Field application of evaluated methodology for determining 1,2‐dibromoethane,EDB, in ambient air

Abstract

EDB (ethylene dibromide) is of regulatory interest because it has cancer inducing properties and is a causative agent of aspermia. Previously evaluated methodology was used to determine the extent of exposure of workers to EDB in citrus fumigation stations and a warehouse used as a holding site before shipment. The purpose of this effort was to carry out environmental sampling, and to determine the exposure level of workers and related administrative personnel at two citrus fumigation centers and at a warehouse     

The Effects of Infiltration and Insulation on the Source Strengths and Indoor Air Pollution from Combustion Space Heating Appliances

Many energy conservation strategies for residences involve reducing house air exchange rates. Reducing the air exchange rate of a house can cause an increase in pollutant levels if there is an indoor pollution source and if the indoor pollutant source strength remains constant. However, if the indoor pollutant source strength can also be reduced, then it is possible to maintain or even improve indoor air quality. Increasing the insulation level of a house is a means of achieving energy conservation goals and, in addition, can reduce the need for space heating and thereby reduce the pollutant source strengths of combustion space heaters such as unvented kerosene space heaters, unvented gas space heaters, and wood stoves. In this paper, the indoor air quality trade-off between reduced infiltration and increased insulation in residences is investigated for combustion space heaters. Two similar residences were used for the experiment. One residence was used as a control and the other residence had infiltration and insulation levels modified. An unvented propane space heater was used as the source in this study. A model was developed to describe the dependence of both indoor air pollution levels and the appliance source strengths on house air exchange rates and house insulation levels. Model parameters were estimated by applying regression techniques to the data. Results show that indoor air pollution levels in houses with indoor combustion space heating pollution sources can be held constant (or lowered) by reducing the thermal conductance by an amount proportional to (or greater than) the reduction of the air exchange rate.     

Ambient Air Benzene Concentrations in Canada (1989-1993): Seasonal and Day of Week Variations,Trends, and Source Influences

Abstract

Since 1987, the Pollution Measurement Division of the Environmental Protection Service, Environment Canada, has operated a field program for measuring benzene in ambient air. With the cooperation of provincial and municipal environmental agencies, samples have been collected at over 30 urban and rural monitoring sites across the country. Samples are collected in evacuated canisters and analyzed by gas chromatography with a mass-selective detector. Using data from all sites, the composite average benzene concentration for Canada over the years 1989 to 1993 was 3.6 μg/m³ and the composite median was found to be 2.6 μ/m³. Benzene concentrations are highest at urban sites near major streets and at sites influenced by industrial sources. For eighteen urban and suburban trend sites (those with no nearby industrial sources), composite annual median benzene concentrations decreased by 20% between 1989 and 1993. For the same period, median benzene concentrations decreased by 33% at four trend sites with nearby industries. At most monitoring sites the parameters for benzene and CO are highly correlated; supporting the inventory estimate that most emissions of benzene are due to vehicle exhaust. For sites with nearby industrial sources of benzene, the industries are estimated to account for 35 to 70% of the benzene dose experienced at the sites. These site specific contributions are much more significant than the estimated national emissions assigned to industrial sources.     

Controlled Enrichment System for Experimental Fumigation of Plants in the Field with Sulfur Dioxide

A prototype Free-Air Controlled Enrichment (FACE) system was developed at Brookhaven National "Laboratory (BNL) for the experimental control of gas concentrations in an open field, without any form of enclosure. This FACE system consists of a toroidal plenum chamber, 15 m in diameter, with a series of 32 vertical vent pipes from which the release of a test gas can be controlled. Data on gas concentration at the center of the array and wind velocity are fed to a microprocessor where a proportional, integrative, differential (PID) algorithm is used to regulate a mass-flow controller. Data on wind direction are used to control the opening and closing of the vertical vent pipes to maintain an upwind release. In 72 hours of continuous operation during which wind velocity varied between 0.3 to 8 m sec^-1, the FACE prototype maintained 1 -min averaged concentrations within twenty percent of the 40 ppb set point 94 percent of the time.     

Weekday/Weekend Ozone Differences: What Can We Learn from Them?

Abstract

A national analysis of weekday/weekend ozone (O₃) differences demonstrates significant variation across the country. Weekend 1-hr or 8-hr maximum O₃ varies from 15% lower than weekday levels to 30% higher. The weekend O₃ increases are primarily found in and around large coastal cities in California and large cities in the Midwest and Northeast Corridor. Both the average and the 95th percentile of the daily 1-hr and 8-hr maxima exhibit the same general pattern. Many sites that have elevated O₃ also have higher O₃ on weekends even though traffic and O₃ precursor levels are substantially reduced on weekends. Detailed studies of this phenomenon indicate that the primary cause of the higher O₃ on weekends is the reduction in oxides of nitrogen (NO_x) emissions on weekends in a volatile organic compound (VOC)-limited chemical regime. In contrast, the lower O₃ on weekends in other locations is probably a result of NO_x reductions in a NO_x-limited regime. The NO_x reduction explanation is supported by a wide range of ambient analyses and several photochemical modeling studies. Changes in the timing and location of emissions and meteorological factors play smaller roles in weekend O₃ behavior. Weekday/weekend temperature differences do not explain the weekend effect but may modify it.     

Comparison of gamma-ray dosimeters in a field study in the Chernobyl exclusion zone

ABSTRACT

Five different models of dosimeters were compared in the Chernobyl Inner Exclusion Zone by measuring gamma radiation in 12 locations. We used an instrument made by Mirion Technologies, Inc., as the reference, since that instrument had an NIST-traceable calibration. Two models of dosimeters gave radiation values similar to the Mirion at all levels of radiation encountered. Two other models gave similar values to the Mirion instrument at low radiation levels but not at higher radiation levels encountered. These results offer a caution regarding the accuracy of inexpensive commercially available radiation instruments.

Implications: Comparison of gamma ray dosimeters in the Chernobyl Exclusion Zone showed varying agreement with an NIST-calibrated instrument, as well as varying linearity of response to ambient radiation. These results suggest caution regarding accuracy of inexpensive dosimeters. However, dosimeters used that were manufactured in Ukraine exhibited good agreement with the reference instrument.     

Emerging technologies for removing nonpoint phosphorus from surface water and groundwater: introduction

Coastal and freshwater eutrophication continues to accelerate at sites around the world despite intense efforts to control agricultural P loss using traditional conservation and nutrient management strategies. To achieve required reductions in nonpoint P over the next decade, new tools will be needed to address P transfers from soils and applied P sources. Innovative remediation practices are being developed to remove nonpoint P sources from surface water and groundwater using P sorbing materials (PSMs) derived from natural, synthetic, and industrial sources. A wide array of technologies has been conceived, ranging from amendments that immobilize P in soils and manures to filters that remove P from agricultural drainage waters. This collection of papers summarizes theoretical modeling, laboratory, field, and economic assessments of P removal technologies. Modeling and laboratory studies demonstrate the importance of evaluating P removal technologies under controlled conditions before field deployment, and field studies highlight several challenges to P removal that may be unanticipated in the laboratory, including limited P retention by filters during storms, as well as clogging of filters due to sedimentation. Despite the potential of P removal technologies to improve water quality, gaps in our knowledge remain, and additional studies are needed to characterize the long-term performance of these technologies, as well as to more fully understand their costs and benefits in the context of whole-farm- and watershed-scale P management.