Could curcumin ameliorate titanium dioxide nanoparticles effect on the heart? A histopathological,immunohistochemical, and genotoxic study

Environmental Science and Pollution Research - The evaluation of the toxicological effects of titanium dioxide nanoparticles (TiO2NPs) is increasingly important due to their growing occupational...     

Assessing interactions,predicting function,and increasing degradation potential of a PAH-degrading bacterial consortium by effect of an inoculant strain

Environmental Science and Pollution Research - A natural phenanthrene-degrading consortium CON was inoculated with an exogenous strain Sphingobium sp. (ex Sp. paucimobilis) 20006FA yielding the...     

Guarana improves behavior and inflammatory alterations triggered by methylmercury exposure: an in vivo fruit fly and in vitro neural cells study

Environmental Science and Pollution Research - Methylmercury (MeHg) is a well-known environmental pollutant associated with neurological and developmental deficits in animals and humans. However,...     

Bromide affecting drinking water mutagenicity

The effect of bromide on the mutagenicity of artificially recharged groundwater and purified artificially recharged groundwater after chlorine, ozone, hydrogen peroxide, permanganate, and UV treatments alone and in various combinations was studied. The highest mutagenicity was observed after chlorination, while hydrogen peroxide-ozone-chlorine treatment produced the lowest value for both waters. Chlorinated waters, which were spiked with bromide, had up to 3.7 times more mutagenic activity than waters without bromide after every preoxidation method. 3-Chloro-4-(dichloromethyl)-5-hydroxy-2(5H)-furanone (MX) was found to correspond as much as 76% of the overall mutagenicity in the waters not spiked with bromide. MX formation was found to be lower when the treated water contained bromide, implicating the formation of brominated MX analogues. Trihalomethane formation increased when the treated water contained bromide.     

Toxicity of chemical components of fine particles inhaled by aged rats: effects of concentration

This study tested the hypothesis that exposure to mixtures containing fine particles and ozone (O3) would cause pulmonary injury and decrements in functions of immunological cells in exposed rats (22-24 months old) in a dose-dependent manner. Rats were exposed to high and low concentrations of ammonium bisulfate and elemental carbon and to 0.2 ppm O3. Control groups were exposed to purified air or O3 alone. The biological end points measured included histopathological markers of lung injury, bronchoalveolar lung fluid proteins, and measures of the function of the lung's innate immunological defenses (macrophage antigen-directed phagocytosis and respiratory burst activity). Exposure to O3 alone at 0.2 ppm did not result in significant changes in any of the measured end points. Exposures to the particle mixtures plus O3 produced statistically significant changes consistent with adverse effects. The low-concentration mixture produced effects that were statistically significant compared to purified air but, with the exception of macrophage Fc receptor binding, exposure to the high-concentration mixture did not. The effects of the low- and high-concentration mixtures were not significantly different. The study supports previous work that indicated that particle + O3 mixtures were more toxic than O3 alone.     

Predicting logP of pesticides using different software

We compared experimental and calculated logP values using a data set of 235 pesticides and experimental values from four different sources: The Pesticide Manual, Hansch Manual, ANPA and KowWin databases. LogP were calculated with four softwares: HyperChem, Pallas, KowWin and TOPKAT. Crossed comparison of the experimental and calculated values proved useful, especially for pesticides. These are harder to study than simpler organic compounds. Structurally they are complex, heterogeneous and similar to drugs from a chemical point of view. They offer an interesting way to verify the goodness of the different methods. Other studies compared several logP predictors using a single set of experimental values taken as a reference. Here we discuss the utility of the different logP predictors, with reference to experimental data found in different databases. This offers three advantages: (1) it avoids bias due to the assumption that one single data set is correct; (2) a given predictor can be developed on the same data set used for evaluation; (3) it takes account of experimental variability and can compare it with the predictor's variability. In our study Pallas and KowWin gave the best results for prediction, followed by TOPKAT.     

Environmental impacts of coastal aquaculture in eastern mediterranean bays the case of astakos gulf,Greece

GOAL, SCOPE AND BACKGROUND: Over the last decade Greece has become a leading country in the EU as concerns the cage farming of seabream and seabass. A strong debate has risen, however, about the environmental impacts of aquacultures in the coastal areas. The present paper deals with this problem and it is based on measurements of physico-chemical parameters in the water column, particulate matter and sediments in the area of Astakos Gulf, a coastal embayment in western Greece where three big fish farms are currently operating. METHODS: Water samples were collected by using Hydro-Bios sampling bottles, whereas a prototype sediment trap was installed under a fish cage for the collection of particulate matter. Temperature, dissolved oxygen, pH and salinity were measured in situ using portable equipment. Nutrients were determined by standard spectrophotometric methods. Trace metals were determined by Atomic Absorption Spectrometry. Dissolved organic carbon was determined by a Shimadzu 5000A carbon analyzer, whereas organic carbon in sediments was determined titrimetrically. RESULTS AND DISCUSSION: No clear eutrophication incidents have been identified, although the water column near the fish farms was enriched in nutrients and organic carbon. A sludge 'blanket' covers considerable parts of the seabed and is enriched in colloidal organic carbon and trace metals (Cd, Cu, Fe and Zn) that come from unused fish food. The biodegradation of this sludge leads to the development of anoxic conditions followed by the formation of undesirable gases, precipitation or remobilization of metals and the extinction of benthic fauna. CONCLUSION: The operation of fish farms at the coastal area of Astakos Gulf, and probably in similar Mediterranean gulfs, affects the marine environment, particularly in the vicinity of the cages. The most significant influence concerns the near-bottom water layer. The environmental impacts depend on the amount of food given to fishes, the mode of feeding, the fish density in cages, the annual production and the years of unit operation. The hydrology and the geomorphology of the area are also critical factors for its environmental quality. RECOMMENDATION AND OUTLOOK: The success of the fish-farming sector in the Mediterranean is accompanied by environmental and, in some extents, by social and marketing problems. These problems, derived from the rapid development of fish farming, can be solved only through an integrated management, using methods such as environmental impact assessment, risk assessment, economic evaluation, vulnerability assessments, resource accounting, cost-benefit analysis and outcome-based monitoring.     

Investigation of the complexation of metal-ions by strong ligands in fresh and marine water

SCOPE: The detection and investigation of metal ions bound in strong complexes in natural waters is a difficult task, due to low concentration of the metal ions themselves, and also of the strong ligands, which, moreover, are often not of a well-defined composition. Here, a method is proposed for the investigation of the speciation of metal ions in natural waters. OBJECTIVE AND METHOD: It is based on the sorption of metal ions on strongly sorbing ion exchange resins, i.e. complexing resins. For this reason the method is called Resin Titration. It has been shown in previous investigations that the concentration of metal ion totally sorbed by a particular resin, and its reaction coefficient in the solution phase in the presence of the resin, can be determined from the sorption data using a simple relationship. Here, a data treatment (the Ruzic linearization method) is proposed for also determining the concentration of the ligands responsible for the complex in equilibrium with the resin. RESULTS: The method was applied to data obtained by Resin Titration of a freshwater and a seawater. Copper(II) and aluminium(III) were considered, using Chelex 100 as a titrant, due to its strong sorbing properties towards these metal ions. The results were: the total metal concentration in equilibrium with the resin, the side reaction coefficients, and the concentration of ligands. In all these cases the ligands forming very strong complexes were found to be at concentration lower than that of the metals. CONCLUSION: The Ruzic linearization method allows the determination of the concentration of the ligands forming very strong complexes in equilibrium with Chelex 100. The reaction coefficient was better determined by the calculation method previously proposed for RT. The ligands responsible for the strong complexes were found to be at low concentration, often lower than that of the metal ions considered. The metal in the original sample is partly bound to these ligands, since the complexes are very strong. Only a part of the metal is linked to weaker ligands, or free.     

Trimethylbenzoic acids as metabolite signatures in the biogeochemical evolution of an aquifer contaminated with jet fuel hydrocarbons

Evolution of trimethylbenzoic acids in the KC-135 aquifer at the former Wurtsmith Air Force Base (WAFB), Oscoda, MI was examined to determine the functionality of trimethylbenzoic acids as key metabolite signatures in the biogeochemical evolution of an aquifer contaminated with JP-4 fuel hydrocarbons. Changes in the composition of trimethylbenzoic acids and the distribution and concentration profiles exhibited by 2,4,6- and 2,3,5-trimethylbenzoic acids temporally and between multilevel wells reflect processes indicative of an actively evolving contaminant plume. The concentration levels of trimethylbenzoic acids were 3-10 orders higher than their tetramethylbenzene precursors, a condition attributed to slow metabolite turnover under sulfidogenic conditions. The observed degradation of tetramethylbenzenes into trimethylbenzoic acids obviates the use of these alkylbenzenes as non-labile tracers for other degradable aromatic hydrocarbons, but provides rare field evidence on the range of high molecular weight alkylbenzenes and isomeric assemblages amenable to anaerobic degradation in situ. The coupling of actual tetramethylbenzene loss with trimethylbenzoic acid production and the general decline in the concentrations of these compounds demonstrate the role of microbially mediated processes in the natural attenuation of hydrocarbons and may be a key indicator in the overall rate of hydrocarbon degradation and the biogeochemical evolution of the KC-135 aquifer.     

Emission and fate assessment of methyl tertiary butyl ether in the Boston area airshed using a simple multimedia box model: comparison with urban air measurements

Expected urban air concentrations of the gasoline additive methyl tertiary butyl ether (MTBE) were calculated using volatile emissions estimates and screening transport models, and these predictions were compared with Boston, MA, area urban air measurements. The total volatile flux of MTBE into the Boston primary metropolitan statistical area (PMSA) airshed was calculated based on estimated automobile nontailpipe emissions and the Universal Quasi-Chemical Functional-Group Activity Coefficient computed abundance of MTBE in gasoline vapor. The fate of MTBE in the Boston PMSA was assessed using both the European Union System for the Evaluation of Substances, which is a steady-state multimedia box model, and a simple airshed box model. Both models were parameterized based on the meteorological conditions observed during air sampling in the Boston area. Measured average urban air concentrations of 0.1 and 1 microg/m3 MTBE during February and September of 2000, respectively, were comparable to corresponding model predictions of 0.3 and 1 microg/m3 and could be essentially explained from estimated temperature-dependent volatile emissions rates, observed average wind speed (the airshed flushing rate), and reaction with ambient tropospheric hydroxyl radical (*OH), within model uncertainty. These findings support the proposition that one can estimate gasoline component source fluxes and use simple multimedia models to screen the potential impact of future proposed gasoline additives on urban airsheds.