Adsorption of multi-heavy metals Zn and Cu onto surficial sediments: modeling and adsorption capacity analysis

Improved multiple regression adsorption models (IMRAMs) was developed to estimate the adsorption capacity of the components [Fe oxides (Fe), Mn oxides (Mn), organic materials (OMs), residuals] in surficial sediments for multi-heavy metal Zn and Cu. IMRAM is an improved version over MRAM, which introduces a computer program in the model developing process. As MRAM, Zn(Cu) IMRAM, and Cu(Zn) IMRAM again confirmed that there is significant interaction effects that control the adsorption of compounded Zn and Cu, which was neglected by additional adsorption model. The verification experiment shows that the relative deviation of the IMRAMs is less than 13 %. It is revealed by the IMRAMs that Mn, which has the greatest adsorption capability for compounded Zn and Cu (54.889 and 161.180 mg/l, respectively), follows by interference adsorption capacity of Fe/Mn (?1.072 and ?24.591 mg/l respectively). Zn and Cu influence each other through different mechanisms. When Zn is the adsorbate, compounded Cu mainly affects the adsorption capacities of Fe/Mn and Fe/Mn/OMs; while when Cu is the adsorbate, compounded Zn mainly exerts its effect on Mn, Fe/Mn, and Mn/OMs. It also shows that the compounded Zn or Cu weakened the interference adsorption of Fe/Mn, and meanwhile, strengthened the interference adsorption of Mn/OMs.     

Carbon Sequestration Function of Check-Dams: A Case Study of the Loess Plateau in China

Check-dams are the most common structures for controlling soil erosion in the Loess Plateau. However, the effect of check-dams on carbon sequestration, along with sediment transport and deposition, has not been assessed over large areas. In this study, we evaluated the carbon sequestration function of check-dams in the Loess Plateau. The results indicate that there were approximately 11 000 check-dams distributed in the Loess Plateau, with an estimate of the amount of sediment of 21 × 10⁹ m³ and a soil organic carbon storage amount of 0.945 Pg. Our study reveals that check-dams in the Loess Plateau not only conserve soil and water but also sequester carbon.     

基于白碳黑的水化硅酸钙制备及其磷回收特性简

以白碳黑、硅灰、硅藻土和硅胶筛选硅质原料,并与钙质原料电石渣制备了水化硅酸钙。借助XRF、BET、FTIR等表征手段,通过多次重复除磷实验,研究了硅质原料特性对水化硅酸钙回收磷性能的影响。结果表明,白碳黑具有极高的反应活性,因此可作为制备具有磷回收特性的水化硅酸钙的硅质原料。结合XRD等表征发现,白碳黑的有效利用率是影响水化硅酸钙回收磷性能的关键,该利用率取决于白碳黑与电石渣的摩尔配比以及水热反应温度。当电石渣与白碳黑的摩尔比为1.6：1,反应温度为170℃时,白碳黑具有最佳的利用效率。该条件制备的水化硅酸钙可作为晶种,在其表面结晶形成羟基磷灰石,从而达到磷回收的目的,磷回收后固体物质中的磷含量为19.05%。     

接种微生物与人粪便同步连续投加对好氧堆肥效果的影响简

利用新型梨形筒式好氧堆肥反应器,在通风量为3.0 L/min,搅拌频率为5 min/h的条件下,就不接种微生物、接种土著菌种、枯草芽孢杆菌与酵母菌时人粪便连续投加好氧堆肥效果进行了对比。堆制20 d即2个运行周期中各堆体的温度、含水率、COD、总氮、pH值与GI等的变化表明,接种微生物可以显著提高堆体的升温速率与堆体平均温度、COD降解率、GI（P<0.01）,堆肥可迅速达到完全腐熟。接种土著菌种效果最为明显（P<0.01）,其后相继为枯草芽孢杆菌与酵母菌。接种土著菌种可使堆体温度在50℃以上维持18 d,第8天COD降解率达到61.17%、总氮损失率为25.75%,第6天时GI达到108.22%。     

电镀污泥的热处理特性以及对金属回收的影响

焙烧-酸浸法可有效回收电镀污泥中的有价金属,而污泥的热处理特性是决定能否采用焙烧预处理的重要因素。研究了氧化焙烧和还原焙烧对污泥成分和金属浸出性的影响,并对焙烧前后的污泥进行了金属形态分析和X射线衍射(XRD)分析。结果表明,焙烧预处理实现了污泥减量和金属富集;ES1经氧化焙烧后金属浸出率接近原泥,Cu的浸出率达99%;ES2的还原焙烧效果优于氧化焙烧,特别是Cu的浸出率超过97%,XRD分析发现,还原焙烧过程中金属Cu被还原为铁铜合金;2种焙烧均造成了ES3中目标金属Ni的浸出率的降低;金属浸出性的下降与残渣态的形成有关。     

船舶塑料垃圾热解特性及动力学分析

利用热重分析(TGA)研究船舶塑料垃圾在不同升温速率和不同气氛下的热解特性,并得到了热解动力学参数。结果表明,船舶塑料垃圾的热解过程主要有3个阶段,比一般塑料热解复杂;随着升温速率增大,最大热解速率和最大热解速率温度等热解特性参数也增大,反应变得更剧烈;N2/CO2比为4∶1时,热解反应进行得最完全,固体残留率最少。动力学分析表明,采用3个连续一级反应模型能很好地拟合实验数据;不同的升温速率和气氛比对反应各阶段活化能均有不同程度的影响。     

KOH活化花生壳生物质炭对亚甲基蓝吸附性能研究

以花生壳生物质炭(P-BC)为原料,KOH为活化剂,采用化学活化法制得活化生物质炭(K-BC),通过考察对亚甲基蓝的吸附性能,研究了花生壳生物质炭的最佳活化条件,并利用N2吸附-脱附实验、SEM等对最佳活化条件下的生物质炭进行表征。结果表明,K-BC活化的最佳条件为碱炭比为1.5∶1,活化温度为800℃,活化时间为90 min,此时K-BC的比表面积达到597.93 m2/g,总孔容达到0.76 cm3/g。并考察了亚甲基蓝初始浓度、pH等对K-BC吸附亚甲基蓝的影响,随着初始浓度的增加,吸附平衡时间显著延长,亚甲基蓝去除率显著降低;当pH=6时,K-BC对亚甲基蓝的吸附量最大;K-BC对亚甲基蓝的吸附动力学曲线符合伪二阶动力学模型,吸附平衡时K-BC对亚甲基蓝的吸附能力为80~149.95 mg/g。     

聚丙烯酸钠作为调理剂对好氧堆肥的保氮影响

实验以污泥、锯末、猪粪为原料,以聚丙烯酸钠(PAAS)为调理剂,利用自制好氧堆肥反应器,研究了PAAS在污泥好氧堆肥中的保氮效果。实验显示,PAAS会提高堆体的pH水平,抑制氨氮的生成,从而减少NH3的挥发源,在PAAS对水溶性氨的吸附作用下,堆肥产品的最终氨氮水平依然得到提高;PAAS对硝化反应有一定的促进作用,添加PAAS的堆体在堆肥周期内的硝氮平均增幅可达到未添加PAAS的空白堆体的4.64倍;添加PAAS的堆体在堆肥周期内全氮平均降幅只有空白堆体的52.24%。PAAS做为堆肥调理剂起到了较为明显的保氮效果。     

改性膨润土联合混凝剂处理微污染水中有机物

采用十二烷基多糖苷季铵盐作为改性剂制备改性膨润土,研究了改性膨润土联合混凝剂去除有机物的效果,考察了有机改性剂用量、微波辐射功率、辐射时间、膨润土投加量、pH值对有机物去除效果的影响,探讨了改性膨润土的改性和去除机理。结果表明,经微波改性后,实现了十二烷基多糖苷季铵盐阳离子对膨润土的插层,增大了层间距,提高了膨润土的吸附性能。联合混凝剂投加改性膨润土能够改善絮凝性能,显著提高有机物的去除效果。在最佳条件下,改性膨润土与PAC联合后的强化混凝,对初始浓度15.3 mg/L的微污染水中有机物的去除率达到95%以上,吸附符合Freundlich吸附等温方程。     

DO浓度对间歇曝气单级自养脱氮系统N2O排放的影响

以单级自养脱氮系统为研究对象,采用有效容积为15 L的SBBR反应器,系统进水NH+4-N浓度约为360 mg/L,控制温度为(30±2)℃,采用间歇曝气方式运行,曝气段DO浓度从2.4~2.6 mg/L逐渐下降到0.9~1.1 mg/L,研究了单级自养脱氮系统的脱氮性能与N2O排放情况。结果表明,反应器曝气段DO浓度从2.4~2.6 mg/L下降到0.9~1.1mg/L,系统TN去除率均达到80%,但在相同运行时间内的TN去除率依次降低,NH+4-N平均反应速率从0.19 mg/(L·min)降低至0.05 mg/(L·min),NO-3-N累计产生量稳定于14.9~16.5 mg/L,NO-2-N浓度在反应器内未产生明显的积累。随着曝气段DO浓度的下降,最大N2O释放速率逐渐降低,N2O累计释放量从73.8 mg下降到61.0 mg,N2O转化率介于2.4%~2.9%。