The Number-Size Distribution of Atmospheric Particles During Temperature Inversions

Instruments capable of measuring in situ numbers of particles within specific size ranges covering a particle-diameter spectrum of approximately 0.001 – 10 microns have been employed to continuously monitor the concentration and size-distribution of atmospheric aerosols. The monitoring site was a television tower located on the boundary between Minneapolis and St. Paul, Minnesota. Air samples were drawn from 70, 170, and 500 feet above ground level and analyzed with optical, electrical, and condensation particle counters to obtain a number-size distribution within the 0.001 – 10 micron size range. In addition to the measurement of particle number and size, several micrometeorological parameters were simultaneously monitored. Particle number-size distributions which were measured during periods of temperature inversion are reported     

Ozone Injury to Pinus Strobus

In a study of the ozone-induced needle blight of eastern white pine in central New York, acute injuries naturally induced on field trees during a year of relatively low ozone concentrations (1 966) were compared with injuries induced during a year of higher concentrations (1967). Injuries were more frequent and severe and were associated with higher mean ozone concentrations in 1967 than in 1966. Characteristic symptoms were induced on foliage of pine branches exposed to controlled doses of ozone as low as 7 ± 1 pphm for four hours or 3 ± 1 pphm for 48 hours. Such doses were equalled or exceeded two and four times, respectively, in the field during the 1 967 season. Ozone sensitivity of pine needle tissue was increased by fumigation in atmospheres containing water mist. High concentrations of ozone (40-60 pphm) caused general injury of foliage of both ozone-susceptible and resistant trees; the symptoms were unlike those found in the field or caused by fumigation with low concentrations of ozone.     

Pennsylvania’s Compuiterized Air Monitoring System

The Pennsylvania Air Pollution Commission has developed a regulatory program based upon the control of local air pollution problems and reduction of pollutant levels in air basins. The geographical boundaries of 10 air basins have been established. The Commission’s air basin regulations will provide for the reduction of over-all pollutant levels and for emergency procedures in the event of adverse meteorological conditions. The paper discusses the format and objectives of the program.

In order to effectively enforce the air basin regulations and maintain the necessary surveillance of the state’s air quality, a "computerized real time on-line integrated air monitoring-data handling system" has been designed. The system will incorporate a network to constantly monitor the air in each air basin.The primary objectives of the system are: 1. Constant surveillance of air pollution in the air basins.

2. Provide information on air pollution potential alerts.

3. Aid in further development of air quality criteria and regulations.

The air monitoring network is estimated to include approximately 25 remote stations. Each remote will contain air pollution and meteorological sampling equipment and hardware to telemeter to a central station. The data will be transmitted over leased telephone lines. The central station in Harrisburg will contain the necessary hardware to receive and process data, calculate and display results and permit supervisory control of the network. Output options will include immediate display of edited data, command and alarm information, and presentation of statistical results.

Although the air monitoring system is one of the principle ingredients of the program, the air basin concept encompasses other component systems designed to knit together the entire air pollution control program in Pennsylvania.     

A Portable,Battery-Operated,Immediate-Readout Dust-Particle Analyzer

A portable, battery-operated, electro-optical dust analyzer operating on the principle of light scattering from individual dust particles in air drawn through a high-intensity light field has been developed for monitoring dust levels where external power may be unavailable. The instrument counts and size-discriminates airborne particles over two size ranges upwards of 0.3 microns with immediate readout. A dilution mechanism permits analysis of particulate concentrations as high as 2400 particles/cm³ on each channel. The self-contained Ni-Cd batteries are rechargeable. Total weight, including batteries and all components, is approximately 14 Ib. Total power used, mainly for pumping a filtered air sheath at 300 cm/sec and for the light source, is less than 34 watts. Another unique feature is the flow system designed for turbulence suppression.

Electronic calibration in terms of number of particles/cm³ for each size range is accomplished in the laboratory by means of a pulse generator with respect to which the readout indicator is calibrated for count. The input voltages to the pulse-height discriminators are appropriately attenuated for various pulse amplitudes simulating the output of the light-sensitive pickup, a photomultiplier tube.Pulse height as a function of particle size was measured for polystyrene latex beads ranging from 0.3 to 2 microns in diameter. Good correlation is obtained with results from commercial analyzers.

Field surveys have been undertaken with the CAES prototype analyzer at various sites in central Pennsylvania and at numerous sampling points within the cities of Pittsburgh and Philadelphia. Particulate concentrations as high as 1400 particles/ cm³ have been measured at a coal cleaning plant.     

Honorary Memberships

Honorary Memberships are conferred by the Air Pollution Control Association on persons of widely recognized eminence in some part of the field of air pollution control or who have rendered especially meritorious service to the Association. Honorary Memberships were awarded this year to Dr. Leonard Greenburg and Mr. Milton Reizenstein, both past presidents of APCA.     

Mathematical Modeling of Photochemical Smog Using the PICK Method

A new method for solving the turbulent atmospheric diffusion equation has been developed based on Lagrangian mass points, or particles moving through an Eulerian grid. The method is one of a family of Particle-/n-Cell techniques but is a unique extension to incorporate the effects of turbulent diffusion based on K-theory; thus the acronym PICK.

In the three-dimensional computer-aided model, NEXUS (Numerical EXamination of Urban Smog), this method has been applied to simulation of carbon monoxide (CO) in Los Angeles. For CO the NEXUS simulation was within 20% of observed day-averaged concentrations at 12 stations and the hour-averages were also in good agreement. This model was extended to include the effects of photochemical smog in Los Angeles. The results of the photochemical simulation were also qualitatively correct due to rapid NO to NO₂ conversion in the simulation.     

Rotating Concentric “Homogeneous Turbulence” Gas Scrubber

A device which utilizes the Couette (secondary) flow patterns, which are developed in a fluid between rotating concentric cylinders, is proposed for use in particle collection. The gas being cleaned is dispersed in the scrubbing liquid within the annular space between cylinders. The device was untested at the time of presentation of the paper.     

Stack Dust Sampling: in-Stack Filter or E.P.A. Train

The Environmental Protection Agency has recommended or specified methods for the measurement of participate concentrations in flue gases. The EPA Train for this measurement originally comprised two segments: the front half and the impinger train downstream from the filter proper. This review examines the controversial areas implicit in the use of this EPA Train or the revised EPA train which eliminates the impinger train.     

Evaluation of the Effectiveness of The Lead Peroxide Method for Atmospheric Monitoring of Sulfur Dioxide

This paper presents a simplified analysis to determine the variables that affect the empirical correlation factor used in the lead peroxide method. The rate of sulfation has been determined from two different models. In the first model, the mass transfer rate is calculated from the gas phase resistance alone whereas in the second model, the diffusion resistance in the gel phase is assumed to be the rate limiting step. Although the gas phase and the gel phase resistances may be both important in the actual case, it has been found that the correlation factor based on the first model is adequate to describe general experimental observations. Reasonable agreement has been obtained between the measured and the calculated va|ue of the correlation factor.