Cell 4）, deep marsh （Cell 5） and final settling basin （Cell 6）. Analysis revealed that the NH4＋-N concentration decreased because of ammonification which was then followed by nitrification. The NO4＋-N and NO4＋-N were also further reduced by means of microbial activities and plant uptake during photosynthesis. The average nitrogen concentration at the influent was 37,819 kg/year and approximately 45% of that amount exited the CW in the effluent. The denitrification amounted to 34% of the net nitrogen input, whereas the accretion of sediment was only 7%. The biomass uptake of plants was able to retain only 1% of total nitrogen load. In order to improve the nutrient removal by plant uptake, plant coverage in four cells （i.e., Cells 1, 3, 4 and 5） could be increased.     

The response of a mid- and high latitude peat bog to predicted climate change: methane production in a 12-month peat incubation

There are fears that global warming will lead to degradation of peatlands, higher emissions of greenhouse gases from peat, and accelerated warming. Anaerobic decomposition of organic soils produces methane (CH₄), a potent greenhouse gas. Two peat bogs differing in mean annual temperature, Velke Darko (VD, Czech Republic, 7.2 °C), and Stor Åmyran (SA, Sweden, 4.0 °C), were selected for a comparative study of how organic soils in different climatic zones will respond to warmer and drier conditions. Twenty peat cores from each bog were incubated in growth chambers. Under present-day summer conditions, VD produced 14 times more CH₄ than SA. Two different warming scenarios were used. Peat-core replicates were kept at temperatures of 11 versus 16 °C, and 11 versus 22 °C. From 11 to 16 °C, the CH₄ production slightly decreased at SA, and slightly increased at VD. From 11 to 22 °C, the CH₄ production increased 9 times at SA, but slightly decreased at VD. After an 8-month incubation, peat cores under drying conditions (water table at ?14 cm) were compared to samples with original water table (?2 cm). Drying conditions led to a steeper reduction in CH₄ production at VD, compared to SA. The CH₄ production decreased more than 100 times at VD. Then, the combined effect of simultaneous warming and drying at 11 and 22 °C was studied. We did not find any significant effect of interactions between increasing temperature and decreasing water table level. Overall, the warmer site VD responded more strongly to the simulated climate change than the colder site SA.     

A new Dasypodini armadillo (Xenarthra: Cingulata) from San Gregorio Formation,Pliocene of Venezuela: affinities and biogeographic interpretations

We describe Pliodasypus vergelianus gen. et sp. nov., a Dasypodini armadillo from the middle Pliocene of Venezuela (Vergel Member, San Gregorio Formation). Although scarce, the remains are remarkable because of their geochronologic proximity to the main phase of Great American Biotic Interchange (GABI). The cladistic analysis conducted reveals that Pliodasypus groups with Dasypus and both are sister taxa of Propraopus, whereas Anadasypus is at a basal position. With respect to the records of tribe Dasypodini, after its oldest representative (Anadasypus, middle and late Miocene), the chronologically subsequent form is Pl. vergelianus (middle Pliocene), followed by Dasypus bellus in higher northern latitudes (late Pliocene), and then by widespread occurrences in the Pleistocene of North America (D. bellus) and South America (Propraopus, Dasypus punctatus, and Dasypus novemcinctus). Thus, we infer that Dasypus differentiated in the late Pliocene at low latitudes in the northern South America. It leads to two alternative hypotheses of dispersal: (a) some early Dasypus remained cryptically in South America until the Pleistocene, whereas others dispersed to North America between 2.2 and 2.7 Ma, or (b) they dispersed to North America subsequently to the emersion of the Panamanian isthmus and D. bellus differentiated there; later, during the Pleistocene, D. bellus entered South America and experienced speciation. The same process of re-ingression has been proposed to other xenarthrans, breaking with the traditional assumption that the GABI was unidirectional.     

Trail laying during tandem-running recruitment in the ant Temnothorax albipennis

Tandem running is a recruitment strategy whereby one ant leads a single naïve nest mate to a resource. While tandem running progresses towards the goal, the leader ant and the follower ant maintain contact mainly by tactile signals. In this paper, we investigated whether they also deposit chemical signals on the ground during tandem running. We filmed tandem-running ants and analysed the position of the gasters of leaders and followers. Our results show that leader ants are more likely to press their gasters down to the substrate compared to follower ants, single ants and transporter ants. Forward tandem-run leaders (those moving towards a new nest site) performed such trail-marking procedures three times more often than reverse tandem leaders (those moving towards an old nest site). That leader ants marked the trails more often during forward tandem runs may suggest that it is more important to maintain the bond with the follower ant on forward tandem runs than on reverse tandem runs. Marked trails on the ground may serve as a safety line that improves both the efficiency of tandem runs and their completion rates.     

A One Year Study on the Concentrations of Norovirus and Enteric Adenoviruses in Wastewater and A Surface Drinking Water Source in Norway

Enteric viruses transmitted via the faecal-oral route occur in high concentrations in wastewater and may contaminate drinking water sources and cause disease. In order to quantify enteric adenovirus and norovirus genotypes I and II (GI and GII) impacting a drinking source in Norway, samples of surface water (52), wastewater inlet (64) and outlet (59) were collected between January 2011 and April 2012. Samples were concentrated in two steps, using an electropositive disc filter and polyethylene glycol precipitation, followed by nucleic acid extraction and analysis by quantitative polymerase chain reaction. Virus was detected in 47/52 (90.4 %) of surface water, 59/64 (92 %) of wastewater inlet and 55/59 (93 %) of wastewater outlet samples. Norovirus GI occurred in the highest concentrations in surface water (2.51e + 04) and adenovirus in wastewater (2.15e + 07). While adenovirus was the most frequently detected in all matrices, norovirus GI was more frequently detected in surface water and norovirus GII in wastewater. This study is the first in Norway to monitor both sewage and a drinking water source in parallel, and confirms the year-round presence of norovirus and adenovirus in a Norwegian drinking water source.     

Mapping Adolescents’ Sense of Place and Perceptions of Change in an Urban–Rural Transition Area

Environmental Management - Landscapes are changing, with rural areas becoming increasingly urbanized. Children and adolescents are underrepresented in the sense-of-place literature. Our study aimed...     

Muskox status,recent variation,and uncertain future

Ambio - Muskoxen (Ovibos moschatus) are an integral component of Arctic biodiversity. Given low genetic diversity, their ability to respond to future and rapid Arctic change is unknown, although...     

A novel in vitro exposure technique for toxicity testing of selected volatile organic compounds

Exposure to vapours of volatile chemicals is a major occupational and environmental health concern. Toxicity testing of volatile organic compounds (VOCs) has always faced significant technological problems due to their high volatility and/or low solubility. The aim of this study was to develop a practical and reproducible in vitro exposure technique for toxicity testing of VOCs. Standard test atmospheres of xylene and toluene were generated in glass chambers using a static method. Human cells including: A549-lung derived cell lines, HepG2-liver derived cell lines and skin fibroblasts, were grown in porous membranes and exposed to various airborne concentrations of selected VOCs directly at the air/liquid interface for 1 h at 37 degrees C. Cytotoxicity of test chemicals was investigated using the MTS (3-(4,5-dimethylthiazol-2-yl)-5-(3-carboxymethoxyphenyl)-2-(4-sulfophenyl)-2H-tetrazolium) and NRU (neutral red uptake) assays following 24 h incubation. Airborne IC(50) (50% inhibitory concentration) values were determined using dose response curves for xylene (IC(50)=5350+/- 328 ppm, NRU; IC(50)=5750+/- 433 ppm, MTS in skin fibroblast) and toluene (IC(50)=0 500+/- 527 ppm, NRU; IC(50)=11,200 +/- 1,044 ppm, MTS in skin fibroblast). Our findings suggest that static direct exposure at the air/liquid interface is a practical and reproducible technique for toxicity testing of VOCs. Further, this technique can be used for inhalational and dermal toxicity studies of volatile chemicals in vitro as the exposure pattern in vivo is closely simulated by this method.     

Bioaerosol sampling by a personal rotating cup sampler CIP 10-M

High concentrations of bioaerosols containing bacterial, fungal and biotoxinic matter are encountered in many workplaces, e.g. solid waste treatment plants, waste water treatment plants and sewage networks. A personal bioaerosol sampler, the CIP 10-M (M-microbiologic), has been developed to measure worker exposure to airborne biological agents. This sampler is battery operated; it is light and easy to wear and offers full work shift autonomy. It can sample much higher concentrations than biological impactors and limits the mechanical stress on the microorganisms. Biological particles are collected in 2 ml of liquid medium inside a rotating cup fitted with radial vanes to maintain an air flow rate of 10 l min(-1) at a rotational speed of approximately 7,000 rpm. The rotating cup is made of sterilisable material. The sampled particles follow a helicoidal trajectory as they are pushed to the surface of the liquid by centrifugal force, which creates a thin vertical liquid layer. Sterile water or another collecting liquid can be used. Three particle size selectors allow health-related aerosol fractions to be sampled according to international conventions. The sampled microbiological particles can be easily recovered for counting, incubation or further biochemical analysis, e.g., for airborne endotoxins. Its physical sampling efficiency was laboratory tested and field trials were carried out in industrial waste management conditions. The results indicate satisfactory collection efficiency, whilst experimental application has demonstrated the usefulness of the CIP 10-M personal sampler for individual bioaerosol exposure monitoring.