改性壳聚糖复合凹凸棒土絮凝油漆废水

将壳聚糖、阳离子淀粉和二甲基二烯丙基氯化铵(DMDAAC)进行三元接枝共聚,制备了三元接枝改性壳聚糖(CTS-DMDAAC-CS),通过红外光谱和扫描电镜对其结构进行了表征。并且将三元接枝改性壳聚糖与凹凸棒土进行优化复配,对油漆废水进行了絮凝实验,得出了当pH=12,沉降时间为20 min,复合絮凝剂投加量为0.2 g,三元接枝共聚物∶凹凸棒土=1∶10时,该复合絮凝剂对油漆去除率最佳能够达到89.3%,并且絮凝效果好,是一种新型绿色环保的有机-无机复合絮凝剂。     

CdIn2S4/复合材料的制备及光降解罗丹明B

利用高压静电纺丝技术,制得含有羧基的导电聚合物纤维(聚偏氟乙烯/苯乙烯-马来酸酐共聚物/纳米石墨),高温水热条件下在纤维表面制备CdIn2S4颗粒,得到CdIn2S4/导电聚合物纤维复合材料。运用扫描电子显微镜(SEM)、X射线衍射仪(XRD)、紫外-可见吸收光谱仪(UV-Vis)和热失重分析仪(TGA)对复合材料的结构进行表征。并利用350 W氙灯模拟太阳光进行光催化降解罗丹明B。结果发现,CdIn2S4/导电聚合物纤维复合材料的降解效率高于CdIn2S4粉体和Degussa P25 TiO2粉体,光催化降解3 h,罗丹明B的降解率为96.2%。     

甲苯对UASB反应器中溶解性微生物产物的影响

以乙酸钠为外加碳源,考察了UASB反应器内甲苯对可溶性微生物产物（SMP）的影响。实验结果表明：低质量浓度（20~70 mg/L）的甲苯对微生物有刺激作用,使得污泥增殖速率变小,SMP的质量浓度也逐渐减少,经过一段时间的驯化后,系统COD和TOC的去除率分别达到93%和94%以上,下降趋势较小;较高质量浓度（70~200 mg/L）的甲苯对微生物有抑制作用,污泥活性下降,反应器运行状况开始恶化,SMP的质量浓度也逐渐增大,经过一段时间的驯化后,系统COD和TOC的去除率分别维持在81%和83%以上;当甲苯质量浓度超过200 mg/L时,表现为污泥活性严重下降,对COD的去除效果极差。     

Behavior and mechanism of arsenate adsorption on activated natural siderite: evidences from FTIR and XANES analysis

Activated natural siderite (ANS) was used to investigate its characteristics and mechanisms of As(V) adsorption from aqueous solution. Batch tests were carried out to determine effects of contact time, initial As(V) concentration, temperature, pH, background electrolyte, and coexisting anions on As(V) adsorption. Arsenic(V) adsorption on ANS well-fitted pseudo-second-order kinetics. ANS showed a high-adsorption capacity of 2.19 mg/g estimated from Langmuir isotherm at 25 °C. Thermodynamic studies indicated that As(V) adsorption on ANS was spontaneous, favorable, and endothermic. ANS adsorbed As(V) efficiently in a relatively wide pH range between 2.0 and 10.0, although the removal efficiency was slightly higher in acidic conditions than that in basic conditions. Effects of background electrolyte and coexisting anions were not significant within the concentration ranges observed in high As groundwater. Results of XRD and Fe K-edge XANES analysis suggested ANS acted as an Fe(II)/(III) hybrid system, which was quite effective in adsorbing As from aqueous solution. There was no As redox transformation during adsorption, although Fe(II) oxidation occurred in the system. Two infrared bands at 787 and 872 cm^?1 after As(V) adsorption suggested that As(V) should be predominantly adsorbed on ANS via inner-sphere bidendate binuclear surface complexes.     

Formation of indoor nitrous acid (HONO) by light-induced NO<Subscript>2</Subscript> heterogeneous reactions with white wall paint

Gaseous nitrogen dioxide (NO₂) represents an oxidant that is present in relatively high concentrations in various indoor settings. Remarkably increased NO₂ levels up to 1.5 ppm are associated with homes using gas stoves. The heterogeneous reactions of NO₂ with adsorbed water on surfaces lead to the generation of nitrous acid (HONO). Here, we present a HONO source induced by heterogeneous reactions of NO₂ with selected indoor paint surfaces in the presence of light (300 nm?<?λ?<?400 nm). We demonstrate that the formation of HONO is much more pronounced at elevated relative humidity. In the presence of light (5.5 W m^?2), an increase of HONO production rate of up to 8.6?·?10⁹ molecules cm^?2 s^?1 was observed at [NO₂]?=?60 ppb and 50 % relative humidity (RH). At higher light intensity of 10.6 (W m^?2), the HONO production rate increased to 2.1?·?10¹⁰ molecules cm^?2 s^?1. A high NO₂ to HONO conversion yield of up to 84 % was observed. This result strongly suggests that a light-driven process of indoor HONO production is operational. This work highlights the potential of paint surfaces to generate HONO within indoor environments by light-induced NO₂ heterogeneous reactions.     

Scanning electron microscopic investigations of root structural modifications arising from growth in crude oil-contaminated sand

The choice of plant for phytoremediation success requires knowledge of how plants respond to contaminant exposure, especially their roots which are instrumental in supporting rhizosphere activity. In this study, we investigated the responses of plants with different architectures represented by beetroot (Beta vulgaris), a eudicot with a central taproot and many narrower lateral roots, and tall fescue (Festuca arundinacea), a monocot possessing a mass of threadlike fibrous roots to grow in crude oil-treated sand. In this paper, scanning electron microscopy was used to investigate modifications to plant root structure caused by growth in crude oil-contaminated sand. Root structural disorders were evident and included enhanced thickening in the endodermis, increased width of the root cortical zone and smaller diameter of xylem vessels. Inhibition in the rate of root elongation correlated with the increase in cell wall thickening and was dramatically pronounced in beetroot compared to the roots of treated fescue. The latter possessed significantly fewer (p?<?0.001) and significantly shorter (p?<?0.001) root hairs compared to control plants. Possibly, root hairs that absorb the hydrophobic contaminants may prevent contaminant absorption into the main root and concomitant axile root thickening by being sloughed off from roots. Tall fescue exhibited greater root morphological adaptability to growth in crude oil-treated sand than beetroot and, thus, a potential for long-term phytoremediation.     

假单胞菌好氧降解四溴双酚A的特性

为了解四溴双酚A(TBBPA)的好氧降解特性,采用选择富集法从活性污泥中分离出一株能够高效降解四溴双酚A的菌株。根据其形态、生理生化特性及16S rDNA核苷酸序列分析,该菌株被鉴定为假单胞菌属(Pseudomonas sp.)。研究结果表明,该菌株可通过好氧共代谢方式实现四溴双酚A的降解,葡萄糖是四溴双酚A降解的最佳碳源,其最优降解条件为葡萄糖8 g/L,牛肉膏0.5 g/L,pH值为7.0,培养温度为35℃,摇床转速为150 r/min。在该条件下其生物降解过程符合一级动力学模型,6 d后的降解率高达95.6%。LC-MS结果表明,四溴双酚A在好氧降解过程中会生成异丙苯酚类物质。     

酸性矿井水中和沉淀法除铁优化

针对山西某煤矿高矿化度、高铁酸性矿井水除铁效果差、出水容易返色等问题,采用NaOH中和调pH、曝气及化学氧化等处理工艺进行酸性矿井水中和沉淀法除铁优化实验研究。结果表明,采用NaOH中和沉淀法除铁时,投加中和剂使出水pH达6.7以上时,出水中铁含量低于10 mg/L,满足排放要求。对于本实验废水NaOH所需投加量为2.8 g/L,铁的去除率可达到99.75%;以H2O2对原水进行氧化处理,可迅速将Fe(Ⅱ)氧化成Fe(Ⅲ),其用量与原水中Fe(Ⅱ)的含量成正比。当其用量为1.6 mL/L时,可将原水中的Fe(Ⅱ)完全转化为Fe(Ⅲ),投加中和剂使出水pH达到4.5以上时,能使出水中铁含量满足排放要求。对于实验废水所需的NaOH投加量为2.0 g/L,比直接中和沉淀所需的NaOH用量要节省28.6%。曝气处理对原水中Fe(Ⅱ)的氧化效果不明显。     

改性活性炭对水中铬离子(Ⅵ)的吸附性能

为了研究改性前后活性炭对水中铬离子(Ⅵ)的吸附效果,以磷酸活性炭(PAC)为原料,用10%硝酸改性得到硝酸改性活性炭(N-PAC)及直接蒸发法载铁改性得到载铁活性炭(Fe-PAC)。通过静态吸附研究表明,改性后活性炭对Cr(Ⅵ)的吸附率有较大提高。在常温、自然pH条件下,0.2 g活性炭处理50 mL浓度为100 mg/L的含Cr(Ⅵ)溶液,N-PAC和Fe-PAC对Cr(Ⅵ)的吸附率分别为79.21%和90.59%,都高于原PAC对Cr(Ⅵ)的吸附率49.58%。pH从2.2升高到11.92,Fe-PAC对Cr(Ⅵ)的吸附率从99.86%降低到14.77%,N-PAC则从99.86%降低到3.23%,PAC从97.05%降低到2.53%。温度从25℃升高到70℃,3种活性炭对Cr(Ⅵ)吸附率都有较大提高,都增加到98%以上。且吸附过程较符合Langmuir等温吸附模型。     

Classification and comparison of municipal solid waste based on thermochemical characteristics

Municipal solid waste (MSW) has been normally sorted into six categories, namely, food residue, wood waste, paper, textiles, plastics, and rubber. In each category, materials could be classified further into subgroups. Based on proximate and ultimate analysis and heating value, statistical methods such as analysis of variance (ANOVA) and cluster analysis were applied to analyze the characteristics of MSW in every subgroup and to try to distinguish their relative properties. The chemical characteristics analysis of MSW showed that polyethylene (PE), polypropylene (PP), and polystyrene (PS) had the highest volatile matter content, with almost no ash and fixed carbon, while polyethylene terephthalate (PET) had high carbon content but low hydrogen content. Bones and vegetables had the highest ash content, while nutshells and rubber had the highest fixed carbon content. Paper and starch food had the highest oxygen content, and wool and bones had the highest nitrogen and sulfur content. Polyvinyl chloride (PVC) had the highest chlorine content at about 55%. PE, PP, and PS had the highest heating value, followed by chemical products such as rubber and chemical fiber. Conversely, paper, vegetables and bones had the lowest heating value. The results of cluster analysis of MSW components showed that fruit peel, weeds, wood, bamboo, leaves and nutshells could be classified as the lignocellulose category; starch food, cotton, toilet paper, printing paper and cardboard could be classified as the glucose monomer category; wood and chemical fiber could be classified as the high nitrogen and sulfur category; and PE, PP, and PS could be cluster as the polyolefin category.

Implications: The yield of municipal solid waste (MSW) is constantly increasing and waste to energy (WTE) has been used extensively all over the world. During the processes of incineration, pyrolysis, or gasification, the impact of physical and chemical properties of MSW is of great significance. However, the traditional classification of MSW is too general to provide more detailed information in many investigations. It is necessary to perform the investigation of characteristics of combustible MSW to distinguish different categories of MSW and find out their subclassification.