Effect of membrane type and material on performance of a submerged membrane bioreactor

This study evaluated the impact of membrane type and material on filtration performance in a submerged membrane bioreactor (MBR) for municipal wastewater treatment. Three types of microfiltration membranes with similar pore size of 0.1 microm but different materials and types, phase-inversed polytetrafluoroethylene (PTFE), track-etched polycarbonate (PCTE) and track-etched polyester (PETE), were used. Changes in permeability with time for the PCTE and PTFE membranes appeared similarly, whereas the PETE membrane exhibited the most rapid flux decline. Lower TOC in the permeate compared to the supernatant was probably due to a combination of biodegradation by the biofilm (cake layer) developed on the membrane surface and further filtration by cake layer and narrowed pores. The faster permeability decline and higher TOC removal rate of the PETE membrane were attributed to an initial permeate flux higher than an average design flux, which led to a faster rate of fouling and thicker cake layer. Therefore, an MBR should not be operated at a flux higher than the average design flux for a specific type of membrane. A gradual increment of biomass concentration did not significantly affect membrane permeability of each membrane investigated. Dissolved organic carbon fractionation results showed that the composition of each fraction between the supernatant and permeates did not change significantly with time, suggesting that membrane hydrophobicity was not a dominant factor affecting MBR fouling in this study. The organic foulants desorbed from the PCTE membrane contained approximately 60% of hydrophobic fraction, which was probably attributable to the extracellular polymeric substances proteins released from the biomass attached to the membrane. While the total filtration resistance of the PTFE membrane was influenced by a higher surface roughness, those of the PETE and PCTE membranes, which had a similar and lower roughness, were affected by the initial operating flux.     

Distribution of organochlorine pesticides (OCPs) and polychlorinated biphenyls (PCBs) in human serum from urban areas in Korea

Concentrations of organochlorine pesticides (OCPs) and polychlorinated biphenyls (PCBs) were determined in serum samples from residents of a Korean urban area (Seoul). This study was performed on 40 Koreans in the general population, aged 27-58, who had resided in urban areas for more than 10 years without occupational exposure to organochlorine pollutants. To our knowledge, this study was the first report on serum concentrations of OCPs in Korean residents. p,p'-DDE, beta-HCH, p,p'-DDT, HCB, and trans-nonachlor were the dominant OCPs in most samples. In addition, concentrations of 22 OCPs were measured by the isotope dilution method with GC-HRMS, which gave accurate and precise data for investigations of trend and international comparisons. The dominant PCBs were PCB153, 138, 180, 187, and PCB118, which contributed 60% to total PCBs. The median concentrations of total OCPs and total PCBs were 315 ng g(-1) lipid and 104 ng g(-1) lipid, respectively. In females, the serum concentrations of all determined organochlorine compounds except beta-HCH were positively correlated with age, and higher concentrations of organochlorine pollutants were found in males than in females. Compared to our previous studies, PCB concentrations in serum from urban areas have substantially decreased during the last decade leading to the observation that the strict regulation of PCBs was helpful in controlling the concentration of PCBs in the environment. Extensive monitoring programs are required for evaluating the concentrations of OCPs and PCBs in serum samples of the general population as an indicator of possible adverse health effects.     

Leaching of brominated flame retardants from TV housing plastics in the presence of dissolved humic matter

In this study, we investigated the contents of several brominated compounds in TV molding plastics, as well as their leaching characteristics in the presence of DHM. The PBDE content was about 3% of the sample weight, and deca-BDE was the most abundant homologue, accounting for over 80% of the total amount. TBBPA, PBPs and PBBs content was 8100, 4700 and 250 ng/g, respectively. Despite no detection of most of the lower brominated DEs in distilled water, most homologues could be detected in DHM solution, and their solubility increased according to the contact time; those of highly brominated compounds increased to 10 times their maximum solubility in distilled water. Especially, contrary to the relatively faster equilibrium in distilled water, BFR solubility in DHM solution was maintained even after 20 days. In addition, a modified first-order model adequately reflected rapid desorption for each compound in the initial period, but slow desorption afterwards. From an overall perspective, it is clear that hydrophobic BFRs can leach out to a great extent in the presence of DHM, which is a matter of great concern in E&E waste as the potential contaminant source of BFRs, especially in landfills and open dump sites that provide the perfect conditions for exposure of BFRs to abundant DHM.     

Dioxin and dioxin-like PCB profiles in the serum of industrial and municipal waste incinerator workers in Korea

To assess occupational exposure, we determined the concentrations of PCDD/Fs and PCBs in human serum samples from 26 incinerator workers (10 industrial waste and 16 municipal solid waste incinerator workers), 38 residents near the facilities and 7 inhabitants (as control subjects) living over 10 km away from any incinerator facilities in Korea. The mean TEQ_WHO levels of PCDD/Fs in the industrial and MSWI workers were 41.57 and 9.86 pg TEQ_WHO g^? 1 lipid, respectively. For the residents, the mean TEQ_WHO was 13.47 pg TEQ_WHO g^? 1 lipid (residents near IWI, MSWI, and control subjects: 17.64, 13.31, and 6.91 pg TEQ_WHO g^? 1 lipid). Higher levels of certain PCDD/F congeners, mainly PCDFs, were detected in the serum of industrial incinerator workers in comparison to the levels measured in the residents. Significant differences were observed for PCDFs, the major compounds were OCDF, 1,2,3,4,6,7,8-HpCDF, and the minor components 1,2,3,4,7,8-HxCDF, 1,2,3,6,7,8-HxCDF, and 2,3,4,6,7,8-HxCDF (p < 0.01). The PCDD/F congener patterns and concentrations measured in the 71 serum samples examined suggest that the industrial incinerator workers were exposed to PCDD/Fs in the workplace, possibly through inhalation and/or skin contact. In contrast, the levels and congener patterns of PCBs measured were similar in all subjects, indicating that workers from the incinerator facilities examined were not subjected to additional exposure to these compounds.     

Assessment of PCDD/F risk after implementation of emission reduction at a MSWI

Municipal solid waste incinerators (MSWIs) have been shown to be important sources of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs). The emission of PCDD/Fs by MSWIs is a controversial subject in human health risk assessment. In this study the effect of a MSWI on a residential area was assessed before and after the installation of an additional treatment system for flue gas. This additional treatment system resulted in a dramatic decrease in PCDD/F concentrations in stack flue gas samples by 99.98%, while the concentrations in air decreased by approximately 50% (36,500 and 0.75 pg I-TEQ m(-3) for air in 1999; 3.5 and 0.38 pg I-TEQ m(-3) in 2002; 1.6 and 0.076 pg I-TEQ m(-3) in 2005 for stack gas and air, respectively). Considering the congener distributions of PCDD/Fs between stack flue gas and air samples, the study area seemed to have been contaminated by other urban sources as well as the MSWI. ISC3 model results support the conclusion that this incinerator became only a minor contributor to the study area after installation of the supplementary systems. This resulted from both proper MSWI operation using modern technology and additional sources of contaminants in this region. Finally, PCDD/F uptake by humans through inhalation of contaminated air was estimated. Assuming that inhalation exposure contributes 10% of total exposure, total exposure was lower than WHO guidelines. These results confirm that proper operation and maintenance of the incinerator led to a reduction in emissions and potential health impacts of PCDD/Fs.     

Comparison of sludge characteristics and PCR-DGGE based microbial diversity of nanofiltration and microfiltration membrane bioreactors

The objective of this study was to compare the sludge characteristics and microbial community diversity between the submerged nanofiltration membrane bioreactor (NF MBR) and microfiltration membrane bioreactor (MF MBR) treating the same municipal wastewater. The influence of a higher concentration of organic matter and salt was investigated. The results of water qualities showed that the dissolved organic carbon (DOC), total phosphorus (T-P) and salt concentrations of the supernatant in the NF MBR were three, four and two times as high as those in the MF MBR, respectively. The specific oxygen uptake rate of the NF MBR (2.9+/-0.4 mg O(2)g(-1)MLSSh(-1)) was lower than that of the MF MBR (4.3+/-1.1 mg O(2)g(-1)MLSS h(-1)). Result of extractable extracellular polymeric substances showed that the NF MBR sludge had more protein and less polysaccharide compared to the MF MBR sludge, whereas specific amount of total organic carbon were the same in both MBRs. The median floc diameters of the NF MBR and the MF MBR were 72+/-12 microm and 59+/-12 microm, respectively, which could be attributable to the different polysaccharide concentrations between both MBR mixed liquor. A higher concentration of materials (DOC, T-P and salt) in the bioreactor, determined by the high rejection rate of the NF membrane, did not significantly affect the microbial diversity under similar operation conditions.     

The toxic effects of neem extract and azadirachtin on the brown planthopper, Nilaparvata lugens (Stål) (BPH) (Homoptera: Delphacidae)

Extracts of neem (Azadirachta indica A. Juss) are used in the developing world for many purposes including management of agricultural insect pests. The effects of different neem extracts (aqueous (NSKEaq), ethanol (NSKEeth) and hexane (NSKEhex)) on mortality, survival and weight of the brown planthopper, Nilaparvata lugens (St?l) (BPH) (Homoptera: Delphacidae) third and fourth nymphal instars were investigated. When fed rice plants treated with neem derivatives in bioassays, the survival of BPH nymphs is affected. Comparisons were made with the pure neem limonoid, azadirachtin (AZA) to ascertain its role as a compound responsible for these effects. AZA was most potent in all experiments and produced almost 100% nymphal mortality at 0.5 ppm and higher concentrations. When higher concentrations were applied, the effects appeared shortly after treatment and mortality was higher. Many insects died after remaining inactive for several days or during prolonged moulting. At lower concentrations, if moulting was achieved, disturbed growth and abnormalities were then likely to occur in the moulting process. Nymphs that were chronically exposed to neem extract showed a reduction in weight (45-60%). The results clearly indicate the simple NSKE (aqueous, ethanolic or both), containing low concentrations of AZA, can be used effectively to inhibit the growth and survival of BPH.     

The prediction of PCDD/DF levels in wet scrubbers associated with waste incinerators

Wet scrubber is one of the most conventional types of air pollutant control devices (APCDs), which is specially designed to treat dust and acidic gases in the flue gas simultaneously. In spite of its outstanding ability to control them, however, wet scrubbers have been considered as potential contaminant sources that may increase PCDD/DF concentrations in the flue gas. In this study, we investigated the change of PCDD/DF concentrations at the inlets and outlets of seven wet scrubbers, and compared them with other published data. With a multi-regression analysis of dust concentrations and temperature at the inlets and outlets of given wet scrubbers, we developed an empirical model to understand factors dominating the change of PCDD/DF concentrations. As a result, we confirmed that the changes of PCDD/DF concentrations in wet scrubbers are closely related to their concentrations at the inlets, which would usually be determined by the type of APCDs installed upstream of the wet scrubber.     

Inactivation of Bacillus subtilis spores during ozonation in water treatment plant: influence of pre-treatment and consequences for positioning of the ozonation step

This study reports on quantitative methodology for rational selection of the ozone injection point within unit processes of conventional drinking water treatment plants to improve disinfection efficiencies. The method is based on the fact that a specific inactivation level of microorganisms is achieved at a unique value of ozone exposures, independent of ozone dose and type of water, and quantitatively described by a Delayed Chick-Watson model (C T(lag): 1.03mgl(-1), k: 1.44mg(-1)lmin(-1)). This study demonstrated this phenomenon by performing the inactivation of Bacillus subtilis (B. subtilis) spores with ozone in various types of water collected from a series of unit processes in a water treatment plant. Simple measurements of the ozone decomposition behavior in waters from each unit process of a water treatment plant can allow the quantitative evaluation of the ozone needed to achieve a required level of inactivation. This methodology will be useful for drinking water treatment plants which intend to improve the disinfection efficiencies of their ozonation process.     

Electrochemical Detection of Pathogen Infection Using Cell Chip

The immobilized cell using self-assembled synthetic oligopeptide was applied to the electrochemical detection of pathogen infection. Thin films based on cysteine-terminated synthetic oligopeptides were fabricated for the immobilization of HeLa cell on gold (Au) substrate. Layer formation and immobilization of the cell were investigated with surface plasmon resonance (SPR) and electrochemical impedance spectroscopy (EIS). Experimental results showed that the thin film of cysteine-terminated synthetic oligopeptide was successfully fabricated and it could be applied for the immobilization of HeLa cells. The adhered living cell was exposed to E. coli O157:H7, which induced the change of SPR angle and electrochemical impedance signal. The proposed cell immobilization method using self-assembly technique can be applied to construct the cell microarray for on-site pathogen monitoring.